Water resource management requires simple tools to enable managers to make decisions. This is the case for water quality indices that provide access to clear, synthetic and well-targeted information. In this study, we have chosen two indices based on two different approaches, the Microbiological Quality Index (MQI), which is determined from bacteriological analyses of water, and the Water Quality Index (WQI), which is based on physicochemical parameters. The Water Quality Index (WQI) shows a longitudinal upstream-downstream variation and ranges from is between five (5) (Null Faecal Contamination) at sampling point P1 and 3.4 (Moderate Fecal Contamination) at P2. The Water Quality Index (WQI) ranges from a low of 14.08 (excellent water quality) at the P1 level to a high of 93.05 at the P2 level (poor water quality) receiving wastewater discharges. The WQI results for P3 and P4, show that the water is of good quality (downstream of P2), which shows the degree of self-purification of the Oum Er Rabia River, regardless of the sampling period. Finally, the results of the MQI corroborate those obtained with the WQI for the water quality of the different sampling points.

Water is one of the most crucial substances for life. In order to maintain their public health, each and every country has defined standards of drinking water quality, beyond which the water is considered harmful for human health. The current study compares physical, chemical, and biological standards of drinking water quality for the USA, EU, Japan, India, and Bangladesh, considering 4 physical parameters (namely, color, odor, taste, and turbidity), 35 chemical parameters (such as Calcium (Ca), Magnesium (Mg), Phosphate (PO43-), Sodium (Na), Phenolic compounds, Nitrite (NO2-), Arsenic (As), Aluminum (Al), etc.) and 2 biological parameters (i.e., Coliform (Fecal) and Coliform (Total)). The data has been collected from several secondary sources and since processes of data collection for water quality differ from one another, this aspect has been ignored. No variation has been found in biological water quality standards along with physical quality standards of the considered regions. In order to find out the differences in chemical parameters, standard ANOVA and pair-wise F-test have been conducted. There was no disparity among chemical parameters in ANOVA test. Moreover, thanks to the few excessive values of the standards (as in case of Bangladesh), the COD value is 4 mg/L, whereas in other countries this parameter is much less. However, the chemical parameters of water quality standards in Bangladesh vary significantly from other countries. Besides, there has been no variation among the standards of other countries, even though they are located in different continents. Most interestingly, despite being neighbors, Bangladesh and India differ significantly in this regard.

The effluent stream of the anaerobic digestion processes, the digestate, accommodates high residual organic content that needs to be further treated before discharge. Anaerobic treatment of digestate would not only reduce the residual organic compounds in digestate but also has a potential to capture the associated biogas. High-rate anaerobic reactor configurations can treat the waste streams using lower hydraulic retention times which requires less footprint opposed to the conventional completely stirred tank reactors. This study investigated the high-rate anaerobic treatment performance and the associated biogas capture from the digestate of a manure mixture composed of 90% laying hen and 10% cattle manures in fixed-film reactors. The results indicated that it was possible to reduce total chemical oxygen demand content of the digestate by 57–62% in 1.3–1.4 days of hydraulic retention time. The corresponding biogas yields obtained were in the range of 0.395–0.430 Lbiogas/g VSadded which were found to be comparable to many raw feedstocks. Moreover, significant total phosphorus reduction (36–47%) and greenhouse gas capture (over 14.5–18.1 tCO2e/d per m3 digestate) were also recorded in the anaerobic fixed-film reactors.

We evaluated concentrations of eight heavy metals Cr, Zn, Pb, Ni, Cu, Cd, Co and V, in tissues of representative macrofauna species from 68 sandy beaches from the coast of Rio de Janeiro state. The links between contamination levels and community descriptors such as diversity, evenness, density and biomass, were also investigated. Metal concentrations from macrofaunal tissues were compared to maximum permissible limits for human ingestion stipulated by the Brazilian regulatory agency (ANVISA). Generalized linear models (GLM's) were used to investigate the variability in macrofauna density, richness, eveness and biomass in the seven different regions. A non-metric multidimensional scaling analysis (n-MDS) was used to investigate the spatial pattern of heavy metal concentrations along the seven regions of Rio de Janeiro coast. Variation partitioning was applied to evaluate the variance in the community assemblage explained by the environmental variables and the heavy metal concentrations. Our data suggested high spatial variation in the concentration of heavy metals in macrofauna species from the beaches of Rio de Janeiro. This result highlighted a diffuse source of contamination along the coast. Most of the metals concentrations were under the limits established by ANVISA. The variability in community descriptors was related to morphodynamic variables, but not with metal contamination values, indicating the lack of direct relationships at the community level.Concentration levels of eight heavy metals in macrofauna species from 68 sandy beaches on Rio de Janeiro coast (Brazil) were spatially correlated with anthropogenic activities such as industrialization and urbanization.

Many technologies have been designed to monitor, evaluate, and improve surface water quality, as high-quality water is essential for human activities including agriculture, livestock, and industry. As such, in this study, we investigated water quality indices (WQIs), trophic status indices (TSIs), and heavy metal indices (HMIs) for assessing surface water quality. Based on these indices, we summarised and compared water assessment models using expert system (ES) and machine learning (ML) methods. We also discussed the current status and future perspectives of water quality management. The results of our analyses showed that assessment indices can be used in three aspects of surface water quality assessment: WQIs are aggregated from multiple parameters and commonly used in surface water quality classification; TSIs are calculated from the concentrations of different nutrients required for algae and bacteria, and employed to evaluate the eutrophication levels of lakes and reservoirs; HMIs are mainly applied for human health risk assessment and the analysis of correlation of heavy metal sources. ES- and ML-based assessment models have been developed to efficiently generate assessment indices and predict water quality status based on big data obtained from new techniques. By implementing dynamic monitoring and analysis of water quality, we designed a next-generation water quality management system based on the above indices and assessment models, which shows promise for improving the accuracy of water quality assessment.

Hot moments of nitrous oxide (N₂O) emissions induced by interactions between weather and management make a major contribution to annual N₂O budgets in agricultural soils. The causes of N₂O production during hot moments are not well understood under field conditions, but emerging evidence suggests that short-term fluctuations in soil oxygen (O₂) concentration can be critically important. We conducted high time-resolution field observations of O₂ and N₂O concentrations during hot moments in a dryland agricultural soil in Northern China. Three typical management and weather events, including irrigation (Irr.), fertilization coupled with irrigation (Fer.+Irr.) or with extreme precipitation (Fer.+Pre.), were observed. Soil O₂ and N₂O concentrations were measured hourly for 24 h immediately following events and measured daily for at least one week before and after the events. Soil moisture, temperature, and mineral N were simultaneously measured. Soil O₂ concentrations decreased rapidly within 4 h following irrigation in both the Irr. and Fer.+Irr. events. In the Fer.+Pre. event, soil O₂ depletion did not occur immediately following fertilization but began following subsequent continuous rainfall. The soil O₂ concentration dropped to as low as 0.2% (with the highest soil N₂O concentration of up to 180 ppmv) following the Fer.+Pre. event, but only fell to 11.7% and 13.6% after the Fer.+Irr. and Irr. events, which were associated with soil N₂O concentrations of 27 ppmv and 3 ppmv, respectively. During the hot moments of all three events, soil N₂O concentrations were negatively correlated with soil O₂ concentrations (r = −0.5, P < 0.01), showing a quadratic increase as soil O₂ concentrations declined. Our results provide new understanding of the rapid short response of N₂O production to O₂ dynamics driven by changes in soil environmental factors during hot moments. Such understanding helps improve soil management to avoid transitory O₂ depletion and reduce the risk of N₂O production.

The present study is a literature-based analysis investigating occurrence and the possible consequences of polycyclic aromatic hydrocarbons (PAH) in marine protected areas (MPAs) of Latin America and Caribbean. The approach using overlapping of georeferenced MPA polygons with data compiled from peer-reviewed literature, published during the last 15 years, showed 341 records of PAH in 9 countries. PAH was reported to occur within the boundaries of 36 MPAs located in Argentina, Brazil, Colombia, Mexico, Nicaragua and Uruguay. According to quality guidelines, low to moderate impacts are expected in MPAs categorized in different management classes. Considering sediment samples, 13% of the records presented concentrations enough to cause occasional toxicity. Such level of risk was also seen in Ramsar sites and in Amazonian MPAs. In addition, based on concentrations reported in biota, occasional deleterious effects on organisms from Biosphere Reserves might occur. Diagnostic ratios pointed out petrogenic and pyrolytic processes as PAH predominant sources, and were mainly attributed to the proximity to ports, industries and urban areas. MPAs located in the vicinity of impact-generating areas may be under threat and require government attention and action, mainly through implementation of contamination monitoring programs.

Pollution of coastal and marine environments by mismanaged anthropogenic debris is a global threat requiring complex, multilateral solutions and mitigation strategies. International efforts to catalogue and quantify the density, extent and nature of mismanaged waste have not yet assessed the heterogeneity of debris between nearby areas. Better understanding of how debris types and density can be used as a proxy between regions and between land and seafloor habitats at a global scale can aid in developing cost effective and representative debris monitoring systems. Using volunteer collected clean-up and survey data, we compared the proportion and density of both total debris and specific items across 19,428 coastal land and seafloor sites from International Coastal Cleanups and Dive Against Debris surveys, from 86 countries between 2011 and 2018. We show that although some items common on land are also common on the seafloor, there is an overall global mismatch between debris types and densities on land and the seafloor from nearby areas. Correlations in land/seafloor debris type/density occurred primarily for items which entangle and/or sink, including fishing line, plastic bags, glass and polyethylene terephthalate (PET) bottles. Minimal similarity between land and seafloor surveys occurs for items which float or degrade. We suggest that to accurately evaluate local debris density, land and seafloor surveys are required to gain a holistic understanding. When detailed information on debris type, relative concentration, and likely source and transport are assessed, more cost effective and efficient policy interventions can be designed and implemented from local through to global scales.

Marine plastic waste has become an ever-increasing environmental threat in the world’s ocean largely due to their unique properties and ubiquitous occurrence. They include diverse forms of land- and ocean-based sources of plastics and are estimated to account for up to 85% of marine debris worldwide. As secondary pollutants, marine microplastic particles (<5 mm) are derived from pellet loss and degradation of macroplastics. Up to now, several reports have proposed negative impacts of both macro-sized and micro-sized plastics on marine biota. As one of the rapidly growing economies, China is the topmost contributor of plastic waste in the world. China’s massive impact on the plastic levels of the ocean are a definite cause of concern and is developing multiple economic, environmental and biological complications. The research of plastics impact on coastal environments in China is only incipient. Here we review the available information on plastic waste, their impacts on marine biota and human health, and Chinese government policies and management initiatives. Although Chinese coastal environments (surface water, coastal sediments, water column) are affected by microplastics pollution, both from land-based and sea-based activities, their impacts on marine biota remain to be elucidated. Though national-level policies are modern and well suited for minimizing the impacts of plastic pollution, there is hardly any legislation for containment of microplastic pollution. Our objective is to review and summarize the information about the occurrence, impacts, and management of plastic pollution in the Chinese coastal environments in order to comprehend their widespread repercussions.Microplastics are increasingly being detected and quantified in Chinese coastal environments and legislation for containment of such pollution is highly recommended.