Random and unscientific disposal of municipal waste is an important factor affecting the geotechnical characteristics and concentrations of heavy metals in the soil. Unconfined compressive strength, Atterberg limit, and maximum dry density tests were included. These tests were designed to determine the effects of open waste dumps on geotechnical properties and the concentration of heavy metals in the underlying open dump soil. Soil samples collected from the landfill at Al-Sayyahia Village, Babylon Governorate, showed changes in the rates of geotechnical properties evaluation, as the value of the confined compressive strength decreased by high rates from 54 to 22 kN/m2. As well, when comparing the maximum values of dry density of samples from the control site, neighboring the landfill, the average value decreased from 1.91 to 1.74 gm/cm3. Chemical tests revealed that the pH and organic matter percentages in the open dump soil samples were significantly higher than in the control site. These percentages ranged from 9.67% and 2.542% to 7.4% and 0.215%, respectively. In addition, the average value of electrical conductivity was 5.6 mS/cm in the open dump soil, whereas in the control site was 3.6 mS/cm. Iron, lead, Copper, Nickel, Chrome, Zinc, Cadmium, and Arsenic have average concentrations of 4.64%, 14.02, 44.86, 236.36, 278.36, 95.26, 2.034, and 13.84 ppm, respectively. They are higher at open landfill sites than in control site samples.

In the present investigation, 41 soil samples were subjected to single step chemical partitioning to assess the lithogenic and non-lithogenic portions of metals in Tehran's soils. The share of various studied metals in the anthropogenic portion ranges from as low as 0.2% to as high as 85% of bulk concentration. Geo-accumulation index (Igeo) showed that Cd falls within "heavily contaminated" soils. It might be inferred that Ni, Cu, Cr, Zn, Co and Ca fall within "Deficient to minimal" class in accordance with enrichment factor (EF) classification.. Enrichment factor values (to some extents) match with the chemical partition studies results (except for Ni and Cr). The very low Ca content of soil samples could be indicative of low biological productivity in the Tehran's soil. Also the very low concentrations of Mn could be indicative of reducing environment in soils of Tehran.

Lighvan hot spring and Toptapan mineral spring are located in the Eastern Azarbaijan, NW of Iran. The host rocks of Lighvan hot spring are dacite, andesite and Quaternary volcanic tuffs. Their main rock forming minerals are quartz, plagioclase, biotite and rarely amphibole. The host rocks of Toptapan mineral water spring are Cretaceous and Jurassic sandstone, shales and carbonate sedimentary rocks. Their main rock forming minerals are quartz, calcite, dolomite and clays. Due to the deposition of mineral water springs, travertine is the main Quaternary sediments around the springs. Water samples were collected from Toptapan mineral spring and Lighvan hot spring in July (dry season). The sampling method was according to standard methods for geochemical analysis. Field parameters such as PH, temperature, and EC were measured in situ, and samples were analyzed by ICP-OEC and ICP-MS in the laboratory of the Geological Survey of Iran. The measuring data showed that pH varies between 6.1 to 6.4. The surface temperature varies from 20.1˚C to 32.8˚C. The concentration of anions and cations in the Piper diagram show calcic bicarbonate type for Toptapan mineral spring and sodic bicarbonate type for Lighvan hot spring respectively. According to Lunglier – Ludwig diagram, the dissolution of carbonate and silicate minerals is the most important factor in increasing calcic cation. The Cl-Li-B diagram shows that the dissolution of sodic minerals and clays and ionic exchange are also the most important factors for increasing sodium in these springs. These data are in agreement to the host rocks, their mineralogy and their chemical composition. Based on the Ca-Mg-K geothermometer diagram, the geothermal reservoir temperature for Lighvan hot spring is 95-100 ˚C with a depth of about 2Km and for Toptapan mineral spring is 65-85 ˚C with a depth of less than 1Km. Also, high concentrations of chlorine show a deep geothermal primary reservoir in the Lighvan hot spring. These geochemical data show that these cold and hot springs are not polluted and not harmful for environmental point of views.

Evaluation of the geochemistry and hydrochemical quality of Bam salt dome located in southern Iran, was conducted in this study. Two composite samples from salt units were collected and analysed by XRD and XRF to determine their mineral and elemental compositions. Water samples were also collected from the only spring in the area and analysed for major anions, cations and some toxic elements. The results indicated halite as the major mineral present, while quartz, anhydrite and dolomite were present at minor levels. The presence of anhydrite and dolomite together with quartz had negative effects on edible salt quality. The dominant water type in the area was sodium-chloride. Negligible sulphate and calcium contents may be attributed to anhydrites detected in the geological texture of the study area. According to a Schoeller diagram, the water is not suitable for drinking. Concentrations of toxic metals in the salt sample were significantly higher than those in water samples. Such a result can be viewed as an opportunity to produce edible salts from the evaporation of spring water.