The feasibility of using recycled granular tire rubber (GTR) to remove molinate from contaminated water bodies was evaluated in this study. Adsorption equilibrium data was well described by a linear isotherm, and the adsorption was completely reversible. Breakthrough curves showed column efficiencies of approximately 40%, based on total capacity, and complete bed regeneration was achieved using clean water. The effluent from the regeneration step was successfully decontaminated using a defined bacterial mixed culture, capable of molinate mineralization. It was shown that this treated water can be used for regenerating a subsequently saturated bed. The GTR adsorbent showed two important features: complete reversibility towards molinate adsorption and stability along successive adsorption/bio-regeneration cycles. Common adsorbents, such as activated carbons and resins, loose performance very quickly under the same conditions, due to irreversible adsorption.

The effects of bentazon and molinate, two selective herbicides recommended for integrated weed management in rice, were studied in Anabaena cylindrica, an abundant cyanobacterium isolated from a Portuguese rice field agro-ecosystem. Comparative effects of both herbicides on A. cylindrica were estimated under laboratory conditions by measuring its dry weight yield, photopigments, and carbohydrate and protein contents in a time- and dose-dependent exposure throughout 72 h. Photosynthesis and respiration were also monitored. The results revealed that both herbicides exerted a pleiotropic effect on the cyanobacterium at the range of concentrations tested (0.75-2 mM). Growth, chlorophyll a, carotenoids and phycobiliproteins were more adversely affected by molinate than by bentazon. Cyanobacterial growth inhibitions of over 50% were observed after 48 h when 1.5-2 mM of molinate were applied. Bentazon concentrations ranging from 0.75 to 2 mM did not significantly modified chlorophyll a content with time, however, considerable reductions in chlorophyll a, carotenoids and specially phycobiliproteins were observed with molinate. Protein content increased with both herbicides although the effect was particularly noticeable with the highest concentration of molinate. Herbicide effects on carbohydrate content were contrasting: molinate increased this organic fraction whereas bentazon decrease it. Photosynthesis and respiration were inhibited by both herbicides and higher molinate concentrations (1.5-2 mM) completely ceased O₂ evolution after 48 h. Since A. cylindrica is abundant in Portuguese rice fields and could be used as an inoculum source in rice biofertilization programs, their protection from potential residual effects of herbicides is fundamental for a correct management of local soil fertility.

Pesticide residues in muscles of nine marine fish and four seaweed species of Iskenderun Bay (Northeastern Mediterranean) have been investigated. In sampled fish species, two herbicides, three insecticides, two fungicides, and one synergist were identified and quantified. Metribuzin DADK, propamocarb HCl, and piperonyl butoxide (PBO) were detected in all the muscles of sampled fish species. Metribuzin DADK was the most abundant pesticide residue in fish muscles and the highest metribuzin DADK concentration was found in sardine (311.20 μg/kg). Propamocarb HCl concentrations varied greatly among species; from 0.530 ± 0.020 μg/kg in striped sea bream to 34.170 μg/kg in sea bass. The level of PBO ranged from 0.001 μg/kg for fourlined terapon to 0.013 μg/kg for sardine. No measurable oxamyl residue was found in any of the muscles of sampled fish species (except sardine). In seaweeds, two herbicides and two insecticides were identified and quantified. Metribuzin DADK was the most abundant and found in Cystoseira corniculata (5.01 mg/kg), Corallina elongata (0.703 mg/kg), and Jania rubens (3.85 mg/kg). Molinate was a minor contaminant and only found in Corallina elongata (0.002 mg/kg). Pyrethrin I was determined only in Padina pavonia to be 0.567 mg/kg. Pyrethrine II was found in Padina pavonia and Corallina elongate to be 1.214 and 0.229 mg/kg, respectively. The most hazardous pesticide residues of organochlorines and organophosphorus were not detected in both sampled fish muscles and seaweeds. There are no clear maximum residue limits for the detected eight pesticide residues declared for fish muscle by European Union MRL (2017). In conclusion, it can be considered that observed concentrations of pesticides in sampled nine marine fish species do not have a potential health risk for consumers. Some of the detected pesticide residues can be toxic for algae and aquatic life and regular monitoring studies are therefore essential to control the pesticide concentrations of aquatic biota in the region.

In this study, the degradation of molinate through heterogeneous photocatalysis, using two different types of the semiconductor TiO₂ as photocatalyst, as well as through homogeneous treatment, applying the photo-Fenton reaction, has been investigated. As far as heterogeneous photocatalysis is concerned, the degradation of the pesticide follows apparent first-order kinetics, while the type of the catalyst and the pH value of the solution affect the degradation rate. The effect of the addition of electron scavengers (H₂O₂ and K₂S₂O₈) was also studied. In the case of photo-Fenton-assisted system, the degradation also follows pseudo-first-order kinetics. Parameters such as iron’s and electron scavenger’s concentration and inorganic ions strongly affect the degradation rate. The extent of pesticide mineralization was investigated using dissolved organic carbon (DOC) measurements. The toxicity of the treated solution was evaluated using the Microtox test based on the luminescent bacteria Vibrio fischeri. The detoxification and mineralization efficiency was found to be dependent on the system studied, and although it did not follow the rate of pesticide disappearance, it took place in considerable extent. The study of the photodegradation treatment was completed by the determination of the intermediate by-products formed during the process, which was carried out using LC-MS/MS technique and led to similar compounds with both processes.