For more than a decade, Lakeland, FL, has invested in restoring its urban Lake Hollingsworth from a hypereutrophic state to its natural eutrophic state. The lake bottom was dredged of nearly 2 million m3 of accumulated organic sediments, and treatment wetlands, storm water curb inlet strainers, and a storm water baffle box were installed within the lake’s catchment area to reduce the loading of dirt, leaves, and trash to the lake. After dredging ceased, the lake was dosed one time with alum to improve water clarity and reduce phosphorus recycling from its sediments. Water quality surrogates for algal biomass— Secchi disk transparency and water column total nitrogen, total phosphorus, and chlorophyll-α concentrations— were reviewed to assess Lakeland’s progress towards its goal. In the years since dredging has stopped, algal biomass concentration in Lake Hollingsworth has significantly declined. Even with these improvements, however, the lake still remains hypereutrophic.

In 1996, dichlorodiphenyltrichloroethane (DDT) pollution of industrial origin was discovered in Lake Maggiore. It was caused by industrial effluents on a tributary of the River Toce, one of the major affluents of the lake in correspondence of Pallanza Bay. This event is the worst case of environmental pollution that has occurred in Western countries in the last 25 years, not due to agricultural use of DDT, but because of an accidental industrial discharge. Heavy polychlorinated biphenyls (PCBs) pollution was also noticed in 2002, with concentration levels three to seven times higher than those measured in other Italian subalpine lakes. In this study, the current DDT and PCBs contamination levels were assessed according to their presence in zebra mussel (Dreissena polymorpha) specimens sampled in the last 5 years (2003-2008) in eight sampling stations of Lake Maggiore, chosen to cover the entire perimeter of the basin. Moreover, for two stations (Baveno and Pallanza-Villa Taranto) located inside and outside Pallanza Bay, respectively, it is possible to make comparisons starting from 1996. The results obtained show how Lake Maggiore is still an ecosystem with a severe environmental risk, more than 10 years after the original insecticide discharge. DDT contamination continues to evolve, and natural events, like lake overturn, floods, and heavy rains, can have a great influence on the insecticide levels in the lake. By contrast, PCB contamination is absolutely negligible, even if the peak of pollution revealed in 2002 seems to indicate that these pollutants are still present in large quantities in the Lake Maggiore watershed.

Groundwater flow models are applied to a large variety of hydrogeological conditions in different aquifer types, in order to simulate the groundwater flow of the investigated system. This paper aims to present the application of a groundwater flow model for the simulation of a sedimentary aquifer, located in Northern Greece. The simulation involves the period between April 2003 and April 2004, and the model is divided into two distinct stress periods, each containing two different time steps. The simulation of the aquifer is found to be satisfactory, conclusion which is based on both graphical as well as arithmetical verifications. The groundwater flow simulation was achieved by the application of the MODFLOW code.

The impact of plants (Phalaris arundinacea L.) on the leakage of ammonium, cadmium, copper, nitrate, phosphate, and zinc from sulfidic mine tailings covered with wood fly ash and sewage sludge was investigated. Either ash or sludge was placed in contact with the tailings, and ash layers of either low or high compactness were used. It was revealed that an ash/sludge cover effectively decreased the metal leaching from the tailings regardless of the order in which the materials were applied. Plants decreased the amount of leachate and the concentrations of ammonium and phosphate. The presence of ash below the sludge decreased the plant uptake of copper and zinc and nitrate leakage. However, when the ash was added as a thin (1.5 cm) porous layer, roots and air reached the tailings and caused high metal leakage. The results support the use of a vegetated ash/sludge cover in the treatment of mine tailings, provided that the sealing layer is firm enough to prevent root penetration.

The main objective of this study was to compare the effectiveness of different methods (heavy metals in pore water (PW), diffusive gradients in thin films (DGT), diethylene triamine pentaacetic acid (DTPA) extraction, and total heavy metals (THM) in soil) for the assessment of heavy metal bioavailability from soils having various properties and heavy metal contents. The effect of soil heavy metal pollution on shoot yield and sulfatase enzyme activity was also studied. Wheat (Triticum aestivum) was grown in different soils from Spain (n = 10) and New Zealand (n = 20) in a constant environment room for 25 days. The bioavailabilities of Cd, Cr, Cu, Ni, Pb, and Zn were assessed by comparing the metal contents extracted by the different methods with those found in the roots. The most widely applicable method was DGT, as satisfactory Cu, Ni, Pb, and Zn root concentrations were obtained, and it was able to distinguish between low and high Cr values. The analysis of the metal concentrations in PW was effective for the determination of Cr, Ni, and Zn content in root. Copper and Pb root concentrations were satisfactorily assessed by DTPA extraction, but the method was less successful with determining the Ni and Cr contents and suitable just to distinguish between high and low concentrations of Zn. The THM in soil method satisfactorily predicted Cu and Pb root concentrations but could only be used to distinguish between low and high Cr and Zn values. The Cd root concentration was not successfully predicted for any of the used methods. Neither shoot yield nor sulfatase enzyme activity was affected by the metal concentrations.

In this research, geological and hydrogeological studies were conducted to determine the source of high arsenic levels in the surficial aquifer of Simav Plain, Kutahya, Turkey. One of the two aquifer systems isolated in the study area was a deep confined aquifer composed of fractured metamorphic rocks that supply hot geothermal fluid. The other one was an unconfined alluvial aquifer, which developed within the graben area as a result of sediment deposition from the highlands. This aquifer serves as the primary water resource within the plain. A water quality sampling campaign conducted in 27 wells drilled in the surficial aquifer has yielded an average arsenic concentration of 99.1 µg/L with a maximum of 561.5 µg/L. Rock and sediment samples supported the fact that local metamorphic rocks contained significant amounts of sulfur minerals where arsenic-containing lenses are present inside. It was also determined that a Cu-Pb-Zn mine was operated in the past in the same formation. Arsenic-containing wastes of this mine were deposited near the Simav district center in an uncontrolled manner. This mined formation had arsenic levels reaching to levels as high as 660 mg/kg, which was found out to be the highest arsenic level in the area. Another potential arsenic source in the study area was the geothermal fluid that was used extensively in three geothermal fields with levels reaching to levels as high as 594 µg/L. Uncontrolled discharges of waste geothermal fluid and overexploitation of groundwater were also found to contribute to arsenic pollution in surface/subsurface waters of the plain. Thus, natural sources and anthropogenic influences of arsenic were found to create high concentrations in local water reserves of the area and influence human health. Consequently, death statistics from the 1995 to 2005 period collected from the area has revealed increased rates of gastrointestinal cancers above Turkish average.

The objectives of this study were algal control and health assessments in a temperate eutrophic reservoir. Laboratory and mesocosm-scale in situ top-down biomanipulation experiments using planktivorous fishes and filter-feeding macroinvertebrates were conducted along with identification of the limiting nutrient using nutrient enrichment bioassays (NEBs), and ecosystem health evaluation based on the modified index of biological integrity model (Reservoir Ecosystem Health Assessment; REHA). Nutrients and N/P ratio analyses during 5 years revealed that the reservoir was in a eutrophic-hypertrophic state and that the key limiting nutrients, based on the NEBs, varied among seasons. Reservoir trophic guilds indicated declines in sensitive and endemic fish species and dominance of tolerant omnivores. Model values from multimetric REHAs averaged 25.8, indicating that the ecological health was in “fair to poor” condition. Overall microcosm biomanipulation tests suggested that macroinvertebrates, specifically Palaemon paucidens and Caridina denticulata, were effective candidates for phytoplankton control, compared to fishes. In situ mesocosm experiments revealed the highest removal rates with bluegreen algae and a phytoplankton size fraction of 2-19 μm (R e > 90%, Mann-Whitney U = 64.5-74.0, p < 0.01), the dominant fractions in the reservoir. Our biomanipulation technique may provide a key tool for efficient management and restoration of eutrophied reservoirs.

The effect of in situ immobilization of lead (Pb) and arsenic (As) in soil with respectively phosphate and iron is well recognized. However, studies on combined Pb and As-contaminated soil are fewer, and assessment of the effectiveness of the immobilization on mobility and bioaccessibility is also necessary. In this study, a Pb and As-contaminated soil was collected from an abandoned lead/zinc mine in Shaoxing, Zhejiang province of China, which has been treated with three phosphates, i.e., calcium magnesium phosphate (CMP), phosphate rock, and single super-phosphate (SSP) for 6 months in a field study. The ferrous sulfate (FeSO₄) at 20 g kg⁻¹ was then amended to the soil samples and incubated for 8 weeks in a greenhouse. The solubility and bioaccessibility tests were used to assess the effectiveness of the in situ immobilization. The result showed that phosphates addition decreased the concentrations of CaCl₂-extractable Pb; however, the concentrations of water-soluble As increased upon CMP and SSP addition. With the iron addition, the water-soluble As concentrations decreased significantly, but CaCl₂-extractable Pb concentrations increased. The bioaccessibility of As and Pb measured in artificial gastric and small intestinal solutions decreased with phosphate and iron application except for the bioaccessibility of As in the gastric phase with SSP addition. Combined application of phosphates and iron can be an effective approach to lower bioaccessibility of As and Pb, but has opposing effects on mobility of As and Pb in contaminated soils.

The aim of the present study was to determine the influence of light soil fertilization using sewage sludges or composts on soil toxicity for three plant species (Lepidium sativum, Sorgo saccharatum, and Sinapis alba) and crustaceans (Heterocypris incongruens). The results obtained were compared to the polycyclic aromatic hydrocarbon (PAHs) content as a potential toxicity factor. The PAH content in soils fertilized with sludges was proportional to the dose applied. Soil fertilization with the studied materials negatively influenced plant growth and development. The negative influence was clearer in the case of sewage sludges than composts. Both sludges and composts significantly influenced H. incongruens mortality. However, the influence of sludges and composts on H. incongruens growth did not exceed 20%. The EC50 and LC50 values calculated on the basis of toxicity parameters showed that H. incongruens was characterized by a higher sensitivity to sludges and composts than most of the plants. L. sativum was characterized by the lowest EC50 values among all plants. No significant relationships between sewage sludge or compost toxicity and their PAHs content were observed.

Reaction behaviors and kinetics of catalytic oxidation of benzene, toluene, and ethyl acetate with feed concentrations in the range of 700-5,000 ppm over Pd/ZSM-5 catalyst were investigated. Results for single components show that ethyl acetate (T ₅₀ = 190-200°C) is more easily oxidized than benzene (T ₅₀ = 215-225°C) and toluene (T ₅₀ = 225-235°C). The conversion of ethyl acetate was increased with the increase of its feeding concentration, while the opposite behaviors were observed for benzene and toluene as their conversion rates were decreased with the increase of the inlet concentration. Different behaviors were observed in catalytic oxidation of volatile organic compound (VOC) multi-components, the presence of benzene or toluene inhibits the conversion of ethyl acetate, and the aromatic hydrocarbons inhibit each other in all cases. Ethyl acetate possesses obvious inhibitory effect on benzene oxidation, while it is interesting to note that ethyl acetate has a promotion effect on toluene conversion. The kinetic data were fitted by the Power-law and Mars-van Krevelen kinetic models. The fitting result shows that the Power-law model is more suitable for predicting the conversion of benzene than the other VOCs, and the Mars-van Krevelen model can accurately express the reaction rate of all investigated VOCs.