The objective of present study was to obtain the fixation of nano zero valent iron (nZVI) particles on a permeable matrix and evaluate the performance of this composite material for the removal of Cr(VI) from contaminated waters. The experiments were carried out using the cationic resin Dowex 50WX2 as porous support of the iron nanoparticles. The work was carried out in two phases. The first phase involved the fixation of nZVI on the resin matrix. The resin granules were initially mixed with a FeCl3 solution to obtain the adsorption of Fe(III). Then the Fe(III) loaded resin (RFe) was treated with polyphenol solutions to obtain the reduction of Fe(III) to the elemental state. Two polyphenol solutions were tested as reductants, i.e. green tea extract and gallic acid. Green tea was found to be inefficient, probably due to the relatively big size of the contained polyphenol molecules, but gallic acid molecules were able to reach adsorbed Fe(III) and reduce the cations to the elemental state. The second phase was focused on the investigation of Cr(VI) reduction kinetics using the nanoiron loaded resins (R-nFe). It was found that the reduction follows a kinetic law of first order with respect to Cr(VI) and to the embedded nanoiron. Compared to other similar products, this composite material was found to have comparable performance regarding reaction rates and higher degree of iron utilization. Namely the rate constant for the reduction of Cr(VI), in the presence of 1 mM nZVI, was equivalent to 1.4 h of half-life time at pH 3.2 and increased to 24 h at pH 8.5. The degree of iron utilization was as high as 0.8 mol of reduced Cr(VI) per mole of iron. It was also found that this composite material can be easily regenerated and reused for Cr(VI) reduction without significant loss of efficiency.

We used XAD-resin based passive air samplers (PAS) to measure atmospheric levels of polycyclic aromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs) at five ombrotrophic bogs in Eastern Canada. The aims of our study were to investigate the influence of local roads on contaminant levels in the bogs, to derive the regional pattern of atmospheric concentrations, and to assess the uncertainties of the method. Expanded uncertainties based on the duplicate PAS deployed at 24 sites were good for the PAHs, while the deployment period of approx. 100 days was too short to yield acceptable uncertainties for PCBs. The regional PAH distribution was in good agreement with the calculated source proximity of the sampled bogs. We conclude that XAD-resin based PAS deployed for comparatively short periods are well suited for measuring atmospheric concentrations of volatile PAHs, while in remote regions longer deployment is necessary for less volatile PAHs and for PCBs.

Benthic invertebrates can uptake metals through diffusion of free ion solutes, or ingestion of sediment-bound forms. This study investigated the efficacy of the metal chelating resin SIR 300™ in adsorbing porewater metals and isolating pathways of metal exposure. A field experiment (Botany Bay, Sydney, Australia) and a laboratory toxicity test each manipulated the availability of porewater metals within contaminated and uncontaminated sediments. It was predicted that within contaminated sediments, the resin would adsorb porewater metals and reduce toxicity to invertebrates, but in uncontaminated sediments, the resin would not significantly affect these variables. Whereas in the laboratory, the resin produced the predicted results, in the field the resin increased porewater metal concentrations of contaminated sediments for at least 34 days and decreased abundances of four macroinvertebrate groups, and richness in all sediments. These contrasting findings highlight the limits of extrapolating the results of laboratory experiments to the field environment.

In this work, soil contaminated by petroleum resins was remediated by electrokinetic-bioremediation (EK-BIO) technology for 60 days. A microbial consortium, comprising Rhizobium sp., Arthrobacter globiformis, Clavibacter xyli, Curtobacterium flaccumfaciens, Bacillus subtilis, Pseudomonas aeruginosa and Bacillus sp., was used to enhance the treatment performance. The results indicate that resin removal and phytotoxicity reduction were highest in the inoculated EK process, wherein 23.6% resins was removed from the soil and wheat seed germination ratio was increased from 47% to around 90% after treatment. The microbial counts, soil basal respiration and dehydrogenase activity were positively related to resins degradation, and they could be enhanced by direct current electric field. After remediation, the C/H ratio of resins decreased from 8.03 to 6.47. Furthermore, the structure of resins was analyzed by Fourier-transform infrared spectroscopy, elemental analysis, and ¹H nuclear magnetic resonance (¹H NMR) before and after treatment. It was found that the changes of the structure of resins took place during EK-BIO treatment and finally led to the reduction of aromaticity, aromaticity condensation and phytotoxicity.

Microplastics are emerging pollutants in water bodies worldwide. The environmental entry areas must be studied to localise their sources and develop preventative and remedial solutions. Rivers are major contributors to the marine microplastics load. Here, we focus on a specific type of plastic microbead (diameter 286–954 μm, predominantly opaque, white–beige) that was repeatedly identified in substantial numbers between kilometres 677 and 944 of the Rhine River, one of Europe's main waterways. Specifically, we aimed (i) to confirm the reported abrupt increase in microbead concentrations between the cities of Leverkusen and Duisburg and (ii) to assess the concentration gradient of these particles along this stretch at higher resolution. Furthermore, we set out (iii) to narrow down the putative entry stretch from 81.3 km, as reported in an earlier study, to less than 20 km according to our research design, and (iv) to identify the chemical composition of the particles and possibly reveal their original purpose. Surface water filtration (mesh: 300 μm, n = 9) at regular intervals along the focal river stretch indicated the concentration of these spherules increased from 0.05 to 8.3 particles m−3 over 20 km. This spot sampling approach was supported by nine suspended solid samples taken between 2014 and 2017, encompassing the river stretch between Leverkusen and Duisburg. Ninety-five percent of microbeads analysed (202/212) were chemically identified as crosslinked polystyrene-divinylbenzene (PS-DVB, 146/212) or polystyrene (PS, 56/212) via Raman or Fourier-transform infrared spectroscopy. Based on interpretation of polymer composition, surface structure, shape, size and colour, the PS(-DVB) microbeads are likely to be used ion-exchange resins, which are commonly applied in water softening and various industrial purification processes. The reported beads contribute considerably to the surface microplastic load of the Rhine River and their potential riverine entry area was geographically narrowed down.

Adsorption is an efficient method for removal of pharmaceuticals and personal care products (PPCPs). Magnetic resins are efficient adsorbents for water treatment and exhibit potential for PPCP removal. In this study, the magnetic hypercrosslinked resin Q100 was used for adsorption of PPCPs. The adsorption behavior of this resin was compared with those of two activated carbons, namely, Norit and F400D. Norit exhibited the fastest adsorption kinetics, followed by Q100. Norit featured a honeycomb shape and long-range ordered pore channels, which facilitated the diffusion of PPCPs. Moreover, the large average pore size of Q100 reduced diffusion resistance. The adsorbed amounts of 11 PPCPs on the three adsorbents increased with increasing adsorbate hydrophobicity. For Q100, a significant linear correlation was observed between the adsorption performance for PPCPs and hydrophobicity (logD value) of adsorbates (R2 = 0.8951); as such, PPCPs with high logD values (>1.69) could be efficiently removed. Compared with those of Norit and F400D, the adsorption performance of Q100 was less affected by humic acid because of the dominant hydrophobic interaction. Furthermore, Q100 showed improved regeneration performance, which renders it promising for PPCP removal in practical applications.

Due to their terrestrial habitats and aquatic reproduction, many amphibians are both very vulnerable and highly suitable bioindicators. The plasticizer bisphenol A (BPA) is one of the most produced chemical substances worldwide, and knowledge on its impacts on humans and animals is mounting. BPA is used for the industrial production of polycarbonate plastics and epoxy resins and found in a multitude of consumer products. Studies on BPA have involved mammals, fish and the fully aquatic anuran model Xenopus laevis. However, our knowledge about the sexual development of non-model, often semi-terrestrial anuran amphibians remains poor. Using a recently developed experimental design, we simultaneously applied BPA to two non-model species (Hyla arborea, Hylidae; Bufo viridis, Bufonidae) and the model X. laevis (Pipidae), compared their genetic and phenotypic sex for detection of sex reversals, and studied sexual development, focusing on anatomical and histological features of gonads. We compared three concentrations of BPA (0.023, 2.28 and 228 μg/L) to control groups in a high-standard flow-through-system, and tested whether conclusions, drawn from the model species, can be extrapolated to non-model anurans. In contrast to previous studies on fish and Xenopus, often involving dosages much higher than most environmental pollution data, we show that BPA causes neither the development of mixed sex nor of sex-reversed individuals (few, seemingly BPA-independent sex reversals) in all focal species. However, environmentally relevant concentrations, as low as 0.023 μg/L, were sufficient to provoke species-specific anatomically and histologically detectable impairments of gonads, and affected morphological traits of metamorphs. As the intensity of these effects differed between the three species, our data imply that BPA diversely affects amphibians with different evolutionary history, sex determination systems and larval ecologies. These results highlight the role of amphibians as a sensitive group that is responsive to environmental pollution.

Atmospheric nitrogen deposition is one of the main threats for biodiversity and ecosystem functioning. Measurement techniques like ion-exchange resin collectors (IECs), which are less expensive and time-consuming than conventional methods, are gaining relevance in the study of atmospheric deposition and are recommended to expand monitoring networks. In the present work, bulk and throughfall deposition of inorganic nitrogen were monitored in three different holm oak forests in Spain during two years. The results obtained with IECs were contrasted with a conventional technique using bottle collectors and with a literature review of similar studies. The performance of IECs in comparison with the conventional method was good for measuring bulk deposition of nitrate and acceptable for ammonium and total dissolved inorganic nitrogen. Mean annual bulk deposition of inorganic nitrogen ranged 3.09–5.43 kg N ha−1 according to IEC methodology, and 2.42–6.83 kg N ha−1 y−1 using the conventional method. Intra-annual variability of the net throughfall deposition of nitrogen measured with the conventional method revealed the existence of input pulses of nitrogen into the forest soil after dry periods, presumably originated from the washing of dry deposition accumulated in the canopy. Important methodological recommendations on the IEC method and discussed, compiled and summarized.

Bromophenols (BRPs) have been widely detected in human tissues, however, relative proportions from natural products and/or anthropogenic flame retardants are not clear. 21 polybrominated diphenyl ethers (PBDEs), 15 MeO/OH-PBDEs, and 10 BRPs were simultaneously quantified in adipose collected from people from New York City, USA. An in vitro assay utilizing human liver microsomes was performed for detected predominant organobromine. High concentrations of 2,4,6-triBRP and PBDEs were observed, and extremely low concentrations of naturally occurring MeO/OH-PBDEs were detected. Similar biotransformatioin rates of BRPs and MeO/OH-PBDEs indicated that the relative high concentration of 2,4,6-triBRP in humans was not of natural origin. Significant correlation observed between concentrations of 2,4,6-triBRP and BDE-209 suggested that the two chemicals may share a common source. Both 2,4,6-triBRP and BDE-209 were detected in commercial ABS resins, suggesting that plastic products made from ABS resins could be potential sources of co-exposure of the two compounds for humans.

Bisphenol A (BPA) is widely used industrially to produce polycarbonate plastics and epoxy resins. Numerous studies document the harmful effects caused by low-dose BPA exposure especially on nervous systems and behavior in experimental animals such as mice and rats. Here, we exposed embryos of a model chordate, Ciona intestinalis, to seawater containing BPA to evaluate adverse effects on embryonic development and on the swimming behavior of subsequent larvae. Ciona is ideal because its larva develops rapidly and has few cells. The rate of larval hatching decreased in a dose-dependent manner with exposures to BPA above 3 μM; swimming behavior was also affected in larvae emerging from embryos exposed to 1 μM BPA. Adverse effects were most severe on fertilized eggs exposed to BPA within 7 h post-fertilization. Ciona shares twelve nuclear receptors with mammals, and BPA is proposed to disturb the physiological functions of one or more of these.