This research aims at developing a new relation to estimate the urban runoffwater quality through urban land use. According to the first phase of this research, sixurban characteristics and land use indices have been defined concerning all parameterswith either direct or indirect impacts on urban water quality: Population, land use type,meteorological factors, local physiographical parameters, urban patterns etc. have beenconsidered when developing the new indices. Three study areas, including different urbanland uses, have been selected in Tehran Metropolitan and urban drains maps andstructures have gone under study to determine the sampling points. Multi-statisticalanalysis, discriminate analysis, and multi-linear regression analysis have been applied forall water quality results and urban indices in each site, with the results revealing verystrong relations between urban land use and water quality variation. Temporarypopulation especially in downtown site has proved to be an effective temporal factor onhow even public transport could not have any significant effects, in case populationdensity has no significant influence on water quality, as all sanitary waste water inselected sites is collected through urban wastewater systems separately. General slop is asignificant factor in hydrocarbons and heavy metals, once they are not alongside thestreets route. All told, this paper recommends reusing urban drained runoff locally beforejoining other regions’ collectors. Here in urban drainage system, collection andaggregation of water could not be an appropriate factor in water quality managementunlike river systems. The model could be employed in urban local water consumptionmanagement in irrigation and public recovery.

The present study simulates the frontal dust storm by means of WRF-Chem model and AFWA emission scheme between April 23 and 24, 2019. It then applies reanalysis data (ERA5) to analyze this case from a synoptic perspective. The simulation results show that the model have been accurately characterized first by the onset of dust from the south-east of the country in Kerman Province and then via its transmission to large areas of the east and south-east. The model output also fits well with satellite images. A quantitative comparison of PM10 concentration of the model with actual values shows that the PM10 model estimates are larger than actual values, though it predicts the trend of concentration changes well. Examining the synoptic maps, the isobars’ curve, wind direction change, and temperature advection in the area reveals the presence of atmospheric fronts within a strong dynamic low-pressure system. This causes high temperature and pressure gradients, in turn speeding up the wind within the region. Results from the synoptic analysis show that by passing the frontal system and behind the cold front, a dust mass is formed, which gradually spreads in eastern and the southeastern regions of Iran. In this case, extreme pressure gradient, cold front passage, low-level jet, wind gust on dry areas of dry Hamoon wetland, and cold air advection over flat area of the Lut Desert are important factors in storm formation and emission, east of the country.

Because of the pinch of air pollution on human health and its environment, it has become necessary to monitor and map out the peaks and lows threat places of air pollution in different land use across a city. In this regard, air pollution exposure mapping of Kano metropolis based on land use classifications namely industrial, residential, commercial and institutional was carried out for interpretive and assessment of health hazard associated with the selected pollutants. The observations for ambient air quality parameters (CO, SO2, H2S, NO2, and PM10) monitored with portable digital air pollution detecting devices for creation of data. Geographic Information Systems (GIS) technique was applied to create spatial distribution maps of urban air quality of the metropolitan area. The results of pollution index map of ArcGIS extrapolation indicated that neighbourhoods in the vicinity of Bompai and Sabon Gari industrial and commercial zones, respectively were found to be highly exposed and liable to ailments associated with air pollution, while places nearby Dorawa and School of Technology were air pollution-ease zones but could experience bioaccumulation over long exposure time. Therefore, the study reveals that variability of air quality was strongly related to predominant land use in particular areas within the metropolis and could help in estimate and valuation of likely health challenges associated with poor air quality due to air pollution. Besides, the observed spatial variation for air quality could serve as hot spot identifier and as an informant for rational decision on air quality control strategies for environmental management.

Significant attention has been given to nanotechnology as an emerging approach in water/wastewater treatment for heavy metals removal. Numerous research works on synthesizing, fabrication and upgrading nanoparticles have reported as an efficient adsorbent in removal of wide range of heavy metals from wastewater. This review intends to provide researchers with understanding and knowledge regarding the efficient nanoadsorbents, their adsorption mechanism towards selected heavy metals and fundamental principles of nanoadsorbent materials synthesis. In addition, further attention on the modification of nanoadsorbent and development of nanocomposites are highlighted in this paper as value added products to increase the adsorption capacity and enhance the heavy metals removal. Possible challenges and direction on utilization of nanocomposites for heavy metal removal in real wastewater effluent are discussed in view of their removal capability and cost efficiency. Future research works on developing a cost-effective way of nanocomposite production and toxicity testing of nanomaterials in wastewater applications are recommended. Further studies on the efficiency of the nanoadsorbents in pilot or industrial scale are highly needed to test the practicality of the nanoadsorbents for selected heavy metals removal from real wastewater.

This study assesses heavy metal levels in water, soil, and vegetables (swiss chard, lettuce, cabbage, collard green, tomato, green pepper and carrot) irrigated with waste water in Gamo, Ethiopia. The samples of soils, water, and vegetables were randomly collected, processed, and analyzed for heavy metals using atomic absorption spectrophotometry. The results obtained show that the irrigational water is profoundly contaminated with heavy metals Cd, Cr and Ni and Pb, Zn and Cu had the lowest concentration in irrigation water. The levels of Cd in Kulfo river area and Chamo Lake area and Ni in most of the farm soils were also found to be higher than the guideline values. The study also revealed that the mean levels of Cd in most vegetables and Cr and Pb in some vegetables were higher than the maximum recommended limits set by WHO/FAO. In general the results show that the highest concentration of the heavy metals was obtained from Kulfo river area compared to the Arbaminch textile share company area, Abaya Lake area, and Chamo Lake area. Cabbage was maximally contaminated with potential toxic elements followed by Swiss-chard, carrot, tomato, collard green, green pepper and lettuce. Hence, from kulfo river area frequent consumption of cabbage and Swiss chard may cause serious health risks to consumers. The levels of many elements were found to vary with location, suggesting localized inputs of the various contaminants related to industrial and other activities that generate wastewater. This study recommends regular monitoring of heavy metals in soils, waters, and foodstuffs to prevent excessive accrual in food chain.

The present study deals with groundwater pollution in multilayer aquifer. The model is based on decomposition of finite layers in semi-infinite groundwater reservoir. A constant pollutant source is injected at the input boundary of the uppermost layer (UML) of the landfill. At the intermediate inlet boundary, some average value for the longitudinal exchange of the input source concentration in each sub-layer is considered from the previous layer. Initially, the aquifer is not solute free in each sub layer that means some constant background contaminant concentration exists. In each sub layer, concentration gradient is assumed to be zero at the extreme boundary. The linear sorption and first orders decay terms are considered to model the groundwater pollution in multilayer aquifer. The Laplace transform technique is adopted to solve one-dimensional (1D) advection-dispersion equation (ADE). This approach is helpful to understand the solute migration in finite sub layers. The results are elucidated for the different time periods to examine the peak of pollutant concentration level in geological formations.

In this study, efficiency of humic acids (HAs) derived from various sources to reduce CrVI in aqueous solutions was compared. HAs were extracted from leonardite, peat moss, peat, cocopeat, coal, common char, biochar, vermicompost and sewage sludge. Some chemical and spectral characteristics of the extracted HAs were measured. Then, the reducing efficiency of HAs was measured and its relationship with the determined properties was investigated. To measure the reducing efficiency of HAs, a concentration of 0.1 mM CrVI (as potassium dichromate) in a sodium nitrate solution (0.03M) with a pH of 2 and in the presence of 100 mg of HA per liter was used. The experiment was conducted in three ways (symbolized by E1, E2 and E3). They differ from each other with respect to the method of phosphate buffer addition to release CrVI ions adsorbed by HA. This buffer was added to an aliquot of final extract, to the whole volume of final suspension and to initial solution containing CrVI in experiments E1, E2 and E3, respectively. According to the results, the CrVI reducing efficiency depends not only on the nature of HA but on the method of experiment. The minimum reducing efficiency was observed for common char using experiment E2 and the maximum value was for biochar and cocopeat in all three experiments. The results showed that the two factors of ΔlogK and maximum reducing efficiency in the format of a multiple regression had a significant relationship with CrVI reducing efficiency of HAs.

The present study attempts to investigate some blood parameters of Otolithes ruber during different seasons in terms of both temperature and pollution. For so doing it uses 10 specimens, for each station and season, collected from 5 polluted stations, including Petrochemical, Ghanam, Zangi, Douragh, Patil, and Sajafi as the control group, away from pollution in Musa Creek. The fish are anesthetized with 1ml of clove extract per liter. Their blood samples are taken immediately from the caudal vein, using a heparinized syringe. Afterwards, the serum is separated in a centrifuge with a speed of 6000 rpm for 2 minutes. The desired factors are measured by the Mindray BS200 auto-analyzer and the total protein level, by Bradford's usual laboratory methods. Results show that AST, ALT, ALP, Glucose, and Triglycerides have increased in more polluted stations (P≤0.05). In sheer contrast, total protein and Albumin have decreased as pollution grows (P≥0.05). According to this study, environmental water pollution of the fish has a large impact on the concentration of measured blood parameters, whereas the influence of seasonal changes on most of them is low.

The production rate of industrial and agricultural waste is increasing due to population growth. Soil is the most important receiver of industrial and agricultural waste. Contaminants such as heavy metals in various waste after reception by the soil, immediately become part of the cycle that has different impacts on the environment. Geopolymer, as a chemical stabilizer has the potential to stabilize heavy metals in the soil. In this research, several geopolymers for the stabilization of heavy metals in soil were synthesized. Silicon dioxide (SiO2) and aluminosilicate (Al2SiO4) must be used to produce the geopolymers. Rice husk ash was used as the SiO2 source. Also, Iranian zeolite and sepiolite, and red clay soil were utilized as the source of Al2SiO4. The synthesized geopolymers were investigated for the adsorption of nickel and cadmium. Also, batch and column studies of using geopolymers for the chemical stabilization of heavy metals in soil were conducted. The results revealed a high adsorption capacity of the geopolymers. The zeolite, sepiolite, and red clay geopolymer-soil samples adsorbed 100% of the heavy metals (i.e., Ni and Cd) at a concentration of 100 ppm. The zeolite geopolymer adsorbent adsorbed 57% and 96% of Ni and Cd at a concentration of 1000 ppm, respectively. In general, it was concluded that the use of geopolymer compounds in soils with high heavy metal adsorption capacity could be an efficient approach to prevent groundwater resource pollution.

This paper is the first to report on the role of a wastewater treatment plant (WWTP) in Sari, as a source of microplastics (MPs) in the Caspian Sea. Composite 270-liter/24-hour samples were taken the treated effluent of the WWTP in winter and spring, two seasons with different levels of human activity. The effluent contained 380±52.5 and 423±44.9 MPs/m3 in winter and spring, respectively, with the total numbers of MPs/m3 not differing between the two seasons. The dominant type of MPs in the effluent was microfibers with 237±68.7 and 328±33.4 per m3 in winter and spring, respectively. In both seasons, fiber sizes of