Of the wide variety of dumped objects containing radioactive materials in the Arctic seas, the submarine K-27 constitutes a major risk due to the large amount of highly enriched uranium onboard and its location in shallow waters. As the matter of potential operations involving raising of the submarine have entered the public arena, a priori assessment of the contamination in the Arctic marine environment that could result after a possible accident during such operations is a matter of some interest. The dispersion of contaminants within the Arctic has been assessed using a large scale hydrodynamic model for a series of plausible accident scenarios and locations under different oceanographic regimes. Results indicate that, depending primarily on the nature of a release (i.e. instantaneous or continuous), large areas of the Arctic marine environment will exhibit contamination to varying degrees.

CWs for combined sewer overflow treatment (CSO CWs) are vertical flow filters with detention basin and fixed outflow rate. They receive stochastic loadsinduced by urban runoff and protect natural waters against pollutants and streambed erosion. Thefull-scale site at Marcy l‘Etoile was monitored to gain data about hydrology and to quantify NH4-N adsorption capacities and nitrification rate. The throttled outlet ensuresa uniformflow in the porous media, butonly aftersaturation. Until then,the percolation is focused to the inletzone. As only a partof the filteris water-contacted and detention times are shorter than normal, removal performances are lower. The phenomenon is referred to as shortcutting, a temporary state at commencing load, which might last at low inflow rates. Eighteen TDR probes weredug in the longitudinal section of the filter to follow changes in the water content. This enabled to createan animation of the expansion of saturated area until complete saturation. Furthermore, tracer tests were carried out to signify shortcutting at different stages in the filter (Fig. 1).The filter was fed at the inlet point at a fixed and lowrate until saturation and three fluorescein pulses were dosed withidenticaldelay.The basin was flooded after to follow tracer passage and washout. Results were used to parameterizethemodel-based design-support tool Orage [1]and to suggest an improvementof the outflow limitationstructureto minimize shortcutting.

Constructed wetlands for combined sewer overflow treatment (CSO CWs) are variably saturated vertical flow filters in France. The design-support software Orage aims to facilitate engineering work by optimizing filter area and material sitespecifically which was otherwise encumbered by the stochasticity of CSO flows and concentrations. The optimization process relies on measured or simulated CSO series and a low number of input parameters. The iterative shell calls the core model repetitively. During the process, effluent flows and concentrations are simulated from a range of CW domains and compared to legislative thresholds. The iterative shell was tested both with measured and simulated inflows. First, key parameters of the hydraulic optimization were fixed. Large and underscaled designs are excluded this way and succeeding optimizations for pollutant removal are more efficient. Then, the optimization functions were verified using inflow and available land from an existing CSO CW. At third, the automatizations were used to test model predictions in the function of legislative thresholds. Zeolite-enriched media ensures high NH4-N removal at hydraulic loads exceeding the recommendations of present guidelines, marking clogging as an issue for further research. In summary, the demonstrated simulation experiments verified the optimization approach of the dynamic design tool Orage.

In recent years, unsaturated/saturated vertical flow constructed wetlands(VFCW) treating raw wastewateraregradually considered as apromising solution for their adaptation under various climatic conditions. These facilities provide surface optimization but alsobetter treatment efficiencies compare to classical French VFCW.The main performance improvements are: SS entrapment and carbon consumption for denitrification within saturated layer.When total nitrogen, by nitrification and denitrification,istargeted in the two successive zones, a design compromise has to be fund between nitrification efficiency and available carbon source for denitrification. As performance largely depends on unsaturated and saturated layers depths,a better understanding of their quantitative effects on treatment performance is essential for the adaptation of this system under various installation conditions. The aim of this study was to estimate the influence of these two linked design parameters onN efficiency with a focus onremoval limitations in regard to nitrogen loads. For this purpose, two different pilot-scale experimental configurations were designed: (i) 45 cm of unsaturated and 25 cm of saturated layers and (ii) 55 cm of unsaturated and 35 cm of saturated layers. The mature pilots were operated over 5 months using real wastewater with a feeding/resting period cycle of 3.5/3.5 days with a daily hydraulic load of 0.36 m d-1.In order to vary inlet nitrogen loads, ammonium nitrogen enrichments were added to vary loads from 10 to 40 g N m-2 d-1.24h flow composite samples at inlet and outlet of each pilot were semiweekly collected and analyzed for the following parameters: total suspended solids (TSS), total and dissolved chemical oxygen demand (COD), Kjeldahl nitrogen (TKN), ammonium, nitrate, phosphate and sulfate. Online measurement on a minute time step were done for inlet/outlet flows, oxygen content at three different depths, outlet ammonium and nitrate concentrationsby ion specific probes, and temperature. The paper will present the performance and limitations ofthe two configurations.Dynamics of nitrogen removal processes will be discussed in relation to physicochemical conditions (temperature, oxygen content, hydraulic retention time, carbon sources, etc.).

The AZTI’s marine biotic index (AMBI), an ecological indicator for managing estuarine and coastal waters worldwide, was tested in two fjords in Chilean Patagonia. The Aysen Fjord (42° Lat. S) supports intensive salmon farming in coastal ecosystems, while the Baker Fjord (48° Lat. S) is currently just beyond the limit of the southern expansion of salmon concessions. The ecological status of the Aysen Fjord was classified as good, while the status of the Baker Fjord was classified as high and unbalanced. These differences were consistent with our expectations, illustrating the effect of local environmental conditions and human activities, combined with river inputs into semi-confined fjords. This method is appropriate for the evaluation of the ecological status of the fjords, but requires a sufficient amount of data for the robust environmental assessment as proposed by the Water Framework Directive (WFD).

The MAPPE GIS based multimedia model is used to produce a quantitative description of the behaviour of γ-hexachlorocyclohexane (γ-HCH) in Europe, with emphasis on continental surface waters. The model is found to reasonably reproduce γ-HCH distributions and variations along the years in atmosphere and soil; for continental surface waters, concentrations were reasonably well predicted for year 1995, when lindane was still used in agriculture, while for 2005, assuming severe restrictions in use, yields to substantial underestimation. Much better results were yielded when same mode of release as in 1995 was considered, supporting the conjecture that for γ-HCH, emission data rather that model structure and parameterization can be responsible for wrong estimation of concentrations. Future research should be directed to improve the quality of emission data. Joint interpretation of monitoring and modelling results, highlights that lindane emissions in Europe, despite the marked decreasing trend, persist beyond the provisions of existing legislation. An spatially-explicit multimedia modelling strategy was applied to describe the historical distribution of γ-HCH in European soils and surface waters.

peer reviewed | Foliar analysis was undertaken in two plots of Picea abies (L.) Karst., located in a watershed of Haute Ardenne, Belgium, in order to estimate the decline of the trees. Apart from a general Mg deficiency, the concentrations of the needles were in the same range as those determined in other European stands. Comparisons between healthy and declining trees within each plot revealed a general pattern of decline similar to that observed elsewhere in Western Europe. This was shown as lower Ca, Mg, Zn concentrations and water content and higher N and P concentrations of the needles collected from declining trees. It is concluded that this decline could be due to N over fertilization by the atmospheric deposition. The difference of decline between the two plots was attributed to the turnover rate of the soil organic layer which was less intensive in the most damaged plot.