The presence of synthetic dyes in textile wastewater is a problematic issue for environmentalist. Nowadays, dye removal is practiced via different methods. Among all these methods, biodecolorization is an ideal technique. The present research apples vermicompost microflora to remove reactive black- C, pH = 7, and under anaerobic condition. At 36h, removal efficiencies of 94.79%, 94.06%, and 93.6% are obtained for concentrations of 800, 850, and 950 mg/ L, respectively. It has also been observed that when the initial concentration rises to 1400 mg/ L, the efficiency drops to 51.57% at 36h. Also, methyl red, methyl orange, eriochrome black-t, and acid blue-113 could be decolorized by the isolated bacterial strain with an efficiency of 94.29%, 92.10%, 90.83%, and 88.95%, respectively. Phytotoxicity Test shows that the parent form of reactive black-5 has not been toxic for the seeds (100% germination for Triticum aestivum and 90% for Maize). When reactive black-5 is treated with isolated bacterial strain under anaerobic condition, none of the seeds remain germinated which might be due to the possible formation of toxic aromatic amines intermediates. Therefore, ultraviolet C + 100 mM H2O2 has been used as the post-treatment process for detoxifying of by-products. After the integrated treatment of synthetic wastewater, containing RB-5, complete germination (100%) of Triticum aestivum and Maize is observed. In the post-treatment process, due to the generation and activation of hydroxyl radicals, the toxic aromatic amines compounds convert to the less toxic compounds.

In this work, anthraquinone-2-sulfonate (AQS) was covalently immobilized onto activated carbon cloth (ACC), to be used as redox mediator for the reductive decolorization of reactive red 2 (RR2) by an anaerobic consortium. The immobilization of AQS improved the capacity of ACC to transfer electrons, evidenced by an increment of 3.29-fold in the extent of RR2 decolorization in absence of inhibitors, compared to incubations lacking AQS. Experiments conducted in the presence of vancomycin, an inhibitor of acidogenic bacteria, and with 2-bromoethane sulfonic acid (BES), an inhibitor of methanogenic archaea, revealed that acidogenic bacteria are the main responsible for RR2 biotransformation mediated by immobilized AQS. Nonetheless, the results also suggest that some methanogens are able to maintain their capacity to use immobilized AQS as an electron acceptor to sustain the decolorization process, even in the presence of BES.

Dust samples were collected from four indoor environments, including childcare facilities, houses, hair salons, and a research facility from the USA and were analyzed for brominated compounds using full scan liquid chromatography high-resolution mass spectrometry. A total of 240 brominated compounds were detected in these dust samples, and elemental formulas were predicted for 120 more abundant ions. In addition to commonly detected brominated flame retardants (BFRs), nitrogen-containing brominated azo dyes (BADs) were among the most frequently detected and abundant. Specifically, greater abundances of BADs were detected in indoor dusts from daycares and salons compared to houses and the research facility. Using authentic standards, a quantitative method was established for two BADs (DB373: Disperse Blue 373 and DV93: Disperse Violet 93) and 2-bromo-4,6-dinitroaniline, a commonly used precursor in azo dye production, in indoor dust. Generally, greater concentrations of DB373 (≤3850 ng/g) and DV93 (≤1190 ng/g) were observed in indoor dust from daycares highlighting children as a susceptible population to potential health risk from exposure to BADs. These data are important because, to date, targeted analysis of brominated compounds in indoor environments has focused mainly on BFRs and appears to underestimate the total amount of brominated compounds.

Zero valent iron (ZVI)–microbe technology has an increasing application on the removal of organic pollution, yet the molecular mechanism of microbe respond to ZVI is still a mystery. Here, we established a successive ZVI-enhanced microbial system to remove azo dye (a typical organic pollutant) by Shewanella decolorationis S12 (S. decolorationis S12, an effective azo dye degradation bacterium) and examined the gene expression time course (10, 30, 60, and 120 min) by whole genome transcriptional analysis. The addition of ZVI to the microbial degradation system increases the rate of azo reduction from ~60% to over 99% in 16 h reaction, suggesting the synergistic effect of ZVI and S12 on azo dye degradation. Comparing with the treatment without ZVI, less filamentous cells were observed in ZVI treated system, and approximately 8% genes affiliated with 10 different gene expression profiles in S. decolorationis S12 were significantly changed in 120 min during the ZVI-enhanced azo reduction. Intriguingly, MarR transcriptional factor might play a vital role in regulating ZVI-enhanced azo reduction in the aspect of energy production, iron homeostasis, and detoxification. Further investigation showed that the induced [Ni–Fe] H₂ase genes (hyaABCDEF) and azoreductase genes (mtrABC-omcA) contributed to ZVI-enhanced energy production, while the reduced iron uptake (hmuVCB and feoAB), induced sulfate assimilation (cysPTWA) and cysteine biosynthesis (cysM) related genes were essential to iron homeostasis and detoxification. This study disentangles underlying mechanisms of ZVI-enhanced organic pollution biotreatment in S. decolorationis S12.

Textile wastewater contains a huge amount of azo dyes and heavy metals and catastrophically deteriorates the agricultural field by affecting its phyisco-chemical/biological and nutritional properties when directly drained to agricultural lands without any treatment. Recently, biogenic copper nanoparticles (CuNPs) have gained considerable attention for photocatalytic degradation of wastewater pollutants owing to their unique physico-chemical and biological properties, low cost and environmental sustainability. The current study reports the synthesis of CuNPs by a native copper-resistant bacterial strain Escherichia sp. SINT7 and evaluation of the photocatalytic activity of the biogenic CuNPs for azo dye degradation and treatment of textile effluents. Scanning electron microscopy and transmission electron microscopy revealed the spherical shape of biogenic CuNPs with particle size ranging from 22.33 to 39 nm. Moreover, X-ray diffraction data revealed that the CuNPs have spherical crystalline shapes with an average particle size of 28.55 nm. FTIR spectra showed the presence of coating proteins involved in the stabilization of nanomaterial. Azo dye degradation assays indicated that CuNPs decolorized congo red (97.07%), malachite green (90.55%), direct blue-1 (88.42%) and reactive black-5 (83.61%) at a dye concentration of 25 mg L⁻¹ after 5 h of sunlight exposure. However, at 100 mg L⁻¹ dye concentration, the degradation percentage was found to be 83.90%, 31.08%, 62.32% and 76.84% for congo red, malachite green, direct blue-1 and reactive black-5, respectively. Treatment of textile effluents with CuNPs resulted in a significant reduction in pH, electrical conductivity, turbidity, total suspended solids, total dissolved solids, hardness, chlorides and sulfates as compared to the non-treated samples. Thus, the promising dye detoxification and textile effluent recycling efficiency of biogenic CuNPs may lead to the development of eco-friendly and cost-efficient process for large-scale wastewater treatment.

The toxicity of selected azo and anthracenedione dyes was studied using chronic exposures of embryo-larval fathead minnows (Pimephales promelas). Newly fertilized fathead minnow embryos were exposed through the egg stage, past hatching, through the larval stage (until 14 days post-hatch), with dye solutions renewed daily. The anthracenedione dyes Acid Blue 80 (AB80) and Acid Blue 129 (AB129) caused no effects in larval fish at the highest measured concentrations tested of 7700 and 6700 μg/L, respectively. Both azo dyes Disperse Yellow 7 (DY7) and Sudan Red G (SRG) decreased survival of larval fish, with LC50s (based on measured concentrations of dyes in fish exposure water) of 25.4 μg/L for DY7 and 16.7 μg/L for SRG. Exposure to both azo dyes caused a delayed response, with larval fish succumbing 4–10 days after hatch. If the exposures were ended at the embryo stage or just after hatch, the potency of these two dyes would be greatly underestimated. Concentrations of dyes that we measured entering the Canadian environment were much lower than those that affected larval fish survival in the current tests. In a total of 162 samples of different municipal wastewater effluents from across Canada assessed for these dyes, all were below detection limits. The similarities of the structures and larval fish responses for the two azo and two anthracenedione dyes in this study support the use of read-across data for risk assessment of these classes of compounds.

Herein, activated carbon supported modified with bimetallic-platin ruthenium nano sorbent (PtRu@AC) was synthesized by a thermal decomposition process and used in the removal of methylene blue (MB) from aqueous solutions. The synthesized nano sorbents were characterized by X-ray Diffraction (XRD), Transmission Electron Microscopy (TEM), and X-ray Photoelectron Spectroscopy (XPS) spectroscopic techniques. The data obtained from characterization studies showed that PtRu@AC nano sorbent was highly crystalline and in a form of PtRu alloy with a monodispersed composition. The results indicated that the maximum adsorption capacity (qemax) for the removal of MB with PtRu@AC under optimum conditions was detected to be 1.788 mmol/g (569.4 mg/g). The experimental kinetic results of the study revealed that the adsorption of methylene blue was found to be more compatible with the false second-order model compared to some tested models. Calculations for thermodynamic functions including enthalpy change (ΔHo), entropy change (ΔSo), and Gibbs free energy change (ΔGo) values were performed to get an idea about the adsorption mechanism. As a result, the synthesized PtRu@AC nano adsorbent was detected as a highly effective adsorbent material in the removal of MB from aquatic mediums.

A biocomposite system was developed and tested for the removal of the azo dye Reactive Red (RR195) from wastewater. The biocomposite was synthesized using ceramic particles containing 75% alumina which were coated using chitosan cross-linked with oxalic acid. The biocomposite showed high performance at low pH (maximum adsorption capacity = 345.3mg.g⁻¹ at pH=2.0). The physicochemical and structure characteristics of the matrix were evaluated by Z-potential, FTIR-ATR, SEM-EDS, XRD, and porosity. Langmuir sorption isotherm and pseudosecond-order model gave the best fit. The electrostatic interaction between RR195 (due to the sulfonate groups) and the free amino groups of chitosan, enabled successive desorption/regeneration cycles. The maximum removal percentage (>80%) occurred at pH=2.0 due to the cross-linking effect. Experiments at different temperatures allowed the calculation of thermodynamic parameters (ΔG, ΔS, ΔH); adsorption was spontaneous, exothermic, and enthalpy controlled. The presence of inorganic ions ([Formula: see text]) was analyzed during the adsorption process. This novel biocomposite can be applied as a cost-effective and environmentally friendly adsorbent for anionic azo dye removal from wastewater. The application of chitosan cross-linked with oxalic acid as a coating of the ceramic support enhanced the adsorption capacity and enabled its use under acidic conditions without solubilization.

Phytoremediation is an innovative, eco-friendly, and solar-driven technique, which becomes a well-known alternative solution for remediation of hazardous dyes from wastewater. In present research work, potential of a submerged fresh water macroalgae Chara vulgaris L. (C. vulgaris) examined for removal of acidic azo dye methyl red (MR) in its solution form. A series of experiments were done with C. vulgaris to predict the effects of different parameters viz. contact time, initial dye concentration, amount of macroalgae, and pH. The increase in initial dye concentration directly impacts on the potential of macroalgae. The decolorization percentage declined with increase in initial dye concentration. The equilibrium condition was found to achieve after contact time of approximately 48 h. The decolorization of MR dye was found to be favorable at pH 5. The macroalgae was successfully utilized repeatedly with MR for eight cycles in batch experiments. The kinetics of phytoremediation of MR dye was studied with help of pseudo-first-order, pseudo-second-order, and Elovich kinetic models and the results were well suited to pseudo-second-order kinetic model with the correlation value R² ≥ 0.99. In addition, the experimental data was also assessed by using Langmuir and Freundlich adsorption equilibrium isotherms. The results of phytoremediation data was found to be in favor of Freundlich equilibrium isotherm which having the correlation value R² ≥ 0.977. The intraparticle diffusion model also studied to interpret the macroalgae phytoremediation mechanism for phytoremediation of MR. The surface interactions of C. vulgaris were investigated before and after the removal of dye with Fourier transform-infrared spectroscopy (FTIR) technique. On the basis of these studies, a hypothetical mechanism has also been proposed to depict the phytoremediation of acidic azo dye by C. vulgaris.

The removal kinetics and mechanism of active black removal by zero-valent iron were investigated. The experimental results showed that the rate of reactive black removal by zero-valent iron increased with the decreasing of pH and initial dye concentration, and increased with the increasing of temperature and ZVI dosage. SO42- promoted the removal rate of reactive black. Ca2+ had an inhibitory effect on the removal of reactive black in the early stage by zero-valent iron and promoted it in the later stage, while Mg2+, CO32-, ClO4-, NO3-, PO43- and HCO3- all inhibited the removal rate of reactive black by zero-valent iron. The activation energy was 26.38 KJ mol-1 by using the Arrhenius formula, indicating that this reaction was easy to occur. The degradation process was further analysed by UV-Vis, SEM and XRD, and the main reaction product was Fe2O3.