Microplastics are ubiquitous in the marine environment but characterizing them in marine organisms is challenging. Herein we describe a method to detect, identify, and quantify microplastics in marine mussels (Mytilus edulis) using thermal gravimetric analysis – Fourier Transform infrared spectroscopy – gas chromatography mass spectrometry (TGA-FTIR-GC/MS) after extracting and isolating the microplastics using chemical digestion, density separation, and filtration. Combining the three instrumental techniques adds discriminatory power as temperature profiles, chromatograms, and vibrational and mass spectra differ among common plastics. First, we tested several digestion schemes after spiking the mussels with plastics commonly found in the marine environment, including polyethylene (PE), polystyrene (PS), polypropylene (PP) and polyvinyl chloride (PVC). KOH (10%, w/v) was the most suitable reagent, providing good recoveries (>97%) without degrading the microplastics. We show that the technique TGA-FTIR-GC/MS can be optimized to readily determine both the type (polymer) and amount (mass) of microplastics in the sample. Applied to 100 mussels from each of six locations along the coast of China, we found an average of 0.58 mg of plastic per kg of tissue (range 0.16–1.71 mg/kg), with PE being the most abundant type of plastic measured. Among the coastal cities, mussels from Dalian had the highest microplastic content. Overall, we demonstrate that the method is a powerful technique to quantify masses of microplastics in marine mussels, a species commonly used as a bioindicator of pollution, and may be applied to other biota as well.

Heavy metal risks to human health in farmland of wastewater-irrigated areas have long been recognized. It remains to be shown whether farmland heavy metals from wastewater irrigation can migrate to deeper soil at a regional scale. In this study, nine soil cores deep to 30 m from three transects (A, B and C) of a linear wastewater reservoir and the adjacent farmland topsoils and wheat grains were sampled. Heavy metals including As, Cd, Cr, Cu, Pb and Zn in the soils and wheat grains were determined, and the grains’ health risks were assessed using the Target Hazard Quotient (THQ). Considerably high contents of heavy metals in both total and soluble forms were detected in deep soils, especially for the transect B where total As of 73.0 mg kg⁻¹ at 29 m, Cd of 3.80 mg kg⁻¹ at 13 m and Pb of 214 mg kg⁻¹ at 30 m were detected. The silty clayey and silty layers of the transect B had higher contents of As, Cr, Cu, Pb and Zn compared with the sandy layers. Across the studied area, 19.5%–34.1% of the topsoil samples were contaminated by As, Cd, Cu, Pb and Zn, and 34.1% and 19.5% of the wheat grains were contaminated by Cd and Pb, respectively. Wheat grains from all the sampling sites had a combined target hazard quotient (TTHQ) value of >1, with As and Cd being the most important contributors. Our study revealed a wider and deeper risk of typical heavy metals originated from long-term wastewater irrigation in the sampling area, which may pose substantial health risks to the local residents via wheat grains and groundwater.

The well-known toxicity of conventional chemical oil spill dispersants demands the development of alternative and environmentally friendly dispersant formulations. Therefore, in the present study we have developed a pair of less toxic and green dispersants by combining lactonic sophorolipid (LS) biosurfactant individually with choline myristate and choline oleate ionic liquid surfactants. The aggregation behavior of resulted surfactant blends and their dispersion effectiveness was investigated using the baffled flask test. The introduction of long hydrophobic alkyl chain with unsaturation (attached to choline cation) provided synergistic interactions between the binary surfactant mixtures. The maximum dispersion effectiveness was found to be 78.23% for 80:20 (w/w) lactonic sophorolipid-choline myristate blends, and 81.15% for 70:30 (w/w) lactonic sophorolipid-choline oleate blends at the dispersant-to-oil ratio of 1:25 (v/v). The high dispersion effectiveness of lactonic sophorolipid-choline oleate between two developed blends is attributed to the stronger synergistic interactions between surfactants and slower desorption rate of blend from oil-water interface. The distribution of dispersed oil droplets at several DOR were evaluated and it was observed that oil droplets become smaller with increasing DOR. In addition, the acute toxicity analysis of developed formulations against zebra fish (Danio rerio) confirmed their non-toxic behavior with LC₅₀ values higher than 400 ppm after 96 h. Overall, the proposed new blends/formulations could effectively substitute the toxic and unsafe chemical dispersants.

Microplastics are widespread in the aquatic environment and thus available for many organisms at different trophic levels. Many scientific papers focus their attention on the study of the effects of microplastics on different species at individual level. Here we performed a global scale meta-analysis focusing our work on the study of the effect of microplastics on the functional traits of aquatic benthic organisms. Overall, microplastics showed a moderate negative effect on the examined functional traits of benthic organisms. Our results show that some crucial functional traits, such as those linked to behaviour and feeding, appear to be unaffected by microplastics. In contrast, traits related to the capacity of organisms to assimilate energy are affected. Moreover, traits with possible effects at population level appear to be negatively affected by microplastics. We discuss how the direct impact of organismal performance may have indirect repercussions at higher levels in the ecological hierarchy and represent a risk for the stability and functioning of the ecosystem.

The tannery industries utilize environmentally hazardous chemicals to achieve dehairing of animal hides, which causes enormous waterbed pollution & high TDS load. Alkaline protease enzyme for dehairing can be an effective solution to resolve the environmental problems of the tannery industry waste. However, stable, cost-efficient and eco-benign formulations of alkaline protease need to be developed for commercial applications in the tannery industry. This works aimed at development of a nano-formulation of the enzyme alkaline protease (AKP) as a bioconjugate nano silica-alkaline protease enzyme (BC–SiNP-AKP). This work reports one pot green synthesis of the BC-SiNP-AKP bionanoconjugate complex which included both biotemplating and immobilization of the AKP on to the synthesized silica nanoparticles from cell-free extracts of Bacillus circulans grown in potato peel based medium. Among the cell free crude, acetone concentrated and purified sols of the enzyme AKP, acetone precipitated enzyme sol was found to be best for the biological SiNP synthesis and formation of BC-SiNP-AKP conjugate. The BC-SiNP-AKP had size ranging from 100 to 200 nm with crystalline morphologies varying from spherical, tubular to laminated crystallites. The developed bioconjugate formulation displayed 1.7-fold increase in the enzyme activity post nano-conjugation with superlative dehairing potential on goat skin. The optimized parameters for dehairing were found to be as temperature 37 °C for 24 h of incubation and with enzyme to buffer ratio (2: 50 mL). Thereafter, the dehaired skin was assessed for its histopathological effects, which were found to be safe without any deteriorative changes. The developed formulation is environmentally congenial for its use as depilating agent for animal hides in terms of being green, single pot and cost effective synthesis.

Microorganisms able to form biofilms in marine ecosystems are selected depending on immersed surfaces and environmental conditions. Cell attachment directly on toxic surfaces like antifouling coatings suggests a selection of tolerant (or resistant) organisms with characteristics conferring adaptive advantages. We investigated if environment would drive metal resistance gene abundance in biofilms on artificial surfaces. Biofilms were sampled from three surfaces (a PVC reference and two antifouling coatings) deployed in three coastal waters with dissimilar characteristics: The Mediterranean Sea (Toulon) and Atlantic (Lorient) and Indian (Reunion) Oceans. The two coatings differed in metals composition, either Cu thiocyanate and Zn pyrithione (A3) or Cu2O (Hy). Metal resistance genes (MRG) specific to copper (cusA, copA, cueO) or other metals (czcA and pbrT) were monitored with qPCR in parallel to the microbial community using 16S rRNA gene metabarcoding. A lower α-diversity on A3 or Hy than on PVC was observed independent on the site. Weighted Unifrac suggested segregation of communities primarily by surface, with lower site effect. Metacoder log2 fold change ratio and LeFSe discrimination suggested Marinobacter to be specific of Hy and Altererythrobacter, Erythrobacter and Sphingorhabdus of A3. Likewise, the relative abundance of MRG (MRG/bacterial 16S rRNA) varied between surfaces and sites. A3 presented the greatest relative abundances for cusA, cueO and czcA. The latter could only be amplified from A3 communities, except at Toulon. Hy surface presented the highest relative abundance for copA, specifically at Lorient. These relative abundances were correlated with LeFSe discriminant taxa. Dasania correlated positively with all MRG except cueO. Marinobacter found in greater abundance in Hy biofilm communities correlated with the highest abundances of copA and Roseovarius with czcA. These results prove the selection of specific communities with abilities to tolerate metallic biocides forming biofilms over antifouling surfaces, and the secondary but significant influence of local environmental factors.

Neonicotinoids (NEOs) have become the most widely used insecticides in the world. However, information on the NEO concentrations in tap water based on nationwide surveys is limited in China. In this study, the levels of six NEOs were measured in tap water samples collected from 38 cities in China. Across all sampling locations, the overall frequency of detection for at least one NEO was 100%, indicating that NEOs are ubiquitous in tap water from China. Imidacloprid was the most abundant NEO (median: 7.59 ng/L), followed by (in decreasing order) clothianidin (5.46 ng/L), dinotefuran (4.55 ng/L), thiamethoxam (4.50 ng/L), acetamiprid (2.72 ng/L), and thiacloprid (0.38 ng/L). Significantly positive correlations (r = 0.655–0.902, p < 0.001) among all pairs of NEOs were observed, which showed that the sources of NEOs in tap water were common or related. Across all sampling locations, regional differences in concentrations (ΣNEOs; sum of six NEOs varied from 0.79 ng/L to 415 ng/L) were observed within China, showing an increasing trend from northern to southern China. Although the estimated daily intake of NEOs were much lower than the reference dose, the potential health risk of NEOs via tap water consumption should raise more public concern considering the high detection rates of NEOs in tap water.

The Peace-Athabasca Delta (PAD) receives a mixture of hydrocarbons from biogenic, pyrogenic, and petrogenic processes. Source apportionment in the PAD has focussed on polycyclic aromatic compounds (PACs), which are ubiquitous in the environment and susceptible to weathering. In contrast, petroleum biomarkers of terpanes, hopanes, and steranes are degradation-resistant organic compounds found uniquely in petroleum products that can identify the input and origin of petrogenic hydrocarbons (PHCs). We provide an analysis of environmentally-relevant PHCs (including n-alkanes, PACs, and petroleum biomarkers) in surficial sediments of strategically selected lakes in the Athabasca and Peace deltas and adjacent boreal uplands. Alkanes were found to be predominately biogenic in all lakes. PAC sources were identified as wood combustion in the upland boreal lakes, a mixture of petrogenic and pyrogenic combustion in two closed-drainage lakes in the Peace Delta, and predominately petrogenic in two flood-prone Athabasca Delta lakes. Using multivariate analyses, raw Alberta oil sands were identified as a potential source of PHCs to the two flood-prone lakes in the Athabasca Delta. Biomarkers of terpanes and hopanes were identified in the Peace Delta and boreal uplands, likely from bitumen and transported atmospherically. These findings validate the use of petroleum biomarkers as tracers for bituminous sands in surficial lake sediments and their potential use in paleolimnological investigations at the PAD to improve understanding of relative roles of natural and industrial processes on far-field deposition of PHCs.

The response of freshwater invertebrates following accidental releases of oil is not well understood. This knowledge gap is more substantial for unconventional oils such as diluted bitumen (dilbit). We evaluated the effects of dilbit on insect emergence and benthic invertebrates by conducting experimental spills in limnocorrals (10-m diameter; ~100-m³) deployed in a boreal lake at the IISD-Experimental Lakes Area, Canada. The study included seven dilbit treatments (spill volumes ranged from 1.5 L [1:66,000, oil:water, v/v] to 180 L [1:590, oil:water, v/v]), two controls, and additional lake reference sites, monitored for 11 weeks. Invertebrate emergence declined at the community level following oil addition in a significantly volume-dependent manner, and by 93–100 % over the 11 weeks following the spill in the highest treatment. Dilbit altered community structure of benthic invertebrates, but not abundance. One-year post-spill and following oil removal using traditional skimming and absorption techniques, benthic richness and abundance were greater among all treatments than the previous year. These results indicate that recovery in community composition is possible following oil removal from a lake ecosystem. Research is needed concerning the mechanisms by which surface oil directly affect adult invertebrates, whether through limiting oviposition, limiting emergence, or both. The response of benthic communities to sediment tar mats is also warranted.

The increasing demand for fresh water coupled with the need to recycle water and nutrients has witnessed a global increase in wastewater irrigation. However, the development of antibiotic resistance hotspots in different environmental compartments, as a result of wastewater reuse is becoming a global health concern. The effect of irrigation water sources (wastewater, surface water, fresh water) on the presence and abundance of antibiotic resistance genes (ARGs) (blaCTX₋ₘ₋₃₂, tet-W, sul1, cml-A, and erm-B) and class 1 integrons (intI1) were investigated in the irrigation water-soil-crop continuum using quantitative real-time PCR (qPCR). Sul1 and blaCTX₋ₘ₋₃₂ were the most and least abundant ARGs in three environments, respectively. The abundance of ARGs and intI1 significantly decreased from wastewater to surface water and then fresh water. However, irrigation water sources had no significant effect on the abundance of ARGs and intI1 in soil and crop samples. Principal component analysis (PCA) showed that UV index and air temperature attenuate the abundance of ARGs and intI1 in crop samples whereas the air humidity and soil electrical conductivity (EC) promotes the ARGs and intI1. So that the climate condition of semi-arid regions significantly affects the abundance of ARGs and intI1 in crop samples. The results suggest that treated wastewater might be safely reused in agricultural practice in semi-arid regions without a significant increase of potential health risks associated with ARGs transfer to the food chain. However, further research is needed for understanding and managing ARGs transfer from the agricultural ecosystem to humans through the food chain.