Previous researches have demonstrated that biological phosphorus removal (BPR) from wastewater could be driven by the aerobic/extended-idle (A/EI) regime. This study further investigated temperature effects on phosphorus removal performance in six A/EI sequencing batch reactors (SBRs) operated at temperatures ranging from 5 to 30 °C. The results showed that phosphorus removal efficiency increased with temperature increasing from 5 to 20 °C but slightly decreased when temperature continually increased to 30 °C. The highest phosphorus removal rate of 97.1 % was obtained at 20 °C. The biomass cultured at 20 °C contained more polyphosphate accumulating organisms (PAO) and less glycogen accumulating organisms (GAO) than that cultured at any other temperatures investigated. The mechanism studies revealed that temperature affected the transformations of glycogen and polyhydroxyalkanoates, and the activities of exopolyphosphatase and polyphosphate kinase activities. In addition, phosphorus removal performances of the A/EI and traditional anaerobic/oxic (A/O) SBRs were compared at 5 and 20 °C, respectively. The results showed the A/EI regime drove better phosphorus removal than the A/O regime at both 5 and 20 °C, and more PAO and less GAO abundances in the biomass might be the principal reason for the higher BPR in the A/EI SBRs as compared with the A/O SBRs.

To investigate the response of the tributyltin-degrading fungal strain Cunninghamella elegans to the organotin, a comparative lipidomics strategy was employed using an LC/MS-MS technique. A total of 49 lipid species were identified. Individual phospholipids were then quantified using a multiple reaction monitoring method. Tributyltin (TBT) caused a decline in the amounts of many molecular species of phosphatidylethanolamine or phosphatidylserine and an increase in the levels of phosphatidic acid, phosphatidylinositol and phosphatidylcholine. In the presence of TBT, it was observed that overall unsaturation was lower than in the control. Lipidome data were analyzed using principal component analysis, which confirmed the compositional changes in membrane lipids in response to TBT. Additionally, treatment of fungal biomass with butyltin led to a significant increase in lipid peroxidation. It is suggested that modification of the phospholipids profile and lipids peroxidation may reflect damage to mycelium caused by TBT.

Optimizing process parameters that affect the remediation time and power consumption can improve the treatment efficiency of the electrokinetic remediation as well as determine the cost of a remediation action. Lab-scale electrokinetic remediation of Pb-contaminated soils was investigated for the effect of complexant ethylenediaminetetraacetic acid (EDTA) and acetic acid and approaching anode on the removal efficiency of Pb. When EDTA was added to the catholyte, EDTA dissolved insoluble Pb in soils to form soluble Pb–EDTA complexes, increasing Pb mobility and accordingly removal efficiency. The removal efficiency was enhanced from 47.8 to 61.5 % when the EDTA concentration was increased from 0.1 to 0.2 M, showing that EDTA played an important role in remediation. And the migration rate of Pb was increased to 72.3 % when both EDTA and acetic acid were used in the catholyte. The “approaching anode electrokinetic remediation” process in the presence of both EDTA and acetic acid had a higher Pb-removal efficiency with an average efficiency of 83.8 %. The efficiency of electrokinetic remediation was closely related to Pb speciation. Exchangeable and carbonate-bounded Pb were likely the forms which could be removed. All results indicate that the approaching anode method in the presence of EDTA and acetic acid is an advisable choice for electrokinetic remediation of Pb-contaminated soil.

To test the feasibility of the reuse of iron-rich sludge (IRS) produced from a coal mine drainage treatment plant for removing As(III) and As(V) from aqueous solutions, we investigated various parameters, such as contact time, pH, initial As concentration, and competing ions, based on the IRS characterization. The IRS consisted of goethite and calcite, and had large surface area and small particles. According to energy dispersive X-ray spectroscopy mapping results, As was mainly removed by adsorption onto iron oxides. The adsorption kinetic studies showed that nearly 70 % adsorption of As was achieved within 1 h, and the pseudo-second-order model well explained As sorption on the IRS. The adsorption isotherm results agreed with the Freundlich isotherm model, and the maximum adsorption capacities for As(III) and As(V) were 66.9 and 21.5 mg/g, respectively, at 293 K. In addition, the adsorption showed the endothermic character. At high pH or in the presence of phosphate, the adsorption of As was decreased. When the desorption experiment was conducted to reuse the IRS, 85 % As was desorbed with 1.0 N NaOH. In the column experiment, adsorbed As in real acid mine drainage was 43 % of the maximum adsorbed amount of As in the batch test. These results suggested that the IRS is an effective adsorbent for As and can be effectively applied for the removal of As in water and wastewater.

Dimethylformamide (DMF) is a broad solvent used in the production of synthetic leather. Decades of year's research have been focused on workers in leather factories suffering from the release of DMF. However, little attention was paid on general population. Here, we examined the relationship between consistent DMF exposure and annual hospitalizations of local residents in Longwan, China, in 2008. We found a positive correlation with a relative risk (RR) increase of 1.110 for total hospitalizations. When the data were stratified by sex, we observed a higher correlation for female hospitalizations than for male hospitalizations, with RR values of 1.55 and 1.084, respectively. This might be attributed to the differences in genotypes of oxidant enzyme between gender. The significance of the correlations did not disappear after we excluded the extreme value of DMF or adjusted for SO₂, NO₂, and PM₁₀. Population living near the leather factory has experienced almost constant DMF exposure, and real concern should be raised regarding such exposure. Governments should take responsibility for the protection of not only occupational workers but also residents, especially women.

The feasibility for developing a protocol to assess marine water quality based on early colonization features of periphytic ciliate fauna was studied in coastal waters of the Yellow Sea, northern China. The ciliate communities with 3–28-day ages were collected monthly at four stations with a spatial gradient of environmental stress from August 2011 to July 2012. The spatial patterns of both early (3–7 days) and mature (>10 days) communities of the ciliates represented significant differences among the four stations, and were significantly correlated with environmental variables, especially nutrients and chemical oxygen demand (COD). Seven and eight dominant species were significantly correlated with nutrients or COD within the early and mature communities, respectively. The species richness indices were strongly correlated with nutrients, especially in mature communities. These findings suggest that it is possible to assess the status of water quality using early colonization features of periphytic ciliate fauna in coastal waters.

The purpose of this study was to investigate adsorption characteristic of swine manure biochars pyrolyzed at 400 °C and 700 °C for the removal of Cu(II) ions from aqueous solutions. The biochars were characterized using BET surface area, Fourier transform infrared spectroscopy (FTIR), zeta potential, scanning electron microscopy/energy dispersive spectrometer (SEM–EDS), and X-ray diffraction (XRD). The adsorption of Cu(II) ions by batch method was carried out and the optimum conditions were investigated. The adsorption processes of these biochars are well described by a pseudo-second-order kinetic model, and the adsorption isotherm closely fitted the Sips model. Thermodynamic analysis suggested that the adsorption was endothermic. The maximum Cu(II) adsorption capacities of biochars derived from fresh and composted swine manure at 400 °C were 17.71 and 21.94 mg g⁻¹, respectively, which were higher than those at 700 °C. XRD patterns indicated that the silicate and phosphate particles within the biochars served as adsorption sites for Cu(II). The removal of Cu(II) ions from industrial effluent indicated that the fresh swine manure biochar pyrolyzed at 400 °C can be considered as an effective adsorbent.

Emission from large-scale post-harvest agricultural-waste burning (paddy-residue burning during October–November and wheat-residue burning in April–May) is a conspicuous feature in northern India. The poor and open burning of agricultural residue result in massive emission of carbonaceous aerosols and organic pollutants to the atmosphere. In this context, concentrations of atmospheric polycyclic aromatic hydrocarbons (PAHs) and their isomer ratios have been studied for a 2-year period from a source region (Patiala: 30.2°N; 76.3°E) of two distinct biomass burning emissions. The concentrations of 4—6 ring PAHs are considerably higher compared to 2–3 ring PAHs in the ambient particulate matter (PM₂.₅). The crossplots of PAH isomer ratios, fluoranthene / (fluoranthene + pyrene) and indeno[1,2,3-cd]pyrene/(indeno[1,2,3-cd]pyrene + benzo[g,h,i]perylene) for two biomass burning emissions, exhibit distinctly different source characteristics compared to those for fossil-fuel combustion sources in south and south-east Asia. The PAH isomer ratios studied from different geographical locations in northern India also exhibit similar characteristics on the crossplot, suggesting their usefulness as diagnostic tracers of biomass burning emissions.

The occurrence of pharmaceuticals in the aquatic environment has become a matter of concern in the last decade due to potential risks posed to non-target organisms and the potential for unintended human exposure via food chain. This concern has been driven by a high detection frequency for drugs in environmental samples; these substances are produced in large quantities and are used in both veterinary and human medicine, leading to deposition and potential effects in the environment. However, few studies have focused on the presence of pharmaceuticals in rural areas associated with farming activities in comparison to urban areas. The aim of this study is to investigate the occurrence of pharmaceutically active compounds in surface waters collected from urban and rural areas in northwestern Spain. A monitoring study was conducted with 312 river water samples analysed by high-performance liquid chromatography coupled to tandem mass spectrometry. Positive detection of pharmaceuticals was made for 51 % of the samples. Decoquinate, sulfamethazine, sulfamethoxypyridazine and trimethoprim were the drugs most frequently detected, being present in more than 10 % of the samples. The sampling sites located downstream of the discharge points for wastewater treatment plants yielded the highest number of positive samples, 13 % of the positive samples were detected in these sites and 38 % of the samples collected near the collection point of a drinking water treatment plant were positive.

Poly(lactic acid) nanocomposites containing Cloisite 15A, Cloisite 30B, and Dellite 43B were prepared by melt-mixing in a batch mixer and were exposed to UV radiation, temperature, and microorganism in solution and in a compost. Exposed samples, collected along the time, were characterized by several techniques. While the addition of organoclays had a positive effect on thermal stability, the degradation rate of nanocomposites increased when exposed to UV radiation and microorganism. Moreover, the degradation rate depends on the organoclay type. Even though the degradation rate is higher for nanocomposites, Fourier transform infrared spectrometry and gel permeation chromatography results demonstrated that the degradation mechanism is the same.