The intensive use of Cu-based pesticides in agriculture could have an unintended impact on the ecosystems and human health via different exposure pathways. This paper presents the results of experiments involving colloidal stability, aggregation, and dissolution of Cu₂O commercial pesticide under various environmental conditions in view of ecological implications. The investigated pesticide contains ∼750 g kg⁻¹ Cu (75% weight of product), Cu₂O particles with sizes < 1 μm, and nominal size fraction of Cu₂O nanoparticles. The co-presence of Ca²⁺ (20 mM) and humic acid (HA, 15 mg L⁻¹) significantly modulates (p < 0.001) the colloidal stability and mobility of particles. The dissolution of Cu at pH 5.5 was about 85%, 90%, and 75% weight more than the dissolution of Cu at pH 7.0, pH 8.5, and pH 7.0 and pH 8.5 combined, respectively in all dispersions. However, increasing HA content from 0 to 15 mg L⁻¹ reduced the dissolution of Cu by 56%, 50%, and 40% weight at pH 5.5, 7.0, and 8.5, respectively. Thus, pH below 7.0 is a critical factor to control the dissolution and bioavailability of Cu that may pose ecotoxicity and environmental pollution, whereas pH above 7.0 and the presence of HA attenuate the pH effect. These findings provide insight into how the potential mobility and bioavailability of Cu is modulated by the water chemistry under various environmental scenarios and media.

The presence of microscale polymer particles (i.e., microplastics) in the environment has become a major concern in recent years. Sorption of organic compounds by microplastics may affect the phase distribution within both sediments and aqueous phases. To investigate this process, isotherms were determined for the sorption of seven aliphatic and aromatic organic probe sorbates by four polymers with different physico-chemical properties. Sorption increased in the order polyamide < polyethylene < polyvinylchloride < polystyrene. This order does not reflect the particle sizes of the investigated microplastics within the aqueous dispersions, indicating the influence of additional factors (e.g., π-π-interactions) on the sorption of aromatic compounds by polystyrene. Linear isotherms by polyethylene suggested that sorbate uptake was due to absorption into the bulk polymer. In contrast, non-linear isotherms for sorption by PS, PA, and PVC suggest a predominance of adsorption onto the polymer surface, which is supported by the best fit of these isotherms using the Polanyi-Manes model. A strong relationship between the sorption coefficients of the microplastics and the hydrophobicity of the sorbates suggests that hydrophobic interactions are of major importance.

Oil-related aggregates (ORAs) may contribute to the fate of oil spilled offshore. However, our understanding about the impact of diatoms and associated bacteria involved in the formation of ORAs and the fate of oil compounds in these aggregates is still limited. We investigated these processes in microcosm experiments with defined oil dispersions in seawater at 5 °C, employing the Arctic diatom Fragilariopsis cylindrus and its associated bacterial assemblage to promote ORA formation. Accumulation of oil compounds, as well as biodegradation of naphthalenes in ORAs and corresponding water phases, was enhanced in the presence of diatoms. Interestingly, the genus Nonlabens was predominating the bacterial communities in diatom-supplemented microcosms, while this genus was not abundant in other samples. This work elucidates the relevance of diatom biomass for the formation of ORAs, microbial community structures and biodegradation processes in chemically dispersed oil at low temperatures relevant for Arctic conditions.

The disturbance and subsequent dispersion of sediment arising from aggregate dredging results in increases in suspended sediment concentrations and, potentially, settlement of fine sediment or sand onto the bed, which may both cause adverse effects on local ecology. This subject is one area which has seen much research over many years and this paper sets out to synthesise some basic general conclusions for use when assessing the significance of planned operations. The literature detailing the dispersion of fine sediment plumes, and the longer term dispersion of sand released through the dredging process, is scrutinised, and in some cases re-evaluated, and used to identify an evidence-based footprint of potential impact.

Physically and chemically (Corexit 9500) generated Macondo 252 oil dispersions, or emulsions (no Corexit), were prepared in an oil-on-seawater mesocosm flume basin at 30–32°C, and studies of oil compound depletion performed for up to 15days. The use of Corexit 9500 resulted in smaller median droplet size than in a physically generated dispersion. Rapid evaporation of low boiling point oil compounds (C⩽15) appeared in all the experiments. Biodegradation appeared to be an important depletion process for compounds with higher boiling points in the dispersions, but was negligible in the surface emulsions. While n-alkane biodegradation was faster in chemically than in physically dispersed oil no such differences were determined for 3- and 4-ring PAH compounds. In the oil dispersions prepared by Corexit 9500, increased cell concentrations, reduction in bacterial diversity, and a temporary abundance of bacteria containing an alkB gene were associated with oil biodegradation.

Adsorption of suspended particles to the interface of surfactant-dispersed oil droplets can alter emulsion phase and sedimentation behavior. This work examines the effects of model mineral aggregates (silica nanoparticle aggregates or SNAs) on the behavior of oil (octane)–water emulsions prepared using sodium bis(2-ethylhexyl) sulfosuccinate (DOSS). Experiments were conducted at different SNA hydrophobicities in deionized and synthetic seawater (SSW), and at 0.5mM and 2.5mM DOSS. SNAs were characterized by thermogravimetric analysis (TGA) and dynamic light scattering (DLS), and the emulsions were examined by optical and cryogenic scanning electron microscopy. In deionized water, oil-in-water emulsions were formed with DOSS and the SNAs did not adhere to the droplets or alter emulsion behavior. In SSW, water-in-oil emulsions were formed with DOSS and SNA–DOSS binding through cation bridging led to phase inversion to oil-in-water emulsions. Droplet oil-mineral aggregates (OMAs) were observed for hydrophilic SNAs, while hydrophobic SNAs yielded quickly sedimenting agglomerated OMAs.

Biodegradation of chemically dispersed oil at low temperature (0–2 °C) was compared in natural seawater from Arctic (Svalbard) and a temperate (Norway) fjords. The oil was premixed with a dispersant (Corexit 9500) and small-droplet oil dispersions prepared. Faster biotransformation of n-alkanes in the Arctic than in the temperate seawater were associated with the initially higher abundance of the alkane-degrading genus Oleispira in the Arctic than the temperate seawater. Comparable transformation of aromatic hydrocarbons was further associated with the late emergences Cycloclasticus in both seawater sources. The results showed that chemically dispersed oil may be rapidly biodegraded by microbial communities in Arctic seawater. Compared to oil biodegradation studies at higher seawater temperatures, longer lag-periods were experienced here, and may be attributed to both microbial and oil properties at these low seawater temperatures.

Zooplankton are suggested to be biotic contributors to the transport and weathering of oil in marine environments due to their ingestion of oil. In the present experiment, feeding activity and microbial communities in feces from Calanus finmarchicus feeding in oil dispersions were characterized. Feeding activity was significantly reduced in oil dispersions. The microbial communities in clean and oil-containing copepod feces were dominated by Rhodobacteraceae family bacteria (Lesingera, Phaeobacter, Rugeria, and Sulfitobacter), which were suggested to be indigenous to copepod feces. The results also indicated that these bacteria were metabolizing oil compounds, as a significant increase in the concentrations of viable oil degrading microorganisms was observed in oil-containing feces. This study shows that bacteria in feces from copepods feeding in dilute oil dispersions have capacity for degradation of oil. Zooplankton may therefore contribute to weathering of oil by excreting feces with microbial communities already adapted to degradation of oil.

Coastal areas are strongly affected by episodes of fecal contamination due to polluted water inflows from inadequately treated sewages. The present study aims to investigate the dispersion of Escherichia coli in the artificial semi-enclosed bathing area of Santa Marinella (Latium, Italy) through in situ samplings carried out in summer 2012 and the application of a dynamic model. Collected samples were analyzed by the Culture-Based technique and the Fluorescent Antibody method in order to estimate both the viable culturable cells and the total E. coli population, respectively. The in situ datasets were used to test the proposed modeling approach and simulate the behavior of bacteria as particles subjected, or not, to decay. Next, the flushing time and the computation of the Microbiological Potential Risk Area allowed the evaluation of the contribution of physical and biological processes to coliform dispersion and the related potential risk for bathers.

During the Deepwater Horizon (DWH) accident in 2010 a dispersant (Corexit 9500) was applied at the wellhead to disperse the Macondo oil and reduce the formation of surface slicks. A subsurface plume of small oil droplets was generated near the leaking well at 900–1300m depth. A novel laboratory system was established to investigate biodegradation of small droplet oil dispersions (10μm or 30μm droplet sizes) of the Macondo oil premixed with Corexit 9500, using coastal Norwegian seawater at a temperature similar to the DWH plume (4–5°C). Biotransformation of volatile and semivolatile hydrocarbons and oil compound groups was generally faster in the 10μm than in the 30μm dispersions, showing the importance of oil droplet size for biodegradation. These data therefore indicated that dispersant treatment to reduce the oil droplet size may increase the biodegradation rates of oil compounds in the deepwater oil droplets.