The aim of investigations was to compare different absorber material efficiency to examine collector tracking the Sun and stationary collector efficiency as well as the efficiency of insulated and non-insulated collectors. The 0.1x0.5x1.0 meter long experimental solar collectors were constructed for investigations and different types of absorber materials were made. The manifold length, the Sun radiation effect on the degree of air heating was analyzed. ASHARE used standard 93-2003 is determined for insulated and non-insulated solar collectors and absorber effectiveness. We determined the influence of the Sun radiation on the air heating degree for those types of absorbers. The experimental data were measured and recorded in the electronic equipment REG (electronic metering and recording equipment of temperature, radiation and lighting). The collector covered material was a polystyrol plate and different absorbers. We compared insulated and non-insulated collectors to prove that the insulated collector is more effective. The insulated collector was made of the collector surfaces faced with cellular plastic two cm plates. Our task was to calculate the air heating solar collector efficiency. The collector tracking the Sun is approximately 30% more efficient than the same type of stationary collectors in operation time for 6 hours. Insulation increases solar panel efficiency especially in windy weather. The insulated collector demonstrates almost two times higher efficiency than the non-insulated collectors (up to 93%) with absorbent material steel tinplate on top.

It is very important to use the exact investment model for energy enterprises. Giant investment is necessary for establishing continued energy systems using renewable energy resources. Demand of the heat energy usually is higher in a winter period compare to the summer time. Program combinations of different heating modus are researched using EnergyPRO.