Subsea blowouts have the potential to spread oil across large geographical areas, and subsea dispersant injection (SSDI) is a response option targeted at reducing the impact of a blowout, especially reducing persistent surface oil slicks. Modified Weber scaling was used to predict oil droplet sizes with the OSCAR oil spill model, and to evaluate the surface oil volume and area when using SSDI under different conditions. Generally, SSDI reduces the amount of oil on the surface, and creates wider and thinner surface oil slicks. It was found that the reduction of surface oil area and volume with SSDI was enhanced for higher wind speeds. Overall, given the effect of SSDI on oil volume and weathering, it may be suggested that tar ball formation, requiring thick and weathered oil, could possibly be reduced when SSDI is used. | acceptedVersion

The well-known toxicity of conventional chemical oil spill dispersants demands the development of alternative and environmentally friendly dispersant formulations. Therefore, in the present study we have developed a pair of less toxic and green dispersants by combining lactonic sophorolipid (LS) biosurfactant individually with choline myristate and choline oleate ionic liquid surfactants. The aggregation behavior of resulted surfactant blends and their dispersion effectiveness was investigated using the baffled flask test. The introduction of long hydrophobic alkyl chain with unsaturation (attached to choline cation) provided synergistic interactions between the binary surfactant mixtures. The maximum dispersion effectiveness was found to be 78.23% for 80:20 (w/w) lactonic sophorolipid-choline myristate blends, and 81.15% for 70:30 (w/w) lactonic sophorolipid-choline oleate blends at the dispersant-to-oil ratio of 1:25 (v/v). The high dispersion effectiveness of lactonic sophorolipid-choline oleate between two developed blends is attributed to the stronger synergistic interactions between surfactants and slower desorption rate of blend from oil-water interface. The distribution of dispersed oil droplets at several DOR were evaluated and it was observed that oil droplets become smaller with increasing DOR. In addition, the acute toxicity analysis of developed formulations against zebra fish (Danio rerio) confirmed their non-toxic behavior with LC₅₀ values higher than 400 ppm after 96 h. Overall, the proposed new blends/formulations could effectively substitute the toxic and unsafe chemical dispersants.

Exposure to crude oil during spill events causes a variety of pathologic effects in birds, including oxidative injury to erythrocytes, which is characterized in some species by the formation of Heinz bodies and subsequent anemia. However, not all species appear to develop Heinz bodies or anemia when exposed to oil, and there are limited controlled experiments that use both light and electron microscopy to evaluate structural changes within erythrocytes following oil exposure. In this study, we orally dosed zebra finches (Taeniopygia guttata) with 3.3 or 10 mL/kg of artificially weathered Deepwater Horizon crude oil or 10 mL/kg of peanut oil (vehicle control) daily for 15 days. We found that birds receiving the highest dosage experienced a significant increase in reticulocyte percentage, mean corpuscular hemoglobin concentration, and liver mass, as well as inflammation of the gastrointestinal tract and lymphocyte proliferation in the spleen. However, we found no evidence of Heinz body formation based on both light and transmission electron microscopy. Although there was a tendency for packed cell volume and hemoglobin to decrease in birds from the high dose group compared to control and low dose groups, the changes were not statistically significant. Our results indicate that additional experimental dosing studies are needed to understand factors (e.g., dose- and species-specific sensitivity) and confounding variables (e.g., dispersants) that contribute to the presence and severity of anemia resulting from oil exposure in birds.

Hg pollution is a global concern due to its high ecotoxicity and health risk to human beings. A comprehensive understanding of the fast-developed technology applied in determining and controlling Hg pollution is beneficial for risk assessment and field remediation. Herein, we mainly assembled the recent progress on Hg treatment in the environment by nanotechnology. The advantages and disadvantages of the conventional and nanotechnology-based methods commonly used in water-/soil-Hg remediation were compared and summarized. Specifically, green nanomaterials derived from plant tissues (e.g., nanocellulose) have prominent merits in remediation of Hg contaminated environments, including high efficiency in Hg removal, low cost, environment-friendly, and easily degradable. Based on the theories of Hg biogeochemistry and existed researches, four promising pathways are proposed, 1) developing surface-modified green nanocellulose with high selectivity and affinity towards Hg; 2) designing effective dispersants in preventing nanocellulose from agglomeration in soil; 3) mediating soil properties by adding green nanomaterials-based fertilizers; 4) improving plant-Hg-extract capacity with green nanomaterials addition. Briefly, more efficient and available approaches are still expected to be developed and implemented in the natural environment for Hg remediation.

The high density and viscosity of fuel oil leads to its prolonged persistence in the environment and causes widespread contamination. Dispersants with a low environmental impact are necessary for fuel oil spill remediation. This study aimed to formulate bio-based dispersants by mixing anionic biosurfactant (lipopeptides from Bacillus subtilis GY19) with nonionic oleochemical surfactant (Dehydol LS7TH). The synergistic effect of the anionic-nonionic surfactant mixture produced a Winsor Type III microemulsion, which promoted petroleum mobilization. The hydrophilic-lipophilic deviation (HLD) equations for ionic and nonionic surfactant mixtures were compared, and it was found that the ionic equation was applicable for the calculation of lipopeptides and Dehydol LS7TH concentrations. The best formula contained 6.6% w/v lipopeptides and 11.9% w/v Dehydol LS7TH in seawater, and its dispersion effectiveness for bunker fuels A and C was 92% and 78%, respectively. The application of bio-based dispersants in water sources was optimized by Box-Behnken design. The efficiency of the bio-based dispersant was affected by the dispersant-to-oil ratios (DORs) but not by the water salinity. A suitable range of DORs for different oil contamination levels could be identified from the response surface plot. The dispersed fuel oil was further degraded by adding an oil-degrading bacterial consortium to the chemically enhanced water accommodated fractions (CEWAFs). After 7 days of incubation, the concentration of fuel oil was reduced from 3692 mg/L to 356 mg/L (88% removal efficiency). On the other hand, the abiotic control removed less than 40% fuel oil from the CEWAFs. This bio-based dispersant had an efficiency comparable to that of a commercial dispersant. The process of dispersant formulation and optimization could be applied to other surfactant mixtures.

Marine oil spill often causes contamination of drinking water sources in coastal areas. As the use of oil dispersants has become one of the main practices in remediation of oil spill, the effect of oil dispersants on the treatment effectiveness remains unexplored. Specifically, little is known on the removal of dispersed oil from contaminated water using conventional adsorbents. This study investigated sorption behavior of three prototype activated charcoals (ACs) of different particle sizes (4–12, 12–20 and 100 mesh) for removal of dispersed oil hydrocarbons, and effects of two model oil dispersants (Corexit EC9500A and Corexit EC9527A). The oil content was measured as n-alkanes, polycyclic aromatic hydrocarbons (PAHs), and total petroleum hydrocarbons (TPHs). Characterization results showed that the smallest AC (PAC100) offered the highest BET surface area of 889 m2/g and pore volume of 0.95 cm3/g (pHPZC = 6.1). Sorption kinetic data revealed that all three ACs can efficiently adsorb Corexit EC9500A and oil dispersed by the two dispersants (DWAO-I and DWAO-II), and the adsorption capacity followed the trend: PAC100 > GAC12 × 20 > GAC4 × 12. Sorption isotherms confirmed PAC100 showed the highest adsorption capacity for dispersed oil in DWAO-I with a Freundlich KF value of 10.90 mg/g∙(L/mg)1/n (n = 1.38). Furthermore, the presence of Corexit EC9500A showed two contrasting effects on the oil sorption, i.e., adsolubilization and solubilization depending on the dispersant concentration. Increasing solution pH from 6.0 to 9.0 and salinity from 2 to 8 wt% showed only modest effect on the sorption. The results are useful for effective treatment of dispersed oil in contaminated water and for understanding roles of oil dispersants.

Naphthalene sulfonic acids (NSAs) are used extensively in industrial applications as dispersants in dyes, rubbers, and pesticides, and as anti-corrosive agents in coatings, gels, and sealants. This study examined the toxicity of three NSA congeners, barium dinonylnaphthalene sulfonate (BaDNS), calcium dinonylnaphthalene sulfonate (CaDNS), and dinonylnaphthalene disulfonic acid (DNDS), to two benthic species, Tubifex tubifex and Hyalella azteca. Two substrates with different levels of organic carbon (sediment [2%] and sand [0%]) were used in toxicity tests. Juvenile production was the most sensitive endpoint for T. tubifex: the 28-d EC50s were <18.2, 22.2, and 64.0 μg/g dw in sand and 281.3, 361.6, and 218.9 μg/g dw in sediment for BaDNS, CaDNS, and DNDS, respectively. The 28-d LC50s for H. azteca were similar among compounds: 115.3, 82.1, and 49.0 μg/g dry weight (dw) in sand, and 627.3, 757.9, and >188.5 μg/g dw in sediment, for BaDNS, CaDNS, and DNDS, respectively. However, when LC50s were estimated based on concentrations of NSAs measured in overlying water (which can be an important route of exposure for H. azteca), BaDNS and CaDNS were 3–4 orders of magnitude more toxic than DNDS. The NSAs examined were >3-fold more toxic when present in substrates with no organic carbon (e.g., sand) for all H. azteca endpoints where LC/EC50s could be calculated and for sublethal endpoints for T. tubifex. The organic carbon content of the sediment appears to have acted as a sink and reduced NSA toxicity by decreasing bioavailability. Environmental sediment samples were collected from 12 river sites across southern Ontario. The maximum concentration of CaDNS observed in sediment collected from this region was 2.8 μg/g dw in sediment with 2% organic carbon; 100-fold lower than the lowest EC10 in the current study.

Remediation of soil chromium (Cr) pollution is becoming more and more urgent. In this study, a multi-loaded nano-zero-valent iron (nZVI) material (CNH) was prepared by carboxymethyl cellulose (CMC) and humic acid (HA) as dispersant and support agent, respectively, and the remediation effect of CNH, HA and CN (CNH without HA) for Cr contaminated soil was investigated within 90 d cycle. After 7 d treatment of CNH, the HOAc-extractable Cr decreased significantly. After the 90 d remediation, the HOAc-extractable Cr decreased most in the treatment of 3% CNH, about 74.48% lower than control. All treatments eventually caused different decline of soil pH, with a range of 0.12–0.54, in which the CNH treatment group had the least depression. HA loading significantly weakened the toxicity of nZVI, resulting in the higher soil microbial quantity and enzyme activities compared with CN. Additionally, the improvement of soil microecology by CNH and HA was positively correlated with the ratio of application, while CN was negatively correlated (except FDA enzyme activity) with these indexes. These results emphasized the potential of the synthesized CNH as a promising material to remediate Cr contaminated soil. Furthermore, details of possible mechanistic insight into the Cr remediation were carefully discussed.