Environmental pollution by heavy metals (HMs) has raised considerable attention due to their toxic impacts on plants, animals and human beings. Thus, the environmental cleanup of these toxic (HMs) is extremely urgent both from the environmental and biological point of view. To remediate HMs-polluted environment, several nanoparticles (NPs) such as metals and its oxides, carbon materials, zeolites, and bimetallic NPs have been documented. Among these, Fe-based NPs have emerged as an effective choice for remediating environmental contamination, due to infinite size, high reactivity, and adsorption properties. This review summarizes the utilization of various Fe-based NPs such as nano zero-valent iron (NZVI), modified-NZVI, supported-NZVI, doped-NZVI, and Fe oxides and hydroxides in remediating the HMs-polluted environment. It presents a comprehensive elaboration on the possible reaction mechanisms between the Fe-based NPs and heavy metals, including adsorption, oxidation/reduction, and precipitation. Subsequently, the environmental factors (e.g., pH, organic matter, and redox) affecting the reactivity of the Fe-based NPs with heavy metals are also highlighted in the current study. Research shows that Fe-based NPs can be toxic to living organisms. In this context, this review points out the environmental hazards associated with the application of Fe-based NPs and proposes future recommendations for the utilization of these NPs.

Industrial dye effluents, which are a major wastage component that enter the natural environment, pose a significant health risk to human and aquatic life. Therefore, the effective removal of dye effluents is a major concern. Against this backdrop, in this study, a low-cost, earth-abundant, and ecofriendly ɤ-Fe₂O₃–PPy nanocomposite was prepared employing the conventional hydrothermal method. The morphology, functional groups, and elemental composition of ɤ-Fe₂O₃–PPy were characterized by XRD, SEM, XPS, and FTIR studies. Under optimized conditions, the prepared novel ɤ-Fe₂O₃–PPy nanocomposite showed a high methylene blue (MB) adsorption capacity of 464 mg/g, which is significantly higher than that of existing adsorbents such as CNTs and polymer-modified CNTs. The adsorption parameters such as pH, adsorbent dosage, and ionic strength were optimized to enhance the MB adsorption capacity. The adsorption results revealed that MB is adsorbed onto the adsorbent surface via electrostatic interactions, hydrogen bonding, and chemical binding interactions. In terms of practical application, the adsorbent’s adsorption–desorption ability in conjunction with magnetic separation was investigated; the prepared ɤ-Fe₂O₃–PPy nanocomposite exhibited excellent adsorption and desorption efficiencies over more than seven adsorption–desorption cycles.

Disinfection means the killing of pathogenic organisms (e.g. bacteria and its spores, viruses, protozoa and their cysts, worms, and larvae) present in water to make it potable for other domestic works. The substances used in the disinfection of water are known as disinfectants. At municipal level, chlorine (Cl₂), chloramines (NH₂Cl, NHCl₂), chlorine dioxide (ClO₂), ozone (O₃) and ultraviolet (UV) radiations, are the most commonly used disinfectants. Chlorination, because of its removal efficiency and cost effectiveness, has been widely used as method of disinfection of water. But, disinfection process may add several kinds of disinfection by-products (DBPs) (∼600–700 in numbers) in the treated water such as Trihalomethanes (THM), Haloacetic acids (HAA) etc. which are detrimental to the human beings in terms of cytotoxicity, mutagenicity, teratogenicity and carcinogenicity. In water, THMs and HAAs were observed in the range from 0.138 to 458 μg/L and 0.16–136 μg/L, respectively. Thus, several regulations have been specified by world authorities like WHO, USEPA and Bureau of Indian Standard to protect human health. Some techniques have also been developed to remove the DBPs as well as their precursors from the water. The popular techniques of DBPs removals are adsorption, advance oxidation process, coagulation, membrane based filtration, combined approaches etc. The efficiency of adsorption technique was found up to 90% for DBP removal from the water.

Excess fluoride concentration in drinking water is a global issue, as this has an adverse effect on human health. Several adsorbents have been synthesized from natural raw material to remove fluoride from water. Reported adsorbents have some problems with the leaching of metal ions, fewer adsorption sites, and low adsorption capacity. Therefore, to address this, an effective biomaterial derived from the Luffa cylindrica (LC), containing many active sites, was integrated with a nano form of cerium oxide to form a robust, biocompatible, highly porous, and reusable LC–Ce adsorbent. This synthesized biosorbent offers better interaction between the active sites of LC–Ce and fluoride, resulting in higher adsorption capacity. Several factors, influence the adsorption process, were studied by a central composite design (CCD) model of statistical analysis. Langmuir’s and Freundlich’s models well describe the adsorption and kinetics governed by the pseudo–second–order model. The maximum monolayer adsorption capacity was found to be 212 and 52.63 mg/g for LC–Ce and LC, respectively determined by the Langmuir model. Detailed XPS and FTIR analyses revealed the underlying mechanism of fluoride adsorption via ion-exchange, electrostatic interaction, H–bonding, and ion-pair formation. All the results indicate that LC–Ce could serve as a suitable adsorbent for efficient fluoride removal (80–85%).

Zeolite-supported nanoscale zero-valent iron (Z-NZVI) has great potential for metal(loid) removal, but its encapsulation mechanisms and ecological risks in real soil systems are not completely clear. We conducted long-term incubation experiments to gain new insights into the interactions between metal(loid)s (Cd, Pb, As) and Z-NZVI in naturally contaminated farmland soils, as well as the alteration of indigenous bacterial communities during soil remediation. With the pH-adjusting and adsorption capacities, 30 g kg⁻¹ Z-NZVI amendment significantly decreased the available metal(loid) concentrations by 10.2–96.8% and transformed them into strongly-bound fractions in acidic and alkaline soils after 180 d. An innovative magnetic separation of Z-NZVI from soils followed by XRD and XPS characterizations revealed that B-type ternary complexation, heterogeneous coprecipitation, and/or concurrent redox reactions of metal(loid)s, especially the formation of Cd₃(AsO₄)₂, PbFe₂(AsO₄)₂(OH)₂, and As⁰, occurred only under specific soil conditions. Sequencing of 16S rDNA using Illumina MiSeq platform indicated that temporary shifts in iron-resistant/sensitive, pH-sensitive, denitrifying, and metal-resistant bacteria after Z-NZVI addition were ultimately eliminated because soil characteristics drove the re-establishment of indigenous bacterial community. Meanwhile, Z-NZVI recovered the basic activities of bacterial DNA replication and denitrification functions in soils. These results confirm that Z-NZVI is promising for the long-term remediation of metal(loid)s contaminated farmland soil without significant ecotoxicity.

Hexavalent chromium has aroused a series of environmental concerns due to its high mobility and toxicity. Iron and manganese oxides usually coexist in the environments and influence the speciation and geochemical cycling of chromium. However, the interaction mechanism of iron-manganese oxides with dissolved Cr(VI) remains largely unknown. In this work, the interaction processes of dissolved Cr(VI) and manganite in the presence of goethite coating were investigated, and the effects of pH (2.0–9.0) and iron oxide content were also studied. Manganite-goethite composites were formed with uniform micromorphologies in the system of manganite and Fe(II). In the reaction system of single manganite and Cr(VI), manganite could only adsorb but not reduce Cr(VI), with the adsorption amount decreasing at higher pHs. In the reaction system of manganite-goethite composites and Cr(VI), adsorbed Cr(VI) was reduced to Cr(III) by Fe(II) on composites surface. The generated Cr(III) was then retained as Cr(OH)₃ on the mineral surface. Goethite coating suppressed the re-oxidation of newly formed Cr(III) by manganite. The amounts of adsorbed Cr(VI) and generated Cr(III) increased with increasing iron oxide content, and increased first and then decreased with increasing pH. The Cr(III) formation and Cr(VI) adsorption amount reached the maximum at pH 5.0–6.0. The present work highlights the transformation and retention of Cr(VI) by iron-manganese oxides and provides potential implications for the use of such oxides in the remediation of Cr(VI) polluted waters and soils.

Porous carbon, which can be functionalized, is considered as a potential carbon material. Herein, two-dimensional (2D) nitrogen-doped magnetic Fe₃C/C (NMC) was prepared by a simple carbonization method using potassium humate (HA-K) as raw material. Remarkably, two templates, g-C₃N₄ and KCl, were formed in situ during the carbonization process, which provide the necessary conditions for the formation of 2D NMC. The NMC was comprehensively studied by different characterization methods. The results show that NMC has a large surface area and mesoporous structure. The prepared NMC-0.50 was used to test the removal performance of Cr(VI). The effects of pH value, coexisting ions and time on Cr(VI) removal performance were investigated, and the adsorption kinetics, isotherm and thermodynamics were studied. The results showed that the adsorption isotherm model of NMC-50 accorded with the Langmuir model, and the maximum adsorption capacity was 423.73 mg g⁻¹. The reaction mechanism of Cr(VI) is adsorption and redox reaction. In addition, NMC-0.50 exhibit high selectivity, separability and regeneration performance. A convenient means for the synthesis of NMC was designed in this work, and demonstrate that NMC has practical value as an adsorbent.

The increased occurrence of Mercury (Hg II) contaminant has caused environmental and health concerns worldwide. Removal of Hg(II) from water is of significant interest, in particular if these can be coupled in a manner of detection. Here, a novel activated carbon (AC) adsorbent and a fast detection device to form a closed-cycle strategy was developed. The synthesis of conjugates of streptavidin-biotinylated DNA probes modified gold nanoparticle was used with lateral flow biosensors for Hg(II) detection. A quantification was completed via a self-developed smartphone app and its limit of detection was 2.53 nM. Moreover, AC was activated with a new activating agent of diammonium hydrogen phosphate. The adsorbent was characterized and determined to have an amorphous microporous structure with a high surface area (1076.5 m² g⁻¹) and demonstrated excellent removal efficiency (99.99%) and adsorption capacity (∼100 mg g⁻¹) for Hg(II). The kinetics of the pseudo-second-order model and the mechanisms of electrostatic adsorption, ion exchange, and complex reactions are provided. The proposed closed-cycle strategy can be useful for early, fast, and mobile detection of Hg (II) pollution, followed by its effective removal during water treatment.

Riverbed sediments are the interface layer in riverine ecosystems connecting the overlying medium of water and the vadose zone. The transport behavior of phosphorus (P), which has been recognized as the primary cause of freshwater eutrophication, in riverbed sediments remains unclear. Understanding the impact of riverbed sediments on P transport is a necessary prerequisite for the development of appropriate strategies to reduce potential groundwater pollution. In this study, riverbed sediments were collected from the upstream, midstream, and downstream sections of the Beiyun River, China, and packed into vertical soil columns to perform leaching experiments to quantify P transport characteristics. In addition, the impact mechanisms were further explored by conducting laboratory batch tests of P adsorption and desorption. The results demonstrated that approximately 80% of P can be adsorbed by riverbed sediments in soil column leaching experiment, and a tailing phenomenon was observed in its desorption. The hydraulic conductivity properties of riverbed sediments were evaluated by the advection-dispersion equation, showing a gradually decreasing adsorption capacity for P from upstream to downstream sections, which was supported by the results obtained from adsorption–desorption thermodynamic and kinetic batch tests. The estimated annual leaching masses of P increased from 60.72 g/(m² a) in the upstream section to 132.31 g/(m² a) in the downstream section. The role of riverbed sediments as a source or sink of P is possibly determined by their coarse sand particles content, and the mean equilibrium P concentration (EPC0). The competitive relationship between P and other forms of nutrients also has an important influence on its source-sink role. These findings suggest that the prevention of the potential P leaching is most needed in the downstream sections of Beiyun River, and corresponding control strategies should be developed to avoid groundwater pollution.

Soils have the ability to modify contaminant bioavailability and toxicity. Prediction the modifying effect of soil on arsenic phytoaccumulation and phytoavailability using either soil property data or soil chemical extraction data in risk assessment of contaminated soil is highly desirable. In this study, plant bioassays important to ecological receptors, were conducted with 20 soils with a wide range in chemical and physical soil properties to determine the relationships between As measured by soil chemical extraction (soil pore water, Bray-1, sodium phosphate solution, hydroxylamine hydrochloride, and acid ammonium oxalate) or soil physico/chemical properties on arsenic phytotoxicity and phytoaccumulation. Soil pore water As and Bray-1 extracted As were significantly (P < 0.01) correlated with lettuce tissue As and those extractants and sodium phosphate were correlated with ryegrass tissue As. Hydroxylamine and acid ammonium oxalate extractions did not correlate with plant bioassay endpoints. Simple regression results showed that lettuce tissue relative dry matter growth (RDMG) was inversely related to tissue As concentration (r² = 0.85, P < 0.01), with no significant relationship for ryegrass. Soil clay exhibited strong adsorption for As and significantly reduce tissue As for lettuce and ryegrass. In addition to clay content, reactive aluminum oxide (AlOx), reactive Fe oxide (FeOx) and eCEC was inversely related to ryegrass tissue As. Multiple regression equation was strongly predictive (r² = 0.83) for ryegrass tissue As (log transformed) using soil AlOx, organic matter, pH, and eCEC as variables. Soil properties can greatly reduce contaminant phytoavailability, plant exposure and risk, which should be considered when assessing contaminant exposure and site-specific risk in As-contaminated soils.