The effect of ceramic filter composition on improving the quality of produced water by reducing total dissolved solids (TDS), barium, and phenol for reverse osmosis (RO) treatment was investigated in the present work. The ceramic filters were fabricated using a residue catalytic cracking (RCC) unit spent catalyst with and without activation, clay, and Dioscorea hispida starch (DHS), at various compositions.  The result showed that the optimum removal of TDS, barium, and phenol in produced water was achieved at a flow rate of sample 7 L/min and an operating time of 90 min. Ceramic filter with the composition of 60% spent catalyst without activation: 37.5% clay: 2.5% DHS reduced 34.84% TDS, 27.97% barium, and 71.11% phenol. While, the ceramic filter with a composition of 37.5% activated spent catalyst: 60% clay: 2.5% DHS was removed 51.44% TDS, 27.93% barium, and 85.29% phenol from produced water. The next steps of treatment of filtrates of the ceramic filter using reverse osmosis (RO) membrane showed that the permeate met the Indonesian standard for oil and gas wastewater. In addition, adsorption of TDS, barium, and phenol from produced water was dominated by clay composition in the ceramic filter.

Partie B | International audience | Incidental zinc sulfide nanoparticles (nano-ZnS) are spread on soils through organic waste (OW) recycling. Here we performed soil incubations with synthetic nano-ZnS (3 nm crystallite size), representative of the form found in OW. We used an original set of techniques to reveal the fate of nano-ZnS in two soils with different properties. 68 Zn tracing and nano-DGT were combined during soil incubation to discriminate the available natural Zn from the soil, and the available Zn from the dissolved nano-68 ZnS. This combination was crucial to highlight the dissolution of nano-68 ZnS as of the third day of incubation. Based on the extended X-ray absorption fine structure, we revealed faster dissolution of nano-ZnS in clayey soil (82% within 1 month) than in sandy soil (2% within 1 month). However, the nano-DGT results showed limited availability of Zn released by nano-ZnS dissolution after 1 month in the clayey soil compared with the sandy soil. These results highlighted: (i) the key role of soil properties for nano-ZnS fate, and (ii) fast dissolution of nano-ZnS in clayey soil. Finally, the higher availability of Zn in the sandy soil despite the lower nano-ZnS dissolution rate is counterintuitive. This study demonstrated that, in addition to nanoparticle dissolution, it is also essential to take the availability of released ions into account when studying the fate of nanoparticles in soil.

The synthesis of clay-biochar composite has been recognized as an effective way to enhance the removal of pollutants. The interaction between clay mineral and biomass during thermal pyrolysis and the sorption capacity for ionic/nonionic organic containments have not been elaborated. In this study, two types of biochar were obtained from pyrolytic carbonization of the cellulosic-rich corn straw (C) and lignin-rich pine wood (P) at 500 or 700 °C. Typical clay minerals kaolinite and montmorillonite were selected to prepare clay-biochar composite. The results showed that the addition of clay mineral could strengthen dehydration reaction of corn straw biomass and reinforce its carbon structure. Montmorillonite-biochar composite owned more CC functional groups and porous structure than kaolinite-biochar composite. The addition of clay minerals could promote electrostatic attraction of ionic formed norfloxacin (NOR) on clay-pine wood biochar. However, the sorption capacity of nonionic diethyl phthalate (DEP) adsorption on clay-corn straw biochar decreased, owing to that clay increased the compactness of the biochar carbon structure, thus inhabited hydrophobic partition of nonionic organic compounds on disordered carbon fraction. The results from this study provide insights into the suitable contaminated site remediation by clay-biochar composite.

The inconsistency of available methods and the lack of harmonization in current microplastics (MPs) analysis in soils demand approaches for extraction and quantification which can be utilized across a wide variety of soil types. To enable robust and accurate assessment of extraction workflows, PET MPs with an inorganic tracer (Indium, 0.2% wt) were spiked into individual soil subgroups and standard soils with varying compositions. Due to the selectivity of the metal tracer, MPs recovery rates could be quickly and quantitatively assessed using ICP-MS. The evaluation of different methods specifically adapted to the soil properties were assessed by isolating MPs from complex soil matrices by systematically investigating specific subgroups (sand, silt, clay, non-lignified and lignified organic matter) before applying the workflow to standard soils. Removal of recalcitrant organic matter is one of the major hurdles in isolating MPs for further size and chemical characterization, requiring novel approaches to remove lignocellulosic structures. Therefore, a new biotechnological method (3-F-Ultra) was developed which mimics natural degradation processes occurring in aerobic (Fenton) and anaerobic fungi (CAZymes). Finally, a Nile Red staining protocol was developed to evaluate the suitability of the workflow for non-metal-doped MPs, which requires a filter with minimal background residues for further chemical identification, e.g. by μFTIR spectroscopy. Image analysis was performed using a Deep Learning tool, allowing for discrimination between the number of residues in bright-field and MPs counted in fluorescence mode to calculate a Filter Clearness Index (FCI). To validate the workflow, three well-characterized standard soils were analyzed applying the final method, with recoveries of 88% for MPs fragments and 74% for MPs fibers with an average FCI of 0.75. Collectively, this workflow improves our current understanding of how to adapt extraction protocols according to the target soil composition, allowing for improved MPs analysis in environmental sampling campaigns.

The sedimentary history of polycyclic aromatic hydrocarbons (PAHs) and organochlorine pesticides (OCPs) over the past 140 years in a lake sediment core from Huixian karst wetland was reconstructed. The total PAHs and OCPs concentrations ranged from 40.0 to 210 ng g⁻¹ and 0.98 to 31.4 ng g⁻¹, respectively. The vertical distribution of PAHs and OCPs in different stages was great consistent with the history of regional socio-economic development and the usage of OCPs. As the indicators of socio-economic development, gross domestic product (GDP), population, energy consumption, highway mileage, and private vehicles correlated with the PAHs concentrations, indicating the impact of human activities on PAHs levels. The PAHs and OCPs concentrations were also affected by environmental changes in the wetland, as reconstructed by total organic carbon (TOC), sand, silt, clay, quartz, and calcite in sediments. Redundancy analysis (RDA) results showed TOC was the dominant factor to explain the concentrations of PAHs and OCPs with the explanation of 86.7% and 43.5%, respectively. In addition, TOC content had significantly positive correlation with PAHs (0.96, p < 0.01) and OCPs (0.78, p < 0.01). In particular, the significantly positive correlation (p < 0.05) between calcite and PAHs and OCPs inferred that karstification might play an important role in the migration of PAHs and OCPs in the karst area. Therefore, the lake in Huixian wetland tended to be a sink more than a source of PAHs and OCPs influenced by the increasing TOC content and karstification under climate warming.

Plastic mulching and straw incorporation are common agricultural practices in China. Plastic mulching is suspected to be a significant source of microplastics in terrestrial environments. Straw incorporation has many effects on the storage of soil organic carbon (SOC) and greenhouse gas emissions, but these effects have not been studied in the presence of microplastic pollution. In this study, 365-day soil incubation experiments were conducted to assess the effects of maize straw and polyethylene microplastics on SOC fractions and carbon dioxide (CO₂) and nitrous oxide (N₂O) emissions in two different soils (fluvo-aquic and latosol). Against the background of straw incorporation, microplastics reduced the mineralization and decomposition of SOC, resulting in a microbially available SOC content decrease by 18.9%. In addition, microplastics were carbon-rich, but relatively stable and difficult to be used by microorganisms, thus increasing the mineral-associated SOC content by 52.5%. This indicated that microplastics had adverse effects on microbially available SOC and positive effects on mineral-associated SOC. Microplastics also decreased coarse particulate SOC (>250 μm), and increased non-aggregated silt and clay aggregated SOC (<53 μm). Furthermore, microplastics changed microbial community compositions, thereby reducing the CO₂ and N₂O emissions of straw incorporation by 26.5%–33.9% and 35.4%–39.7%, respectively. These results showed that microplastics partially offset the increase of CO₂ and N₂O emissions induced by straw incorporation. Additionally, the inhibitory effect of microplastics on CO₂ emissions in fluvo-aquic soil was lower than that in latosol soil, whereas the inhibitory effect on N₂O emissions had the opposite trend.

Hydraulic fracturing has become widely used in recent years to access vast global unconventional sources of oil and gas. This process involves the injection of proprietary mixtures of water and chemicals to fracture shale formations and extract the hydrocarbons trapped within. These injection fluids, along with minerals, hydrocarbons, and saline waters present within the formations being drilled into, return to the surface as flowback and produced water (FPW). FPW is a highly complex mixture, containing metals, salts and clay, as well as many organic chemicals, including polycyclic aromatic hydrocarbons such as phenanthrene. The present study sought to determine the effects of temperature on the accumulation of phenanthrene in rainbow trout (Oncorhynchus mykiss). This model organism resides in rivers overlapping the Montney and Duvernay formations, both highly developed formations for hydraulic fracturing. Rainbow trout acclimated to temperatures of 4, 13 and 17 °C were exposed to either 5% or 20% FPW, as well as saline mixtures representing the exact ionic content of FPW to determine the accumulation of radiolabelled ¹⁴C phenanthrene within the gill, gut, liver and gallbladder. FPW exposure reduced the overall accumulation of phenanthrene in a manner most often similar to high salinity exposure, indicating that the high ionic strength of FPW is the primary factor affecting accumulation. Accumulation was different at the temperature extremes (4 and 17 °C), although no consistent relationship was observed between temperature and accumulation across the observed tissues. These results indicate that several physiological responses occur as a result of FPW exposure and water temperature change which dictate phenanthrene uptake, particularly in the gills. Temperature (and seasonality) alone cannot be used to model the potential accumulation of polycyclic aromatic hydrocarbons after FPW spills.

Multi-layered engineered landfill consists of the bottom liner layer (mainly bentonite clay (B)) upon which the hazardous wastes are dumped. In current practice, sand (S) is mixed with bentonite to mitigate the adverse effects of using bentonite alone in the liner layer. Incorporation of waste and unutilized fly ash (FA) as an amendment material to B has been explored in terms of its hydro-mechanical properties, but not gauged its adsorption potential. Indian subcontinent primarily relies on the thermal power source, and FA dumps have already reached its full capacity. The objective of this study is to explore the adsorption characteristics of four B-FA composite mixes sourced within India, considering Pb²⁺ as a model contaminant. The effect of fly ash type, fly ash amendment rate and adsorbate concentration was explored in the current study and juxtaposed with B-S mixes, based on 960 batch adsorption tests. Both B-FA and B-S mixes reached equilibrium adsorption capacity within 65 min. At higher adsorbate concentrations (commonly observed in the liner), B-FA mixes exhibited superior adsorption capacity, mainly one mixed with Neyvelli fly ash (NFA). The effect of higher amendment rate had little impact on the adsorption capacity at different concentration, but gradually decreased the percentage removal of Pb²⁺. The B-S mix showed a drastic decrease in percentage removal at higher adsorbate concentration among all tested mixes. Systematic characterization including geotechnical properties, microstructure and chemical analysis was also done to interpret the obtained results. Both Freundlich and Langmuir models fitted the isotherm data well for all B-FA mixes. The maximum adsorption capacity from the isotherm was correlated to easily measurable Atterberg limits by two empirical relationships.

Pharmaceutically active compounds (PhACs) have attracted increasing attention due to their large consumption volumes, high bioactivity and potential ecotoxicity. In this study, a total of 150 commonly used drugs were investigated in sediments of Jiaozhou Bay (JZB). Twenty-five target compounds were detected, of which ten were discovered for the first time in marine sediments. The range of total PhAC content was 3.62–21.4 ng/g dry weight. Ketoprofen (2.49 ng/g), oxytetracycline (1.00 ng/g) and roxithromycin (0.97 ng/g) were the preponderant PhACs. PhACs gradually decreased from east to west, and the distribution of PhACs in the sediment was controlled by the source channel, seawater dynamic process and sediment composition. The diatom, organic matter, and clay proportions in the sediments and the nutrients in the overlying water were the most important environmental factors affecting the distribution of PhACs. PhAC pollution in the sediments of the JZB exhibited an increasing trend. Coprostanol could be used as a chemical indicator of the PhAC concentration in JZB sediments. PhACs were mainly derived from direct pollution due to human fecal excretion in the eastern region. Ofloxacin, tetracycline and oxytetracycline were found to pose high or medium risks to aquatic organisms. It is necessary and urgent to improve the treatment technology of drug residues in sewage treatment plants to decrease the pollution of PhAC residues. With the continuous aging of the global population, the use of PhACs will increase rapidly, which may cause more unpredictable threats to the marine ecosystem. Therefore, the monitoring of PhACs in the marine environment needs to be strengthened, and studies on PhAC occurrence and effects must be considered a priority in global environmental research.