In this study, the European Sea Bass (Dicentrarchus labrax) were fed rich canola oil which is containing monounsaturated fatty acid (MUFA) and rich cottonseed oil which is containing n-6 polyunsaturated fatty acid (PUFA) and the effects of these feeds on some hematological parameters were investigated. Experimental fish were fed two times daily with 100% fish oil (FO-control), 100% cottonseed oil (CSO), 100% canola oil (CO) and 50% CSO - 50% CO (CSO50-CO50) for 162 days. End of the experiment, total erythrocyte (RBC) amount was highest in the CSO group 269.0 x (104 mm3 -1) compared to all other groups. Leukocyte (WBC) 96.280 x (103 mm3 -1), monocyte, lymphocyte and neutrophil amounts showed significant increases in only CSO group. Therefore, in terms of fish health and welfare, the exclusive use of cottonseed oil without mixing with the other vegetable oils in sea bass diet formulation can be a viable alternative to fish oil since it has the most suitable fatty acids.

In this study, the effects of UV B (50 µW/cm2) radiation at 306 nm on oil-in-water emulsions (O/W) using canola oil, soybean oil and linoleic acid were investigated. The oxidation rates of emulsions incubated at pH 7.0 and 37°C in the presence and absence of Cu (II) ions were determined by using iron (III) thiocyanate and thiobarbituric acid methods for the determination of primary and secondary products, respectively. The UV B-induced oxidation rates followed the order LA / Cu (II) > LA > Canola Oil / Cu (II) > Canola Oil > Soybean Oil / Cu (II) > Soybean Oil for both crops. Simultaneously, structural studies were performed using gas chromatography mass spectrometry (GC-MS). It was found that 18-carbon polyunsaturated fatty acid (PUFA) and monounsaturated fatty acid (MUFA) contents have an important role in canola and soybean oil oxidation. The unsaturated fatty acid contents of small carbon numbers increased for each emulsion sample, while the oxidation of fatty acid changes did not follow a regular order.

In this study, the physicochemical properties of canola and waste cooking oil biodiesels, as well as various binary biodiesel blends, were investigated according to TS EN 14214 and ASTM D 6751 standards. Critical parameters such as density, kinematic viscosity, cold filter plugging point (CFPP), calorific value, flash point, copper strip corrosion, water content, and ester yield were evaluated. The findings highlighted the notable density of C100 and W100 biodiesels, with the addition of butanol reducing density. While viscosity values adhered to standards, the addition of butanol was observed to decrease viscosity. CFPP values indicated compliance with standards only for C100 and C75W25. Flash points of C100 and W100 biodiesels met standards, but the addition of butanol to binary biodiesel blends lowered flash points. Copper strip corrosion values were determined to comply with standards for all fuels. Calorific values demonstrated the prominence of C100 and W100 biodiesels, with the addition of butanol observed to decrease calorific values in binary biodiesels. While water content favored canola biodiesel over waste cooking oil biodiesel, the addition of butanol to binary biodiesels increased water content. Regarding ester yield, C100 biodiesel exhibited the highest yield, and the addition of butanol to binary biodiesels increased ester yield. In conclusion, this study thoroughly analyzed the physicochemical properties of biodiesel and blend fuels, revealing the impact of butanol addition on these properties.