Flows and transport of sediment and associated chemical constituents within the lower reaches of the Athabasca River between Fort McMurray and Embarrass Airport are investigated using a two-dimensional (2D) numerical model called Environmental Fluid Dynamics Code (EFDC). The river reach is characterized by complex geometry, including vegetated islands, alternating sand bars and an unpredictable thalweg. The models were setup and validated using available observed data in the region before using them to estimate the levels of cohesive sediment and a select set of chemical constituents, consisting of polycyclic aromatic hydrocarbons (PAHs) and metals, within the river system. Different flow scenarios were considered, and the results show that a large proportion of the cohesive sediment that gets deposited within the study domain originates from the main stem upstream inflow boundary, although Ells River may also contribute substantially during peak flow events. The floodplain, back channels and islands in the river system are found to be the major areas of concern for deposition of sediment and associated chemical constituents. Adsorbed chemical constituents also tend to be greater in the main channel water column, which has higher levels of total suspended sediments, compared to in the flood plain. Moreover, the levels of chemical constituents leaving the river system are found to depend very much on the corresponding river bed concentration levels, resulting in higher outflows with increases in their concentration in the bed sediment.

Neonicotinoid pesticides were first introduced in the mid-1990s, and since then, their use has grown rapidly. They are now the most widely used class of insecticides in the world, with the majority of applications coming from seed dressings. Neonicotinoids are water-soluble, and so can be taken up by a developing plant and can be found inside vascular tissues and foliage, providing protection against herbivorous insects. However, only approximately 5% of the neonicotinoid active ingredient is taken up by crop plants and most instead disperses into the wider environment. Since the mid-2000s, several studies raised concerns that neonicotinoids may be having a negative effect on non-target organisms, in particular on honeybees and bumblebees. In response to these studies, the European Food Safety Authority (EFSA) was commissioned to produce risk assessments for the use of clothianidin, imidacloprid and thiamethoxam and their impact on bees. These risk assessments concluded that the use of these compounds on certain flowering crops poses a high risk to bees. On the basis of these findings, the European Union adopted a partial ban on these substances in May 2013. The purpose of the present paper is to collate and summarise scientific evidence published since 2013 that investigates the impact of neonicotinoids on non-target organisms. Whilst much of the recent work has focused on the impact of neonicotinoids on bees, a growing body of evidence demonstrates that persistent, low levels of neonicotinoids can have negative impacts on a wide range of free-living organisms.

We conducted a 60-day roadside measurement campaign on a busy street in Münster, Germany, during summer 2016. We used gas and particle concentration measurements with high temporal resolution (10 Hz) to quantify both the emission ratios of nitrogen oxides per carbon dioxide (NO ₓ /CO₂) for over 70,000 individual exhaust plumes as well as the emission ratios for size-resolved particle numbers per carbon dioxide (d(PN CO₂ ⁻¹)/dlogD) for about 10,000 plumes. The real-world fleet passing by the measurement station consisted of passenger cars (85%), buses (5.9%), light duty commercial vehicles (5.7%), trucks (1.7%), and motorcycles (1.6%). The median measured NO ₓ /CO₂ ratio was 3.33 g kg⁻¹. The median measured PN/CO₂ emission ratio for particles with diameters between 0.03 and 10 μm was 5.6 × 10¹⁴ kg⁻¹. We compared our results with the Handbook Emission Factors for Road Transport (HBEFA) and the Euro 5 and Euro 6 emission standards by employing traffic counts, assuming the diesel-to-gasoline ratios of vehicles according to registration statistics, and estimating that stop-and-go traffic occurred 65% of the time. Using a conservative estimate, our median ratios exceeded the HBEFA data by more than 65% for NO ₓ /CO and by a factor of about 100 for PN/CO₂. Furthermore, our median NO ₓ emission per kilometer travelled (NO ₓ km⁻¹) exceeded the Euro 5 emission limit for diesel cars by a factor of 3 and exceeded the Euro 6 limit by almost a factor of 7. Additionally, our median particle number emission (PN km⁻¹) exceeded the Euro 5 and Euro 6 limits of diesel cars by a factor of almost 150. These results confirm the presumption that the emissions of a real-world traffic fleet comprehensively exceed the legal limits. Very likely, the widespread presence of defeat devices in vehicle emission control systems plays a major role in this discrepancy. This has a strong impact on the apparent inability of authorities to comply with the legal limits of the NO₂ concentrations in urban air.

Veterinary antibiotics could enter the environment after the application of manure or farm wastewater on soil as fertilizer. In this study, a UPLC-MS/MS analytical method was developed and validated for the simultaneous determination of enrofloxacin (ENR) and ciprofloxacin (CIP) at environmental relevant concentrations in piggery wastewater, piggery wastewater solids, agricultural soil and ground water with good performance characteristics. The method recovery for ENR and CIP was 94.2 and 89.9% in the filtered piggery wastewater, 81.3 and 82% in the wastewater solid material, 78.1 and 76.8% in the soil and 95.6 and 97.3% in the ground water. The Limit of Detection (LOD) and Limit of Quantification (LOQ) for ENR were 21 and 64 ng L⁻¹ and for CIP was 18 and 54 ng L⁻¹, respectively. The method was implemented to monitor ENR and CIP in the wastewater of a piggery facility in Cyprus which applied anaerobic treatment before the final disposal of the reclaimed water. The highest antibiotic concentrations were measured in the wastewater samples collected from the nursery, where ENR is continuously used, with average concentration 31.4 μg L⁻¹ for ENR and 16.0 μg L⁻¹ for CIP. After the anaerobic digester, the two antibiotics were found only on the solid matter of the treated wastewater with an average concentration of 1.7 μg kg⁻¹ for ENR and 1.0 μg kg⁻¹ for CIP. The antibiotics adsorption at pH = 7 on clay soil, quartz sand and on solid matter isolated from the piggery wastewater was found to be higher than 95% for all solid materials. The concentration of the antibiotics in soil samples taken from a field where reclaimed piggery wastewater was applied for 10 years and in samples of groundwater from a nearby well was found for all samples below the LOD.

This paper presents a model to analyze the mechanism of the global contribution of energy usage by product exports. The theoretical analysis is based on the perspective that contribution estimates should be in relatively smaller sectors in which the production characteristics could be considered, such as the productivity distribution for each sector. Then, we constructed a method to measure the global contribution of energy usage. The simple method to estimate the global contribution is the percentage of goods export volume compared to the GDP as a multiple of total energy consumption, but this method underestimates the global contribution because it ignores the structure of energy consumption and product export in China. According to our measurement method and based on the theoretical analysis, we calculated the global contribution of energy consumption only by industrial manufactured product exports in a smaller sector per industry or manufacturing sector. The results indicated that approximately 42% of the total energy usage in the whole economy for China in 2013 was contributed to foreign regions. Along with the primary products and service export in China, the global contribution of energy consumption for China in 2013 by export was larger than 42% of the total energy usage.

Phosphorus (P) adsorpted by sediments, when covered by and mixed with ignited sediments from Meiliang Bay in Tai Lake, was analyzed in the laboratory. Potassium dihydrogen phosphate (KH₂PO₄) was added to the parallel experimental units to simulate periodic external P input. Based on the Langmuir model, the sediments after ignition had a greater Sₘₐₓ (maximum P adsorption), a lower equilibrium phosphorus concentration at zero adsorption (EPC₀), and a lower degree of phosphorus saturation in comparison with sediments without ignition. This was confirmed by the variation in the dissolved inorganic phosphorus in the overlying water. When sediments were mixed with or covered by the ignited sediments, 5.985 and 5.978 mg of input P disappeared from the overlying water, respectively. However, when the sediments were mixed with the ignited sediments, 84.18% of the input P was converted to HCl-P, whereas when they were covered by the ignited sediments, sedimentary P was released, mainly from Fe/Al-P (up to 87.50%). This was attributed to differences in the microenvironments where less-intense anaerobic conditions were formed in the mixed sediments than in the sediments covered by the ignited sediments. This suggests that the injection of ignited sediments into existing sediments enhances their P adsorption and retention. It is favor of the control of the eutrophication with a simple technology.

The aim of the study was to compare the phytoextraction abilities of six tree species (Acer platanoides L., Acer pseudoplatanus L., Betula pendula Roth, Quercus robur L., Tilia cordata Miller, Ulmus laevis Pall.), cultivated on mining sludge contaminated with arsenic (As), cadmium (Cd), copper (Cu), lead (Pb), thallium (Tl), and zinc (Zn). All six tree species were able to survive on such an unpromising substrate. However, A. platanoides and T. cordata seedlings grown on the polluted substrate showed significantly lower biomass than control plants (55.5 and 45.6%, respectively). As, Cd, Cu, Pb, and Tl predominantly accumulated in the roots of all the analyzed tree species with the following highest contents: 1616, 268, 2432, 547, and 856 mg kg⁻¹, respectively. Zn was predominantly localized in shoots with the highest content of 5801 and 5732 mg kg⁻¹ for U. laevis and A. platanoides, respectively. A. platanoides was the most effective in Zn phytoextaction, with a bioconcentration factor (BCF) of 8.99 and a translocation factor (TF) of 1.5. Furthermore, with the exception of A. pseudoplatanus, the analyzed tree species showed a BCF > 1 for Tl, with the highest value for A. platanoides (1.41). However, the TF for this metal was lower than 1 in all the analyzed tree species. A. platanoides showed the highest BCF and a low TF and could, therefore, be a promising species for Tl phytostabilization. In the case of the other analyzed tree species, their potential for effective phytoextraction was markedly lower. Further studies on the use of A. platanoides in phytoremediation would be worth conducting.

In recent years, international research on the toxicity of the heavy metal, antimony, has gradually changed focus from early medical and pharmacological toxicology to environmental toxicology and ecotoxicology. However, little research has been conducted for sources identification and risk management of heavy metals pollution by long-term antimony mining activities. In this study, a large number of investigations were conducted on the temporal and spatial distribution of antimony and related heavy metal contaminants (lead, zinc, and arsenic), as well as on the exposure risks for the population for the Yuxi river basin in the Hunan province, China. The scope of the investigations included mine water, waste rock, tailings, agricultural soil, surface water, river sediments, and groundwater sources of drinking water. Health and ecological risks from exposure to heavy metal pollution were evaluated. The main pollution sources of heavy metals in the Yuxi River basin were analyzed. Remediation programs and risk management strategies for heavy metal pollution were consequently proposed. This article provides a scientific basis for the risk assessment and management of heavy metal pollution caused by antimony basin ore mining.

With an exponential increase in urbanization and industrialization, water pollution is an inevitable consequence of relatively lagging wastewater treatment facilities. The conventional activated sludge process for wastewater treatment primarily emphasizes the removal of harmful substances to maintain increasingly stringent effluent discharged standards, which is considered an energy-intensive technique. Therefore, innovative and sustainable wastewater treatment should pay more attention to energy and resource recovery in dealing with fossil fuel depletion, global-scale energy security, and climate change. A bibliometric analysis was applied to trace wastewater-energy nexus-related research during the period 1991 to 2015, with respect to the Science Citation Index EXPANDED (SCI-EXPANDED) database. Journal of Hazardous Materials, ranking 1st in h-index (79), was the most productive journal (431, 4.5%) during the same time, followed by International Journal of Hydrogen Energy (422, 4.4%) and Water Research (393, 4.1%) journal, the latter owning a topmost journal impact factor. Though, China (2154, 22.5%) was the most productive country, while the USA with highest h-index (88) was the favorest collaborative country. The Chinese Academy of Sciences, China (241, 2.5%) produced the maximum publications. A novel method called “word cluster analysis” showed that the emerging sustainable processes and novel renewable energy application are applied in response to the desire for a net wastewater-energy nexus system. Based on different wastewater types, the emerging energy and sources recovery treatment processes of Anammox, anaerobic digestion, and microbial fuel cells gained extensive innovation. Evaluation indicators including sustainability, life cycle assessment, and environmental impact were appropriately used to dissert feasibility of the novel treatment methods in regard of renewable energy utilization, energy savings, and energy recovery. The transformation of the new concept of “broaden income source, economize on expenditures and exploit inner potential” should be generalized in order to achieve an environmentally sustainable development of wastewater-energy nexus system.

With the concerns of ecological and circular economy along with sustainable development, reverse logistics has attracted the attention of enterprise. How to achieve sustainable development of reverse logistics has important practical significance of enhancing low carbon competitiveness. In this paper, the system boundary of reverse logistics carbon footprint is presented. Following the measurement of reverse logistics carbon footprint and reverse logistics carbon capacity is provided. The influencing factors of reverse logistics carbon footprint are classified into five parts such as intensity of reverse logistics, energy structure, energy efficiency, reverse logistics output, and product remanufacturing rate. The quantitative research methodology using ADF test, Johansen co-integration test, and impulse response is utilized to interpret the relationship between reverse logistics carbon footprint and the influencing factors more accurately. This research finds that energy efficiency, energy structure, and product remanufacturing rate are more capable of inhibiting reverse logistics carbon footprint. The statistical approaches will help practitioners in this field to structure their reverse logistics activities and also help academics in developing better decision models to reduce reverse logistics carbon footprint.