This study was launched to establish comprehensive environmental monitoring on the levels and patterns of polychlorinated biphenyls (PCBs), polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs), and polycyclic aromatic hydrocarbons (PAHs) both in soil and ambient air around a thermal desorption plant in China. All 209 congeners of PCBs, 136 congeners of PCDD/Fs (P = 4 to 8) and 16 EPA priority PAHs were analyzed. The concentration of PCBs ranged from 20.0 to 536 ng g⁻¹(or 0.077–5.27 pg WHO-TEQ g⁻¹) in soil and from 972 to 991 ng Nm⁻³(or 0.245–0.374 pg WHO-TEQ Nm⁻³) in air samples, much higher than the levels in cities. A single soil sampling point could have been affected by some transfer of PCBs from the untreated soil by the fingerprint characteristics and the statistical analysis. Establishing blank values prior to the start-up of new plant is a safe and sure method to establish subsequent impacts on the environment. During the treatment of hazardous waste, strict control of all waste materials and all emissions is required.

Amending polycyclic aromatic hydrocarbon (PAH)-contaminated soils with biochar may be cheaper and environmentally friendly than other forms of organic materials. This has led to numerous studies on the use of biochar to either bind or stimulate the microbial degradation of organic compounds in soils. However, very little or no attention have been paid to the fact that biochars can give simultaneous impact on PAH fate processes, such as volatilization, sorption and biodegradation. In this review, we raised and considered the following questions: How does biochar affect microbes and microbial activities in the soil? What are the effects of adding biochar on sorption of PAHs? What are the effects of adding biochar on degradation of PAHs? What are the factors that we can manipulate in the laboratory to enhance the capability of biochars to degrade PAHs? A triphasic concept of how biochar can give simultaneous impact on PAH fate processes in soils was proposed, which involves rapid PAH sorption into biochar, subsequent desorption and modification of soil physicochemical properties by biochar, which in turn stimulates microbial degradation of the desorbed PAHs. It is anticipated that biochar can give simultaneous impact on PAH fate processes in soils.

Near-ground air (26 substances) and surface seawater (55 substances) concentrations of persistent toxic substances (PTS) were determined in July 2012 in a coordinated and coherent way around the Aegean Sea based on passive air (10 sites in 5 areas) and water (4 sites in 2 areas) sampling. The direction of air–sea exchange was determined for 18 PTS. Identical samplers were deployed at all sites and were analysed at one laboratory. hexachlorobenzene (HCB), hexachlorocyclohexanes (HCHs) as well as dichlorodiphenyltrichloroethane (DDT) and its degradation products are evenly distributed in the air of the whole region. Air concentrations of p,p′-dichlorodiphenyldichloroethylene (p,p′-DDE) and o,p′-DDT and seawater concentrations of p,p′-DDE and p,p′-DDD were elevated in Thermaikos Gulf, northwestern Aegean Sea. The polychlorinated biphenyl (PCB) congener pattern in air is identical throughout the region, while polybrominated diphenylether (PBDE)patterns are obviously dissimilar between Greece and Turkey. Various pollutants, polycyclic aromatic hydrocarbons (PAHs), PCBs, DDE, and penta- and hexachlorobenzene are found close to phase equilibrium or net-volatilisational (upward flux), similarly at a remote site (on Crete) and in the more polluted Thermaikos Gulf. The results suggest that effective passive air sampling volumes may not be representative across sites when PAHs significantly partitioning to the particulate phase are included.

Longan (Dimocarpus longana Lour. cv. Wulongling) of uniform one-aged seedlings grown in pots were selected to study specific proteins expressed in leaves under simulated acid rain (SiAR) stress and exogenous Ca²⁺ regulation. Sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) results showed that there was a protein band specifically expressed under SiAR of pH 2.5 stress for 15 days with its molecular weight of about 23 kD. A 17 kD protein band specifically expressed after SiAR stress 5 days. Compared with pH 2.5, the pH 3.5 of SiAR made a less influence to protein expression. Two-dimensional electrophoresis (2-DE) results showed that six new specific proteins including C₄ (20.2 kD pI 6.0), F (24 kD pI 6.35), B₃ (22.3 kD pI 6.35), B₄ (23.5 kD pI 6.5), C₅ (21.8 kD pI 5.6), and C₆ (20.2 kD pI 5.6) specifically expressed. C₄ always expressed during SiAR stress. F expressed under the stress of pH 2.5 for 15 days and expressed in all pH SiAR stress for 20 days. The expression of proteins including B₃, C₅, and C₆ was related to pH value and stress intensity of SiAR. The expression of B₄ resulted from synergistic effects of SiAR and Ca. The expression of G₁ (Mr 19.3 kD, pI 4.5), G₂ (Mr 17.8 kD, pI 4.65), G₃ (Mr 16.6 kD, pI 4.6), and G₄ (Mr 14.7 kD, pI 4.4) enhanced under the treatment of 5 mM ethylene glycol tetraacetic acid (EGTA) and 2 mM chlorpromazine (CPZ). These proteins showed antagonistic effects and might be relative to the Ca-calmodulin (Ca-CaM) system of longan in response to SiAR stress.

Nanoparticles (NPs) are widely used in many industrial applications. NP fate and behavior in seawater are a very important issue for the assessment of their environmental impact and potential toxicity. In this study, the toxic effects of two nanomaterials, silicon dioxide (SiO₂) and titanium dioxide (TiO₂) NPs with similar primary size (~20 nm), on marine microalgae Dunaliella tertiolecta were investigated and compared. The dispersion behavior of SiO₂ and TiO₂ NPs in seawater matrix was investigated together with the relative trend of the exposed algal population growth. SiO₂ aggregates rapidly reached a constant size (600 nm) irrespective of the concentration while TiO₂ NP aggregates grew up to 4 ± 5 μm. The dose–response curve and population growth rate alteration of marine alga D. tertiolecta were evaluated showing that the algal population was clearly affected by the presence of TiO₂ NPs. These particles showed effects on 50 % of the population at 24.10 [19.38–25.43] mg L⁻¹ (EC50) and a no observed effect concentration (NOEC) at 7.5 mg L⁻¹. The 1 % effect concentration (EC1) value was nearly above the actual estimated environmental concentration in the aquatic environment. SiO₂ NPs were less toxic than TiO₂ for D. tertiolecta, with EC50 and NOEC values one order of magnitude higher. The overall toxic action seemed due to the contact between aggregates and cell surfaces, but while for SiO₂ a direct action upon membrane integrity could be observed after the third day of exposure, TiO₂ seemed to exert its toxic action in the first hours of exposure, mostly via cell entrapment and agglomeration.

The concentrations of total petroleum hydrocarbons (TPH), n-alkanes (n-C₈ through n-C₄₀), and 16 polycyclic aromatic hydrocarbons (PAHs) in soils were determined to assess the level of organic contamination in soils from the Da-gang Petrochemical Industry Park with several big state-run enterprises, a recent rapid flourishing park in China. The results showed that the concentration of TPH in soil was high, up to 20 ng/g–12.8478 %; in particular, the content in most sites ranged from 1 to 2 %. Thus, it is clear that soil environment in the Da-gang Petrochemical Industry Park has been seriously polluted by TPH according to the Nemerow pollution index method. Furthermore, the average concentration of Σ(n-C>₁₆ through n-C₃₄) in 30 sampling sites was above the maximum limit set for F3 under all the conditions in the Canada-wide standards for petroleum hydrocarbons (PHC CWS) with 43.33–93.33 % soil samples exceeding F3 standards, and n-alkanes possessing higher concentrations were proved much abundant alkanes in this study. Besides, the predominance of even n-alkanes and lower carbon preference index (CPI) demonstrated that n-alkanes in surface soils were mainly caused by anthropogenic inputs, while the concentration of Σ₁₆-PAHs was in the range of 1652.5–8217.3 ng/g and the BaA/(BaA + Chr) and Flu/(Flu + Pyr) ratios indicated that pyrogenic PAHs may be the dominant PAHs in most soils with the contribution of petrogenic hydrocarbons in some sites.

The purpose of this work was to study the efficiency of different treatments, based on the combination of O₃, H₂O₂, and TiO₂, on fresh surface water samples fortified with wild strains of Escherichia coli. Moreover, an exhaustive assessment of the influence of the different agents involved in the treatment has been carried out by kinetic modeling of E. coli inactivation results. The treatments studied were (i) ozonation (O₃), (ii) the peroxone system (O₃/0.04 mM H₂O₂), (iii) catalytic ozonation (O₃/1 g/L TiO₂), and (iv) a combined treatment of O₃/1 g/L TiO₂/0.04 mM H₂O₂. It was observed that the peroxone system achieved the highest levels of inactivation of E. coli, around 6.80 log after 10 min of contact time. Catalytic ozonation also obtained high levels of inactivation in a short period of time, reaching 6.22 log in 10 min. Both treatments, the peroxone system (O₃/H₂O₂) and catalytic ozonation (O₃/TiO₂), produced a higher inactivation rate of E. coli than ozonation (4.97 log after 10 min). While the combination of ozone with hydrogen peroxide or titanium dioxide thus produces an increase in the inactivation yield of E. coli regarding ozonation, the O₃/TiO₂/H₂O₂ combination did not enhance the inactivation results. The fitting of experimental values to the corresponding equations through non-linear regression techniques was carried out with Microsoft® Excel GInaFiT software. The inactivation results of E. coli did not respond to linear functions, and it was necessary to use mathematical models able to describe certain deviations in the bacterial inactivation processes. In this case, the inactivation results fit with mathematical models based on the hypothesis that the bacteria population is divided into two different subgroups with different degrees of resistance to treatments, for instance biphasic and biphasic with shoulder models.

The investigation of arsenic (As) re-accumulation in an area previously remediated by soil dressing will help in sustainable controlling the risks of As to local ecosystems and should influence management decisions about remediation strategies. In this study, As content in an area remediated by soil dressing and the possible As accumulation risk in agricultural products were investigated. The results indicated that after 7 years of agricultural activities, the average As content (24.6 mg kg⁻¹) in surface soil of the investigated area increased by 83.6 % compared with that (13.4 mg kg⁻¹) in clean soil. Of the surface soil samples (n = 88), 21.6 % had As levels that exceeded the limits of the Environmental Quality Standard for Soils of China (GB 15618-1995) and 98.9 % of the surface soil samples with As contents exceeding that in clean soil was observed. Soil dressing might be not a remediation method once and for all in some contaminated areas, even though no significant difference in available As content was found between clean (0.18 mg kg⁻¹) and surface (0.22 mg kg⁻¹) soils. The foreign As in surface soil of the investigated area mainly specifically sorbed with soil colloid or associated with hydrous oxides of Fe and Al, or existed in residual fraction. The upward movement of contaminated soil from the deeper layers and the atmospheric deposition of slag particles might be responsible for the re-accumulation of As in the investigated area. Decreases in soil pH in the investigated soils and the fact that no plant samples had As levels exceeding the limits of the National Food Safety Standards for Contaminants of China (GB 2762-2012) were also observed.

We investigated dioxin formation and removal in a commercial thermal waste treatment plant employing a gasification and melting process that has become widespread in the last decade in Japan. The aim was to clarify the possibility of dioxin formation in a process operation at high temperatures and the applicability of catalytic decomposition of dioxins. Also, the possible use of dioxin surrogate compounds for plant monitoring was further evaluated. The main test parameter was the influence of changes in the amount and type of municipal solid waste (MSW) supplied to the thermal waste treatment plant which from day to day operation is a relevant parameter also from commercial perspective. Here especially, the plastic content on dioxin release was assessed. The following conclusions were reached: (1) disturbance of combustion by adding plastic waste above the capability of the system resulted in a considerable increase in dioxin content of the flue gas at the inlet of the bag house and (2) bag filter equipment incorporating a catalytic filter effectively reduced the gaseous dioxin content below the standard of 0.1 ng toxic equivalency (TEQ)/m³ N, by decomposition and partly adsorption, as was revealed by total dioxin mass balance and an increased levels in the fly ash. Also, the possible use of organohalogen compounds as dioxin surrogate compounds for plant monitoring was further evaluated. The levels of these surrogates did not exceed values corresponding to 0.1 ng TEQ/m³ N dioxins established from former tests. This further substantiated that surrogate measurement therefore can well reflect dioxin levels.

Anaerobic digestion (AD) is one of the few sustainable technologies that both produce energy and treat waste streams. Driven by a complex and diverse community of microbes, AD may be affected by different factors, many of which also influence the composition and activity of the microbial community. In this study, the biodiversity of microbial populations in innovative mesophilic/thermophilic temperature-phased AD of sludge was evaluated by means of fluorescence in situ hybridization (FISH). The increase of digestion temperature drastically affected the microbial composition and selected specialized biomass. Hydrogenotrophic Methanobacteriales and the protein fermentative bacterium Coprothermobacter spp. were identified in the thermophilic anaerobic biomass. Shannon–Weaver diversity (H′) and evenness (E) indices were calculated using FISH data. Species richness was lower under thermophilic conditions compared with the values estimated in mesophilic samples, and it was flanked by similar trend of the evenness indicating that thermophilic communities may be therefore more susceptible to sudden changes and less prompt to adapting to operative variations.