Per- and polyfluoroalkyl Substances (PFAS) are ubiquitous in the environmental matrix, and their eco-toxicity on wide life and health risks on humans arising concerns. Due to the information gap, current risk assessments of PFAS ignore the indoor exposure pathway such as indoor dust and the different sources of drinking water. We collected and analyzed 168 indoor dust and 27 drinking water samples (including tap water, filtered water and bottled water). The mean concentrations of six typical PFAS measured in indoor dust and drinking water are in the range of 15.13–491.07 ng g⁻¹ and 0.31–4.14 ng L⁻¹, respectively. For drinking water, PFOA and PFOS were the dominant compounds, while PFHxS was the most abundant in indoor dust. Short-chain PFAS concentrations were higher than long-chain PFAS in both drinking water and indoor dust. Higher concentration of PFAS was observed in tap water and filtered water than bottled water. The total daily intake (TDI) of six PFAS are 20.67–52.97 ng kg⁻¹ d⁻¹ for infants, children, teenagers, and adults. As to children, teenagers, and adults, perfluorooctanoate (PFOA) is the major compound, accounting for 72.9–74.7% of the total daily intake. And PFOA (38.7%) and perfluorooctane sulfonate (PFOS, 42.2%) are the dominant PFAS for infants. The quantitative proportions of exposure sources are firstly revealed in this study, which in the order of foodstuff > indoor dust > drinking water > indoor air. Although the contribution to the PFAS intake of drinking water and indoor dust was not predominant (<9%), the health risks caused by long-term exposure need our attention. The hazard quotient (HQ) values of total PFAS were in the range of 0.154–0.498, which suggesting the relatively lower exposure risk in Chinese population. This study provides important reference to understand PFAS exposure status other than foodstuff.

Microplastics exhibit active environmental behavior and unique surface characteristics, and act as carriers for the migration of trivalent arsenic (As(III)) in the environment. Herein, the mechanism by which polytetrafluoroethylene (PTFE) microplastic particles adsorb As(III) is systematically determined. The larger the size of PTFE particles, the smaller the specific surface area, the higher the point of zero charge (PZC), and the more unfavorable adsorption of As(III); the highest adsorption amount can reach 1.05 mg g⁻¹. The adsorption process can be divided into three stages by the intraparticle diffusion model: external mass transfer, intraparticle diffusion, and dynamic equilibrium, of which the external mass transfer stage is the adsorption rate-limiting stage. The Langmuir isotherm model better represented the equilibrium adsorption results. The adsorption of As(III) by PTFE was an exothermic process, and because the increase in temperature broke the hydrogen bond, the amount of adsorption was decreased, which was not conducive to spontaneous adsorption. In the pH range of 3–7, as the pH value increased, the amount of As(III) adsorbed by PTFE gradually decreased, which may be related to the change in PZC for PTFE and the protonation of As(III). The H on the surface hydroxyl group of the PTFE exhibited a very large positive potential (+82.37 kcal mol⁻¹). Thus, it can attract the arsenic oxyanion, and As(III) was subsequently adsorbed on the surface of the PTFE through the hydrogen bond on the hydroxyl group. Electrostatic force and non-covalent interaction were the key mechanisms affecting the PTFE adsorption.

The sediment characterisation of wetlands belonging to the Northeastern Region of India particularly regarding the assessment of sediment carbon stock is very scanty. The presently available literature on the wetlands cannot be employed as a common model for managing the wetlands of the Northeastern Region of India as wetlands are a sensitive ecosystem with a different origin or endogenous interventions. Thereby, this research was conducted on Deepor Beel for investigating the spatial and seasonal variation of sediment parameters, the relationship between the parameters and pollution status of the wetland. Results revealed that the study area is of an acidic nature with a sandy clay loam type texture. Organic carbon, total nitrogen and available nitrogen were higher in sediments in the monsoon period. The mean stock of the sediment carbon pool of Deepor Beel is estimated to be 2.5 ± 0.7 kg m−2. The average non-residual fraction percentage (63.2%) of Pb was higher than the residual fraction. Zn content ∼490 mg kg−1 exceeding its effect range medium (ERM) was determined to suggest frequent biological adverse effects. Highest metal enrichment factor (EF) values were shown by Zn and Pb, which ranged between 78 and 255. Risk assessment code (RAC) values of Pb between 21 and 29% indicated its high bio-accessibility risk. Pearson's coefficient matrix revealed a low degree of positive correlation between organic carbon content and metal concentration. Principal component analysis revealed that the first component comprising of EC, basic cations and metals accounted for 62.3% of variance while the second component (OM, OC, TN, AN, AP) and the third component (pH) accounted for 21.8% and 7.0% of the variance, respectively. The present study revealed the adverse impact of human inputs on the Deepor Beel quality status.

From a health prospective, it is critical to provide a comprehensive model which integrates all the parameters involved in virus transmission and its consequences on human body. In order to estimate the health risks, for workers and residents, associated with an exposure airborne viruses emitted from a wastewater treatment (WWTP), the concentration levels of viruses in emitted bioaerosols over a twelve-month period were measured by real-time polymerase chain reaction (RT-PCR). A combined Gaussian plum dispersion model and quantitative microbial risk assessment (QMRA) with Monte-Carlo simulation served as suitable explanatory tools to estimate the risk of acquiring gastrointestinal illness (GI) due to exposure to air containing Rotavirus (RoV) and Norovirus (NoV) bioaerosols. Additionally, DALY metric was applied to quantify the disability and mortality for workers and residents. RoV and NoV were detected above aeration tank with annual mean concentration 27 and 3099 (Viruses/m³.h), respectively. The medium calculated DALY indicator based on viral loads in contaminant source (RoV:5.76 × 10⁻² and NoV:1.23 × 10⁻¹) and estimated in different distances away (300–1000 m) (RoV:2.87 × 10⁻²- 2.75 × 10⁻² and NoV:1.14 × 10⁻¹-1.13 × 10⁻¹) were markedly higher than the threshold values recommended by US EPA (10⁻⁴ DALY pppy) and WHO (10⁻⁶ DALY pppy). The sensitivity analysis highlighted dose exposure and disease burden per case (DBPC) as two most influential factors for both workers and residents following exposure to two pathogens of concern. Due to high resistance and high concentration in the environment, the presence of RoV and NoV can intensify the consequences of diarrhea especially for children under five years of age; A comprehensible and transparent presentation of DALYs and QMRA can help decision makers and responsibilities to justify the priorities of exposure to wastewater in comparison with other risks of daily life.

Persistent organic pollutants (POPs), including Perfluoroalkyl substances (PFASs), enter into the marine ecosystem, raising questions on possible adverse effects caused to the health of marine organisms and especially of top predators. Thus, there is an urge to assess the occurrence and the tissue distribution of PFASs in apex predators. To this end, the current study examines concentrations and distribution of 15 PFASs among 85 samples of different tissues from 9 shark and ray species collected in Greece. The results showed a similar PFAS pattern among the different tissues, with long carbon chain PFASs being the most frequently detected compounds. PFTrDA was the most predominant compound in terms of concentration and frequency of detection, followed by PFUnDA and PFOS. PFTrDA concentrations ranged between < LOQ and 27.1 ng/g ww, while PFUnDA and PFOS levels ranged from <LOQ to 16.0 and < LOQ to 21.6 ng/g ww, respectively. Regarding their frequency of detection, PFTrDA and PFUnDA were detected in 98% and 91% of the samples, respectively, while PFOS was detected in 79%. ΣPFAS concentrations in each analysed tissue ranged from 0.3 to 85 ng/g ww, with the latter being detected in the liver of angular roughshark (Oxynotus centrina). On average, PFASs were found to be accumulated in tissues in the following order: gonads > heart > liver ≈ gills > muscle. Relative contribution (%) of individual compounds to ΣPFAS concentration varied among the different shark tissues, and also among the different shark species. No correlation between PFASs levels in tissues and sharks’ gender, length and geographical origin was observed.

Dibutyl phthalate (DBP), one of the most widely used plasticizers, is a known environmental endocrine disruptor that impairs male and female fertility. In this study, oral administration of DBP was given to pregnant mice on 14.5 days post coitus (dpc) for 3 days; and additionally, DBP was added into the culture of 14.5 dpc fetal ovaries for 3 days. DBP exposure during gestation disturbed the progression of meiotic prophase I of mouse oocytes, specifically from the zygotene to pachytene stages. Meanwhile, the DBP-exposed pachytene oocytes showed increased homologous recombination sites and unrepaired DNA damage. Furthermore, DBP caused DNA damage by increasing oxidative stress, decreased the expression of multiple critical meiotic regulators, and consequently induced oocyte apoptosis. Moreover, the effect of DBP on meiosis I prophase involved estrogen receptors α and β. Collectively, these results demonstrated a set of meiotic defects in DBP-exposed fetal oocytes. As aberrations in homologous recombination can result in aneuploid gametes and embryos, this study provides new support for the deleterious effects of phthalates.

The increased applications and production of graphene oxide (GO) make the necessity to study information on the interaction of GO with minerals. In this work, adsorption and desorption were used to study the reversibility of interaction between GO and goethite/kaolinite. Result showed that the pH value, ionic strength, and temperature had significant effects on the adsorption and desorption behavior of GO. Interaction force was stronger between GO and goethite than that of kaolinite. The interaction may be attributed to the electrostatic, hydrogen-bonding, and Lewis acid base interactions. The irreversible interaction between GO and minerals may be a main mechanism for the observed desorption hysteresis. These results are important for evaluating the fate and health risk of GO in the environment.

The removals of arsenic and selenium pollutants are always urgent desires for the water security. In this study, both sorption and catalysis strategies were combined for the effective removals of As(V) and Se(VI) over magnetic graphene oxide sheets (GOs)-oxidized carbon nanotubes (OCNTs) hydrogels. The sorption behavior facilitated the operation of catalysis reactions, meanwhile, the catalytic reduction promoted the release of occupied sorption sites and then restarted a new sorption-catalysis cycle. The synergic effect of sorption and catalysis realized 258.2 mg g⁻¹ for As(V) enrichment capacity on MPG2T1, and ultra-fast sorption and catalysis equilibriums were identified within 9 min. In the case of Se(VI), a moderate enrichment performance was observed to be 46.2 mg g⁻¹. Similarly, the ultra-fast sorption and reduction of Se(VI) were realized within 2 min. In the competition experiments, only SO₄²⁻, SO₃²⁻, and HPO₄²⁻ showed interference for As(V) and Se(VI) removals. These results testified the superiority of the synergy effect of sorption and catalysis, and the feasibility of 3D magnetic GOs-OCNTs hydrogel in practical implementations.

The adsorption of polycyclic aromatic hydrocarbons (PAHs) by components such as elemental carbon (EC), total organic carbon (TOC), and particles is different, and EC and PAHs are good materials for reconstructing historical human activity patterns and pollution conditions. In this study, the effects of EC (soot and char), TOC and particles of different grain size on PAHs in surface sediments were quantitatively analysed, and their historical concentrations in a sediment core from western Taihu Lake were reconstructed. The contents of soot, TOC, clay, EC and char explained 57.2%, 27.6%, 26.0%, 24.0% and 16.4%, respectively, of the PAH concentrations in surface sediments. The correlation between the soot and PAH levels was significantly higher than that between the char, TOC, and clay contents and PAH levels, and PAHs were mainly affected by the local economic development and human activity, as indicated by metrics of population, highway mileage, coal burning, and industrial output. With the development of the economy of the Taihu Lake Basin, the composition of PAHs in the sediments has changed: the proportion of low-molecular-weight PAHs decreased from 42.4% to 17.5%, and that of high-molecular-weight PAHs increased from 58.7% to 82.5%. The concentration of PAHs in pore water from Taihu Lake over the past 100 years was reconstructed and ranged from 43.1 to 961.2 μg L−1, with an average of 180.7 μg L−1. After China's reform and opening up, the concentrations of various PAHs in Taihu Lake changed from safe to chronic pollution levels. The ratios of lead (Pb) isotopes and the diagnostic ratios of PAHs showed that the main sources of PAHs in western Taihu Lake sediments were human activities such as coal and petroleum combustion.

Sealcoat is an emulsified coating product applied to asphalt to protect against surface weathering. Sealcoat products contain coal-tar (CT) or petroleum-derived residues and are a recognized source of polycyclic aromatic hydrocarbons (PAHs) in urban areas. Although the toxicity of urban runoff from CT-sealed asphalt is established, chemical characterization has focused more on PAHs and alkylated derivatives and less on polar transformation products. In this study, solid-phase extraction (SPE) was used to concentrate dissolved (<0.2 μm) species in runoff collected from asphalt surfaces sealed with CT pitch or steam-cracked petroleum (SCP) residues. CT-sealed surfaces released a 20-fold greater concentration of SPE-extractable compounds in runoff compared to SCP-sealed surfaces. Representative compounds were sorted into four groups: nitrogen heterocycles (azaarenes) and other oxygen- and sulfur-containing species (N HET); hydroxylated N heterocycles (hydroxylated N HET); the nonionic surfactant 2,4,7,9-tetramethyl-5-decyne-4,7-diol (TMDD); and styrene-acrylonitrile polymer byproducts (SAN Trimer). Species concentrations and weathering-related disappearance behavior differed among the four subgroups. While hydroxylated N HET concentrations decreased by 94% in runoff from CT-sealed surfaces 60 h after sealcoat application, SAN Trimer concentrations in CT and SCP runoff increased over time as polymerization progressed, illustrating the complex changes the chemicals in sealcoat undergo as it cures under environmentally-relevant conditions. Overall, this study shows that urban runoff collected from CT-sealed and SCP-sealed asphalt surfaces is a potential source of water-soluble contaminants with unknown long-term ecotoxicological effects to aquatic systems.