Photosynthetic process is a good approach to discriminate cadmium-tolerant species, because it is reported as one of the most sensitive processes. Our goal was to measure Elephantopus mollis Kunth (Asteraceae) tolerance, determining the interference of Cd on the photosynthetic process. For this, a hydroponic experiment design was conducted in nutrition solution with concentrations of 0 (control), 10, 50, and 100 μM of cadmium (Cd). Measures of photosynthesis performance were obtained, for example, gas exchange, photosystem integrity, chlorophyll content, leaf growth rate, root length, and dry weight. In addition, cadmium and zinc concentrations were measured. Furthermore, results were linked to phytoremediation potential. Our specific questions were as follows: (1) Can the photosynthetic apparatus of E. mollis deal with cadmium stress? (2) Is E. mollis able to accumulate cadmium and maintain zinc level? (3) Is E. mollis a tolerant or sensitive species? (4) Can any phytoremediation practice be suggested from these results? Our results showed that E. mollis can deal with cadmium toxicity up to 10 μM Cd. Moreover, this plant is a potential hyperaccumulator, which can accumulate 248 mg Cd kg⁻¹ dry weight. However, at concentrations of 50 and 100 μM Cd, this species was sensitive and cadmium toxicity affected both biochemistry and photochemistry phases of photosynthesis on account of negative changes on gas exchange, fluorescence chlorophyll, and chlorophyll content. Nevertheless, these results did not compromise the research about its tolerance at lower concentrations of cadmium.

The objective of this study was to investigate the chemisorption mechanisms of Cu(II) on alcohol functionalized carbon nanotubes (OH-CNT) compared to granulated activated carbon (F-400). Two different sizes of OH-CNT were used on both adsorption isotherm experiments and continuous-flow fixed-bed columns. The experiments were conducted as a function of adsorbent type with fixed bed height (5 cm), fixed flow rate (0.035 mL/min), and one initial Cu(II) concentration (10 mg/L) at pH 5.1 and room temperature. Isotherm curves follow Freundlich model with better adsorption capacity for OH-CNT (6.3 and 15.7 mg/g) compared to F-400 (6.0 mg/g). Breakthrough curves for all adsorbents were typical, while OH-CNT showed higher capacity to treat water per amount of adsorbent than F-400. After 5 days of desorption, there was very little Cu(II) leached from the OH-CNT column as compared to F-400 that slowly desorbed 85 % of Cu(II). These results indicated chemisorption process on OH-CNT with low residual release of Cu(II) from adsorbent after reaching saturation. A systematic correlation method using converted FTIR absorbance curves (first derivative analysis) of as-received and hybrid OH-CNT identified new peaks on the spectra for Cu(II) chemisorbed on CNT surface, showing that Cu(II) target acidic functional groups during adsorption.

We investigated the magnetic and chemical properties of the roadside soil samples collected from five European and Asian countries. Spots in which cars slowed down and/or accelerated due to the traffic organization (speed limits, junctions, and traffic lights) were selected for sampling. Apart from the Zabrze site (Poland), the magnetic susceptibility and heavy metal contents decreased with increasing distance from the road edge. The highest mass-specific magnetic susceptibility values (χ) were observed in the samples collected from Mumbai (India) and Zabrze (Poland). Moreover, the high contents of Fe, Ni, Mn, and Co were observed in Mumbai, whereas in Zabrze, all the examined elements demonstrated high contents, except for Co. Analyses revealed that magnetite was the main magnetic mineral in the roadside soil samples. The high correlation coefficients (r = 0.87) between the magnetic susceptibility values and the total Fe content demonstrated that Fe occurred mainly as ferrimagnetic particles of technogenic origin resulting from traffic emissions. The traffic origin of the pollutants was also confirmed by the increased contents of the typically anthropogenic metals (Pb, Zn, Cd, and Cu) and a good correlation (r = 0.83) between the Ti and Mo contents, which do not occur in natural associations. The ratio between particular polycyclic aromatic hydrocarbons (PAHs) and high content of PAHs typical for car exhaust also implied traffic as their main source.

Here, we report on the ability of two different water treatment residues, a Fe-based (Fe-WTR) and an Al-based (Al-WTR) ones, to accumulate Cd(II) and Zn(II) from aqueous solutions at different pH values (pH 4.5, 5.5, and 7.0). Fe-WTR showed a greater Zn(II) and Cd(II) sorption capacity than Al-WTR at all the pH values investigated, in particular at pH 7.0 (e.g., ∼0.200 and ∼0.100 mmol g⁻¹ of Me(II) sorbed by Fe- and Al-WTR at pH 7.0, respectively). The greater capacity of the Fe-WTR to accumulate Me(II) seems to be linked to its higher content of iron and manganese ions and to its higher CEC value compared to Al-WTR. The role of the inorganic and organic fractions of WTRs in metal sorption was also assessed. A higher affinity of Cd(II) with respect to Zn(II) toward functional groups of the organic matter of both WTRs was observed, while Zn(II) showed a stronger association with the inorganic phases. The sorption of both metal ions appeared mainly governed by the formation of inner-sphere surface complexes with the inorganic and organic phases of WTRs, as suggested by the sequential extraction data.

Poultry litter and bedding materials generated from laying chicken farm often contain high levels of arsenic when roxarsone is included in feed to combat disease and improve egg production. This study was conducted to determine the fate and ecological risk of arsenic species in poultry litter which applied to agricultural field. Three poultry litter application rates (0, 10, 60 % dry weight) were used to amend soil samples under anaerobic and aerobic circumstances, respectively, incubated at 30 % moisture content for 110 days. Experiment indicated that under anaerobic circumstance, As(V) and As(III) decreased in treatments applied 60 and 10 % rates within initial 7 days, subsequently methylated arsenic displayed increasing, suggesting biotic activity transformed inorganoarsenical to methylated arsenic species. In contrast, As(V) dropped in the first 7 days but increased thereafter under aerobic circumstances, with methylated arsenic increasing, implying abiotc and biotic activities enhanced arsenic speciation. Based on different arsenic species, we evaluated their ecological risk in poultry litter respectively. It was found that ecological risks under anaerobic circumstance were higher than under aerobic circumstance of the same poultry litter rates, and higher poultry litter rates applied to soil would bring about higher ecological risk. We suggest that poultry litter should be disposed at low rate (approximately 10 %) and applied to soil surface to create aerobic circumstance for the initial 2 months time, but should be buried into a deeper depth thereafter.

This study compares the efficiency of a synthetic chelate (ethylenediaminetetraacetic acid-EDTA), a natural low-molecular-weight organic acid (citric acid), and their combination for phytoremediation of Cu-pyrene co-contaminated soils. Zea mays was grown in each soil and amended with citric acid and/or EDTA to understand the effect of chelates during phytoremediation of contaminated soils. In Cu or pyrene-contaminated soil, plant growth was negatively affected by EDTA (43 %) and citric acid (44 %), respectively, while EDTA + citric acid promoted (41 %) plant growth in co-contaminated soil. EDTA and EDTA + citric acid increased the phytoextraction of Cu in Cu-contaminated and co-contaminated soils, respectively. In pyrene-contaminated soil, all tested chelates increased the dissipation of pyrene reaching 90.4 % for citric acid, while in co-contaminated soil, only citric acid or EDTA + citric acid enhanced pyrene dissipation. These results show that Z. mays can be effective with the help of chelates in phytoextraction of Cu and dissipation of pyrene in co-contaminated soil.

Surface water bodies can be impaired by turbidity and excessive sediment loading due to urban development, construction activities, and agricultural practices. Turbidity has been considered as a proxy for evaluating water quality, aquatic habitat, and aesthetic impairments in surface waters. The US Environment Protection Agency (USEPA) has listed turbidity and sediment as major pollutants for construction site effluent. Recently proposed USEPA regulations for construction site runoff led to increased interest in methods to predict turbidity in runoff based on parameters that are more commonly predicted in runoff–erosion models. In this study, a turbidity prediction methodology that can be easily incorporated into existing runoff–erosion models has been developed using fractions of sand, silt, and clay plus suspended sediment concentration of eight parent soils from locations in Oklahoma and South Carolina, USA.

Drainage water from acid sulfate soils with sulfuric material has high concentrations of protons and dissolved metals which can have detrimental effects on the surrounding ecosystems. Liming is expensive; therefore, alternative methods are needed. Organic materials such as plant residues, compost or biochars can bind protons and metals but have not been evaluated with respect to remediation of acid drainage water from acid sulfate soils. In this study, eight organic materials (compost, two straws and five biochars differing in feed stock and production temperature) were placed in small PVC cores at 1.5 g C/core and synthetic acid drainage water (pH 3, 28 mg Fe/l and 2 mg Al/l, properties based on long-term averages of drainage water from sulfuric acid sulfate soils) was applied in four leaching events. Mallee biochar produced at 550 °C and wheat biochar produced at 450 °C had high retention capacity for protons, Fe and Al. Retention was low in compost and wheat straw. Retention of protons was positively correlated with organic C concentration of the materials. Retention of Fe and Al was correlated with percentage alkyl, aryl and ketone groups. Other properties such as release of native Fe and Al and amount of material per core could explain differences in ability of organic materials to retain protons, Fe and Al. We conclude that some organic materials such as mallee biochar produced at 550 °C and wheat biochar produced at 450 °C could be used to remediate acidic drainage water.

To treat PCP-contaminated soil, abiotic methods for PCP degradation have been developed, where heme or powder hemoglobin acts as a catalyst and hydrogen peroxide as an oxidant. Degradation of PCP had the first-order kinetics, and rate coefficients, k, were 0.073 and 0.104/day for heme and hemoglobin, respectively, indicating that the hemoglobin was a more efficient catalyst than heme. Approximately 96 % of the initial PCP was degraded at day 35. Thus, hemoglobin might be recommended as the catalyst of choice, since it is much less expensive than heme.

The dried powder of the alligator weed root (AWR) was employed as a biosorbent to remove As(III) from aqueous solution, using acid pre-treated AWR (HAWR) and As(V) as the contrasts. The results of batch adsorption experiment suggested that there is no substantial difference between As(III) and As(V) adsorption. Both of them are affected by the solution pH significantly, but insensitive to the ionic strength. The speciation analysis indicated that more than 95 % of the total As(III) in aqueous solution is oxidized into As(V) in the presence of AWR, while barely oxidized in the presence of HAWR. It proves that without pre-oxidation, AWR can oxidize and adsorb As(III), simultaneously. The properties of the biosorbent were characterized by various techniques including scanning electronic microscopy-energy dispersive spectrometer, Fourier transform infrared spectra analysis, inductive coupled plasma emission spectrometer and Zeta potential detection. The results suggested that typical metals including Mn, Fe and Al enrich in the morphology of metal (hydro) oxide over the surface of AWR, originally. Based on the nature of the biosorbent and arsenic besides the adsorption and oxidation performances, the metal (hydro) oxides are proved as the essential role to drive the adsorption and oxidation. The proof is that with the metal (hydro) oxides denuded, as the contrast of AWR, HAWR loses its capability of adsorption and oxidation for As(III), totally.