Rock-Breaking Mechanism and Application of Combined Long and Short Holes in Parallel Holes Cut in Small-Section Tunnels

In order to address the issue of limited excavation footage in the drilling and blasting of a water diversion tunnel with a cross-section of approximately 10 m², which is unable to meet the demands of rapid construction, a blasting method combining long and short straight-hole cutting was proposed based on the theories of elastic mechanics, blasting craters, explosive gas and stress waves. A mechanical model was established to elucidate the parameter design method and cavity formation principle of the combined cutting. Numerical simulation and field tests were employed to analyze the rock-breaking process of combined cutting, with a view to comparing the blasting effect differences between the traditional inclined cutting method and the combined cutting method. The research results indicate that during the blasting process with combined long and short straight-hole cutting, the uncharged portion of the deep hole can serve as an empty hole during the subsequent blasting of the shallow hole. The concentration of stress at the wall of the empty hole and the superposition of reflected and incident waves serve to enhance the rock-breaking effect of the shallow hole, with the enhancement being influenced by the diameter of the hole and the distance between it and the empty hole. The preferential detonation of the shallow hole can provide a smaller resistance line and free surface distance for deep hole detonation, creating favorable conditions for rock fragmentation in deep hole blasting, making it easier for the rock in the cutting area to be thrown out and increasing the utilization rate of the blast holes. The shape of the formed cavity is a long strip-shaped cube, with its volume being influenced by the spacing between each group of deep and shallow holes. The rock mass damage is most severe in the vertical direction, while the rock mass damage at the center of the upper and lower edges is relatively weaker. In order to optimize the utilization of blasting energy, it is essential to select an appropriate spacing between each group of blast holes. In comparison to the utilization of traditional inclined cuts, the implementation of combined long and short holes has been observed to result in a greater extent of blasting footage and relatively lower explosive consumption. These research findings provide a reference point for the rapid and efficient construction of small-section tunnel engineering, as well as the design of straight-hole cut blasting with reduced consumption.