The reaction of Pd(II) with 1,8-dihydroxy-2-(pyrazol-5-ylazo)-naphthalen-3,6-disulphonic acid immobilized by physical sorption onto Dowex 1-X8 ion-exchange resin was investigated with the aim to develop the sorption-spectroscopic test method for the detection of low Pd(II) concentrations in water. The resin phase absorption spectra of the reagent and its Pd(II) complex were followed. The immobilized reagent has the spectral characteristics similar to those in the water and forms with Pd(II) 1:1 complex with the absorption maximum at 650 nm. Parameters, such as pH, wavelength and contact time have been optimized for a given amount of the sorbed reagent. The experimental conditions for the linear dependence of absorbance vs. Pd(II) concentration have been determined.

Targeting the removal of Pb²⁺ in wastewater, cellulosic materials were carbonized in an aerobic environment and activated via ion exchange. The maximum adsorption capacity reached 243.5 mg/g on an MCC-derived adsorbent activated with sodium acetate. The modified porous properties improved the adsorption capacity. The capacity could be completely recovered five times through elution with EDTA. Because of the negative effects of Ni, Mg, and Ca elements, the adsorption capacities of activated carbonized natural materials were lower than that of pure cellulose. N₂ adsorption measurement showed that the adsorbent had a large specific surface area as well as abundant micropores and 4-nm-sized mesopores. FTIR and surface potential results proved that carboxyl group was generated in the aerobic carbonization, and was deprotonated during ion exchange. This adsorbent consisted of C–C bonds as the building blocks and hydrophilic groups on the surface. XPS results demonstrated that the Pb 4f binding energies were reduced by 0.7–0.8 eV due to the interaction between Pb²⁺ and the activated adsorbent, indicating that the carboxylate groups bonded with Pb²⁺ through coordination interactions. Pseudo-second-order and Elovich kinetic models were well fitted with the adsorption processes on the pristine and activated carbonized adsorbents, indicative of chemisorption on heterogeneous surfaces. The Freundlich expression agreed well with the data measured, and the pristine and activated adsorbents had weak and strong affinities for Pb²⁺, respectively. The Pb²⁺ adsorption process was exothermic and spontaneous, and heat release determined the spontaneity. The adsorption capacity is attributed to the carboxylate groups and pores generated in the aerobic oxidation and ion exchange procedures.

Across the planet, winter de-icing practices have caused secondary salinization of freshwater habitats. Many amphibians are vulnerable because of permeable skin and reliance on small ponds, where salinity can be high. Early developmental stages of amphibians are especially sensitive to salt, and larvae developing in salt-polluted environments must osmoregulate through ion exchange in gills. Though ionoregulation in amphibian gills is generally understood, the role of gill morphology remains poorly described. Yet gill structure should affect ionoregulatory capacity, for instance in terms of available surface area. As larval amphibian gills also play critical roles in gas exchange and foraging, changes in gill morphology from salt pollution potentially affect not only osmoregulation, but also respiration and feeding. Here, we used an exposure experiment to quantify salinity effects on larval gill morphology in wood frogs (Rana sylvatica). We measured a suite of morphological traits on gill tufts—where ionoregulation and gas exchange occur—and on gill filters used in feeding. Larvae raised in elevated salinity developed larger gill tufts but with lower surface area to volume ratio. Epithelial cells on these tufts were less circular but occurred at higher densities. Gill filters showed increased spacing, likely reducing feeding efficiency. Many morphological gill traits responded quadratically, suggesting that salinity might induce plasticity in gills at intermediate concentrations until energetic demands exceed plasticity. Together, these changes likely diminish ionoregulatory and respiratory functionality of gill tufts, and compromise feeding functionality of gill filters. Thus, a singular change in aquatic environment from a widespread pollutant appears to generate a suite of consequences via changes in gill morphology. Critically, these changes in traits likely compound the severity of fitness impacts in populations dwelling in salinized environments, whereby ionoregulatory energetic demands should increase respiratory and foraging demands, but in individuals who possess structures poorly adapted for these functions.

Both of thallium (Tl) and antimony (Sb) are toxic elements in the natural environment. Emerging Tl and Sb pollution in water has gradually gained public concerns globally. However, limited technologies are available for co-removal of Tl and Sb from wastewater. Herein, an novel system was successfully fabricated to enhance the synergetic removal of both Tl and Sb in wastewater. In this study, MnFe₂O₄-biochar composite (MFBC) facilely synthesized by a one-pot hydrothermal method was used as adsorbent and persulfate (PS) activator for simultaneously removing Tl and Sb from wastewater. The optimal reaction conditions for best removal efficiency of Tl and Sb simultaneously were obtained by using the response surface design combined with Box-Behnken Design (BBD) model. Results unveiled that the average removal rates of Tl and Sb can achieve 98.33% and 89.14%, respectively under the optimal reaction conditions. Electron Spin Resonance (ESR), and radical quenching experiments showed that OH• and SO₄•– play a critical role in the removal of Tl–Sb compound pollution. Via using different characterization, it is revealed that the mechanism of removing Tl–Sb containing wastewater by MFBC-1.4/PS system is oxidation, adsorption, complexation and ion exchange. All these results indicate that MFBC-1.4/PS technology is prospective in highly effective removal of Tl and Sb from wastewater simultaneously.

Metal oxide-modified biochar showed excellent adsorption performance in wastewater treatment. Iron nitrate and potassium permanganate were oxidative modifiers through which oxygen-containing groups and iron–manganese oxides could be introduced into biochar. In this study, iron–manganese (Fe–Mn) oxide-modified biochar (BC-FM) was synthesized using rice straw biochar, and the adsorption process, removal effect, and the mechanism of cadmium (Cd) adsorption on BC-FM in wastewater treatment were explored through batch adsorption experiments and characterization (SEM, BET, FTIR, XRD, and XPS). Adsorption kinetics showed that the maximum adsorption capacity of BC-FM for Cd(II) was 120.77 mg/g at 298 K, which was approximately 1.5–10 times the amount of adsorption capacity for Cd(II) by potassium-modified or manganese-modified biochar as mentioned in the literature. The Cd(II) adsorption of BC-FM was well fit by the pseudo-second-order adsorption and Langmuir models, and it was a spontaneous and endothermic process. Adsorption was mainly controlled via a chemical adsorption mechanism. Moreover, BC-FM could maintain a Cd removal rate of approximately 50% even when reused three times. Cd(II) capture by BC-FM was facilitated by coprecipitation, surface complexation, electrostatic attraction, and cation-π interaction. Additionally, the loaded Fe–Mn oxides also played an important role in the removal of Cd(II) by redox reaction and ion exchange in BC-FM. The results suggested that BC-FM could be used as an efficient adsorbent for treating Cd-contaminated wastewater.

Lead (Pb) is a toxic metal in industrial production, which can seriously threat to human health and food safety. Thus, it is particularly crucial to reduce the content of Pb in the environment. In this study, raw fly ash (FA) was used to synthesise a new active silicate materials (IM) employing the low-temperature-assisted alkali (NaOH) roasting approach. The IM was further synthesised to form zeolite-A (ZA) using the hydrothermal method. The physicochemical characteristics of IM and ZA amendments before and after Pb²⁺ adsorption were analysed using the Scanning electron microscope-Energy Dispersive Spectrometer (SEM-EDS), Fourier Transform infrared spectroscopy (FTIR), and X-ray diffraction (XRD) apparatuses. The results revealed the considerably change in the microstructure and functional groups of IM and ZA amendments, conducive to Pb²⁺ removal. Moreover, a 3-year field experiment revealed that the IM and ZA significantly improved the growth of rice and reduced available Pb by 21%–26.8% and 9.7%–16.9%, respectively. After 3 years of remediation, the Pb concentration of the rice grain reached the national edible standard (≤0.2 mg kg⁻¹) of 0.171 mg kg⁻¹ and 0.179 mg kg⁻¹, respectively. Meanwhile, the concentration of acid-exchangeable Pb reduced, while those of reducible and residual fractions of Pb increased. There was no significant difference between the IM and ZA treatments. The potential mechanisms of remediation by the amendments were ion-exchange, complexation, precipitation, and electrostatic attraction. Overall, the results indicate that IM is suitable for the remediation of contaminated soil and promotes safe food production, and develops an environmentally friendly and cost-effective amendment for the remediation of polluted soil.

Hydrochar (HC) serves as a promising adsorbent to remove the cadmium from aqueous solution due to porous structure. The chemical aging method is an efficient and easy-operated approach to improve the adsorption capacity of HC. In this study, four chemical aging hydrochars (CAHCs) were obtained by using nitric acid (HNO₃) with mass fractions of 5% (N5-HC), 10% (N10-HC), and 15% (N15-HC) to age the pristine HC (N0-HC) and remove the Cd²⁺ from the aqueous solution. The results displayed that the N15-HC adsorption capacity was 19.99 mg g⁻¹ (initial Cd²⁺ concentration was 50 mg L⁻¹), which increased by 7.4 folds compared to N0-HC. After chemical aging, the specific surface area and oxygen-containing functional groups of CAHCs were increased, which contributed to combination with Cd²⁺ by physical adsorption and surface complexation. Moreover, ion exchange also occurred during the adsorption process of Cd²⁺. These findings have important implications for wastewater treatment to transform the forestry waste into a valuable adsorbent for Cd²⁺ removal from water.

Selenium (Se) radioactive wastes can be disposed through stabilization/solidification (S/S) based on the cementitious matrix on hydration products, where hydrocalumite (Ca₂Al-LDH) is expected to play an important role in the retention of SeO₄²⁻. Natural organic matters (NOMs) are known to be a risk to affect the transportation and mobility of undesirable chemical species in the pedosphere which receives the low level radioactive wastes (LLW). In the present work, five amino acids were selected as the simplified models of NOMs in the pedosphere to explore their effects on the stability of Ca₂Al-LDH after immobilized SeO₄²⁻ under alkaline conditions. As the loading amount of amino acids on Ca₂Al-LDH increasing, release of SeO₄²⁻ was enhanced in HGly, H₂Asp, and H₂Cys series, while no enhancement was observed in HPhe and HTrp series. Density functional theory (DFT) calculation predicted ion-exchange of amino acids and CO₃²⁻ with SeO₄²⁻ in a unit cell of LDH model. The intercalation of Asp²⁻ and CO₃²⁻ caused 003 peaks in XRD sharper and d₀₀₃ decreased from 8.15 Å to 7.70 Å which is assigned to Ca₂Al-LDH(Asp, CO₃). In H₂Cys series, the 003 peaks were kept broad and SeO₄²⁻ was still relatively maintained in LDH which was caused by the lower amounts of intercalated CO₃²⁻ in the presence of H₂Cys. Amino acids in the interlayer of Ca₂Al-LDH have several possible configurations, where the most stable one is prone to be in a horizontal direction through hydrogen bonds and Ca–O chemical bonds. This provides an insight on the stability of selenate immobilized in hydrocalumite, which can be produced in cement disposing in the pedosphere for a long term of burying. Not only carbonate but also small molecular organic matters like amino acids possibly give environmental impact on the mobility of low level anionic radionuclides in LDH.

Biochar has been widely used in the mitigation of soil potentially toxic metals due to its high efficiency and low cost. Crayfish shell biochar (CSBC) was prepared at 300, 500, and 700 °C (referred to as CS300, CS500, and CS700, respectively) and the performance and mechanism of CSBC for mitigating Pb polluted water and soil was investigated. The results indicated that CSBC prepared at higher temperatures possessed higher pH value and ash content, more abundant pore structure, and higher stability. Pb²⁺ adsorption onto CSBC fitted well with the pseudo second order and intraparticle diffusion models. The maximum adsorption capacity of Pb²⁺ increased with the pyrolysis temperature, being 599.70, 1114.53, and 1166.44 mg·g⁻¹ for CS300, CS500 and CS700, respectively. Compared with the control soil samples, the content of available Pb after applying 0.05%–5% CSBC was reduced by 1.87%–16.48% in acidic soils and 1.00%–11.09% in alkaline soils. Moreover, the fractionation of exchangeable Pb was converted to stable organic matter bound, Fe-Mn oxide bound, and residue fractions. XRD, SEM-EDS, and FTIR analysis showed that ion exchange, complexation, precipitation, and C−π interaction are the dominant interaction mechanisms. Therefore, CSBC can employ as an effective immobilizing agent for the mitigation of Pb contaminated water and soil.