The aim of this study was to investigate the long-term effects of a short exposure to natural sediments within the Athabasca oil sand formation to critical stages of embryo-larval development in fathead minnows (Pimephales promelas). Three different sediments were used: Ref sediment from the upper Steepbank River tested at 3 g/L (containing 12.2 ng/g ∑PAHs), and two bitumen-rich sediments tested at 1 and 3 g/L; one from the Ells River (Ells downstream, 6480 ng/g ∑PAHs) and one from the Steepbank River (Stp downstream, 4660 ng/g ∑PAHs). Eggs and larvae were exposed to sediments for 21 days, then transferred to clean water for a 5-month grow-out and recovery period. Larval fish had significantly decreased survival after exposure to 3 g/L sediment from Stp downstream, and decreased growth (length and weight at 16 days post hatch) in Ells and Stp downstream sediments at both 1 and 3 g/L. Decreased tail length was a sensitive endpoint in larval fish exposed to Ells and Stp downstream sediments for 21 days compared to Ref sediment. After the grow-out in clean water, all growth effects from the bitumen-containing sediments recovered, but adult fish from Stp downstream 3 g/L sediment had significant increases in jaw deformities. The study shows the potential for fish to recover from the decreased growth effects caused by sediments containing oil sands-related compounds, but that some effects of the early-life sediment exposure occur later on in adult fish.

Nanomaterials are increasingly being used to improve the properties and functions of common building materials. A new type of self-cleaning cement incorporating TiO2 nanomaterials (TiO2-NMs) with photocatalytic properties is now marketed. This promising cement might provide air pollution-reducing properties but its environmental impact must be validated. During cement use and aging, an altered surface layer is formed that exhibits increased porosity. The surface layer thickness alteration and porosity increase with the cement degradation rate. The hardened cement paste leaching behavior has been fully documented, but the fate of incorporated TiO2-NMs and their state during/after potential release is currently unknown. In this study, photocatalytic cement pastes with increasing initial porosity were leached at a lab-scale to produce a range of degradation rates concerning the altered layer porosity and thickness. No dissolved Ti was released during leaching, only particulate TiO2-NM release was detected. The extent of release from this batch test simulating accelerated worst-case scenario was limited and ranged from 18.7 ± 2.1 to 33.5 ± 5.1 mg of Ti/m2 of cement after 168 h of leaching. TiO2-NMs released into neutral aquatic media (simulate pH of surface water) were not associated or coated by cement minerals. The TiO2-NM release mechanism is suspected to start from freeing of TiO2-NMs in the altered layer pore network due to partial cement paste dissolution followed by diffusion into the bulk pore solution to the surface. The extent of TiO2-NM release was not solely related to the cement degradation rate.

The environmental safety of cerium (Ce) applications in many fields has been debated for almost a century because the cellular effects of environmental Ce on living organisms remain largely unclear. Here, using new, interdisciplinary methods, we surprisingly found that after Ce(III) treatment, Ce(III) was first recognized and anchored on the plasma membrane in leaf cells. Moreover, some trivalent Ce(III) was oxidized to tetravalent Ce(IV) in this organelle, which activated pinocytosis. Subsequently, more anchoring sites and stronger valence-variable behavior on the plasma membrane caused stronger pinocytosis to transport Ce(III and IV) into the leaf cells. Interestingly, a great deal of Ce was bound on the pinocytotic vesicle membrane; only a small amount of Ce was enclosed in the pinocytotic vesicles. Some pinocytic vesicles in the cytoplasm were deformed and broken. Upon breaking, pinocytic vesicles released Ce into the cytoplasm, and then these Ce particles self-assembled into nanospheres. The aforementioned special behaviors of Ce decreased the fluidity of the plasma membrane, inhibited the cellular growth of leaves, and finally, decreased plant yield. In summary, our findings directly show the special cellular behavior of Ce in plant cells, which may be the cellular basis of plant yield reduction induced by environmental Ce.

The release of polycyclic aromatic hydrocarbons (PAHs) into the environment has increased very substantially over the last decades leading to high concentrations in sediments of contaminated areas. To evaluate the consequences of long-term chronic exposure to PAHs, zebrafish were exposed, from their first meal at 5 days post fertilisation until they became reproducing adults, to diets spiked with three PAH fractions at three environmentally relevant concentrations with the medium concentration being in the range of 4.6–6.7 μg g−1 for total quantified PAHs including the 16 US-EPA indicator PAHs and alkylated derivatives. The fractions used were representative of PAHs of pyrolytic (PY) origin or of two different oils of differing compositions, a heavy fuel (HO) and a light crude oil (LO). Fish growth was inhibited by all PAH fractions and the effects were sex specific: as determined with 9-month-old adults, exposure to the highest PY inhibited growth of females; exposure to the highest HO and LO inhibited growth of males; also, the highest HO dramatically reduced survival. Morphological analysis indicated a disruption of jaw growth in larvae and malformations in adults. Intestinal and pancreatic enzyme activities were abnormal in 2-month-old exposed fish. These effects may contribute to poor growth. Finally, our results indicate that PAH mixtures of different compositions, representative of situations encountered in the wild, can promote lethal and sublethal effects which are likely to be detrimental for fish recruitment.

The life cycle assessment (LCA) of the wastewater treatment plant (WWTP) has several categories in the resulting impact analysis. One of them is a wastewater treatment plant on campus or university. Various emissions from WWTP and their impact factors are analyzed using software and utilizing the Eco-inventory database. Recycled water from factories has a positive impact on the categories assessed. System treatment overrides the effects of recycled water in other types such as potential terrestrial eco-toxicity, global warming potential, particulate matter formation, fossil depletion potential, and others. However, untreated sewers’ social effects and the environmental impact of compost generated by the system have not been thoroughly analyzed by a more holistic analysis. By using the LCA method, these results can be seen in Enim River’s environment expressed in GWP units (global warming potential) and human health expressed in ODP units (Ozone Depletion Potential). Several studies have also been conducted on LCA, which has problems with wastewater. One of the most recent research analyses various wastewater treatment strategies, such as aerobic against anaerobic, chemical versus chemical, and biological combinations. The Enim River is found in the Indonesian province of South Sumatra. The Muara Enim Regency area is where the river flows from upstream to downstream. The Enim River is a child of the Lematang River. The GWP value had a GWP of 16% before being treated in wastewater, and it had a GWP of 41.3% after being treated with sewage. This result means that treating wastewater requires energy to do so. Before treatment, the MDP value was 10.4%, and after treatment was 20.4%. However, further action after the management of wastewater gives significant value to the assessment of GWP, MDP, and ODP. The three results provided a reduction value for the reuse of treated water and reused as water needs.

This chapter documents and assesses available best practices and technologies that can be employed to mitigate the release of microplastics from textiles and tyres into the environment. The chapter follows a life-cycle approach, discussing options implementable at the design and manufacturing, use and end-of-life phases, as well as options for the end-of-pipe capture of microplastics.