Increasing the pollution rate of water sources is one of the most severe issues that the world faces. This issue has stimulated researchers to investigate different treatment methods such as adsorption, chemical precipitation, membrane filtration, flocculation, ion exchange, flotation, and electrochemical methods. Among them, adsorption has gained broad interest due to its ease of operation, low cost, and high efficiency. The critical factor of the successful adsorption treatment process is finding attractive adsorbents with attractive criteria such as low cost and high adsorption capacity. In the last few decades, nanotechnology has attracted much attention, and numerous nanomaterials have been synthesized for water and wastewater treatment. This work provides a quick overview of nanomaterials, which have been investigated for water remediation as adsorbent and photocatalyst. This work reviewed more than 100 articles to provide a critical review that would determine the limitation of using nanomaterials in water treatment at the commercial scale.

Antimicrobial nanomaterials provide numerous opportunities for the synthesis of next-generation sustainable water disinfectants. Using the keywords graphene and water disinfection and graphene antibacterial activity, a detailed search of the Scopus database yielded 198 and 1433 studies on using graphene for water disinfection applications and graphene antibacterial activity in the last ten years, respectively. Graphene family nanomaterials (GFNs) have emerged as effective antibacterial agents. The current innovations in graphene-, graphene oxide (GO)-, reduced graphene oxide (rGO)-, and graphene quantum dot (GQD)-based nanocomposites for water disinfection, including their functionalization with semiconductor photocatalysts and metal and metal oxide nanoparticles, have been thoroughly discussed in this review. Furthermore, their novel application in the fabrication of 3D porous hydrogels, thin films, and membranes has been emphasized. The physicochemical and structural properties affecting their antibacterial efficiency, such as sheet size, layer number, shape, edges, smoothness/roughness, arrangement mode, aggregation, dispersibility, and surface functionalization have been highlighted. The various mechanisms involved in GFN antibacterial action have been reviewed, including the mechanisms of membrane stress, ROS-dependent and -independent oxidative stress, cell wrapping/trapping, charge transfer, and interaction with cellular components. For safe applications, the potential biosafety and biocompatibility of GFNs in aquatic environments are emphasized. Finally, the current limitations and future perspectives are discussed. This review may provide ideas for developing efficient and practical solutions using graphene-, GO-, rGO-, and GQD-based nanocomposites in water disinfection by rationally employing their unique properties.

Volatile organic compounds (VOCs) represent a considerable threat to humans and ecosystems. Strategic remediation techniques for the abatement of VOCs are immensely important and immediately needed. Given a unique set of optical, mechanical, electrical, and thermal characteristics, inimitable surface functionalities, porous structure, and substantial specific surface area, graphene and derived nanohybrid composites have emerged as exciting candidates for abating environmental pollutants through photocatalytic degradation and adsorptive removal. Graphene oxide (GO) and reduced graphene oxide (rGO) containing oxygenated function entities, i.e., carbonyl, hydroxyl, and carboxylic groups, provide anchor and dispersibility of their surface photocatalytic nanoscale particles and adsorptive sites for VOCs. Therefore, it is meaningful to recapitulate current state-of-the-art research advancements in graphene-derived nanostructures as prospective platforms for VOCs degradation. Considering this necessity, this work provides a comprehensive and valuable insight into research progress on applying graphene-based nanohybrid composites for adsorptive and photocatalytic abatement of VOCs in the aqueous media. First, we present a portrayal of graphene-based nanohybrid based on their structural attributes (i.e., pore size, specific surface area, and other surface features to adsorb VOCs) and structure-assisted performance for VOCs abatement by graphene-based nanocomposites. The adsorptive and photocatalytic potentialities of graphene-based nanohybrids for VOCs are discussed with suitable examples. In addition to regeneration, reusability, and environmental toxicity aspects, the challenges and possible future directions of graphene-based nanostructures are also outlined towards the end of the review to promote large-scale applications of this fascinating technology.

In agricultural fields, pesticides are widely used, but their residual presence in the environment poses a threat to humans, animals, insects, and ecosystems. The overuse of pesticides for pest control, enhancement of crop yield, etc. leaves behind a significant residual amount in the environment. Various robust, reliable, and reusable methods using a wide class of composites have been developed for the monitoring and controlling of pesticides. Researchers have discovered that carbon nanomaterials have a wide range of characteristics such as high porosity, conductivity and easy electron transfer that can be successfully used to detect pesticide residues from food. This review emphasizes the role of carbon nanomaterials in the field of pesticide residue analysis in different food matrices. The carbon nanomaterials including carbon nanotubes, carbon dots, carbon nanofibers, graphene/graphene oxides, and activated carbon fibres are discussed in the review. In addition, the review examines future prospects in this research area to help improve detection techniques for pesticides analysis.

The mechanisms of soot’s photochemistry are still unclear, especially, how the microstructure and composition of soot influence its photoactivity. In the current study, we started with the exploration of the microstructure of soot particles and gained new insights. The elemental-carbon fraction of soot (E-soot), considered the core component of soot and can reflect the intrinsic characteristics of soot, was extracted by organic solvents and characterized in terms of structure and chemical reactivity. The intrinsic structure of E-soot was found to be more analogous to reduced graphene oxide than to graphene, in terms of containing similar levels of defective sites such as oxygen-containing functional groups and environmentally persistent free radicals, as well as exhibiting similar optoelectronic performance. The generation of reactive oxygen species via an electron transfer pathway under visible light suggests that reduced graphene oxide-like E-soot can serve as a potential carbo-photocatalyst, which facilitates elucidating the mechanism of E-soot’s role during soot’s photochemical aging. Our study reveals the intrinsic structure of soot and its role in photo-triggered reactive oxygen species production, which is vital for atmospheric and health effects.

In this work, we prepared nanocomposites of nickel-decorated manganese oxynitride on graphene nanosheets and demonstrated them as photocatalysts for degradation of acetylsalicylic acid (ASA). The catalyst exhibited a high degradation efficiency over ASA under visible light irradiation and an excellent structural stability after multiple uses. Compared to manganese oxide (MnO) and manganese oxynitride (MnON) nanoparticles, larger specific surface area and smaller band gap were observed for the nanocomposite accounting for the enhanced photocatalytic efficiency. Besides the compositional effect of the catalyst, we also examined the influence of various experimental parameters on the degradation of ASA such as initial concentration, catalyst dose, initial pH and additives. The best performance was obtained for the nanocomposite when the catalyst dose was 10 mg/mL and the initial pH 3. Detection of intermediates during photocatalysis showed that ASA undergoes hydroxylation, demethylation, aromatization, ring opening, and finally complete mineralization into CO₂ and H₂O by reactive species. For practical applications as a photocatalyst, cytotoxicity of the nanocomposite was also evaluated, which revealed its insignificant impact on the cell viability. These results suggest the nanocomposite of nickel-decorated manganese oxynitride on graphene nanosheets as a promising photocatalyst for the remediation of ASA-contaminated water.

A graphite felt (GF) cathode was firstly modified by Fe–Mn binary oxide (FMBO), active carbon (AC), carbon black (CB), and polytetrafluoroethylene (PTFE), which exhibits satisfactory ciprofloxacin (CIP) removal efficiency at neutral pH value in electro-Fenton (EF) system. Morphological data showed that modified cathodes have larger surface area and volume pore as well as more active sites. And electrochemical properties have proved stronger current response after modification. In compassion to the unmodified GF, the FMBO/AC/CB modified GF (FMBO-GF) has wider pH range and higher CIP removal efficiency due to its unique nanoparticles structure. The CIP removal efficiency achieved 95.40% in 30 min, and the removal efficiency of total organic carbon (TOC) achieved 93.77% in 2 h when conditions were optimal (25 mg/L initial CIP concentration, 2 mA/cm² current density, FMBO/AC: CB: PTFE of 1:1:5, and 7 initial pH value) in this study. The results of great degradation and mineralization of CIP in this study indicate that the FMBO-GF cathode has huge potential on antibiotics removals in neutral environment.

Glyphosate (GLY) is a broad-spectrum herbicide used worldwide to control broadleaf sedge, and grass weeds to control non-specific vegetation. Although it was evaluated as non-toxic agent in 20ᵗʰ century, its carcinogenic and genotoxic potential has being intensively investigated all over the world in the last decade. Moreover, the combination of GLY and 2,4-dichlorophenoxyacetic acid (2,4-D) has been widely applied. Although genotoxicity of GLY has been evaluated in vivo studies, there is no report in the literature for the monitoring of in vitro biointeraction of GLY and double stranded DNA, or how effect the combination of GLY and 2,4-D onto DNA. Herein, an electrochemical biosensor platform was developed for detection of the pesticide-DNA interaction by using disposable pencil graphite electrodes (PGEs). First, voltammetric detection of the interaction between GLY and DNA was investigated and the electrochemical characterization of the interaction was achieved. Taking a step further, the synergistic genotoxic effect of the mixture of GLY and 2,4-dichlorophenoxyacetic acid (2,4-D) or the mixture of their herbicide forms onto DNA could be monitored. This effect was concentration dependent, and the herbicide of GLY or the use of mixture of herbicides of GLY and 2,4-D had more genotoxic effect than analytical grade of the active molecules, GLY and 2,4-D. The single-use PGEs provided to fabricate robust, eco-friendly and time saver recognition platform for monitoring of herbicide-DNA interaction with the sensitive and reliable results. It is expected that this study will lead to be designed miniaturized lab-on-a chip platforms for on-line analysis of the pesticide-nucleic acid interactions.

The performance of the cathode significantly affects the ability of the electro-Fenton (EF) process to degrade chemicals. In this study, a simple method to modify the graphite felt (GF) cathode was proposed, i.e. oxidizing GF by hydrothermal treatment in nitric acid. The surface physical and electrochemical properties of modified graphite felt were characterized by several techniques: scanning electron microscope (SEM), water contact angle, X-ray photoelectron spectroscopy (XPS), Raman spectroscopy and linear scanning voltammetry (LSV). Compared with an unmodified GF (GF-0), the oxygen reduction reaction (ORR) activity of a modified GF was significantly improved due to the introduction of more oxygen-containing functional groups (OGs). Furthermore, the results showed that GF was optimally modified after 9 h (GF-9) of treatment. As an example, the H₂O₂ generation by GF-9 was 2.26 times higher than that of GF-0. After optimizing the process parameters, which include the initial Fe²⁺ concentration and current density, the apparent degradation rate constant of levofloxacin (LEV) could reach as high as 0.40 min⁻¹. Moreover, the total organic carbon (TOC) removal rate and mineralization current efficiency (MCE) of the modified cathode were much higher than that of the GF-0. Conclusively, GF-9 is a promising cathode for the future development in organic pollutant removal via EF.

The growing use of graphene-based nanomaterials (GBNs) for various applications increases the probability of their environmental releases and calls for a systematic assessment of their potential impacts on soil invertebrates that serve as an important link along terrestrial food chains. Here, we investigated the response of earthworms (Eisenia fetida) to three types of multi-layer graphenes (MLGs) (G1, G2 and G3 with 12–15 layers) with variable morphology (lateral sizes: 7.4 ± 0.3, 6.4 ± 0.1 and 2.8 ± 0.1 μm; thicknesses: 5.0 ± 0.1, 4.2 ± 0.1 and 4.0 ± 0.2 nm, respectively) and hydrophobicity ((O + N)/C ratios: 0.029, 0.044 and 0.075; contact angles: 122.8, 118.8 and 115.1°, respectively). Exposure to these materials was conducted for 28 days (except for 48-h avoidance test) separately in potting or farm soil at 0.2% and 1% by weight. Earthworms avoided both soils when amended with 1% of the smaller and more hydrophilic MLGs (G2 and G3), leading to a decreased trend in worm cocoon formation. The smallest and most hydrophilic MLG (G3), which was easier to assimilate, also significantly inhibited the viability (20.2–56.0%) and mitochondrial membrane potential (32.0–48.5%) of worm coelomocytes in both soils. In contrast, oxidative damage (indicated by lipid peroxides) was more pronounced upon exposure to more hydrophobic and larger graphenic materials (G1 and G2), which were attributed to facilitated adhesion to and disruption of worm membranes. These findings highlight the importance of MLG morphology and hydrophobicity in their potential toxicity and mode of action, as well as ecological risks associated with incidental and accidental releases.