In modern society, the intense vehicle traffic and the lack of effective mitigating strategies may adversely impact freshwater systems. Road-deposited sediments (RDS) accumulate a variety of toxic substances which are transported into nature during hydrologic events, mainly affecting water bodies through stormwater runoff. The aim of this study was to evaluate the RDS metal enrichment ratio between the end of wet season and the middle of the dry season for Cd, Cr, Cu, Fe, Mn, Ni, Pb and Zn in samples from Natal, Brazil. Twenty RDS, drainage system and river sediment samples were collected in the wet and dry seasons using a stainless-steel pan, brush and spatula. In the laboratory, the samples were submitted to acid digestion and heavy metal concentrations were measured by atomic absorption spectrometry (AAS). A consistent RDS enrichment by heavy metals in dry season samples was followed by an increase in the finest particle size fraction (D < 63 μm). Maximum concentrations were 5, ND, 108, 23810, 83, ND, 77 and 150 mg kg⁻¹ for Cd, Cr, Cu, Fe, Mn, Ni, Pb and Zn, respectively. The RDS enrichment ratio was Cr(1.3 ×), Cu(2.6 ×), Fe(3.3 ×), Mn(1.5 ×), Pb(1.5 ×) and Zn(2.1 ×). The Geo-accumulation Index values showed that RDS were moderately polluted for Cu and slighted polluted for Zn and Pb. Principal Component Analysis (PCA) showed that the accumulation of toxic heavy metals decreased according to water flow.

Metal flux measurements inform the mobility, potential bioavailability and risk of toxicity for metals in contaminated sediments and therefore is an important approach for sediment quality assessment. The binding and release of metals that contribute to the net flux is strongly influenced by the presence and behaviors of benthic organisms. Here we studied the effects of bioturbation on the mobility and efflux of metals from multi-metal contaminated sediments that inhabited by oligochaete worms or both worms and bivalves. Presence of bivalves enhanced the release of Mn, Co, Ni and Zn but not for copper and chromium, which is likely due to the high affinities of copper and chromium for the solid phase. Metals in the overlying water were primarily associated with fractions smaller than 10 kDa, and the fractionation of all metals were not affected by the presence of the bivalve. Metal fluxes attributed to different processes were also distinguished, and the bioturbation induced effluxes were substantially higher than the diffusive effluxes. Temporal variabilities in the total net effluxes of Mn, Co, Ni and Zn were also observed and were attributed to the biological activities of the bivalves. Overall, the present study demonstrated that the response of different metals to the same bioturbation behavior was different, resulting in distinct mobility and fate of the metal contaminants.

Metals are released from biochar (BC) in either the free or dissolved organic carbon (DOC)-combined form. The complexation of metals with DOC influences their toxicity and bioavailability in the environment. The endogenous release of metal species with heterogeneous DOC from BC is very complex; this process has been neglected and remains unaddressed in the literature to date. In this study, the yield and chemical properties of labile DOC from BC were characterized, and the release of endogenous metal/metalloid elements (K, Mg, Mn, Fe, Al, Cu, and Si) and their species from BC with various pyrolysis temperatures and particle sizes were systematically investigated under various solution chemistries. The results showed that pyrolysis temperature of BC significantly influenced the yield and composition of DOC and DOC-metal/metalloid complexes, while particle size had lower impact. The yield of BC-derived DOC significantly decreased and the components gradually changed from low-molecular weight and low-aromaticity hydrophilic humic acid-like substances to complex high-molecular weight and high-aromaticity hydrophobic substances as pyrolysis temperature increased from 200 to 700 °C. The release of total dissolved metals decreased with increasing pyrolysis temperature, while the highest total dissolved Si was released from BC with the moderate pyrolysis temperature (500 °C). The metal elements were mainly released in the DOC-combined form, while the released Si was mainly in the free form in the neutral water environment. The release of DOC increased while that of dissolved metals decreased with increasing solution pH. The release of total dissolved metals/metalloids increased but the ratio of the DOC-combined metals/metalloids decreased with increasing solution ionic strength. These results provide new insight into the understanding of endogenous metal/metalloid release from BC in the natural environment.

Crested ibis (Nipponia nippon), one of the rarest birds in the world, was almost extinct in the historically widespread areas partly due to the environmental pollution. Therefore, non-invasive indicators of feather, eggshell, and excrement were used to investigate the exposure of this endangered bird to eleven trace elements in this study. The results indicated that crested ibises under in situ and ex situ conservations were diversely exposed to trace elements, with higher exposure levels of As, Cd, and Mn in the wild, but higher exposure levels of Hg, Se, and Zn in the captive breeding center. In addition, concentrations of As, Co, Cr, and Ni were significantly greater in the sediments of three types of foraging habitats for wild crested ibis, but concentration of Se was greater in the soil of captive cages. Feather and eggshell of crested ibis exhibited a very consistent indication for most of the trace elements, and concentrations of almost all of the elements in the excrements were very consistent with the results in the environmental samples (sediments or soils). Concentrations of As, Hg, Mn, and Zn in feathers, and Mn and Zn in eggshells of wild and captive crested ibis were greater than those in other similar species. Moreover, As, Cd, Cu, and Mn concentrations in excrement of wild crested ibises were greater than that in captive individuals and other species, but Se and Zn concentrations in excrement of captive crested ibises were greater than that of the wild and other species. The present study provided evidence that both of the wild and captive crested ibis were exposed to trace elements, which may be harmful to their health.

Pesticides guarantee us high productivity in agriculture, but the long-term costs have proved too high. Acute and chronic intoxication of humans and animals, contamination of soil, water and food are the consequences of the current demand and sales of these products. In addition, pesticides such as glyphosate are sold in commercial formulations which have inert ingredients, substances with unknown composition and proportion. Facing this scenario, toxicological studies that investigate the interaction between the active principle and the inert ingredients are necessary. The following work proposed comparative toxicology studies between glyphosate and its commercial formulation using the alternative model Caenorhabditis elegans. Worms were exposed to different concentrations of the active ingredient (glyphosate in monoisopropylamine salt) and its commercial formulation. Reproductive capacity was evaluated through brood size, morphological analysis of oocytes and through the MD701 strain (bcIs39), which allows the visualization of germ cells in apoptosis. In addition, the metal composition in the commercial formulation was analyzed by ICP-MS. Only the commercial formulation of glyphosate showed significant negative effects on brood size, body length, oocyte size, and the number of apoptotic cells. Metal analysis showed the presence of Hg, Fe, Mn, Cu, Zn, As, Cd and Pb in the commercial formulation, which did not cause reprotoxicity at the concentrations found. However, metals can bioaccumulate in soil and water and cause environmental impacts. Finally, we demonstrated that the addition of inert ingredients increased the toxic profile of the active ingredient glyphosate in C. elegans, which reinforces the need of components description in the product labels.

Coexistence of antibiotics/heavy metals and the overexpression of resistance genes in the vermicompost has become an emerging environmental issue. Little is known about the interaction and correlation between chemical pollutants and biological macromolecular compounds. In this study, three typical vermicompost samples were selected from the Yangtze River Delta region in China to investigate the antibiotic, heavy metal and corresponding antibiotic resistance genes (ARGs) and heavy metal resistance genes (HRGs). The results indicated the prevalence of tetracycline (TC), copper (Cu), zinc (Zn), cadmium (Cd), corresponding TC-resistance genes (tetA, tetC, tetW, tetM, tetO, and tetS) and HRGs (copA, pcoA, cusA, czcA, czcB, and czcR) in the three vermicompost samples. In addition, the ARG level was positively associated with the water-soluble TC fraction in the vermicompost, and it was same between the HRG abundance and exchangeable heavy metal content (p < 0.05). Moreover, a positive correlation was found between ARG and HRG abundance in the vermicompost samples, suggesting a close regulation mechanism involving the expression of both genes. The result obtained here could provide new insight into the controlling risk of heavy metals, TC, and relevant resistance genes mixed contamination in the vermicompost.

Copper (Cu) induced phytotoxicity has become a serious environmental problem as a consequence of significant metal release through anthropogenic activity. Understanding the spatial distribution of Cu in plants such as willow is essential to elucidate the mechanisms of metal accumulation and transport in woody plants, particularly as affected by variable environment conditions such as soil flooding. Using synchrotron-based X-ray fluorescence (μ-XRF) techniques, the spatial distribution of Cu and other nutrient elements were investigated in roots and stems of Salix (S.) integra exposed to 450 mg kg⁻¹ Cu under non-flooded (NF)/flooding (F) conditions for 90 d. S. integra grown in the F condition exhibited significant higher tolerance index (TI, determined by the ratio of total biomass in Cu treatments to control) (p < 0.05) than that in the NF condition, indicating soil flooding alleviated Cu toxicity to willow plants. The μ-XRF revealed that Cu was preferentially located in the root cap and meristematic zone of the root tips. Under the NF condition, the Cu intensity in the root epidermis was more highly concentrated than that of the F condition, suggesting the soil flooding significantly inhibited Cu uptake by S. integra. The pattern of the Cu spatial distribution in the S. integra stem indicated that the F condition severely reduced Cu transport via the xylem vessels as a consequence of decreasing the transpiration rate of leaves. To our knowledge, this is the first study to report the in vivo Cu distribution in S. integra in a scenario of co-exposure to the Cu and the soil flooding over a long period. The finding that Cu uptake varies significantly with flooding condition is relevant to the development of strategies for plants to detoxify the metals and to maintain the nutrient homeostasis.

Agricultural soil is one of the main sink for both heavy metals and nanomaterials (NMs). Whether NMs can impact heavy metals uptake or bioaccumulation in plants is unknown. Here, cucumber plants were cultivated in a multi-heavy metals contaminated soil amended with four types of NMs (SiO2, TiO2, ZnS and MoS2) separately for four weeks. Physiological and biochemical parameters were determined to investigate the impact of NMs on plant growth. Inductively coupled plasma mass spectrometry was employed to determine the metal content in plants. Results showed that none of the tested NMs impacted plants biomass, but all the NMs showed different degrees of reduction in heavy metals bioaccumulation in plant roots, stems and leaves. However, four NMs showed different degrees of reduction in macro and micro nutrients uptake. MoS2 decreased the bioaccumulation of heavy metals (As, Cd, Cr, Cu, Ni, Al, Ti and Pb) for 36.4–60.6% and nutrients (Mg, Fe, K, Si and Mn) for 40.1%–50.1% in roots. Exposure to MoS2 NMs also significantly increased 23.4% of Si in leaves, 205.6% and 83.9% of Mo in roots and stems, respectively. In general, the results of this study showed promising potential for NMs to reduce uptake of heavy metals in crop plants, especially MoS2 NMs. However, the negative impacts of perturbing nutrients uptake should be paid attention as well.

Incineration has overtaken landfilling as the most important option for disposal of the increasing volumes of municipal solid waste (MSW) generated in China. Accordingly, disposal of the incineration fly ash, which is enriched with a range of heavy metals, has become a key challenge for the industry. This review analyzes the temporal and spatial trends in the distributions of As, Cd, Cr, Cu, Ni, Pb, Zn, and Hg in MSW incineration fly ash between 2003 and 2017, and estimates the inventories of heavy metals associated with the fly ash and the average levels of heavy metals in Chinese MSW based on their mass flow during MSW incineration. It was estimated that MSW incinerators in China released approximately 1.12 × 10², 2.96 × 10³, 1.82 × 10², 3.64 × 10⁴, 1.00 × 10², 7.32 × 10³, 2.42 × 10², and 1.47 × 10¹ tonnes of Cd, Pb, Cr, Zn, Ni, Cu, As, and Hg, respectively, with the fly ash in 2016. Due to the much greater fly ash generation rate, the incinerators based on circulating fluidized bed combustor (CFBC) technology released more heavy metals during incineration of MSW compared to those based on grate furnace combustor (GFC) technology. Results of mass-flow modeling indicate that the geometric mean contents of Cd, Pb, Cr, Zn, Ni, Cu, As, and Hg in Chinese MSW were 3.0, 109, 101, 877, 34, 241, 21, and 1.7 mg/kg, respectively, which are comparable to those in the MSW from other countries. To protect the environment from the significant potential ecological risk posed by heavy metals in the mismanaged fly ash, strict regulation enforcement and compliance monitoring are necessary to reduce the heavy metal pollution brought by improper disposal of MSW incineration fly ash, and more research and development efforts on advanced technologies for stabilization of heavy metals in fly ash and its environmentally sound reuse can help mitigate its environmental risk.

Muzzle emissions from firing an M4 carbine rifle in a semi-enclosed chamber were characterized for an array of compounds to provide quantitative data for future studies on potential inhalation exposure and rangeland contamination. Air emissions were characterized for particulate matter (PM) size distribution, composition, and morphology; carbon monoxide (CO); carbon dioxide (CO₂); energetics; metals; polycyclic aromatic hydrocarbons; and methane. Three types of ammunition were used: a “Legacy” (Vietnam-era) round, the common M855 round (no longer fielded), and its variant, an M855 round with added potassium (K)-based salts to reduce muzzle flash. Average CO concentrations up to 1500 ppm significantly exceeded CO₂ concentrations. Emitted particles were in the respirable size range with mass median diameters between 0.33 and 0.58 μm. PM emissions were highest from the M855 salt-added ammunition, likely due to incomplete secondary combustion in the muzzle blast caused by scavenging of combustion radicals by the K salt. Copper (Cu) had the highest emitted metal concentration for all three round formulations, likely originating from the Cu jacket on the bullet. Based on a mass balance analysis of each round's formulation, lead (Pb) was completely emitted for all three round types. This work demonstrated methods for characterizing emissions from gun firing which can distinguish between round-specific effects and can be used to initiate studies of inhalation risk and environmental deposition.