Chemical reduction of the hexavalent chromium, Cr(VI), present in contaminated soil and groundwater was carried out in a slurry reactor under dynamic conditions (120 rpm and 25°C) using different reductants [ferrous sulphate (Fe(II))], sodium bisulphite, sucrose, ascorbic acid and zerovalent iron (ZVI)] in order to evaluate the influence of the reductant on the redox process. Chemical analysis of the contaminated soil revealed a Cr(VI) concentration of 528 ± 31 mg kg⁻¹. Batch studies under dynamic conditions (slurry reactor) using different [Cr(VI)]/[reductant] molar ratios revealed that only Fe(II) and ZVI species can promote both reduction of Cr(VI) and immobilisation of Cr(III) (formation of an insoluble hydroxide compound). It was verified that 1.0 g of ZVI is capable of converting 104 ± 5 mg of Cr(VI) in Cr(III). A kinetic redox study was carried out using ZVI in different conditions. In all cases, it was verified that Cr(VI) reduction follows a pseudo-first-order kinetic behaviour. The dependence of the pseudo-first-order kinetic rate constant, k obs, on [ZVI] indicates that the redox process taking place in the slurry reactor is rather complex. A phenomenological kinetic equation for the redox process taking place in the slurry reactor was presented in order to describe the behaviour of k obs under non-ideal conditions.

The debate on sludge recycling and disposal has been recently a target of growing interest due to the expressed concern about the potential risks of its agricultural use on human health and the environment. This fact has led to revisions in government policy and regulations and many novel treatment processes have been proposed in order to make the recycling and reuse of sewage sludge sustainable. In this work, the use of some pretreatments (alkaline, thermal, and ozonation) combined with conventional anaerobic digestion has been assessed on digested sludge quality in terms of pathogens, dewatering properties, heavy metals, and organic pollutants. All pretreatments proved to be efficient to reach the requirements proposed in the Working Document on Sludge prepared by the European Commission (CEC, Council Directive of 27 April 2000 on Working Document on Sludge--third draft. Brussels: European Commission DG Environment. Retrieved from http://ec.europa.eu/environment/waste/sludge/pdf/sludge_en.pdf, 2000a) and also those established by the U.S. Environmental Protection Agency (EPA, Standards for the disposal and utilization of sewage sludge, part 503. Retrieved from http://www.epa.state.il.us/public-notices/2004/lincoln-trails-mhp/draft-permit.pdf, 1993).

In the present work, rapid test methods for field screening of soil for Cu, Ni, and Pb content are presented. They are based on commercially obtainable Microquant tests (Merck, Germany), which are originally developed for water analysis. The same type of color reaction was also used for the determination of heavy metals in soil extracts: Reagents to form colored metal complexes are cuprizone for Cu, dimethylglyoxime for Ni, and dithizone for Pb. The experimental conditions for the colorimetric determination of these metals in the soil extracts were studied and additionally modified. An aqua regia solution (HCl/HNO₃, 3:1) was used for the rapid extraction of metals from soil. To establish accuracy, results obtained with the proposed test methods were compared with those obtained with the standard laboratory method using microwave digestion and flame atomic absorption spectrometry (FAAS). Real soil samples containing metals at background levels generally yielded approximately 50% of the total content obtained with the standard FAAS method. High recovery values of spiked samples confirm that the colorimetric methods are unaffected by soil matrix effects.

The paper presents the results of a study in the region Dübener Heide (Central Germany) testing the suitability of field measurements of magnetic susceptibility for the detection of historical fly-ash deposition. The measurements supported the verification of historically documented deposition zones along an emission gradient. Mean values, standard deviation, and coefficient of variation can be used to characterize the former deposition zones, although the study revealed several problems, which will be the subject of future work: (1) the volume susceptibility measurements used in the study do not allow the calculation of the actual fly-ash amount stored in the soil and thus must be calibrated with correction factors from laboratory measurements; and (2) measurements in regions with similar conditions but without fly-ash deposition are needed to obtain reference values for the natural range of magnetic susceptibility.

The objective of this study was to improve the ability to model the air quality impacts of biomass burning on the surrounding environment. The focus is on prescribed burning emissions from a military reservation, Fort Benning in Georgia, and their impact on local and regional air quality. The approach taken in this study is to utilize two new techniques recently developed: (1) adaptive grid modeling and (2) direct sensitivity analysis. An advanced air quality model was equipped with these techniques, and regional-scale air quality simulations were conducted. Grid adaptation reduces the grid sizes in areas that have rapid changes in concentration gradients; consequently, the results are much more accurate than those of traditional static grid models. Direct sensitivity analysis calculates the rate of change of concentrations with respect to emissions. The adaptive grid simulation estimated large variations in O₃ concentrations within 4 x 4-km² cells for which the static grid estimates a single average concentration. The differences between adaptive average and static grid values of O₃ sensitivities were more pronounced. The sensitivity of O₃ to fire is difficult to estimate using the brute-force method with coarse scale (4 x 4 km²) static grid models.

Frame and daughters directives for evaluating the ambient air quality have been adopted by the EU as a part of the new strategies for pollution prevention and control and environmental management. Therefore, the prediction of ozone concentration and the identification of episodes by modeling are fundamental for protecting and preventing the population and environment against the harmful effects of this species. Under this approach, ambient air quality (immission) data in three zones: A Guarda, Corrubedo and Verín (two coastal and one interior) of Galicia (NW Spain), were collected and evaluated using statistical tools. Punctual and functional background and standard levels of ozone and NOx in the three zones have been determined for detecting abnormal situations and identifying possible emission sources. With this aim, threshold values were established by defining confidence levels. Finally, ozone concentration has been forecasted by time series modeling. Descriptive and predictive models of ozone involving different parameters depending of the area considered have been developed. Satisfactory estimation of ozone concentration was obtained in the three cases with proved efficiency, since predictive values did not exceed the 95% confidence level.

Storm water detention devices collect runoff from impermeable catchments. They provide flow attenuation as well as storage capacity, and rely on natural self-purification processes such as sedimentation, filtration and microbial degradation. The aim was to assess the performance of an experimental combined planted gravel filter, storm water detention and infiltration tank system treating runoff from a car park and its access road. Flows were modeled with the US EPA Storm Water Management Model. An overall water balance of the system was compiled, demonstrating that 50% of the rainfall volume escaped the system as evaporation, whereas, of the remaining 50%, approximately two thirds were infiltrated and one third was discharged into the sewer system. These findings illustrated the importance of evaporation in source control, and showed that infiltration can be applied successfully even on man-made urban soils with low permeability. The assessment of the system's hydrological efficiency indicated mean lag times of 1.84 and 10.6 h for the gravel filter and the entire system, respectively. Mean flow volume reductions of 70% and mean peak flow reductions of 90% were achieved compared to conventional drainage. The assessment of the pollutant removal efficiency resulted in promising removal efficiencies for biochemical oxygen demand (77%), suspended solids (83%), nitrate-nitrogen (32%) and ortho-phosphate-phosphorus (47%). The most important removal processes were identified as biological degradation (predominantly within the gravel ditch), sedimentation and infiltration.

This study determined the content of trace elements in coal ash collected from a coal-fired thermal power plant using local coal from Sawarak, Malaysia. This is crucial for the potential impact on the geoenvironment from its disposal and utilization; as coal ash has recently been produced locally in substantial amounts and very limited data is available. The trace elements concentrations presents in coal ashes are compared with the reported coal ash concentrations and the risk for the local wet tropical geoenvironment from the perspective of its vulnerability to these is studied for an indication of potential environmental implications on the wet tropics. The trace elements were found to be in concentrations that, if applied or inadvertently released into the environmental media, present a potential hazard and further necessary research in this regard is indicated.

The chemical characterization of contaminated soil was assessed in two study areas in Finland contaminated with metals. The aqua regia extractable and/or concentrated nitric acid leachable median concentrations of selected elements within the study areas were first compared to those from various geochemical baseline studies. Based on this comparison, the studied elements were divided into two groups: elements displaying general enrichment in the study areas and those with median concentrations within the range of baseline levels. In addition to comparison with the baseline levels, the distribution of aqua regia extractable concentrations of selected elements was assessed in relation to the Finnish soil screening values. The potential leachability of the selected metallic elements in contaminated, mainly man-made soil was examined by determining the ratio between the median ammonium acetate and median aqua regia extractable concentrations in the two study areas. Aqua regia extractable concentrations are considered to represent the near-total fraction of the elements and ammonium acetate extractable concentrations the 'bioavailable' fraction. These ratios were compared with those from non-polluted sites representing geochemical baselines. In addition, water soluble element concentrations were available from the two study areas and the ratio between synthetic rainwater or distilled, de-ionised water extractable and aqua regia extractable concentrations was calculated. The ratio between ammonium acetate extraction and aqua regia extraction indicated that of the studied elements, Cu, Ni, Pb, Zn and V exist in a more leachable form in contaminated soil than in the natural environment. It can be assumed that these elements are also more 'bioavailable' in contaminated land and could therefore pose a risk to the environment. The water soluble fraction of the potential harmful elements was generally low in both study areas, but single samples had easily leachable metal concentrations. High concentrations of trace elements were found in the groundwater on the down stream side of the potential pollution source. The chemical characteristics of the soil material in both study areas were defined with hierarchical cluster analysis, with the results presented as dendrograms produced using Ward's method. Although some clusters were identified from the dendrograms, no special characterization of the fill material was possible. However, suggestive grouping of certain element groups was observed. Similar grouping of elements was found in factor analysis. Cluster analysis as well as factor analysis was found to be feasible for the chemical characterization of soil provided that a sufficient number of samples with appropriate analysis are available.

The Anllóns basin (NW Spain) has been included in the Natura 2000 Network and declared as Site of Community Importance. The main contamination problems of the basin come from a former gold mine and from agricultural activities, which influence the quality of the sediment-water system. Phosphorus (P) enrichment in the bed sediments was evaluated by analyzing P in the pore waters, in the surface bed sediments, and in the vertical sediment profiles, including both total and bioavailable forms. Two granulometric fractions (<2 mm and <63 μm) were evaluated. Pore waters, bed sediments, and vertical profiles showed high percentages of the bioavailable P fraction with respect to the total P content, which evidences the potential risk of pollution which suppose the bed sediments of the Anllóns River. The vertical profiles showed P enrichment in the superficial layers, which could be the consequence of the increased use of fertilizers in the last decades. With regards to the granulometric distributions, the <63 μm showed, in general, higher P concentrations than the <2 mm fraction. However, at the sampling points most heavily contaminated, the concentration of both fractions becomes similar, thus indicating that, at these sites, the coatings formed over sands can retain important P concentrations in the bed sediments.