Waste site cover systems used to prevent rainfall from reaching the waste need to remain intact throughout the lifetime of the waste site. Monitoring of these covers is needed to ascertain the performance and to determine if any degradation has occurred. Researchers at Brookhaven National Laboratory have used gaseous perfluorocarbon tracers (PFTs) to monitor the integrity of caps and covers for waste disposal sites. Detection of the PFTs currently uses gas chromatography techniques developed at BNL. This paper presents a potential approach to this wide-area screening problem by replacing conventional gas chromatography analysis with laser-based, lidar (Light Detection and Ranging) detection of the PFTs. Lidar can be used to scan the surface of the cover system, looking for fugitive PFTs. If successful this would enable the departure from soil gas analysis and instead look for PFTs in the air just above the soil surface. The advantages of using a lidar platform are multi-fold and include the elimination of soil monitoring ports. Benchtop and pilot-scale indoor experiments using an a continuous wave, line-tunable infrared CO₂ laser were used to detect PMCH (perfluoromethylcyclohexane, one of a group of PFTs used at BNL). Laboratory measurements of the absorption cross-section were the same order of magnitude compared to literature values for similar perfluorocarbon compounds. Initial benchtop, fixed cell length experiments were successful in detecting PMCH to levels of 10 ppb-m. To improve the lower limit of detection, a HgCdTe detector was purchased that was more specific to the lasing region of interest and hence had a higher sensitivity at this spectral region Using a pilot-scale lidar system in a 40m indoor hallway air concentrations of PMCH were then measured down to 1 ppb-m. These results are very promising and show great potential for monitoring the integrity of cover systems using lidar and PFTs.