Application of riverbed sand for the adsorptive separation of cadmium(II) from aqueous solutions has been investigated. Removal increased from 26.8 to 56.4% by decreasing the initial concentration of cadmium from 7.5 x 10-5 to 1.0 x 10-5 M at pH 6.5, 25 °C temperature, agitation speed of 100 rpm, 100 μm particle size and 1.0 x 10-2 NaClO4 ionic strength. Process of separation is governed by first order rate kinetics. The value of rate constant of adsorption, kad, was found to be 2.30 x 10-2 per min at 25 °C. Values of coefficient of mass transfer, βL, were calculated and its value at 25 °C was found to be 1.92 x 10-2 cm/s. Values of Langmuir constant were calculated. Values of thermodynamic parameters ΔG0, ΔH0 and ΔS0 were also calculated and were recorded as -0.81 kcal/mol, -9.31 kcal/mol and -28.10 cal/mol at 25 °C. pH has been found to affect the removal of cadmium significantly and maximum removal, 58.4%, has been found at pH 8.5. Process can be used for treatment of cadmium(II) rich wastewaters.

There has been and continues to be considerable scientific interest in predicting bioremediation rates and endpoints. This requires the development of chemical techniques capable of reliably predicting the bioavailability of organic compounds to catabolically active soil microbes. A major issue in understanding the link between chemical extraction and bioavailability is the problem of definition; there are numerous definitions, of varying degrees of complexity and relevance, to the interaction between organic contaminants and microorganisms in soil. The aim of this review is to consider the bioavailability as a descriptor for the rate and extent of biodegradation and, in an applied sense, bioremediation of organic contaminants in soil. To address this, the review will (i) consider and clarify the numerous definitions of bioavailability and discuss the usefulness of the term 'bioaccessibility'; (ii) relate definition to the microbiological and chemical measurement of organic contaminants' bioavailability in soil, and (iii) explore the mechanisms employed by soil microorganisms to attack organic contaminants in soil. Understanding organic contaminant's behaviour in soil is key to chemically predicting biodegradation.

Metals released by the extraction with aqua regia, EDTA, dilute HCl and sequential extraction (SE) by the BCR protocol were studied in urban soils of Sevilla, Torino, and Glasgow. By multivariate analysis, the amounts of Cu, Pb and Zn liberated by any method were statistically associated with one another, whereas other metals were not. The mean amounts of all metals extracted by HCl and by SE were well correlated, but SE was clearly underestimated by HCl. Individual data for Cu, Pb and Zn by both methods were correlated only if each city was considered separately. Other metals gave poorer relationships. Similar conclusions were reached comparing EDTA and HCl, with much lower values for EDTA. Dilute HCl extraction cannot thus be recommended for general use as alternative to BCR SE in urban soils. Dilute HCl extraction is tested as an alternative to the BCR sequential extraction in urban soils.

Previously recommended rhizosphere-based method (RHIZO) applied to moist rhizosphere soils was integrated with moist bulk soils, and termed adjusted-RHIZO method (A-RHIZO). The A-RHIZO and RHIZO methods were systematically compared with EDTA, DTPA, CaCl2 and the first step of the Community Bureau of Reference (BCR1) methods for assessing metal phytoavailability under field conditions. Results suggested that moist bulk soils are equally suited or even better than rhizosphere soils to estimate metal phytoavailability. The A-RHIZO method was preferred to other methods for predicting the phytoavailability of Ni, Cu, Zn, Cd, Pb and Mn to wheat roots with correlation coefficients of 0.730 (P < 0.001), 0.854 (P < 0.001), 0.887 (P < 0.001), 0.739 (P < 0.001), 0.725 (P < 0.001) and 0.469 (P < 0.05), respectively. When including soil properties, other extraction methods were also able to predict phytoavailability reasonably well for some metals. Soil pH, organic matter and Fe-Mn oxide contents, and cation-exchange capacity mostly influenced the extraction and phytoavailability of metals. An adjusted-RHIZO method was the most promising approach for predicting metal phytoavailability to wheat under field conditions.

Three experiments were conducted to optimize the use of ethylenediaminetetraacetic acid (EDTA) for reclaiming urban soils contaminated with trace metals. As compared to Na2EDTA, (NH4)2EDTA extracted 60% more Zn and equivalent amounts of Cd, Cu and Pb from a sandy loam. When successively saturating and draining loamy sand columns during a washing cycle, which submerged it once with a (NH4)2EDTA wash and four times with deionised water, the post-wash rinses largely contributed to the total cumulative extraction of Cd, Co, Cr, Cu, Mn, Ni, Pb and Zn. Both the washing solution and the deionised water rinses were added in a 2:5 liquid to soil (L:S) weight ratio. For equal amounts of EDTA, concentrating the washing solution and applying it and the ensuing rinses in a smaller 1:5 L:S weight ratio, instead of a 2:5 L:S weight ratio, increased the extraction of targeted Cr, Cu, Ni, Pb and Zn. A single EDTA addition is best utilised in a highly concentrated washing solution given in a small liquid to soil weight ratio.

Constructed wetlands have been recognized as offering a removal treatment option for high concentrations removal of chemical and biological contaminants in domestic wastewater. The enteric protozoan parasite Cryptosporidium is considered one of the highly resistant to treatment and highly infectious organisms to humans and animals. Moreover, some species of Cryptosporidium are known to have a zoonotic nature. In this investigation a pilot scale for domestic wastewater treatment system was used, consisting of the following steps in series: (1) up-flow anaerobic sludge blanket (UASB) reactor, (2) free water surface (FWS) wetland unit, and (3) sub-surface flow (SSF) wetland unit. This treatment system was fed with domestic wastewater to assess its efficiency in removing Cryptosporidium oocysts. The obtained Cryptosporidium oocysts were detected and enumerated by two different staining techniques 'acid fast trichrome (AFT) and modified Ziehl Neelsen (MZN) stains'. Polymerase chain reaction (PCR) technique was also used to detect Cryptosporidium DNA in wastewater samples. Results revealed that anaerobic treatment (using UASB reactor) could remove about 53.1% of Cryptosporidium oocysts present in raw wastewater. The in-series connection between the two wetland units allowed complete elimination of Cryptosporidium oocysts as the first (FWS) wetland unit removed 95.9% of the oocysts present in anaerobically treated wastewater and the remaining portion of oocysts was completely removed by the second (SSF) wetland unit. Cryptosporidium oocysts were detected in 95.8% of raw wastewater samples with a mean count of 43.8 oocysts/l when AFT stain was used while they were detected in only 87.5% of raw wastewater samples with a mean count of 35.6 oocysts/l when MZN stain was used. Polymerase chain reaction (PCR) technique was able to detect Cryptosporidium DNA in only 45.8% of raw wastewater samples. Positive PCR results were only achieved in wastewater samples containing 52 oocysts or more per liter.

The use of vegetated wetlands for accelerating pesticide removal from agricultural runoff is gaining acceptance as a best management practice. In this study, the dissipation of five cotton pesticides – endosulfan, chlorpyrifos, aldicarb, prometryn and diuron – was quantified in cotton field runoff water contained in glasshouse columns, under light or dark conditions. Two water samples sourced from large, non-vegetated storage dams were compared with two other water samples obtained from vegetated wetlands receiving runoff from cotton fields. All pesticides studied except chlorpyrifos dissipated significantly faster from the storage dam samples than the vegetated wetland samples. Suggested reasons include a greater number of pesticide-degrading microorganisms in the storage dam waters and/or the presence of more organic matter in the wetland samples, limiting contaminant volatilisation and hydrolysis. Exposure to light significantly reduced the rate of endosulfan removal, whereas light increased the rate of chlorpyrifos removal. Half-lives are presented for each pesticide where appropriate.

Fluvial bed sediments are widely used for characterizing anthropogenic contaminant signals in urban watersheds. This study presents the first preliminary examination of sequentially extracted Pb from grain size fractionated bed sediments using the optimized (standardized) BCR procedure. Baseline sediment samples and samples from the vicinity of three storm-sewer outlets in Nuuanu Stream, Honolulu, Hawaii, were examined. The weighted average Pb liberated from four sequentially extracted phases was 144 ± 26 mg/kg (±SD). These Pb concentrations are high compared to 3 mg/kg leached by a 0.5 M HCl solution, and 13 mg/kg from a 4-acid total digestion of baseline sediments. Over a 1.8 km section of stream channel, land use variations and traffic density differences had little impact on the magnitude of Pb in specific phases for each of the six grain size fractions examined. Regardless of grain size or spatial location, Pb in the reducible phase exceeded that in oxidizable, residual and acid extractable phases. Weighted reducible Pb concentrations for three sewer outlet sites ranged from 69 to 92 mg/kg, and this phase typically accounted for 70-80% of all labile Pb. The <63 μm grain size class did not exhibit the highest Pb concentration, instead this was found in either the 125-250 μm or 500-1,000 μm fractions. Examining bed sediment phase associations of Pb over a smaller length dimension (i.e., 40 m) centered around one sewer outlet, indicated higher concentrations at the outlet (180 mg/kg) compared to upstream (132 mg/kg) or downstream (150 mg/kg). The differences were primarily associated with higher Pb concentrations in the reducible and oxidizable phases of the coarse sand fractions (500-2,000 μm) at the outlet. Overall, all data point to a significant anthropogenic signal for Pb in bed sediments in the urbanized section of Nuuanu Stream.

To rigorously assess treatment technologies and establish regulatory framework for chromate-contaminated site remediation, it is useful to know the exact chromium speciation in soil matrices. In an earlier study, Thornton, E. C., & Amonette, J. E. (1999). Hydrogen sulfide gas treatment of Cr(VI)-contaminated sediment samples from a plating-waste disposal site - implications for in-situ remediation. Environmental Science & Technology, 33, 4096-4101, reported that some chromate in the bulk particles was not accessible to gaseous reductants or solution-phase extractants, based on XANES studies. We hypothesized that part of this non-extractable chromate may reside in the structure of minerals such as calcium carbonate. To test this hypothesis, a number of calcium carbonate precipitates were prepared in the presence of various concentrations of chromate during the precipitation, which could coprecipitate chromate, or by adding chromate after the precipitation was completed. Hydrochloric acid was used to dissolve calcium carbonate and therefore extract the coprecipitated and surface attached chromate. The results showed that the coprecipitated chromate was non-extractable by hot alkaline solution or phosphate buffer, but could be solubilized by HCl in proportional to the amount of calcium carbonate dissolved. The X-ray diffraction experiments revealed that the coprecipitation of chromate with calcium carbonate had an influence on its crystal structure: The higher the chromate concentration, the greater the ratio of vaterite to calcite.

Clinoptilolite is investigated as a possible regenerable sorbent for acid rock drainage based on its adsorption capacity for Zn, adsorption kinetics, effect of pH, and regeneration performance. Adsorption of Zn ions depends on the initial concentration and pH. Adsorption/Desorption of Zn reached 75% of capacity after 1–2 h. Desorption depended on pH, with an optimum range of 2.5 to 4.0. The rank of desorption effectiveness was EDTA > NaCl > NaNO₃ > NaOAc > NaHCO₃ > Na₂CO₃ > NaOH > Ca(OH)₂. For cyclic absorption/desorption, adsorption remained satisfactory for six to nine regenerations with EDTA and NaCl, respectively. The crystallinity and morphology of clinoptilolite remained intact following 10 regeneration cycles. Clinoptilolite appears to be promising for ARD leachate treatment, with significant potential advantages relative to current treatment systems.