Low-grade weirs are innovative management strategies that control surface drainage, slow water velocities, and encourage sedimentation in agricultural drainage ditches. There is little information on how low-grade weirs perform in terms of short-term (0–12 months) sediment retention and associated phosphorus (P) dynamics. This study documents initial results of sediment and P dynamics of low-grade weirs in a drainage system that was built in a two-stage ditch design. Average sediment deposition did not differ significantly among sites (χ ² = 2.42; P = 0.49); however, average water depths behind weir sites were significantly greater (28 ± 10 cm) than the comparison inflow site (6 ± 8 cm; χ ² = 7.67; P = 0.05). Total P concentrations were not significantly different through time, or between sites, but there was a general trend of progressively higher total P retention moving downstream. Bioavailability ratios of P (i.e., the ratio of potentially bioavailable to non-bioavailable P fractions) were similar between all sites through time (χ ² = 2.09; P = 0.55). The only variables correlated significantly with time were found at the inflow site, where water depth significantly decreased with corresponding increases in sediment/water column pH and bioavailability ratios. From best management practice installation to 12 months after construction, there was a lack of significant correlations with any measured variables behind weirs. However, the lack of correlation between variables suggests increasing the hydroperiod, reducing the ephemeral nature of the drainage ditch system, and prolonging inundation, improves conditions for P retention.

In this study, we evaluated the needle anatomy of Norway spruce trees growing on a territory that was exposed to different alkaline dust pollution. The anatomy of the needles of spruce growing on a polluted site in the vicinity of the Kunda cement plant (Northeast Estonia) was compared with the anatomy and physiological state of the needles from an unpolluted site. The needles from polluted sites had a significantly larger average mesophyll area and thicker epidermis. These needles also had significantly smaller average vascular bundles and xylem areas than needles from the unpolluted site. Although in the alkalised growth conditions, the mesophyll area enlarged, the number of damaged mesophyll cells increased, and as a result, the concentration of chlorophylls decreased reducing the photosynthetic potential of trees. Our study indicates that even though cement dust pollution has practically ceased in the area, the alkalised soil is affecting physiological processes in trees for a long time.

The compositional changes of saturates, aromatics, resins and asphaltenes (SARA) fractions in aqueous clay/oil microcosm experiments with a hydrocarbon-degrading microorganism community were analysed using Iatroscan. The clay mineral samples used in this study were organomontmorillonite, acid-activated montmorillonite and K, Ca, Zn and Cr montmorillonites produced by modifying the original montmorillonite sample. The evaluation and quantification of biodegradation and adsorption were carried out using a combination of the Iatroscan and gravimetric analysis. The SARA compositions in the presence of organomontmorillonite and acid-activated montmorillonite after incubation follow the same pattern in which the aromatic fraction is higher than the other fractions unlike in the presence of unmodified, K, Ca and Zn montmorillonites, where the saturates fraction is higher than the other fractions. Changes in SARA fractions due to biodegradation seemed to occur most in the presence of unmodified and calcium montmorillonites; hence, the removal of SARA fractions due to biodegradation was significant and enhanced in the presence of these two clay samples. However, biodegradation in the presence of organomontmorillonite and acid-activated and Cr montmorillonites was hindered. The study indicated that Cr montmorillonite adsorbed resins most, whereas Zn and K montmorillonites adsorbed aromatics most after incubation.

Soils polluted by metals and organic compounds are a major challenge in soil remediation and environmental recovery; however, the technology to efficiently decontaminate soils polluted by both metal and organic pollutants does not yet exist. Most of these soils are disposed of in landfills. This study first evaluates chemical reagents (hydrochloric, nitric, sulfuric and lactic acids and ethanol) for leaching metals from soil. Assays were then conducted to evaluate non-ionic, ionic and amphoteric surfactants for pentachlorophenol (PCP) removal by flotation. Finally, a laboratory-scale leaching/flotation process was applied to treat four soil samples polluted with both organic ([PCP]ᵢ = 2.5–30 mg kg⁻¹) and metals ([As]ᵢ = 50–250 mg kg⁻¹, [Cr]ᵢ = 35–220 mg kg⁻¹, [Cu]ᵢ = 80–350 mg kg⁻¹) compounds. The organic compounds and metals are concentrated in the froth and liquid fractions, respectively. Removal yields of 82–93 %, 30–80 %, 79–90 % and 36–78 % were obtained from As, Cr, Cu and PCP, respectively, under optimized process conditions (H₂SO₄ = 1 N, [cocamidopropyl betaine]ᵢ = 1 % (w w⁻¹), t = 60 min, T = 60 °C, PD = 10 % (w v⁻¹)). The treatment of the produced leachate was also tested by chemical precipitation using different reagents.

The degradation of sodium p-cumenesulfonate (SCS) by electrochemical, photochemical, and photoelectrochemical methods in aqueous solution of NaClO4, NaCl, and NaClO has been studied. It was found that as a result of NaClO4 electroreduction and photodecomposition, the ions Cl- and ClO3- are formed. These ions undergo transformations into radicals, mainly Cl-center dot, Cl-2(center dot-), ClO center dot, ClO2 center dot, and ClO3 center dot, due to electrochemical and photochemical reactions. It was shown that the interpretation of results of the studies over mineralization processes carried out in the presence of ClO4-cannot be adequate without taking into consideration the reduction of ClO4 to Cl- and ClO3-. Therefore, previous works presented in the literature should be rediscussed on the basis of the new data. Photoelectrochemical mineralization of substrate in NaCl solution at the concentration of 16 mmol L-1 is comparable with the efficiency of the reaction in NaClO4 solution containing more than 8 mmol L-1 of NaClO. Total SCS mineralization was obtained in the photoelectrochemical reactor with a UV immersion lamp with a power 15 W in the period of 135 min and current intensity of 350 mA. In such conditions, the power consumption was about 1.2 kWh per g of TOC removed.

Adsorption together with size exclusion and charge attraction/repulsion has to be taken into account when considering removal of pharmaceuticals as emerging contaminants from water by reverse osmosis and nanofiltration membranes. Glucocorticosteroids (hydrocortisone (HYDRO), dexamethasone (DEXA)), anesthetics (procaine, lidocaine) with relatively weak hydrophobicities (1 < log K O/W < 3), and membranes (XLE, LFC–1, CPA3, SWC1, NF90, and NF270) have been investigated in this study. Adsorption was studied by measuring the concentration of compounds in feed and permeate and by monitoring changes in membrane flux in the batch mode operation during 24 h. A decrease in the feed concentrations for HYDRO and DEXA (log K O/W < 2) was observed. The loss of these compounds in feed was associated with irreversible adsorption onto an NF270 and a CPA3 membrane. Therefore, when considering removal of pharmaceuticals with lower hydrophobicity, adsorption has to be particularly taken into account for membranes with bigger pores in the selective layer. Also, a high dipole moment and low water solubility affected adsorption on the membranes. For smaller and slightly more hydrophobic pharmaceuticals (log K O/W > 2), an increase in the feed concentration was obtained. Firstly, these compounds instantly adsorbed to the membrane. Secondly, the compounds diffused through the polymer matrix and desorbed to the permeate side after equilibrium had been reached.

Biochar has great potential as a soil amendment to immobilize heavy metals, thereby reducing their bioavailability. In this study, biochars derived from chicken manure and green waste were compared with commercial activated carbon (AC) and laboratory produced black carbon (BC) for the sorption of Pb and Cd. Sorption kinetics and equilibrium sorption isotherms for Pb and Cd were obtained for the char materials and the data were fitted to kinetic and sorption isotherm models. Chicken manure-derived biochar (CM) showed the highest sorption capacity for both Pb and Cd, and the Pb sorption by biochars was higher than the Cd sorption because of the precipitation of Pb with various ions released from the biochars such as carbonate, phosphate, and sulfate. The sorption data for both Pb and Cd were better represented by the pseudo-second order kinetic model than the pseudo-first order kinetic model, which indicates chemical sorption between biochar and metals. For the isotherm studies, char materials was mixed with various amount of Pb or Cd solutions and the remaining metal concentration was measured. The equilibrium sorption data followed a Langmuir isotherm with a maximum sorption capacity of 6.8-11 and 1.7-8.0 mg/g by biochars for Pb and Cd, respectively. Furthermore, CM immobilized Pb and Cd up to 93.5 and 88.4 %, respectively, while BC was not effective in the immobilization of Pb in soil. Overall, the sorption experiments in solution and the immobilization experiment in soil showed that biochars are more effective than AC in the sorption of Pb and Cd, and that they have the potential to be used as a soil amendment to remediate metal-contaminated soil. © 2013 Springer Science+Business Media Dordrecht.

Arsenic contamination of groundwater and surface water is widespread throughout the world. Considering its carcinogenicity and toxicity to human and animal health, remediation of arsenic-contaminated water has become a high priority. There are several physicochemical-based conventional technologies available for removing arsenic from water. However, these technologies possess a number of limitations such as high cost and generation of toxic by-products, etc. Therefore, research on new sustainable and cost-effective arsenic removal technologies for water has recently become an area of intense research activity. Bioremediation technology offers great potential for possible future application in decontamination of pollutants from the natural environment. It is not only environmentally friendly but cost-effective as well. This review focuses on the state-of-art knowledge of currently available arsenic remediation methods, their prospects, and recent advances with particular emphasis on bioremediation strategies.

Wetlands in mountain environments provide critical ecosystem services but are increasingly threatened by agricultural land use intensification. This study evaluates agricultural nonpoint source nutrient pollution transport in a wetland–stream–lake complex in a mountain, tussock grassland catchment in the South Island, New Zealand. Flow and water-quality monitoring in the Lake Clearwater catchment during three flow events from May to August 2010 (autumn high flow, winter low flow, and winter high flow) showed high concentrations and exceedances of water quality guidelines for total nitrogen (TN) and total phosphorus (TP) in small ephemeral streams draining agricultural land during high flows. Concentrations were attenuated through the wetlands to below guidelines, with the exception of TN which still remained slightly higher. Most TN was in the organic form above and below the wetland, suggesting N sources from animal waste/agricultural land and organic material and vegetation within the wetland. Most TP was particulate associated with suspended solids during high flows. Dissolved forms of N and P generally were below guidelines. Flows and loads (instantaneous and daily) increased at the lake outlet during winter high flow, indicating unaccounted sources to the lake from groundwater, the wetlands, or the lake sediments, and seasonal N saturation. Infiltration losses to shallow groundwater along the main perennial tributary likely re-appear as discharge to the wetlands and lake downstream. Surface–groundwater interactions play a dominant role in N transport to the wetland complex due to highly permeable soils and glacial alluvial deposits. Loads and unit loads of TN and TP were also elevated in the ephemeral streams. Results show that TN and TP concentrations and unit loads during high flows in ephemeral streams in this mountain grassland catchment are similar to, or higher than, values for impacted lowland pasture catchments. Although impacts to the wetland ecosystem have not been observed to date, the lake is shifting toward a mesotrophic state, and further research is needed to elucidate impacts of nutrient loads and help meet conservation and restoration goals.

Major incidents involving mine waste facilities and poor environmental management practices have left the legacy of thousands of contaminated sites like in the historic mining areas in the Carpathian Basin. Associated environmental risks have triggered the development of new EU environmental legislation to prevent and minimize the effects of such incidents. The Mine Waste Directive requires the risk-based inventory of all mine waste sites in Europe by May 2012. In order to address the mining environmental problems, a standard risk-based pre-selection protocol has been developed by the EU Commission. The protocol consists of 18 simple questions about contamination source, pathway and receptor. This paper evaluates the protocol by applying it to real-life cases, adopting it to local conditions, comparing to the similar method of the European Environmental Agency standard Preliminary Risk Assessment Model (PRAMS) and by carrying out uncertainty analysis. All together, 145 ore mine waste sites have been selected for scientific testing and evaluation using the EU Mining Waste Directive (MWD) Pre-selection Protocol as a case study from Hungary. The proportion of uncertain responses to questions in the protocol for the mine waste site gives an insight of specific and overall uncertainty in the data used. Questions of the EU MWD Pre-selection Protocol are linked to a GIS system, and key parameters such as the topographic slope and distance to the nearest surface and groundwater bodies to settlements and protected areas are calculated and statistically evaluated in order to adjust the RA models to local conditions in Hungary. Results show that the adjustment of threshold values to local conditions is necessary; however, the EU MWD Pre-selection Protocol is robust and is relatively insensitive to threshold values. Results of the EU MWD Pre-selection Protocol are consistent with the pre-screening European Environmental Agency PRAMS model which further confirms that the Protocol delivers reliable selection results that are not sensitive to the selected parameters. An interesting outcome of the study is that the highest uncertainty is associated with the engineering conditions of the waste facilities, such as the heights and size.