Currently, the evidence of the ingestion of microplastics (MPs) by organisms or the accumulation in different environmental compartments has been achieved using several methodological procedures. However, its uses have not been standardized across studies. In this study, we aim to assess and validate a protocol that can be useful for optimizing the identification and quantification procedures of polyethylene microplastics (PE MPs) in biological samples. Initially, considering that numerous studies filter samples previously digested in cellulosic membranes for isolation and analysis of MPs, we evaluated whether washing these membranes with different reagents could contribute to the complete detachment of particles, as well as to their dispersion in the obtained solutions. However, none of the tested reagents (dimethyl sulfoxide, acetone, ethyl alcohol and chloroform), including purified water, was able to completely remove the MPs adhered to the membranes or facilitate their dispersion in the solutions. On the other hand, we observed that the digestion of the membranes by acetonitrile constituted a procedure that prevents the loss of particles due to adherence, in addition to promoting good dispersion of MPs. Subsequently, we evaluated the use of Neubauer chambers for the quantification of MPs, having observed a good recovery rate (>92%) and results with insignificant variation, in PE MPs solutions with different concentrations (0.15; 0.075 and 0.0375 mg/mL). Ultimately, the validation of the proposed procedures took place from the evaluation of the accumulation of PE MPs in Astyanax spp. juveniles, having demonstrated the efficiency and sensitivity of the method proposed for this purpose. Subsequently, our study provides a methodological alternative that can optimize MPs quantifications in biological samples and reduce the generation of biased or unreliable results.

Antibiotics are emerging contaminants in aquatic environments which pose serious risks to the ecological environment and human health. Advanced oxidation processes (AOPs) based on ultraviolet (UV) light have good application prospects for antibiotic degradation. As new and developing UV-AOPs, UV/chlorine and derived UV/chloramine processes have attracted increasing attention due to the production of highly reactive radicals (e.g., hydroxyl radical, reactive chlorine species, and reactive nitrogen species) and also because they can provide long-lasting disinfection. In this review, the main reaction pathways of radicals formed during the UV/chlor (am)ine process are proposed. The degradation efficiency, influencing factors, generation of disinfection by-products (DBPs), and changes in toxicity that occur during antibiotic degradation by UV/chlor (am)ine are reviewed. Based on the statistics and analysis of published results, the effects caused by energy consumption, defined as electrical energy per order (EE/O), increase in the following order: UV/chlorine < UV/peroxydisulfate (PDS)< UV/H₂O₂ < UV/persulfate (PS) < 265 nm and 285 nm UV-LED/chlorine (EE/O). Some inherent problems that affect the UV/chlor (am)ine processes and prospects for future research are proposed. The use of UV/chlor (am)ine AOPs is a rich field of research and has promising future applications, and this review provides a theoretical basis for that.

Exposure to trihalomethanes (THMs) and haloacetic acids (HAAs) has been individually associated with adverse male reproductive effects; however, their joint male reproductive toxicity is largely unknown. This study aimed to explore the joint effects of THMs and trichloroacetic acid (TCAA) on semen quality in a Chinese population. A total of 337 men presenting to the Reproductive Center of Tongjing Hospital, in Wuhan, China to seek semen analysis were included this study. Baseline blood THMs [chloroform (TCM), bromodichloromethane (BDCM), dibromochloromethane (DBCM), and bromoform (TBM)] and urinary TCAA were analyzed and dichotomized at their median levels. The joint effects of THMs and TCAA on below-reference semen quality parameters were evaluated by calculating the relative excess risk due to interaction (RERI). After adjusting for potential confounders, we found a suggestive synergistic effect between Br-THMs (sum of BDCM, DBCM, and TBM) and TCAA for below-reference sperm count (RERI = 2.14, 95% CI: −0.37, 4.91) (P = 0.076); men with high Br-THMs and TCAA levels (above the median) had 3.31 times (95% CI: 1.21, 9.07) elevated risk of having below-reference sperm count than men with low Br-THMs and TCAA levels (below the median). No apparent joint effects were observed between THMs and TCAA for other semen quality parameters. Our results suggest that co-exposure to Br-THMs and TCAA is associated with additive effects on decreased semen quality. However, further studies in a larger sample size and mechanistic studies are needed to confirm the findings.

Although animal data have suggested the carcinogenic activity of trihalomethanes (THMs), there is inconsistent evidence supporting the link between THM exposure and cancers in humans.We investigated the association between specific and total blood THM levels with the risk of total cancer mortality in adults.We analyzed data from the 1999–2004 Third National Health and Nutrition Examination Survey and the Linked Mortality File of the United States. A total of 933 adults (20–59 years of age) with available blood THM levels and no missing data for other variables were included. Four different THM species (chloroform, bromodichloromethane (BDCM), dibromochloromethane (DBCM) and bromoform) were included, and the codes associated with cancer (malignant neoplasm) were C00 through C97, based on the underlying causes of death listed in the International Classification of Disease 10the Revision.Compared with adults in the lowest DBCM, bromoform, and total brominated THM tertiles, those in the highest DBCM, bromoform, and total brominated THM tertiles exhibited adjusted hazard ratios (HR) of total cancer mortality of 4.97 (95% confidence interval (CI) = 1.59–15.50), 4.94 (95% CI = 1.56–15.61), and 3.42 (95% CI = 1.21–15.43) respectively. The risk of total cancer mortality was not associated with increases in blood chloroform and total THM levels.We found that the baseline blood THM species, particularly brominated THMs, were significantly associated with total cancer mortality in adults. Although this study should be confirm by other studies, our findings suggest a possible link between THM exposures and cancer.

Halocarbons including chloroform (CHCl3), trichloroethylene (C2HCl3), tetrachloroethylene (C2Cl4), chlorodibromomethane (CHBr2Cl) and bromoform (CHBr3) were measured in the Yellow Sea (YS) and the East China Sea (ECS) during spring 2011. The influences of chlorophyll a, salinity and nutrients on the distributions of these gases were examined. Elevated levels of these gases in the coastal waters were attributed to anthropogenic inputs and biological release by phytoplankton. The vertical distributions of these gases in the water column were controlled by different source strengths and water masses. Using atmospheric concentrations measured in spring 2012 and seawater concentrations obtained from this study, the sea-to-air fluxes of these gases were estimated. Our results showed that the emissions of C2HCl3, C2Cl4, CHBr2Cl, and CHBr3 from the study area could account for 16.5%, 10.5%, 14.6%, and 3.5% of global oceanic emissions, respectively, indicating that the coastal shelf may contribute significantly to the global oceanic emissions of these gases.

¹H NMR-based metabolomics was used to examine the response of the earthworm Eisenia fetida after exposure to sub-lethal concentrations of phenanthrene over time. Earthworms were exposed to 0.025 mg/cm² of phenanthrene (1/64th of the LC₅₀) via contact tests over four days. Earthworm tissues were extracted using a mixture of chloroform, methanol and water, resulting in polar and non-polar fractions that were analyzed by ¹H NMR after one, two, three and four days. NMR-based metabolomic analyses revealed heightened E. fetida responses with longer phenanthrene exposure times. Amino acids alanine and glutamate, the sugar maltose, the lipids cholesterol and phosphatidylcholine emerged as potential indicators of phenanthrene exposure. The conversion of succinate to fumarate in the Krebs cycle was also interrupted by phenanthrene. Therefore, this study shows that NMR-based metabolomics is a powerful tool for elucidating time-dependent relationships in addition to the mode of toxicity of phenanthrene in earthworm exposure studies.

Silver nanoparticles (AgNPs) are used in many industries for multiple applications that inevitably release AgNPs into surface water sources. The formation kinetics of disinfection by-products (DBPs) in the presence of AgNPs was investigated during chlorination. Experiments were carried out with raw water from a canal in Songkhla, Thailand, which analyzed the formation potential (FP) of trihalomethanes FP (THMFP), iodo-trihalomethanes FP (I-THMFP), haloacetonitriles FP (HANFP), and trichloronitromethane FP. Increased AgNP concentrations by 10–20 mg/L led to a higher specific formation rate of chloroform which is described by zero- and first-order kinetics. The increase in the specific formation of chloroform as increasing chlorine contact time could enhance both the THMFP rates and the maximum THMFP concentrations in all tested AgNPs. The AgNP content did not have a significant influence on I-THMFP and HANFP concentrations or speciation. The I-THMFP and HANFP increased in a short-chlorination time as mostly complete formation <12 h, and then the rate decreased as the reaction proceeded. The levels of THMs and many emerging DBPs are related to the presence of AgNPs in chlorinated water and chlorine reaction time. THMFP had a higher impact on integrated toxic risk value (ITRV) than I-THMFP and HANFP because of the chlorination of water with AgNPs. The chlorine reaction time was more effective for increasing the ITRV of THMFP than the level of AgNPs. Water treatment plants should control the DBPs that cause possible health risks from water consumption by optimizing water distribution time.

The accuracy and reliability of volatile organic compound (VOC) emission data are essential for assessing emission characteristics and their potential impact on air quality and human health. This paper describes a new method for determining VOC emission data by multipoint sampling from various process units inside a large-scale refinery. We found that the emission characteristics of various production units were related to the raw materials, products, and production processes. Saturated alkanes accounted for the largest fraction in the continuous catalytic reforming and wastewater treatment units (48.0% and 59.2%, respectively). In the propene recovery unit and catalytic cracking unit, alkenes were the most dominant compounds, and propene provided the largest contributions (57.8% and 23.0%, respectively). In addition, n-decane (12.6%), m,p-xylene (12.4%), and n-nonane (8.9%) were the main species in the normal production process of the delayed coking unit. Assessments of photochemical reactivity and carcinogenic risk were carried out, and the results indicate that VOC emissions from the propene recovery unit and catalytic cracking unit should be controlled to reduce the ozone formation potential; in addition, alkenes are precedent-controlled pollutants. The cancer risk assessments reveal that 1,2-dibromoethane, benzene, 1,2-dichloroethane, and chloroform were the dominant risk contributors, and their values were much higher than the standard threshold value of 1.0 × 10⁻⁶ but lower than the significant risk value defined by the US Supreme Court. Based on the VOC composition and a classification algorithm, the samples were classified into eight main groups that corresponded to different process units in the petroleum refinery. In conclusion, this work provides valuable data for investigating process-specific emission characteristics of VOCs and performing associated assessments of photochemical reactivity and carcinogenic risk in petrochemical refineries.

PURPOSE OF REVIEW: The purpose of this review is to summarize the current understandings of atmospheric VOC characteristics in China and put forward the methodological drawbacks of the VOC measurement that need to be resolved and the research gaps that need to be filled. RECENT FINDINGS: Whereas in recent investigations in the North China Plain (NCP) a reduction (20–66%) in total VOC concentration is noticed compared with the ones published before 2015, an increase (13–127%) is observed for the Yangtze River Delta (YRD) region. Aromatics and oxygenated VOCs are frequently appearing as the most abundant VOC group in recent investigations. Industry-related VOC sources are more dominant in the YRD regions while vehicle-related sources are more influential in the NCP, Central China, and Pearl River Delta regions. Benzene, 1,3,5-trimethylbenzene, ethylbenzene, naphthalene, dichloromethane, 1,2-dichloroethane, 1,2-dichloropropane, chloroform, carbon tetrachloride, and 1,2-dibromoethane pose carcinogenic risk to exposed population in China and the most risk-prone areas are affected by the petrochemical industry, biomass burning, waste management, and vehicle emissions. Formaldehyde and toluene have relatively high concentrations among the different indoor VOCs observed and their concentrations noticed to be exceeded the national air quality standard. More investigations have to be performed on rarely studied health risk assessment of VOCs and characterization of indoor VOCs. BVOC studies are rarely conducted in China, which has to be performed on common plant species, different forest, and agricultural crops. VOC characterization in forest fire smokes and more process-specific emission characteristics in common industries need to be conducted.

Six volatile halogenated organic compounds (VHOC), namely, chloroform, carbon tetrachloride, trichloroethylene, bromodichloromethane, dibromochloromethane, and bromoform, were studied in the Yellow Sea and East China Sea from April to May, 2009. The spatial variability of these VHOC was influenced by various factors, including anthropogenic inputs, biogenic production and complicated hydrographic features such as Changjiang Diluted Water, Yellow Sea Cold Water Mass, and Kuroshio Current. Diurnal study results showed that factors such as solar irradiation, biological activity, and tide affected the abundance of these VHOC. Correlation analyses revealed that bromodichloromethane was positively correlated with chlorophyll a in surface seawater. Principal component analysis suggested that chlorinated compounds like carbon tetrachloride originated from anthropogenic sources whereas brominated compounds such as bromodichloromethane originated from biogenic sources. Sources of other chlorinated and brominated compounds may not be governed by biological processes in the marine environment.