This work studies the in situ electrobioremediation of an oxyfluorfen-polluted clay soil in a two-stage method. First, a fixed-bed biofilm reactor for oxyfluorfen biodegradation in wastewater was developed; it treated wastewater with 200 mg L⁻¹ of oxyfluorfen and reached 100% of oxyfluorfen degradation in 30 h. Second, a portion of the biofilm-covered bed was included into the polluted soil and it was used as a biological permeable reactive barrier (BioPRB), whereas electrokinetics was applied to promote the contact between the pollutant and microorganisms into the soil. The electrobioremediation study was performed in a bench scale setup under 1.0 V cm⁻¹ at room temperature and under periodic polarity reversal (2 day⁻¹) in a 2-week batch experiment. Two reference tests were done: (i) a conventional in situ biological test without electrokinetics and (ii) a conventional in situ electrokinetic test without using microorganisms. The experimental conditions (temperature, pH, moisture) were correctly controlled in the soil and enabled the microbial activity during the process. A low oxyfluorfen removal efficiency was obtained after 2 weeks (11%) because of the low electrokinetic mobility of such non-polar pollutant into the soil. Despite this low efficiency value, it was considered that the combined biological-electrokinetic technology could be used as a bioaugmentation procedure to perform electrobioremediation processes because the results of both reference tests showed negligible removal efficiencies when using only biological or only electrochemical methods. According to these results, electrobioremediation could be considered a feasible technology although more retention time would be required to achieve successful remediation results.

Experiments were conducted under lead (Pb), cadmium (Cd), and copper (Cu) exposure to observe germination and seedling growth of wheat (Triticum aestivum L), pea (Pisum sativum), and tomato (Solanum lycopersicum L.). Metals were applied in five concentrations (20, 65, 110, 175, and 220 ppm) and Hoagland solution was used to feed the seedlings. Irrespective of the tested crop seeds, copper revealed maximum effect (51.2%) on germination followed by lead (47.5%) and cadmium (35.3%). Tomato seeds were most sensitive in germination stage followed by pea and wheat. In seedling stage, tomato also showed highest sensitivity to both Cd and Cu. However, pea seedlings showed higher tolerance to Pb and wheat seedlings had the highest tolerance to both Cu and Cd. Toxicity and tolerance of metals was found to vary with crops and growth stages. Higher transfer of metals (Pb, Cd, and Cu) in wheat seedling indicates higher risk of food chain contamination when grown in polluted soil. Higher mobility and uptake of Cd in tomato and wheat seedlings even under lower concentration of exposure needs further study.

The purpose of this study is to experimentally investigate the effect of unsaturation of the biodiesels obtained from grapeseed oil, wheat germ oil and coconut oil (reference fuel) for compression ignition (CI) engine application. Fatty acid profile analysis and physio-chemical properties were determined by standard test procedures. Engine testing was carried out in a 5.2-kW single-cylinder CI engine and the combustion, performance and emission characteristics were analysed. The effect of fuel property variation and the combustion reaction kinetics due to unsaturation difference have been discussed. The maximum brake thermal efficiency at full load for diesel was found to be 32.3% followed by 31.3%, 30.2% and 27.4 %, respectively, for coconut biodiesel (CBD), grapeseed biodiesel (GSBD) and wheat germ biodiesel (WGBD). Maximum heat release rate as observed for diesel, CBD, GSBD and WGBD are 63.2 J/°CA 60.7 J/°CA and 59 J/°CA and 43.4 J/°CA respectively. The brake-specific NO emission at full load is higher for CBD followed by GSBD, WGBD and diesel having values of 9.23 g/kWh, 8.91 g/kWh, 8.21 g/kWh and 7.6 g/kWh respectively. Conversely, the smoke emission is lower for CBD compared to the other tested fuels.

A bibliometric analysis was performed to assess historical and recent research trends regarding e-waste studies from 1998 to 2018. Documents related to e-waste were identified from the Clarivate Analytics Web of Science© (WoS) database, and a total of 3311 academic articles was retrieved. The analysis was performed from four main aspects: (1) publication activity by year, by WoS category, and by geographic distribution; (2) journals; (3) most-cited papers; and (4) top 10 countries and author keyword analysis. The number of publications concerning e-waste issues has increased substantially over the last 20 years, especially in the environmental science category, and more than a third of the publications were produced in China (1181 records). Waste Management and Environmental Science & Technology were the most sought-after journals for disseminating the results. Studies related to “e-waste flow analysis,” “recycling,” “recovery of precious metals,” and “risk assessment of recycling areas” have been the most common for several years. The analysis of keywords suggested that there are many topics on electronic waste and that each country has presented a different focus of research. Overall, the bibliometric analysis proved to be an efficient tool with which to monitor historical and current research trends and to evaluate the sheer volume of currently existing scientific literature on e-waste topics.

Washing of contaminated soils or sediments using humic substances (HS) extracted either from source-rich materials or compost has been tested effective to remove various heavy metals. Nevertheless, the remaining chemical fractionation of metals and post-washing biological responses were not discussed in previous research. In this study, we used a HS extracted from green waste compost to wash off Cd, As, and Ni from a contaminated sediment, and evaluated the washing effect on sediment microbes by measuring a series of indexes with regard to microbial biomass and enzyme activities. Results showed that HS washing was more effective in removing the cationic metals Cd and Ni than the anionic metal As. The highest HS dose of 2000 mg L⁻¹ resulted in 24.5-, 33.1-, and 12-fold increases of removal for Cd, Ni, and As, respectively. The remaining Cd and As were found to migrate to less stable fractions, whereas the remaining Ni was dominantly found in the residual fraction. Increases of metal removal efficiency, microbial biomass, and dehydrogenase activity were found to correlate with the increase of HS concentrations. Increasing doses of HS slightly altered sediment pH to the lower range but did not cause any significant effect on microbial activities. The study proves that HS washing is indeed a more environmental-friendly strategy than many existing washing agents which have exerted various side effects on soil properties.

A kinetic model describing Fenton and photo-Fenton degradation of paracetamol (PCT) and consumption of hydrogen peroxide (H₂O₂) was proposed. A set of Fenton and photo-Fenton experiments (18 runs in total) was performed by fixing the initial concentration of PCT to 40 mg L⁻¹ and varying the initial concentrations of H₂O₂ and ferrous ion, Fe²⁺. The experimental set-up was a well-stirred annular photoreactor equipped with an actinic BL TL-DK 36 W/10 1SL lamp. Experimental results highlighted that PCT is no more detected by HPLC analysis within a minimum reaction time of 2.5 and a maximum reaction time of 15.0 min. Besides, a maximum conversion of total organic carbon (TOC) of 68.5% was observed after 75 min of reaction in case of using UV radiation and the highest concentrations of the Fenton reagents. The experimental data were used to fit the kinetic model. The radiation field inside the reactor was taken into account through the local volumetric rate of photon absorption, evaluated by assuming a line source model with spherical and isotropic emission. The kinetic parameters were estimated by using a non-linear least-squares regression procedure and root mean square errors (RMSE) were calculated in order to validate the feasibility of the proposed model. A good agreement between experimental and predicted data was observed and the lowest values of RMSE resulted in 5.84 and 9.59% for PCT and H₂O₂ normalized concentrations, respectively.

The presence of pathogens in drinking water can seriously affect human health. Therefore, water disinfection is needed, but conventional processes, such as chlorination, result in the production of dangerous disinfection by-products. In this regard, an alternative solution to tackle the problem of bacterial pollution may be the application of advanced oxidation processes. In this work, the inactivation of total coliforms, naturally present in a Colombian surface water by means of UV/H₂O₂, UV/US, and the UV/US/H₂O₂ advanced oxidation processes, was investigated. Under the investigated conditions, complete bacterial inactivation (detection limit equal to 1 CFU 100 mL⁻¹) was found within 5 min of treatment by UV/H₂O₂ and UV/US/H₂O₂ systems. UV/US oxidation process also resulted in total bacterial load elimination, but after 15 min of treatment. Bacterial reactivation after 24 h and 48 h in the dark was measured and no subsequent regrowth was observed. This phenomenon could be attributed to the high oxidation capacity of the evaluated oxidation systems. However, the process resulting in the highest oxidation potential at the lowest operating cost, in terms of energy consumption, was UV/H₂O₂ system. Therefore, UV/H₂O₂ advanced oxidation system can be used for disinfection purposes, enabling drinking water production meeting the requirements of regulated parameters in terms of water quality, without incurring extremely high energy costs. Nonetheless, further researches are required for minimizing the associated electric costs.

In order to improve the catalytic properties of Fe₃O₄ nanoparticles in wastewater treatment, the Cu-doped Fe₃O₄/graphene oxide (Fe₃₋ₓCuₓO₄/GO) nanocomposites were prepared by a modified co-precipitation method and used as heterogeneous catalyst for p-Nitrophenol (p-NP) degradation. The effect of the GO and Cu contents in the nanocomposites was investigated. Compared with the unsupported Fe₃O₄ nanoparticles, the Fe₃O₄/GO nanocomposites have obviously improved catalytic performance, especially for the nanocomposite with 6.25 wt.% of the GO content. Furthermore, the catalytic efficiency is greatly improved by doping Cu in the nanocomposite. The Fe₃₋ₓCuₓO₄/GO nanocomposite achieves the best catalytic property in our catalyst system when the x value is about 0.075. Under the optimal reaction condition (0.8 g L⁻¹ of catalyst dosage, 15 mmol L⁻¹ of initial H₂O₂ concentration, 3.0 of pH value, and 30 °C of temperature), the p-NP conversion and chemical oxygen demand removal efficiencies in 120 min for the Fe₂.₉₂₅Cu₀.₀₇₅O₄/GO nanocomposite are about 98.4% and 74.7%, respectively. And the p-NP conversion efficiency is still as high as 96.2% after four recycles under the optimum condition. The results clearly show that the Fe₂.₉₂₅Cu₀.₀₇₅O₄/GO nanocomposite has outstanding catalytic properties for the p-NP degradation.

Brownfields have attracted increasing attentions from both researchers and practitioners. However, few studies have attempted to make a comprehensive and quantitative review on this topic. This study conducted a scientometric review on the brownfield research from 1995 to 2017 using CiteSpace. The knowledge structure, hot topics, research trends, and gaps were analyzed based on the co-author, co-word, co-citation, and clusters analysis. Six hundred thirty articles from the Web of Science core collection database were selected as the research samples. Results revealed that the research focus has changed from soil remediation technologies to sustainable regeneration methods. The most vital development in brownfield research occurred in the USA, England, Canada, Germany, and China. “Brownfield,” “heavy metal,” “remediation,” “redevelopment,” and “sustainability” were the most frequently used keywords. Whereas “management” and “biodiversity” received citation bursts in recent years. Existing researches mainly concentrated on subject categories of environmental sciences ecology, environmental sciences, engineering, environmental studies, engineering environmental, and urban studies. Sustainable regeneration, urban brownfields’ regeneration, mental distribution, coal-mine brownfield, and ecosystem service were the identified co-citation clusters and represented the hot topics and emerging trends. The research gaps can serve as a motivation to research on the next generation of brownfields to support the sustainable development. This study provides researchers and practitioners an extensive and intensive understanding of the salient research themes and trends of brownfields’ research worldwide.

In the present work, graphene oxide (GO) was synthesized via the modified Hummers method and utilized in treating real soil washing wastewater via adsorptive removal of lead (Pb) and zinc (Zn). Characterization analysis of GO was performed using X-ray diffraction, Brunauer-Emmett-Teller method, Fourier transform infrared spectroscopy, scanning electron microscopy, transmission electron microscopy, and zeta potential analysis. The Van’t Hoff, Eyring, and Arrhenius equations were applied to determine the activation and thermodynamic parameters namely activation energy (Eₐ), standard Gibbs energy change (ΔG°), standard enthalpy change (ΔH°), standard entropy change (ΔS°), change in activation Gibbs energy (ΔG#), change in activation enthalpy (ΔH#), and change in activation entropy (ΔS#). Based on the high coefficient of determination values (0.8882 ≥ R² ≥ 0.9094) and low values of SSE (0.0292 ≤ SSE ≤ 0.0511) and ARE (0.8014 ≤ ARE ≤ 0.8822), equilibrium data agreed well with the Freundlich isotherm. The maximum adsorption capacity for Pb(II) and Zn(II) was determined to be 11.57 and 4.65 mg/g, respectively. Kinetic studies revealed that pseudo-second-order equation fitted well with the experimental data, which indicates that chemisorption is the rate-determining step of the adsorption system. Results have shown the possibility of GO as a potential adsorbent material in the treatment of soil washing wastewater.