A waste-oil contaminated site situated near a river is supposed to be cleaned-up by means of different but complementary methods. On the basis of a research project, target values have been developed in close cooperation between the participant parties for the saturated and the unsaturated soil layers. The clean-up targets are introduced and discussed.

India struggles with frequent exceedances of the ambient air quality standard for particulate matter and benzene. In the past two decades, India has made considerable progress in tackling indoor air pollution, by phasing out kerosene lamps, and pushing biofuel using households towards Liquefied Petroleum Gas (LPG) usage. In this study, we use updated emission inventories and trends in residential fuel consumption, to explore changes in the contribution of different sectors towards India's largest air pollution problem. We find that residential fuel usage is still the largest air pollution source, and that the <10% households using cow dung as cooking fuel contribute ∼50% of the residential PM₂.₅ emissions. However, if current trends persist, residential biofuel usage in India is likely to be phased out by 2035. India's renewable energy policies are likely to reduce emissions in the heat and electricity sector, and manufacturing industries, in the mid-term. PM₂.₅ emissions from open waste burning, on the other hand, hardly changed in the decade from 2010 to 2020. We conclude that without strong policies to promote recycling and upcycling of non-biodegradable waste, and the conversion of biodegradable waste to biogas, open waste burning is likely to become India's largest source of air pollution by 2035. While our study is limited to India, our findings are of relevance for other countries in the global South suffering from similar waste management challenges.

Benzene exposure can cause pancytopenia and immunosuppression, leading to serious diseases such as aplastic anemia (AA) or acute myeloid leukemia (AML), but the underlying mechanism has not been fully elucidated. Hypoxia-inducible factor 1 (HIF-1) is an important transcription factor that regulates many downstream target genes. In this study, we reported a novel mechanism by which high expression of HIF-1α alleviated benzene toxicity. Mice with high expression of HIF-1α (HIF-1α⁺) were obtained by the Tet-on system and doxycycline induction, and they and wild-type (WT) mice were exposed to 150 mg/kg benzene for 0, 1, 3, 7, 10, 14, and 28 days. Dynamic changes in hematopoietic and immune-related indicators and the role of HIF-1α were explored. The level of white blood cells in mice reached the highest level on the third day, and immunity was activated and then suppressed within 10 days. Significant pancytopenia and immunosuppression occurred at 14 days and were more pronounced at 28 days. The levels of HIF-1α, EPO, VEGF, RORγt, and IL-17 in WT mice gradually decreased with increasing benzene exposure days, while the levels of Foxp3 and IL-10 increased. These changes were alleviated in HIF-1α⁺ mice. High expression of HIF-1α increased the levels of EPO and VEGF, which helped to maintain the stability of the hematopoietic microenvironment. Simultaneously, it attenuated benzene-induced immunosuppression by alleviating the Th17/Treg imbalance. HIF-1α is expected to be a new target for benzene-induced diseases such as AA and AML.

Benzene is a common environmental carcinogen that induces leukemia. Studies suggest that metabolic disorder has a relationship with the toxicity of benzene. Pyruvate kinase M2 (PKM2) is a key rate-limiting enzyme in glycolysis. However, the upstream and downstream regulatory mechanisms of PKM2 in benzene-induced hematotoxicity and the therapeutic effects of targeting PKM2 in vivo are unclear. This study aims to provide insights into the new mechanism of benzene-induced hematotoxicity and reveal the therapeutic significance of targeting PKM2. Herein, we demonstrated that PKM2-dependent glycolysis contributes to benzene-induced hematotoxicity by regulating inflammation reaction. Mechanistically, acetylated proteomics revealed that 1,4-benzoquinone (1,4-BQ) induced acetylation of PKM2 at position K66, and this modification contributed to the increase of PKM2 expression and can be inhibited by inhibition of acetyltransferase GCN5. Meanwhile, the elevated PKM2 was shown to prompt the activation of nuclear phosphorylated Stat3 (p-Stat3) and IL17A. Clinically, pharmacological inhibition of PKM2 alleviated the blood toxicity induced by benzene, which was mainly characterized by an increase in routine blood parameters and improvement of hematopoietic imbalance. Besides, elevated PKM2 is a promising biomarker in people occupationally exposed to benzene. Overall, we identified PKM2/p-Stat3/IL-17A axis participates in the hematotoxicity of benzene, and targeting PKM2 has certain therapeutic implications in hematologic diseases.

Single-chemical thresholds cannot comprehensively evaluate the risk of chemical mixture exposure in indoor air. Moreover, a large number of researches have focused on short-term and high-concentration co-exposure scenarios related to different species, based on diverse endpoints, which hampers the application and improvement of existing risk evaluation models of chemical mixture exposures. More importantly, current risk evaluation models are not user-friendly for construction practitioners who do not have sufficient toxicological knowledge. Therefore, in this study, an inhalation experiment system and a hazard index (HI) were developed to investigate the risks associated with low-concentration and long-term inhalation exposure scenarios of formaldehyde and benzene, individually and combined, based on Drosophila melanogaster mortality. The results showed that the system exhibited good reproducibility in providing stable exposure concentrations during D. melanogaster life cycle. Furthermore, in a range of experimental concentrations, the interaction between formaldehyde and benzene was additive or synergistic, which was concentration- and ratio-dependent. This study is of great significance in harmonising and providing toxicity data under long-term and low-concentration exposure scenarios, which is beneficial for establishing a new user-friendly risk evaluation model for indoor chemical mixture exposures. It should be noted that the proposed HI value could indicate the hazard degrees of long-term inhalation exposures of formaldehyde and benzene, individually and combined, to D. melanogaster. However, the applicability of this index requires further experiments to evaluate the exposure risks of other volatile organic compounds (VOCs) to D. melanogaster.

Since an invention of synthetic fibers (textiles), our life quality has been improved. However, the cumulative production and disposal of them have perceived as significant since they are not biodegradable and hard to be upcycled/recycled. From washing textiles, microplastics are released into the environment, which are regarded as emerging contaminants. As a means for source reduction of microplastics, this study proposed a rapid disposal platform for waste textiles (WTs), converting them into value-added products. To this end, catalytic pyrolysis of WT was studied. To offer more environmentally sound process, CO₂ was used as a raw material for WT pyrolysis. Thermal cracking of WT led to the production of syngas and CH₄ under the CO₂ environment. CO₂ resulted in additional CO production via gas phase reaction with volatile compounds evolved from pyrolysis of WT. To expedite the reaction kinetics for syngas formation, catalytic pyrolysis was done over Co-based catalyst. Comparing to non-catalytic pyrolysis, CO₂-assisted catalytic pyrolysis had 3- and 8-times higher production of H₂ and CO, respectively. This process also suppressed catalyst deactivation, converting more than 80 wt% of WT into syngas and CH₄. The more generation of CO from the use of CO₂ as a raw material offers an effective means to minimize the formations of harmful chemical species, such as benzene derivatives and polycyclic aromatic hydrocarbons.

Traffic source–dominated volatile organic compound (VOC) samples were collected during four time-intervals in a day (Ⅰ: 7:30–10:30, Ⅱ: 11:00–14:00, Ⅲ: 16:30–19:30, and Ⅳ: 20:00–23:00) in a tunnel in summer, 2019, in Xi’an, China. The total measured VOC (TVOC) in periods Ⅰ and Ⅲ (rush hours, 107.2 ± 8.2 parts per billion by volume [ppbv]) was 1.8 times that in periods Ⅱ and Ⅳ (non-rush hours, 58.6 ± 13.8 ppbv), consistent with the variation in vehicle numbers in the tunnel. The considerably elevated ethane and ethylbenzene levels could have been attributed to emissions from compressed natural gas vehicles and the rapid development of methanol-fueled taxis in Xi’an in 2019. The mixing ratios of benzene, toluene, ethylbenzene, and xylenes (BTEX) contributed 9.4%–12.7% to TVOCs, and the contributions were nearly 40% higher in periods Ⅰ and Ⅲ than in Ⅱ and Ⅳ, indicating that BTEX levels were strongly affected by vehicle emissions. The indicators of motor vehicle emission, namely ethylene, propylene, toluene, m/p-xylenes, o-xylene, and propane, contributed to more than half of the ozone formation potential in this study. The noncarcinogenic risks of VOCs in this study were within the international safety standard, whereas the carcinogenic risks exceeded the standard by 2.3–4.6 times, suggesting that carcinogenic risks were more serious than noncarcinogenic risks. VOCs presented 2.2 and 1.4 times noncarcinogenic and carcinogenic risks during rush hours than during non-rush hours, respectively. Notably, the carcinogenic risk in period Ⅳ was comparable with that in period Ⅲ; however, the vehicle numbers and VOC mixing ratios were the lowest at night, which may have attributed to the increasing number and proportion of methanol M100-fueled vehicles in the tunnel. Therefore, VOCs emitted by new energy vehicles should also be seriously considered while evaluating fossil fuel vehicle emissions.

Polycyclic aromatic hydrocarbons (PAHs) are compounds with two or more benzene rings whose hydroxylated metabolites (OH-PAHs) are excreted in urine. Human PAH exposure is therefore commonly estimated based on urinary OH-PAH concentrations. However, no study has compared PAH exposure estimates based on urinary OH-PAHs to measurements of PAH levels in blood samples. Estimates of PAH exposure based solely on urinary OH-PAHs may thus be subject to substantial error. To test this hypothesis, paired measurements of parent PAHs in serum and OH-PAHs in urine samples from 480 participants in Guangzhou, a typical developed city in southern China, were used to investigate differences in the estimates of human PAH exposure obtained by sampling different biological matrices. The median PAH concentration in serum was 4.05 ng mL⁻¹, which was lower than that of OH-PAHs in urine (8.33 ng mL⁻¹). However, serum pyrene levels were significantly higher than urinary levels of its metabolite 1-hydroxypyrene. Concentrations of parent PAHs in serum were not significantly correlated with those of their metabolites in urine with the exception of phenanthrene, which exhibited a significant negative correlation. Over 28% of the participants had carcinogenic risk values above the acceptable cancer risk level of 10⁻⁶. Overall, estimated human exposure and health risks based on urinary 1-hydroxypyrene levels were only 13.6% of those based on serum pyrene measurements, indicating that estimates based solely on urine sampling may substantially understate health risks due to PAH exposure.

The valorization of municipal solid waste incineration bottom and fly ashes (IBA and IFA) as catalysts for thermochemical plastic treatment was investigated. As-received, calcined, and Ni-loaded ashes prepared via hydrothermal synthesis were used as low-cost waste-derived catalysts for in-line upgrading of volatile products from plastic pyrolysis. It was found that both IBA and air pollution control IFA (APC) promote selective production of BTEX compounds (i.e., benzene, toluene, ethylbenzene, and xylenes) without significantly affecting the formation of other gaseous and liquid species. There was insignificant change in the product distribution when electrostatic precipitator IFA (ESP) was used, probably due to the lack of active catalytic species. Calcined APC (C-APC) demonstrated further improvement in the BTEX yield that suggested the potential to enhance the catalytic properties of ashes through pre-treatment. By comparing with the leaching limit values stated in the European Council Decision, 2003/33/EC for the acceptance of hazardous waste at landfills, all the ashes applied remained in the same category after the calcination and pyrolysis processes, except the leaching of Cl⁻ from the ESP, which was around the borderline. Therefore, the use of ashes in catalytic reforming application do not significantly deteriorate their metal leaching behavior. Considering its superior catalytic activity towards BTEX formation, C-APC was loaded with Ni at 15 and 30 wt%. The Ni-loading favored an increase in overall oil yield, while reducing the gas yield when compared to the benchmark Ni loaded ZSM catalyst. However, Ni addition also caused the formation of more heavier hydrocarbons (C20–C35) that would require post-treatment to recover favorable products like BTEX.

An in-depth study was conducted to quantify and characterize VOC emissions from a petroleum refinery located in Shandong, China. The VOC emission inventory established in this study showed that storage tanks were the largest emission source, accounting for 56.4% of total emissions, followed by loading operations, wastewater collection and treatment system, process vents, and equipment leaks. Meanwhile, the localization factors for refining, storage tanks and loading operations were calculated, which were 1.33, 0.75 and 0.31g VOCs/kg crude oil refined. Furthermore, the characteristics of fugitive and organized emissions were determined for various processes and emission sources using a gas chromatography–mass spectrometry/flame ionization detection (GC-MS/FID) system. Most samples contained mainly alkanes, but the total VOC concentrations and key species varied greatly among processes. The source profile of the refinery, synthesized using the weighted average method, indicated that cis-2-butene (14.5%), n-pentane (10.2%), n-butane (7.4%), isopentane (6.5%) and MTBE (5.9%) were the major species released by this refinery. Assessment of O₃ and secondary organic aerosol formation potentials were completed, and the results indicated that cis-2-butene, m/p-xylene, toluene, n-pentane, isopentane, benzene, o-xylene and ethylbenzene were the active species for which treatment should be prioritized.