Sorption equilibrium of phenol and aniline onto the granular activated carbon and hyperreticulated un-functionalized polymeric resin (MN200) was investigated in single and binary component aqueous systems. Higher loading was obtained for aniline than phenol onto both sorbents, which is probably due to hydrophobic difference between both solutes and the greater electronic density of the aromatic ring of the aniline. Granular activated carbon reported larger uptake than resin MN200 for both solutes, which may be attributed to the better physical properties of the granular activated carbon, for instance, larger surface area. The experimental sorption could be properly described by the Langmuir and Freundlich isotherms. Five models for predicting the binary equilibrium sorption isotherm were compared in order to determine the best fit model to correlate binary experimental data: the extended Langmuir isotherm with and without a constant interaction factor, a simplified model based on the single equilibrium factors, the empirical extended Freundlich isotherm and the modified extended Langmuir equation, which considers the synergistic interactions between sorbate-sorbate and not only the competition between them defined by the extended Langmuir model. The modified extended Langmuir model provides the best agreement between predicted and experimental data indicating that the synergistic interactions between solutes play an important role in the binary phenol/aniline sorption system.

Background, aim, and scope Two new high phenol-degrading strains, Micrococcus sp. and Alcaligenes faecalis JH 1013, were isolated. The two isolates could grow aerobically in mineral salts medium containing phenol as a sole carbon source at concentration of 3,000 mg L⁻¹. It was found that the binary mixed culture of the two isolates possessed good potential for phenol removal. Material and methods Phenol biodegradation using the binary mixed culture of the two isolates was studied. The optimal conditions were determined to be temperature 32°C, pH 7.0, inoculum size 10.0%, and agitation rate 150 rpm in the synthetic wastewater. In addition, the kinetics of the cell growth and phenol degradation by the binary mixed culture were also investigated using Haldane model over a wide range of initial phenol concentrations from 20 to 2,400 mg L⁻¹. Results The experimental data indicated that the binary mixed culture had pretty high phenol degradation potential, which could thoroughly degrade the phenol in the synthetic wastewater containing phenol 2,400 mg L⁻¹ within 72 h under aerobic condition. Under the optimal conditions, the phenol concentration was reduced speedily from 1,000 to below 0.28 mg L⁻¹ in the presence of the binary mixed culture, and the phenol degradation rate reached 99.97% after 16 h. It was well below the standard value 0.28 mg L⁻¹ as described by Chinese Environmental Protection Agency. It was clear that the Haldane kinetic model adequately described the dynamic behavior of phenol degradation by the binary mixed culture with kinetic constants of q max = 0.45 h⁻¹, K sq = 64.28 mg L⁻¹, and K iq = 992.79 mg L⁻¹. The phenol concentration to avoid substrate inhibition had been inferred theoretically to be 252.62 mg L⁻¹. Conclusions Phenol, as the only carbon source, could be degraded by the binary mixed culture at high initial phenol concentrations. Phenol exhibited inhibitory behavior, and the growth kinetics of the binary mixed culture could be correlated well by the simple Haldane's inhibitory model. The kinetics parameters were invariably required for the design and simulation of batch and continuous bioreactor treating phenolic wastewaters.

Background, aim and scope Ria de Aveiro (Portugal) is a shallow coastal lagoon of high economic and ecological importance. Hardly any data on its chemical pollution by polar organic pollutants are available in literature. This study focused on the presence and sources of a series of phenolic endocrine-disrupting compounds (EDCs) in this area, including parabens, alkylphenolic compounds and bisphenol-A (BPA). A number of possible sources of pollution are present in the area, including the large harbours present in the lagoon, the city of Aveiro and the rivers discharging into the area. A recently constructed submarine wastewater outfall, located a few kilometres from the lagoon inlet has also been suggested as a possible source of pollution to Ria de Aveiro in several publications. The aim of the current field study was to investigate the occurrence and main sources of phenolic endocrine disruptors in Ria de Aveiro. Materials and methods An extensive sampling campaign was performed, with surface water and wastewater grab samples taken at over 50 locations, in duplicate on different days. Samples were treated using solid phase extraction and analysed by liquid chromatography tandem mass spectrometry. Results and discussion Concentrations in lagoon water were generally low: not exceeding 20 ng/L for most analytes. Levels in river water exceeded those in the lagoon by a factor 3 to 500 (o-phenylphenol (PhP) and nonylphenoxy ethoxy acetic acids (A₉PEC), respectively), with concentrations up to 700 ng/L for BPA and 7,300 ng/L for A₉PEC. Samples from the harbours showed EDC levels similar to those in the rest of the lagoon, but in the city of Aveiro, elevated concentrations were observed for alkylphenol ethoxylates (A₉PEO), A₉PEC, PhP and BPA. Wastewater effluents showed low levels for parabens, whilst alkylphenolic compounds reached several micrograms per litre. The effluents are discharged into the ocean via a submarine outfall, but as marine water near the outfall showed slightly elevated concentrations only for A₉PEO, it does not seem to be a significant source of these EDCs for the area. Conclusions All the studied phenolic EDCs were detected in the study area, with high levels found in some of the rivers discharging into the lagoon, and generally low concentrations in the lagoon itself. The main sources for all investigated EDCs were the rivers Caster and Antuã which discharge into the lagoon. The city of Aveiro was identified as a secondary source. As the tidal water exchange volume is much larger than the freshwater input from the rivers, concentrations of phenolic EDCs remained low in the lagoon.

Introduction The pyrolytic method was employed to recycle metals and brominated compounds blended into printed circuit boards (PCBs). Methods PCBs were crushed into pieces 4.0-4.8 mm in size, and the crushed pieces were pyrolyzed at temperatures ranging from 200 to 500°C. The compositions of pyrolytic residues, liquid products, and exhaust were analyzed by inductively coupled plasma atomic emission spectrometer, inductively coupled plasma mass spectrometry, and gas chromatography-mass spectrometry. Pyrolytic exhaust was collected by an impinger system in an ice bath cooler to analyze the composition fraction of the liquid product, and uncondensable exhaust was collected for gas constituent analysis. Results Phenol, methyl-phenol, and bromo-phenol were attributed mainly to the liquid product. Metal content was low in the liquid product. In addition, CO, CO₂, CH₄, and H₂ were the major components of pyrolytic exhaust. Conclusions Brominated and chlorinated compounds—i.e., dichloromethane, trans-1,2 dichloroethylene, cis-1,2 dichloroethylene, 1,1,1-trichloroethane, tetrachloromethane, bromophenol, and bromoform—could be high, up to the several parts per million (ppm) level. Low molecular weight volatile organic compounds (VOCs)—i.e., methanol, acetone, ethyl acetate, acrylonitrile, 1-butene, propene, propane, and n-butane—contributed a large fraction of VOCs. The concentrations of toluene, benzene, xylene, ethylbenzene, and styrene were in the ppm range.

Background, aim, and scope Olive oil mill wastewater (OOMW) environmental impacts minimization have been attempted by developing more effective processes, but no chemical or biological treatments were found to be totally effective to mitigate their impact on receiving systems. This work is the first that reports simultaneously the efficiency of three different approaches: biological treatment by two fungal species (Trametes versicolor or Pleurotus sajor caju), enzymatic treatment by laccase, and chemical treatment by photo-Fenton oxidation on phenols removal. Materials and methods Those treatments were performed on OOMW with or without phenol supplement (p-coumaric, vanillin, guaiacol, vanillic acid, or tyrosol). OOMW samples resulted from treatments were extracted for phenols using liquid-liquid extraction and analyzed by gas chromatography coupled to mass spectrometry. Results Treatment with T. versicolor or P. sajor caju were able to remove between 22% and 74% and between 8% and 76% of phenols, respectively. Treatment by laccase was able to reduce 4% to 70% of phenols whereas treatment by photo-Fenton oxidation was responsible for 100% phenols reduction. Discussion Range of phenol degradation was equivalent between T. versicolor, P. sajor caju and laccase for p-coumaric, guaiacol, caffeic acid, and tyrosol in supplemented OOMW, which enhances this enzyme role in the biological treatment promoted by these two species. Conclusions Phenols were removed more efficiently by photo-Fenton treatment than by biological or enzymatic treatments. Recommendations and perspectives Use of fungi, laccase, or photo-Fenton presents great potential for removing phenols from OOMW. This should be further assessed by increasing the application scale and the reactor configurations effect on the performance, besides a toxicity evaluation of treated wastewater in comparison to raw wastewater.