Unmanned aerial systems (UAS, aka drones) are being used to map macro-litter on the environment. Sixteen qualified researchers (operators), with different expertise and nationalities, were invited to identify, mark and categorize the litter items (manual image screening, MS) on three UAS images collected at two beaches.The coefficient of concordance (W) among operators varied between 0.5 and 0.7, depending on the litter parameter (type, material and colour) considered. Highest agreement was obtained for the type of items marked on the highest resolution image, among experts in litter surveys (W = 0.86), and within territorial subgroups (W = 0.85). Therefore, for a detailed categorization of litter on the environment, the MS should be performed by experienced and local operators, familiar with the most common type of litter present in the target area. This work provides insights for future operational improvements and optimizations of UAS-based images analysis to survey environmental pollution.

A baseline dataset from 2005 was used to identify the spatial distribution of macrofaunal assemblages across the eastern English Channel. The range of sediment composition found in association with each assemblage was used to define limits for acceptable change at ten licensed marine aggregate extraction areas. Sediment data acquired in 2010, 4years after the onset of dredging, were used to assess whether conditions remained within the acceptable limits. Despite the observed changes in sediment composition, the composition of sediments in and around nine extraction areas remained within pre-defined acceptable limits. At the tenth site, some of the observed changes within the licence area were judged to have gone beyond the acceptable limits. Implications of the changes are discussed, and appropriate management measures identified. The approach taken in this study offers a simple, objective and cost-effective method for assessing the significance of change, and could simplify the existing monitoring regime.

Boring isopods damage expanded polystyrene floats under docks and, in the process, expel copious numbers of microplastic particles. This paper describes the impacts of boring isopods in aquaculture facilities and docks, quantifies and discusses the implications of these microplastics, and tests if an alternate foam type prevents boring. Floats from aquaculture facilities and docks were heavily damaged by thousands of isopods and their burrows. Multiple sites in Asia, Australia, Panama, and the USA exhibited evidence of isopod damage. One isopod creates thousands of microplastic particles when excavating a burrow; colonies can expel millions of particles. Microplastics similar in size to these particles may facilitate the spread of non-native species or be ingested by organisms causing physical or toxicological harm. Extruded polystyrene inhibited boring, suggesting this foam may prevent damage in the field. These results reveal boring isopods cause widespread damage to docks and are a novel source of microplastic pollution.

Satellite Synthetic Aperture Radar (SAR) has been established as a useful tool for detecting hydrocarbon spillage on the ocean’s surface. Several surveillance applications have been developed based on this technology. Environmental variables such as wind speed should be taken into account for better SAR image segmentation. This paper presents an adaptive thresholding algorithm for detecting oil spills based on SAR data and a wind field estimation as well as its implementation as a part of a functional prototype. The algorithm was adapted to an important shipping route off the Galician coast (northwest Iberian Peninsula) and was developed on the basis of confirmed oil spills. Image testing revealed 99.93% pixel labelling accuracy. By taking advantage of multi-core processor architecture, the prototype was optimized to get a nearly 30% improvement in processing time.

The environmental impact of elevated carbon dioxide (CO2) levels has become of more interest in recent years. This, in relation to globally rising CO2 levels and related considerations of geological CO2 storage as a mitigating measure. In the present study effect data from literature were collected in order to conduct a marine ecological risk assessment of elevated CO2 levels, using a Species Sensitivity Distribution (SSD). It became evident that information currently available from the literature is mostly insufficient for such a quantitative approach. Most studies focus on effects of expected future CO2 levels, testing only one or two elevated concentrations. A full dose-response relationship, a uniform measure of exposure, and standardized test protocols are essential for conducting a proper quantitative risk assessment of elevated CO2 levels. Improvements are proposed to make future tests more valuable and usable for quantitative risk assessment.

Since 2005, five different ballast water management systems (BWMSs) based on chlorination treatment have been tested by Norwegian Institute for Water Research (NIVA) according to guidelines from the International Maritime Organization (IMO). 25% and >50% of all the tested discharge samples exhibited acute and chronic toxic effects on algae, respectively. In most cases this toxicity was plausibly caused by a high free residual oxidant (FRO) level (>0.08mgCl/l). Of the 22 disinfection by-products (DBPs) that were identified in treated water at discharge, four compounds were at times found at concentrations that may pose a risk to the local aquatic environment. However, there seemed to be no clear indication that the measured DBP concentrations contributed to the observed algal toxicity. The addition of methylcellulose instead of lignin in the test water to comply with IMO requirements seemed to limit the formation of DBP.

In the UK, Government policy requires marine aggregate extraction companies to leave the seabed in a similar physical condition after the cessation of dredging. This measure is intended to promote recovery, and the return of a similar faunal community to that which existed before dredging. Whilst the policy is sensible, and in line with the principles of sustainable development, the use of the word ‘similar’ is open to interpretation. There is, therefore, a need to set quantifiable limits for acceptable change in sediment composition. Using a case study site, it is shown how such limits could be defined by the range of sediment particle size composition naturally found in association with the faunal assemblages in the wider region. Whilst the approach offers a number of advantages over the present system, further testing would be required before it could be recommended for use in the regulatory context.

Biomonitoring of estuarine pollution is the subject of active research, and benthic foraminifera are an attractive group to use for these purposes due to their ubiquitous presence in saline water and wide diversity. Here, we describe a case study of biomonitoring using benthic foraminifera in the French Mediterranean lagoon, Bages-Sigean lagoon. In this case, the major pollutants of interest are heavy metals in the sediment, particularly contaminated by Cu and Cd derived from industrial and agricultural sources. The foraminiferal assemblages of the Bages-Sigean lagoon are typical of normal paralic environments, but unusually almost completely lack agglutinated forms. The density of benthic foraminifera was shown to be more influenced by the sediment characteristics rather than heavy metal pollution. However, the relative abundance of Quinqueloculina bicostata was shown to increase in the most polluted areas and we propose that this taxon may be used as an indicator of heavy metal pollution.

Test facilities such as lab basins and wave tanks are essential when evaluating the use of chemical dispersants to treat oil spills at sea. However, these test facilities have boundaries (walls) that provide an ideal environment for surface (interfacial) film formation on seawater. Surface films may form from surfactants naturally present in crude oil as well as dispersant drift/overspray when applied to an oil spill. The objective of this study was to examine the impact of surface film formation on oil spreading rates in a small scale lab basin and on dispersant effectiveness conducted in a large scale wave tank. The process of crude oil spreading on the surface of the basin seawater was influenced in the presence of a surface film as shown using a 1st order kinetic model. In addition, interfacial film formation can greatly influence chemically dispersed crude oil in a large scale dynamic wave tank.

The concept of Ecological Potential was explored using the macrobenthic communities of the Mondego estuary (Portugal). Different scenarios (loss of a primary producer and intertidal habitat, and habitat modification due to hydromorphological changes and continued press perturbation) were tested to predict changes in the biology if hydromorphological pressures could be reversed, assuming that differences with and without the pressure could indicate the potential.Results showed noticeable changes in the system biology in each scenario. The approach followed, indicates that when data sets exist, differences in the measurement of ecological status with and without the hydromorphological change could be a way forward to determine the potential. In the particular case of the Mondego estuary, the South arm (physically unaltered water body) proved to be richer than the North (HMWB). For the Ecological Potential determination, the South arm could thus be used to derive and adjust future reference conditions for the North.