In order to determine the mechanisms of the retention of 60Co, 85Sr and 134Cs in natural silica sand columns, desorption experiments were performed by changes of pH and ionic strength and by injection of natural organic matter (NOM). Injection of KCl (0.1 M) resulted in a high release of 60Co (60-100%) and 85Sr (72-100%) but a smaller release of 134Cs (31-66%). Only limited release of 60Co (66%) and 85Sr (71%) and no release of 134Cs were observed by injection of NOM. The different percentages of desorption were related to the chemical characteristics of the organic colloids previously retained in columns before the desorption step. The results evidenced different sorption processes on energetically heterogeneous surface sites. According to the initial conditions, the binding of the radionuclides to the solid phase resulted from weak and easily reversible sorption processes to strong association probably by inner sphere complexes. The rather weak release of 134Cs by KCl was attributed to the strong retention of 134Cs by clay coatings on the natural silica sand surfaces. © 2005 Elsevier Ltd. All rights reserved.

The objective of this study was to examine the chemistry of trace elements in coalbed methane (CBM) discharge water reacting with semi-arid ephemeral stream channels in Powder River Basin, Wyoming. The study area consisted of two ephemeral streams, Burger Draw and Sue Draw. These streams are tributaries to the perennial Powder River, Wyoming. Samples were collected bimonthly from three CBM discharge points and seven channel locations in Burger Draw and Sue Draw. Samples were also collected bimonthly from the Powder River above and below the confluence of Burger Draw. Before sample collection, pH, temperature, dissolved oxygen (DO), and turbidity were measured in the field. Samples were transported to the laboratory and analyzed for dissolved trace elements including iron (Fe), manganese (Mn), boron (B), arsenic (As), selenium (Se), and fluoride (F). Results suggest pH of discharge water was 7.1 and increased significantly in the downstream channel of Burger Draw to 8.84 before joined with the Powder River. Temperature of CBM produced water at discharge points ranged between 20.3 and 22.7 [composite function (small circle)]C. Before discharge, DO concentrations of CBM produced water were between 1.42 and 1.5 mg/L. No significant differences in temperature, DO, and turbidity were found between Burger Draw flow and Powder River flow. However, significant differences were found within the sampling period in temperature and turbidity in flow of Burger Draw. The temperature, DO, and turbidity were all significantly different in Powder River within the sampling period. The CBM discharge water consisted of higher concentrations of F, Fe and B compared to other components. Significant changes were observed for Fe, Mn, and As; and seasonally for B. Dissolved Fe and Mn decreased, while As and Se increased in downstream channel flow. These findings will be useful in proper management of CBM produced water in semi-arid environments.

The overall objective of this research was to develop a reliable, robust, and maintenance-free passive system for biological denitrification in on-site wastewater treatment systems. The process relies on sulfur oxidizing denitrifying bacteria in upflow packed bioreactors. Since this process consumes alkalinity, it is necessary to add a solid-phase buffer that can scavenge the H⁺ as it is generated by the biologically-mediated reaction and arrest the drop in the pH value. This study investigated the use of limestone, marble chips and crushed oyster shell as solid-phase buffers that provide alkalinity. Two bench-scale upflow column reactors and two field-scale bioreactors were constructed and packed with sulfur pellets and an alkalinity source. The pilot scale bioreactors (~200 L each) were installed at the Massachusetts Alternative Septic System Test Center (MASSTC) in Sandwich, MA. The pilot-scale bioreactors performed better when oyster shell was used as the solid-phase buffer vis-à-vis marble chips. In both (pilot-scale and laboratory-scale) systems, denitrification rates were high with the effluent NO₃ - --N concentration consistently below 8 mg/L.

The Erzgebirge, part of the so-called former “Black Triangle”, used to represent the strongest regional air pollution of Central Europe. To test the hypothesis of deposition enhancement with height, an altitudinal gradient along a N-S transect from the Elbe river lowlands to the Erzgebirge summit was chosen to investigate chemical composition, elevation-related variability, temporal changes, and seasonal patterns of ion concentrations from 1993 to 2002. The following questions were to be answered: (1) Which role does orography play on the composition of precipitation?, (2) Does fog occurrence overrule the orographic influence?, (3) Are there changes in the past 10 years, and if so, why?, (4) Do relevant seasonal changes occur and why? Air streams from westerly and to a lesser degree south-easterly directions prevail. The average precipitation was ion-poor (23 μS cm-¹ and acidic (pH 4.5). Sulphate still was the dominant anion (52.3-59.9 μeq L-¹, while NH⁺ ₄ determined the cations (41.9-62.2 μeq L-¹. Ion concentrations decreased with altitude to about 735 m a.s.l. and subsequently increased. The seeder-feeder effect largely explains the chemical composition of precipitation; enhanced in winter through snow crystals. Sub-cloud scavenging does not explain the observed patterns. Fog occurrence enhanced the observed effects at higher altitudes. Deposition amounts doubled from the lowlands to the Erzgebirge summit. From 1993 to 2002, acidity decreased by about 50%, mainly due to reduced SO₂ -emissions.

The feasibility of degrading 16 USEPA priority polycyclic aromatic (PAH) hydrocarbons (PAHs) with heat and Fe(II)-EDTA catalyzed persulfate oxidation was investigated in the laboratory. The experiments were conducted to determine the effects of temperature (i.e. 20 [composite function (small circle)]C, 30 [composite function (small circle)]C and 40 [composite function (small circle)] C) and iron-chelate levels (i.e., 250 mg/L-, 375 mg/L- and 500 mg/L-Fe(II)) on the degradation of dissolved PAHs in aqueous systems, using a series of amber glass jars as the reactors that were placed on a shaker inside an incubator for temperature control. Each experiment was run in duplicate and had two controls (i.e., no persulfate in systems). Samples were collected after a reaction period of 144 hrs and measured for PAHs, pH and sodium persulfate levels. The extent of degradation of PAHs was determined by comparing the data for samples with the controls. The experimental results showed that persulfate oxidation under each of the tested conditions effectively degraded the 16 target PAHs. All of the targeted PAHs were degraded to below the instrument detection limits (~4 μ/L) from a range of initial concentration (i.e., 5 μ/L for benzo(a)pyrene to 57 μ/L for Phenanthrene) within 144 hrs with 5 g/L of sodium persulfate at 20 [composite function (small circle)] C, 30 [composite function (small circle)]C and 40 [composite function (small circle)]C. The data indicated that the persulfate oxidation was effective in degrading the PAHs and that external heat and iron catalysts might not be needed for the degradation of PAHs. The Fe(II)-EDTA catalyzed persulfate also effectively degraded PAHs in the study. In addition, the data on the variation of persulfate concentrations during the experiments indicated that Fe(II)-EDTA accelerated the consumption of persulfate ions. The obtained degradation data cannot be used to evaluate the influence of temperature and Fe(II) levels on the PAH degradation because the PAHs under each of the tested conditions were degraded to below the instrument detection limit within the first sampling point. However, these experiments have demonstrated the feasibility of degrading PAHs in aqueous systems with persulfate oxidation. Additional tests are being conducted to evaluate the effectiveness of treating PAHs in soils and obtaining the rate of degradation of PAHs with persulfate oxidation. Two sets of laboratory experiments were conducted to evaluate the ability of sodium persulfate in oxidizing real world PAH-contaminated soils collected from a Superfund site in Connecticut. The first set of soil sample were treated only with persulfate and to the second batch, mixture of persulfate and Fe(II)-EDTA solutions were added. The results of the second test showed that within 24 hours, 75% to 100% of the initial concentrations of seven PAH compounds detected in the soil samples were degraded by sodium persulfate mixed with FE(II)-EDTA.