In recent years, an increasing trend towards investigating and monitoring the contamination of the environment by microplastics (MP) (plastic pieces < 5 mm) has been observed worldwide. Nonetheless, a reliable methodology that would facilitate and automate the monitoring of MP is still lacking. With the goal of selecting practical and standardized methods, and considering the challenges in microplastics detection, we present here a critical evaluation of two vibrational spectroscopies, Raman and Fourier transform infrared (FTIR) spectroscopy, and two extraction methods: thermal extraction desorption gas chromatography mass spectrometry (TED-GC-MS) and liquid extraction with subsequent size exclusion chromatography (SEC) using a soil with known contents of PE, PP, PS and PET as reference material. The obtained results were compared in terms of measurement time, technique handling, detection limits and requirements for sample preparation. The results showed that in designing and selecting the right methodology, the scientific question that determines what needs to be understood is significant, and should be considered carefully prior to analysis. Depending on whether the object of interest is quantification of the MP particles in the sample, or merely a quick estimate of sample contamination with plastics, the appropriate method must be selected. To obtain overall information about MP in environmental samples, the combination of several parallel approaches should be considered.

To investigate toxic effects of microplastic on marine microalgae Skeletonema costatum, both algal growth inhibition test and non-contact shading test were carried out, and algal photosynthesis parameters were also determined. The SEM images were used to observe interactions between microplastic and algae. It was found that microplastic (mPVC, average diameter 1 μm) had obvious inhibition on growth of microalgae and the maximum growth inhibition ratio (IR) reached up to 39.7% after 96 h exposure. However, plastic debris (bPVC, average diameter 1 mm) had no effects on growth of microalgae. High concentration (50 mg/L) mPVC also had negative effects on algal photosynthesis since both chlorophyll content and photosynthetic efficiency (ΦPSⅡ) decreased under mPVC treatments. Shading effect was not one reason for toxicity of microplastic on algae in this study. Compared with non-contact shading effect, interactions between microplastic and microalage such as adsorption and aggregation were more reasonable explanations for toxic effects of microplastic on marine microalgae. The SEM images provided a more direct and reasonable method to observe the behaviors of microplastic.

Microplastics (MPs) are thought to be ingested by a wide range of marine organisms before being excreted. However, several studies in marine organisms from different taxa have shown that MPs and nanoplastics could be translocated in other organs. In this study, we investigated the presence of MPs in the livers of commercial zooplanktivorous fishes collected in the field. The study focuses mainly on the European anchovy Engraulis encrasicolus but concerns also the European pilchard Sardina pilchardus and the Atlantic herring Clupea harengus. Two complementary methodologies were used to attest the occurrence of MPs in the hepatic tissue and to exclude contamination. 1) MPs were isolated by degradation of the hepatic tissue. 2) Cryosections were made on the livers and observed in polarized light microscopy. Both methods separately revealed that MPs, mainly polyethylene (PE), were translocated into the livers of the three clupeid species. In anchovy, 80 per cent of livers contained relatively large MPs that ranged from 124 μm to 438 μm, showing a high level of contamination. Two translocation pathways are hypothesized: (i) large particles found in the liver resulted from the agglomeration of smaller pieces, and/or (ii) they simply pass through the intestinal barrier. Further studies are however required to understand the exact process.

Microplastic (MP) vector effects have been well described in the literature but surprisingly little is in known about the impact of MPs on the intestinal uptake of contaminants. The present study aimed to determine whether the intestinal fate of Ag was affected by the presence of polyethylene MP beads. Ag (added as ¹¹⁰ᵐAg) was introduced into the lumen of rainbow trout (Oncorhynchus mykiss) anterior/mid-intestine gut sac preparations as Ag only, Ag and MPs (co-exposure) and Ag-incubated MPs (where Ag was adsorbed to the MP). Results show that after 3 h exposure the distribution of accumulated Ag between the four intestinal compartments (mucus layer, mucosal epithelium, muscle layer and serosal saline) was not affected by either MP condition when compared to Ag alone (p > 0.05, One way ANOVA). Across all treatment groups mucus layer binding dominated (54.2–72.6%) whereas relatively little Ag was transported to the blood compartment (i.e. combined muscle layer and serosal saline compartments, 8.5–15.0%). Accompanying adsorption/desorption studies were performed in relevant media. Over 24 h, 60.6± 2.9% of the available Ag in artificial freshwater adhered to the surface of the PE MPs. In pH adjusted luminal fluids (pH 2.2, 4.1, 7.4 and 9.8) that span the range of conditions encountered within the rainbow trout digestive tract, there was almost complete dissociation at acidic pHs within 3 h (<2% remaining on MPs at both pH 2.2 and pH 4.1). Such pHs are typical of piscine stomach. Based on our finding we suggest that following the ingestion of MPs with adsorbed pollutants, desorption would occur prior to entering the site of uptake. The MPs themselves have no impact on the trans-epithelial transport of the contaminant, but the net result of the MP vector effect is to potentially introduce labile contaminant forms into the intestine.

Microplastic pollution of marine environment is receiving increased publicity over the last few years. The present survey is, according to our knowledge, the survey with the largest sample size analyzed, to date. In total, 1337 specimens of fish were examined for the presence of plastic microlitter representing 28 species and 14 families. In addition, samples of seawater and sediment were also analysed for the quantification of microplastic in the same region. Samples of water/sediment were collected from 18 locations along the Mediterranean coast of Turkey. 94% of all collected plastic microlitter from the sea was in the size range between 0.1 and 2.5 mm, while the occurrence of other sizes was rare. The quantity of microplastic particles in surface water samples ranged from 16 339 to 520 213 per km2. Fish were collected from 10 locations from which 8 were either shared with or situated in the proximity of water/sediment sampling locations. A total of 1822 microplastic particles were extracted from stomach and intestines of fish. Majority of ingested particles were represented by fibers (70%) and hard plastic (20.8%), while the share of other groups: nylon (2.7%), rubber (0.8%) and miscellaneous plastic (5.5%) were low. The blue color of plastic was the most dominant color. 34% of all examined fish had microplastic in the stomach. On average, fish which had microplastic contained 1.80 particle per stomach. 41% of all fish had microplastic in the intestines with an average of 1.81 particle per fish. 771 specimens contained microplastic in either stomach and/or intestines representing 58% of the total sample with an average of 2.36 particles per fish. Microplastic was found in all species/families that had sample size of at least 2 individuals. The number of particles present in either stomach or intestines ranged between 1 and 35. Ingested microparticles had an average diameter ±SD of 656 ± 803 μm, however particles as small as 9 μm were detected. The trophic level of fish species had no influence whatsoever on the amount of ingested microplastic. Pelagic fish ingested more microplastic than demersal species. In general, fish that ingested higher number of microplastic particles originated from the sites that also had a higher particle count in the seawater and sediment.

Several studies in the recent past reported new sources for industrial persistent organic pollutants (POPs) from metropolitan cities of India. To fill the data gap for atmospheric polybrominated diphenyl ethers (PBDEs), polyurethane foam disk passive air sampling (PUF-PAS) was conducted along urban-suburban-rural transects in four quadrilateral cities viz., New Delhi, Kolkata, Mumbai and Chennai from northern, eastern, western and southern India respectively. Average concentration of Σ8PBDEs in pg/m³ for New Delhi, Kolkata, Mumbai and Chennai were 198, 135, 264 and 144 respectively. We observed a distinct urban > suburban > rural trend for atmospheric PBDEs in Mumbai. Principal component analysis (PCA) attributed three different source types. BDE-47, -99, −100, −153 and −154 loaded in the first component were relatively high in the sites where industrial and informal electronic waste (e-waste) recycling activities were prevalent. Penta congener, BDE-99 and tetra congener, BDE-47 contributed 50%–75% of total PBDEs. Ratio of BDE-47 and -99 in Indian cities reflected the usage of penta formulations like Bromkal −70DE and DE-71 in the commercial and electrical products. PC-2 was loaded with BDE-28 and -35. Percentage of BDE-28 and BDE-35 (>10%) were comparatively much higher than commercial penta products. Abundance of BDE-28 in majority sites can be primarily due to re-emission from surface soil. PC-3 was loaded with BDE-183 and elevated levels were observed mostly in the industrial corridor of Indian cities. BDE-183 was notably high in the urban industrial sites of New Delhi. We suspect this octa-BDE congener resulted from recycling process of plastic products containing octa-BDE formulation used as flame retardants.

Microplastics (MP), small plastic particles below 5 mm, have become one of the central concerns of environmental risk assessment. Microplastics are continuously being released into the aquatic environment either directly through consumer products or indirectly through fragmentation of larger plastic materials. The aim of our study was to investigate the effect of polyethylene microbeads from cosmetic products on duckweed (Lemna minor), a freshwater floating plant. The effects of microbeads from two exfoliating products on the specific leaf growth rate, the chlorophyll a and b content in the leaves, root number, root length and root cell viability were assessed. At the same time, water leachates from microbeads were also prepared to exclude the contribution of cosmetic ingredients on the measured impacts. Specific leaf growth rate and content of photosynthetic pigments in duckweed leaves were not affected by polyethylene microbeads, but these microbeads significantly affected the root growth by mechanical blocking. Sharp particles also reduced the viability of root cells, while the impact of microbeads with a smooth surface was neglected. It was concluded that microbeads from cosmetic products can also have negative impacts on floating plants in freshwater ecosystems.

Microplastic particles are increasingly being discovered in diverse habitats and a host of species are found to ingest them. Since plastics are known to sorb hydrophobic organic contaminants (HOCs) there is a question of what risk of chemical exposure is posed to aquatic biota from microplastic-associated contaminants. We investigate bioavailability of polychlorinated biphenyls (PCBs) from polypropylene microplastic by measuring solid-water distribution coefficients, gut fluid solubilization, and bioaccumulation using sediment invertebrate worms as a test system. Microplastic-associated PCBs are placed in a differential bioavailability framework by comparing the results to several other natural and anthrogenic particles, including wood, coal, and biochar. PCB distribution coefficients for polypropylene were higher than natural organic materials like wood, but in the range of lipids and sediment organic carbon, and smaller than black carbons like coal and biochars. Gut fluid solubilization potential increased in the order: coal < polypropylene < biochar < wood. Interestingly, lower gut fluid solubilization for polypropylene than biochar infers that gut fluid micelles may have solubilized part of the biochar matrix while bioaccessibility from plastic can be limited by the solubilizing potential of gut fluids dependent on the solid to liquid ratio or renewal of fluids in the gut. Biouptake in worms was lower by 76% when PCBs were associated with polypropylene compared to sediment. The presence of microplastics in sediments had an overall impact of reducing bioavailability and transfer of HOCs to sediment-ingesting organisms. Since the vast majority of sediment and suspended particles in the environment are natural organic and inorganic materials, pollutant transfer through particle ingestion will be dominated by these particles and not microplastics. Therefore, these results support the conclusion that in most cases the transfer of organic pollutants to aquatic organisms from microplastic in the diet is likely a small contribution compared to other natural pathways of exposure.

Microplastics have been documented in marine environments worldwide, where they pose a potential risk to biota. Environmental interactions between microplastics and lower trophic organisms are poorly understood. Coastal shelf seas are rich in productivity but also experience high levels of microplastic pollution. In these habitats, fish have an important ecological and economic role. In their early life stages, planktonic fish larvae are vulnerable to pollution, environmental stress and predation. Here we assess the occurrence of microplastic ingestion in wild fish larvae. Fish larvae and water samples were taken across three sites (10, 19 and 35 km from shore) in the western English Channel from April to June 2016. We identified 2.9% of fish larvae (n = 347) had ingested microplastics, of which 66% were blue fibres; ingested microfibers closely resembled those identified within water samples. With distance from the coast, larval fish density increased significantly (P < 0.05), while waterborne microplastic concentrations (P < 0.01) and incidence of ingestion decreased. This study provides baseline ecological data illustrating the correlation between waterborne microplastics and the incidence of ingestion in fish larvae.

Samples of microplastic (n = 924) from two beaches in south west England have been analysed by field-portable-x-ray fluorescence (FP-XRF) spectrometry, configured in a low-density mode and with a small-spot facility, for the heavy metals, Cd and Pb, and the halogen, Br. Primary plastics in the form of pre-production pellets were the principal type of microplastic (>70%) on both beaches, with secondary, irregularly-shaped fragments representing the remainder of samples. Cadmium and Pb were detected in 6.9% and 7.5% of all microplastics, respectively, with concentrations of either metal that exceeded 103 μg g−1 usually encountered in red and yellow pellets or fragments. Respective correlations of Cd and Pb with Se and Cr were attributed to the presence of the coloured, inorganic pigments, cadmium sulphoselenide and lead chromate. Bromine, detected in 10.4% of microplastics and up to concentrations of about 13,000 μg g−1, was mainly encountered in neutrally-coloured pellets. Its strong correlation with Sb, whose oxides are effective fire suppressant synergists, suggests the presence of a variety of brominated flame retardants arising from the recycling of plastics originally used in casings for heat-generating electrical equipment. The maximum bioaccessible concentrations of Cd and Pb, evaluated using a physiological extraction based on the chemical characteristics of the proventriculus-gizzard of the northern fulmar, were about 50 μg g−1 and 8 μg g−1, respectively. These concentrations exceed those estimated for the diet of local seabirds by factors of about 50 and 4, respectively.