We evaluated the single-cycle structural properties for axial compression, torsion, and 4-point bending with a central load applied to the caudal or lateral surface of a diaphyseal segment from the normal adult equine humerus, radius, third metacarpal bone, femur, tibia, and third metatarsal bone. Stiffness values were determined from load-deformation curves for each bone and test mode. Compressive stiffness ranged from a low of 2,690 N/mm for the humerus to a high of 5,670 N/mm for the femur. Torsional stiffness ranged from 558 N.m/rad for the third metacarpal bone to 2,080 N.m/rad for the femur. Nondestructive 4-point bending stiffness ranged from 3,540 N.m/rad for the radius to 11,500 N.m/rad for the third metatarsal bone. For the humerus, radius, and tibia, there was no significant difference in stiffness between having the central load applied to the caudal or lateral surface. For the third metacarpal and metatarsal bones, stiffness was significantly (P < 0.05) greater with the central load applied to the lateral surface than the palmar or plantar surface. For the femur, bones were significantly (P < 0.05) stiffer with the central load applied to the caudal surface than the lateral surface. Four-point bending to failure load-deformation curves had a bilinear pattern in some instances, consisting of a linear region at lower bending moments that corresponded to stiffness values from the nondestructive tests and a second linear region at higher bending moments that had greater stiffness values. Stiffness values from the second linear region ranged from 4,420 N.m/rad for the humerus to 13,000 N.m/rad for the third metatarsal bone. Differences in stiffness between nondestructive tests and the second linear region of destructive tests were significant (P < 0.05) for the radius, third metacarpal bone, and third metatarsal bone. Difference between stiffness values of paired left and right bones was not detected for any test. Four-point bending ultimate failure bending moments ranged from 260 N.m for the femur to 940 N.m for the third metatarsal bone. There was no difference in failure bending moment between the directions of applied central load for a given bone.

A matched case-control study design was used to assess the effects of long-term administration of a prolonged release formulation of bovine somatotropin (sometribove) on clinical lameness and limb lesions in dairy cows. Cows treated with sometribove for at least 2 lactations (cases) and nontreated dairy cows matched by herd, parity, age, and stage of lactation (controls) in 8 herds were evaluated for clinical lameness (as assessed by gait abnormality) and limb lesions by 2 observers, using a standardized scoring procedure at a single herd visit. Although a high proportion of the study cows were clinically lame (43%), an association was not detected between chronic administration of sometribove and prevalent lameness. Of 21 types of limb lesions identified, 2 were positively associated and 2 were negatively associated with long-term sometribove use. Superficial laceration of the tarsus (odds ratio [OR] = 2.1) and superficial swelling of the metatarsophalangeal joint (OR = 4.5) were positively associated with sometribove treatment, whereas femoral lesions (OR = 0.2) and superficial lacerations of the femur (OR = 0.14) were negatively associated with sometribove treatment.

Effects of temperature and storage time on canine bone-transfixation pin specimens were tested by comparing pin pull-out forces. A total of 16 femurs from 8 mature dogs were tested. Five nonthreaded Steinmann pins were placed through both cortices in the diaphysis of each femur. The femurs were then sectioned transversely between each pin, with a bonepin specimen placed evenly into each of 5 groups prior to biomechanical testing. Four bone-pin specimen groups were stored at -20 or -70 C for 14 or 28 days, while 1 specimen group was immediately tested. Pull-out forces for frozen groups were compared with pull-out forces for the fresh group. Using two-way ANOVA, there was no statistical difference in mean axial-extraction forces among bonepin specimen in any of the tested groups. It is concluded that acute pin pull-out forces are not significantly affected by freezing temperature or time. However, specimens stored at -20 C for as few as 14 days had a trend for increased pull-out forces, compared with freshly harvested specimens. Therefore, the authors recommend storage of bone-pin specimens at -70 C when possible.