Pharmaceutical compounds were increasingly detected in environmental matrices but little is known whether these compounds would transport to coastal zones via watersheds. Three typical tidal rivers in southeastern China were selected and 15 surface sediment samples (0-10 cm) were collected along a 50-km tidal section of each river. Surface sediment samples were frozen-drying and then extracted for pharmaceutical compounds by an accelerated solvent extraction system. The pharmaceutical compounds in extracts were scanned using a high-performance liquid chromatography/tandern mass spectrometry (HPLC-MS/MS). Three hundred and thirty compounds from nine pharmaceutical groups were detected with signal-to-noise above three (detectable level) in the surface sediments, of which 186 compounds were with a signal-to-noise above ten (measurable level). Of all, 291 and 80 compounds were detectable and measurable in all the three rivers, respectively. The Jiulong River showed a high load of pharmaceutical compounds in surface sediment than other two rivers. Of the nine pharmaceutical groups, the antihistamines and detoxification group and anti-infective drug group contributed five dominant compounds in the surface sediments in all the three rivers. Natures of pharmaceutical compounds rather than the sediment properties (pH, EC, and total carbon content) might influence their residues. The incredible number and intensity of pharmaceutical residues were detected in tidal surface sediments of the three rivers indicating that the pharmaceutical contamination should be strongly considered in China. Source identification and eco-toxicity assessment should be taken into account in the future study. Therapeutic medicine managements need to be strictly improved at a watershed scale to reduce loads of pharmaceuticals into aquatic ecosystems.

Owing to the extensive use of artificial turfs worldwide, over the past 10 years there has been much discussion about the possible health and environmental problems originating from styrene-butadiene recycled rubber. In this paper, the authors performed a Tier 2 environmental-sanitary risk analysis on five artificial turf sports fields located in the city of Turin (Italy) with the aid of RISC4 software. Two receptors (adult player and child player) and three routes of exposure (direct contact with crumb rubber, contact with rainwater soaking the rubber mat, inhalation of dusts and gases from the artificial turf fields) were considered in the conceptual model. For all the fields and for all the routes, the cumulative carcinogenic risk proved to be lower than 10(-6) and the cumulative non-carcinogenic risk lower than 1. The outdoor inhalation of dusts and gases was the main route of exposure for both carcinogenic and non-carcinogenic substances. The results given by the inhalation pathway were compared with those of a risk assessment carried out on citizens breathing gases and dusts from traffic emissions every day in Turin. For both classes of substances and for both receptors, the inhalation of atmospheric dusts and gases from vehicular traffic gave risk values of one order of magnitude higher than those due to playing soccer on an artificial field.

The objective of this study was to investigate the impacts of exogenous nitrogen on a microbial community inoculated with the atrazine-degrading Arthrobacter sp. in soil amended with a high concentration of atrazine. Inoculated and uninoculated microcosms for biodegradation tests were constructed. Atrazine degradation capacity of the strain DAT1 and the strain's atrazine-metabolic potential and survival were assessed. The relative abundance of the strain DAT1 and the bacterial community structure in soils were characterized using quantitative PCR in combination with terminal restriction fragment length polymorphism. Atrazine degradation by the strain DAT1 and the strain's atrazine-metabolic potential and survival were not affected by addition of a medium level of nitrate, but these processes were inhibited by addition of a high level of nitrate. Microbial community structure changed in both inoculated and uninoculated microcosms, dependent on the level of added nitrate. Bioaugmentation with the strain DAT1 could be a very efficient biotechnology for bioremediation of soils with high concentrations of atrazine.

Bioremediation of textile dyestuffs under solid-state fermentation (SSF) using industrial wastes as substrate pose an economically feasible, promising, and eco-friendly alternative. The purpose of this study was to adsorb Red M5B dye, a sample of dyes mixture and a real textile effluent on distillery industry waste-yeast biomass (DIW-YB) and its further bioremediation using Bacillus cereus EBT1 under SSF. Textile dyestuffs were allowed to adsorb on DIW-YB. DIW-YB adsorbed dyestuffs were decolorized under SSF by using B. cereus. Enzyme analysis was carried out to ensure decolorization of Red M5B. Metabolites after dye degradation were analyzed using UV–Vis spectroscopy, FTIR, HPLC, and GC-MS. DIW-YB showed adsorption of Red M5B, dyes mixture and a textile wastewater sample up to 87, 70, and 81 %, respectively. DIW-YB adsorbed Red M5B was decolorized up to 98 % by B. cereus in 36 h. Whereas B. cereus could effectively reduce American Dye Manufacture Institute value from DIW-YB adsorbed mixture of textile dyes and textile wastewater up to 70 and 100 %, respectively. Induction of extracellular enzymes such as laccase and azoreductase suggests their involvement in dye degradation. Repeated utilization of DIW-YB showed consistent adsorption and ADMI removal from textile wastewater up to seven cycles. HPLC and FTIR analysis confirms the biodegradation of Red M5B. GC-MS analysis revealed the formation of new metabolites. B. cereus has potential to bioremediate adsorbed textile dyestuffs on DIW-YB. B. cereus along with DIW-YB showed enhanced decolorization performance in tray bioreactor which suggests its potential for large-scale treatment procedures.

Water quality degradation in river systems has caused great concerns all over the world. Identifying the spatial distribution and sources of water pollutants is the very first step for efficient water quality management. A set of water samples collected bimonthly at 12 monitoring sites in 2009 and 2010 were analyzed to determine the spatial distribution of critical parameters and to apportion the sources of pollutants in Wen-Rui-Tang (WRT) river watershed, near the East China Sea. The 12 monitoring sites were divided into three administrative zones of urban, suburban, and rural zones considering differences in land use and population density. Multivariate statistical methods [one-way analysis of variance, principal component analysis (PCA), and absolute principal component score—multiple linear regression (APCS-MLR) methods] were used to investigate the spatial distribution of water quality and to apportion the pollution sources. Results showed that most water quality parameters had no significant difference between the urban and suburban zones, whereas these two zones showed worse water quality than the rural zone. Based on PCA and APCS-MLR analysis, urban domestic sewage and commercial/service pollution, suburban domestic sewage along with fluorine point source pollution, and agricultural nonpoint source pollution with rural domestic sewage pollution were identified to the main pollution sources in urban, suburban, and rural zones, respectively. Understanding the water pollution characteristics of different administrative zones could put insights into effective water management policy-making especially in the area across various administrative zones.

An ordered hierarchical meso/macroporous monoclinic bismuth vanadate (BiVO₄) particle was fabricated for the first time by a simple two-step melamine template hydrothermal method followed by calcination. The physiochemical parameters of as-prepared porous materials were characterized by means of X-ray diffraction, scanning electron microscopy, high-resolution transmission electron microscopy, Raman, Barrett–Emmett–Teller, and UV–vis techniques. The nitrogen adsorption–desorption measurement and pore size distribution curve suggest that meso/macropores exist in these hierarchical microarchitectures. Further, it is found that melamine plays a significant role in the formation of porous BiVO₄ particles, and when a known amount of melamine was added, the surface area and pore size of such porous BiVO₄ particles were increased. The photocatalytic activities of the as-prepared hierarchical BiVO₄ samples were measured for the photodegradation of Congo red aqueous dye solution under visible light irradiation. Surprisingly, the porous BiVO₄ particles showed outstanding photocatalytic activities than polycrystalline BiVO₄ sample. The possible enhancement of such catalytic performance has also been further discussed.

A batch adsorption process was applied to investigate the removal of perchlorate (ClO) from water by graphene. In doing so, the thermodynamic adsorption isotherm and kinetic studies were also carried out. Graphene was prepared by a facile liquid-phase exfoliation. Graphene was characterized by Raman spectroscopy, Fourier-transform infrared spectroscopy, powder X-ray diffraction, scanning electron microscope, and zeta potential measurements. A systematic study of the adsorption process was performed by varying pH, ionic strength, and temperature. The adsorption efficiency of graphene was 99.2 %, suggesting that graphene is an excellent adsorbent for ClO removal from water. The rate constants for all these kinetic models were calculated, and the results indicate that second-order kinetics model was well suitable to model the kinetic adsorption of ClO. Equilibrium data were well described by the typical Langmuir adsorption isotherm. The experimental results showed that graphene is an excellent perchlorate adsorbent with an adsorbent capacity of up to 0.024 mg/g at initial perchlorate concentration of 2 mg/L and temperature of 298 K. Thermodynamic studies revealed that the adsorption reaction was a spontaneous and endothermic process. Graphene removed the perchlorate present in the water and reduced it to a permissible level making it drinkable.

INTRODUCTION: A biosorbent was developed by simple dried Agaricus bisporus (SDAB) and effectively used for the biosorption of cationic dyes, Crystal Violet and Brilliant Green. MATERIALS AND METHODS: For the evaluation of the biosorbent system, all the batch equilibrium parameters like pH, biomass dose, contact time, and temperature were optimized to determine the decolorization efficiency of the biosorbent. The maximum yields of dye removal were achieved at pH 4.0 for Crystal Violet (CV) and pH 5.0 for Brilliant Green (BG), which are closer to their natural pH also. RESULT AND DISCUSSION: Equilibrium was established at 60 and 40 min for CV and BG, respectively. Pseudo first-order, pseudo second-order, and intraparticle-diffusion kinetic models were studied at different temperatures. Isotherm models such as Freundlich, Langmuir, and Dubinin–Radushkevich were also studied. Biosorption processes were successfully described by Langmuir isotherm model and the pseudo second-order kinetic model. CONCLUSIONS: The biosorption capacity of A. bisporus over CV and BG were found as 21.74 and 12.16 mg gm⁻¹. Thermodynamic parameters indicated that the CV and BG dye adsorption onto A. bisporus is spontaneous and exothermic in the single and ternary systems. Scanning electron microscopy, X-ray diffraction, and Fourier transform infrared spectroscopy were used for the surface morphology, crystalline structure of biosorbent, and dye–biosorbent interaction, respectively. This analysis of the biosorption data confirmed that these biosorption processes are ecofriendly and economical. Thus, this biomass system may be useful for the removal of contaminating cationic dyes.

Urban air quality is one of the key factors affecting human health. Turkey has transformed itself into an urban society over the last 30 years. At the same time, air pollution has become a serious impairment to health in many urban areas in the country. This is due to many reasons. In this study, a nonparametric evaluation was conducted of health effects that are triggered by urban air pollution. Niğde, the city which is the administrative centre of Nigde province was chosen of the effects of air pollution since, like many central Turkish cities, it is situated on a valley where atmospheric inversion occurs. In this paper, the relationship between ambient urban air quality, namely PM₁₀ and sulphur dioxide (SO₂), and human health, specifically asthma, during the winter season is examined. Air pollution data and asthma cases from 2006 to 2010 are covered in this study. The results of our study indicate that total asthma cases reported in Nigde between 2008 and 2010 were highly dependent on ambient SO₂ concentration. More asthma cases were recorded when 30 μg m⁻³ or higher SO₂ was present in the ambient air than those recorded under cleaner ambient air conditions. Moreover, it was determined that in Nigde in 2010, asthma cases reported in males aged between 45 and 64 were closely correlated with ambient SO₂ (α = 0.05).

The characteristics of volatile organic compounds (VOCs) and their annual trends in Seoul, Korea were investigated, with their optimal control strategy suggested. The annual concentration of VOCs (96.2–121.1 ppbC) has shown a decreasing trend from 2004 to 2008, suggesting the control strategy via the “Special Measures for Metropolitan Air Quality Improvement,” which was implemented in 2005, has been successful. The contributions of individual VOC to the production of ambient ozone and secondary organic aerosol (SOA) are discussed to assess the adequacy of current control strategies. The contribution of aromatics (C6–C10) to the production of ozone accounted for 38.7–46.3 % of the total ozone production, followed by low carbon alkanes (C2–C6) (27.0–35.9 %). The total SOA formation potential of VOCs was found to range from 2.5 to 3.5 μg m⁻³, mainly as a result of aromatics (C6–C10) (over 85 %). Considering the contributions from ozone and SOA production, it was concluded that solvent use was the most important emission source, followed by vehicle exhaust emissions. Thus, the current emission control strategy focused on these two emission sources is appropriate to reduce the VOCs related pollution level of the Seoul Metropolitan Region. Still, an additional control strategy, such as controlling the emissions from meat cooking, which is an emission source of high carbon alkanes (C7–C10), needs to be considered to further reduce the VOCs related pollution level in Seoul.