Seawater, sediments, and three genera of wild scleractinian corals were collected from four coral reef areas nearshore Liuqiu Island, southwestern Taiwan. Abundance, characteristics (sizes, colors, shapes, and polymer types), and enrichment of microplastics (MPs) in the corals, and their impacts on coral cover were determined. The average MPs abundances were 0.95, 0.77, and 0.36 item/g for Galaxea sp, Acropora spp, and Pocillopora sp, respectively. The MPs abundance was relatively higher on the coral surfaces than inside the skeletons, dominated by blue rayon-fibers, correspondingly observed in seawater and sediments. Large-size colorless MPs tended to be mis-ingested by Galaxea sp. (71%) compared with Pocillopora sp. (43%) and Acropora spp. (31%). The low hard coral cover (12.5%) observed at Yufu (L1) on the northeastern coastal zone nearby tourism center of Liuqiu Island where correspondingly associated with high MPs abundance in seawater (10 item/L), sediments (260 item/kg), and corals (0.60 item/g). Tourism induced sewage discharges and sailing activities significantly contributed to the MPs pollution, probably contributing to the loss of coral cover. High MPs enrichment in corals (EFMP = 25–283) shows that the marine MPs pollution can critically threaten coral reef ecosystems. Fibrous MPs present inside the coral skeleton serve as potential indicator of MPs’ impact on corals—with the dominance of textile-related rayon and polyester/PET microfibers in the coral reef zones. This study provided valuable information for coral conservation and coastal management.

Marine litter is widely distributed in marine environments and has been a severe concern worldwide, due to the disposal of waste from diverse sources. The severity of this threat has garnered increasing attention in India over the last decade, but the full consequences of this pollution are yet to be quantified. To estimate the spatiotemporal distribution, composition and beach quality of marine litter pollution, 17 beaches along the Hooghly estuary, a part of the Gangetic delta was studied. Marine litter was collected from 100 m long transects during two seasons (monsoon and post-monsoon). The OSPAR monitoring standard was applied to the 16,597 litter items collected, then grouped under 6 types and 44 categories. In terms of number, litter abundance was higher during monsoon (1.10 ± 0.39 items/m²) than that of post-monsoon (0.86 ± 0.32 items/m²). Most of the beaches were categorized as low cleanliness as computed by the general index and clean coast index and the good for the pellet pollution index. Hazardous litter constituted 6.5% of the total collected litter items. The model prediction revealed that the influence of high discharge from Hooghly, Rasulpur and Subarnarekha River carried enormous anthropogenic litter to the northeast beaches. The litter flux decreases with an increase in distance from the shore, and act as a sink to the sea-floor. The results denote that the distribution and typology of marine litter were representatives of household, tourism and fishing, which in turn highlights the need for better regional litter management measures. Suggested management practices include source reduction, mitigation, management of beach environment and change in littering behaviour through environmental education.

Beaches are key attractions for tourism and recreation, and considerable effort is made to keep beaches clean, yet many beaches still have substantial litter loads. Lasting solutions to reduce the amounts of marine litter require an understanding of litter sources. We collected bottles and other single-use containers at 32 sites around the South African coast to infer their sources based on their age and country of manufacture. Bottle densities varied greatly among beaches (8–450 bottles·km⁻¹), depending on proximity to local urban centres and beach cleaning frequency. Most bottles were plastic, despite well-developed recycling initiatives for PET and HDPE bottles in South Africa. Street litter was dominated by bottles made in South Africa (99%), but foreign-manufactured bottles comprised up to 74% of bottles at some beaches, with an increase from urban (4%) through semi-urban (24%) to remote beaches (45%). Most foreign bottles were PET drink bottles from China and other Asian countries, followed by South America and Europe, with little regional variation in the contribution from these sources. This fact, coupled with their recent manufacture dates (mainly <2 years old), indicates that most foreign PET drink bottles are dumped illegally from ships. By comparison, foreign HDPE bottles were more common along the southeast coast of South Africa than along the west coast, consistent with many of these bottles arriving by long-distance drift across the Indian Ocean from southeast Asia. The most common country of origin for these bottles was Indonesia, and most newly-arrived HDPE bottles were 4–6 years old. To tackle beach litter in South Africa we need to greatly reduce plastic leakage from land-based sources, both locally and in southeast Asia, as well as improve measures to prevent the illegal dumping of plastics and other persistent wastes from ships.

Microplastic (MPs) pollution in the aquatic and terrestrial environments has caught many attentions in the scientific literatures. Currently, no information is available about MPs pollution in Caspian Sea, the largest lake in the world. This study indicates the first report on the MPs pollution in the sediments of the southern Caspian coastal zones, northern Iran. Density separation method was conducted on 17 surficial sediments. The combination of observation techniques including SEM-EDS analysis, polarized light microscopy and Raman micro-spectroscopy were used to identify MPs. The abundance and size of microplastics in the samples ranged between 25 and 330 items/kg and 250–500 μm, respectively. Fibers constituted the most common MPs shape and polystyrene (PS) and polyethylene (PE) were major polymer types in the samples. The distribution of MPs in the study area reflected a patchy and irregular spatial pattern implying that the higher MPs concentration are near mouth of permanent rivers and in the regions with higher level of the fishing and tourism activities. The results showed the wide occurrence of MPs in the sediments of the world’s largest lake which extend the knowledge on MPs pollution in the marine system. We also recommend further research on microplastics in different compartments of Caspian Sea to inform policy discussions and the development of appropriate management responses.

Polycyclic aromatic hydrocarbons (PAHs) and aliphatic hydrocarbons (AHs), including petroleum biomarkers, were studied in four sediment cores collected around Deception and Penguin Islands, Antarctica. Total PAHs in Deception Island (DCP) samples ranged from 2.0 to 26.8 ng g⁻¹, and in Penguin Island (PGI) varied between 13.2 and 60.3 ng g⁻¹. Multiple sources of PAHs were verified in DCP, with petrogenic-derived compounds being predominant over the last 10 years. In PGI, PAHs related to natural contributions from the erosion of coal deposits were reported. Total AHs in DCP ranged from 4.5 to 19 μg g⁻¹ and in PGI varied between 5.3 and 21.9 μg g⁻¹. In DCP, the n-alkanes distribution pattern showed the presence of petroleum residues in the top sections and both terpanes and hopanes were detected, related to the use of fossil fuels for power generation and in different types of vessels. In PGI, the main source of n-alkanes was marine inputs and only terpanes were detected. The slight increase in hydrocarbon levels observed from 1980 onward in DCP was assumed to be due to the development of tourism in the region and to the scientific station activities. In PGI, anthropogenic-related hydrocarbons were detected in the recent sections and were linked to the development of tourism near the island, scientific activities and the increase in vessel traffic. In general, the concentrations of hydrocarbons found around both islands were comparable to those found in uncontaminated Antarctic regions.

The occurrence of microplastics in the beach sand of the Bohai Sea was investigated for the first time. The Bohai Sea is the largest Chinese inner sea and its coastal region is one of the most densely urbanized and industrialized zones of China. Samples from three costal sites (i.e., Bijianshan, Xingcheng and Dongdaihe) were collected, quantified and identified for microplastic analysis. Effects of sample depth and tourism activity were investigated. Surface samples (2 cm) contained higher microplastic concentrations than deep samples (20 cm). Samples from the bathing beach exhibited higher microplastic concentrations than the non-bathing beach, suggesting the direct contribution of microplastics from tourism activity. Of eight types of microplastics that were found, PEVA (polyethylene vinyl acetate), LDPE (light density polyethylene) and PS (polystyrene) were the largest in abundances. Moreover, the non-plastic items from samples were analyzed and results revealed that the majority abundance of the observed non-plastics were viscose cellulose fibers. Further studies are required to evaluate the environmental hazards of microplastics, especially as they may “act as a contaminant transporter” to the Bohai Sea ecosystem.

Intensive land development as a result of the rapidly growing tourism industry in the “Riviera Maya” region of the Yucatan Peninsula, Mexico may result in contamination of groundwater resources that eventually discharge into Caribbean coastal ecosystems. We deployed two types of passive sampling devices into groundwater flowing through cave systems below two communities to evaluate concentrations of contaminants and to indicate the possible sources. Pharmaceuticals and personal care products accumulated in the samplers could only have originated from domestic sewage. PAHs indicated contamination by runoff from highways and other impermeable surfaces and chlorophenoxy herbicides accumulated in samplers deployed near a golf course indicated that pesticide applications to turf are a source of contamination. Prevention and mitigation measures are needed to ensure that expanding development does not impact the marine environment and human health, thus damaging the tourism-based economy of the region.

Beaches are an integral part of coastal tourism, but they are deteriorated by the beachgoers and recreational activities due to lack of adequate beach environmental awareness and management. Litter is widely distributed in marine and coastal environment and has been considered a severe concern. In China investigations to determine the beach litter abundance and pollution level are limited. The aim of this study is to estimate spatio-temporal distribution and composition of litter on 10 well-known Qingdao tourist beaches, involving pollution level by beach quality indexes. Beach litter was collected within an area of 25 × 25 m² in both summer (May, June and July) and winter (Nov, Dec and Jan) seasons, and was classified into eight categories. The abundance of beach litter was found higher in summer (0.13 ± 0.04 items/m²) than in winter (0.04 ± 0.01 items/m²). Overall, the percentage of plastics were higher in both summer (23.48%) and winter (24.04%) than that of other litter categories. Based on Clean Coast Index, 70% of beaches were very clean, 25% clean, and 5% moderately clean. Beach Grade Index showed that 15% beaches were very good, 5% good, 55% fair, and 25% poor. 85% beaches constituted some quantity of hazardous litter and 15% had no hazardous litter for Hazardous Items index. The findings suggest that the sources of beach litter along Qingdao beaches mainly come from the recreational and tourist activities. The substantial quantity of litter is also being transported by ocean (tides or current), which are finally deposited along beachfront. Despite regular cleaning operation along most of Qingdao beaches, suggested management practices involve mitigation measures, source reduction, change in littering behavior to improve further quality of beaches.

Studies of microplastics (MPs) in remote, trans-boundary and alpine rivers are currently lacking. To understand the sinks and transport mechanisms of MPs, this study investigated the distributions and sources of MPs in the surface waters and sediments of five tributaries of the Koshi River (KR), a typical alpine river in the Himalayas between China and Nepal. Mean abundances of MPs in water and sediment were 202 ± 100 items/m³ and 58 ± 27 items/kg, dry weight, respectively. The upstream tributary, Pum Qu in China, had the smallest abundance of MPs, while the middle tributary, Sun Koshi in Nepal, had the greatest abundance. Compared to international values in rivers, contamination of the KR with MPs was low to moderate. Fibers represented 98% of all MP particles observed, which consisted of polyethylene, polyethyleneterephthalate, polyamide, polypropylene, and polystyrene. Blue and black MPs were prevalent, and small MPs (<1 mm) accounted for approximately 60% of all MPs. Atmospheric transmission and deposition were considered to be the principal sources of MPs in the upstream tributary. The results imply that point sources associated with mostly untreated sewage effluents and solid wastes from households, major settlements, towns, and cities were most important sources of MPs in the KR. Non-point sources from agricultural runoff and atmospheric transport and deposition in the middle stream tributaries also contribute a part of microplastics, while the least amount was from fishing in the downstream tributary. Urbanization, agriculture, traffic, and tourism contributed to pollution in the KR by MPs. Equations to predict abundances of MPs based on river altitudes revealed that different trends were affected by both natural and human factors within the KR basin. This study presents new insights into the magnitude of MP pollution of a remote alpine river and provides valuable data for developing MP monitoring and mitigation strategies in similar environments worldwide.

The main objective of the Marine Strategy Framework Directive (MSFD) was to achieve a Good Environmental Status (GES) in European waters by 2020, according to 11 descriptors. Descriptor 10 is related to marine litter and envisages that the properties and quantities of marine litter are at a level that does not cause harm to the coastal and marine environment. Even if GES was not achieved by 2020, the first MSFD implementation cycle filled many gaps in knowledge. Here we present the first data (2015–2018) on beach litter densities along Italian coasts and discuss lessons learnt and future perspectives. The beach litter median density was 477 items/100 m (interquartile range: 261–934 items/100 m), but subregional differences emerged both in terms of litter quantities and composition. The Adriatic Sea was the most polluted subregion (590 items/100 m), followed by the Western Mediterranean Sea (491 items/100 m) and the Ionian Sea and Central Mediterranean Sea subregion (274 items/100 m). A high presence of aquaculture-related litter (mainly mussel nets) characterised beaches in the Adriatic Sea. At the same time, the numbers of cotton bud sticks were extremely high in some beaches of the Western Mediterranean Sea. General litter (items discarded or left by the public on the coast or inland and carried by winds and rivers or objects originating from tourism and recreation at land or sea, poor waste management practices, etc.) was the most common litter typology (38.8%). The results of this study represent the first baseline to compare achievement towards GES in the next years and the efficacy of the program of measures which entered into force in 2016, concerning beach litter densities and composition. They also highlight the necessity of a joint effort for deploying harmonised marine litter monitoring methodologies across the European Member States to obtain comparable results.