Interest in selenium pollution and remediation technology has escalated during the past two decades. Although not known to be essential for plants, selenium is essential but could be toxic for humans and animals, depending on its concentration. A major selenium controversy in the 1980's emerged in California when the general public and scientific community became aware of selenium's potential as an environmental contaminant. After extensive research on several strategies to reduce loads of mobile Se for entering the agricultural ecosystem a plant-based technology, defined as 'phytoremediation' received increasing recognition, as a low-cost environmentally friendly approach for managing soluble Se in the soil and water environment. Successful long-term field remediation of Se by plants is, however, dependent upon acceptance and widespread use by growers, who are also concerned about potential commercial value from using the plant-based technology. Obtaining products with economic value from plants used in the cleanup of soil would certainly be an additional benefit to phytoremediation, which could help sustain its long-term use.

The removal of phenanthrene, anthracene and benzo(a)pyrene added at three different concentrations was investigated with or without earthworms (Eisenia fetida) within 11 weeks. Average anthracene removal by the autochthonous micro-organisms was 23%, 77% for phenanthrene and 13% for benzo(a)pyrene, while it was 51% for anthracene, 47% for benzo(a)pyrene and 100% for phenanthrene in soil with earthworms. At 50 and 100 mg phenanthrene kg−1E. fetida survival was 91% and 83%, but at 150 mg kg−1 all died within 15 days. Survival of E. fetida in soil amended with anthracene ≤1000 mg kg−1 and benzo(a)pyrene ≤150 mg kg−1 was higher than 80% and without weight loss compared to the untreated soil. Only small amounts of PAHs were detected in the earthworms. It was concluded that E. fetida has the potential to remove large amounts of PAHs from soil, but more work is necessary to elucidate the mechanisms involved.

This study investigates the fate and behavior of lead (Pb), copper (Cu), antimony (Sb), and arsenic (As) in a shooting range soil. The soil samples were collected from the surface (0-15 cm) and the subsurface (15-40 cm and 40-55 cm) of a grassy and wood chip covered impact area behind a firing position. Optical microscopy images indicate significant amounts of corroded bullet fragments and organic wood chips in the surface soil. Analysis by X-ray powder diffraction (XRPD) and scanning electron microscopy electron dispersive X-ray spectroscopy (SEM-EDS) showed that metallic Pb was transformed into lead oxides (litharge PbO and massicot PbO) and lead carbonates (hydrocerussite Pb₃(CO₃)₂(OH)₂, cerussite PbCO₃, and plumbonacrite Pb₅(CO₃)₃O(OH)₂). Rietveld quantification indicated the surface soil contained 14.1% metallic Pb, 17.9% hydrocerussite, 5.2% plumbonacrite, 5.9% litharge, and 3.9% massicot on a dry weight basis, or a total of 39.7% Pb, far in excess of lead concentrations typically found in US shooting range soils. Metallic Cu (bullet jacket material) appeared stable as no secondary minerals were detected in the surface soil. As and Sb concentrations were on the order of 1,057 mg/kg and 845 mg/kg respectively. The elevated soil pH coupled with high organic carbon content is thought to have caused downward migration of metals, especially for Pb, since 4,153 mg Pb/kg was observed at a depth of 55 cm. More than 60% of Pb was concentrated in the coarse soil (> 0.425 mm) fraction, suggesting soil clean-up possible by physical soil washing may be viable. The concentrations of Pb, As, and Sb in the toxicity characteristic leaching procedure (TCLP) extracts were 8,869 mg/L, 6.72 mg/L, and 6.42 mg/L respectively, were above the USEPA non-hazardous regulatory limit (As and Pb) of 5 mg/L. The elevated Sb and As concentrations draw concern because there is historically limited information concerning these metals at firing ranges and several values exceeded local soil cleanup criteria. As the high Pb concentrations appeared to be linked to the presence of organic-rich berm cover materials, the use of wood chips as berm cover to prevent soil erosion requires reconsideration as a shooting range management practice.

Preliminary leaching column and greenhouse plant uptake studies were conducted in two soils with contrasting characteristics amended with varying rates (0 to 148.3 Mg ha-1) of incinerated sewage sludge (ISS) and weathered sewage sludge (WISS) to estimate the leaching losses of trace elements from the soils amended with incinerated sewage sludge by products and to evaluate the uptake and accumulation of these elements in various parts of Sorghum vulgaris var. sudanense Hitche. (“Sorgrass''), a Sorghum-Sudan grass hybrid. Results of this study indicated that leaching of Cr, Cd, Zn, Cu, Ni, Fe and Mn from soils amended with ISS and WISS increased with increasing rates of amendment. Results of the leaching column study further revealed greater leaching losses from coarse-textured soil compared to medium-textured soil and also from ISS amended soils than with WISS amended soils. Results further suggested that the type of element and the interaction between the element and soil properties affected the leachability of various trace elements. The uptake study indicated uptake and accumulation of trace elements by plant parts increased with increasing rates of amendments. Greater plant uptake and accumulation of trace elements were observed in plant parts grown in soils amended with ISS compared to that of WISS. Results also indicated a greater accumulation of trace elements in below ground part of the plants (roots) compared to that was observed in above ground parts (shoots). Limited data obtained from this one season preliminary studies demonstrated that incinerated sewage sludge products from wastewater treatment plants could be used as soil amendments at low application (no more than 24.7 Mg ha-1) for optimum plant growth, and dry matter yield without resulting in substantial accumulation of metals in plant parts at concentrations above the recommended critical limits and without causing significant leaching losses of various trace elements. It is imperative that long-term field studies are necessary to evaluate the long-term impact of using these new products in leaching and accumulation of various trace elements in plants and soils.

In Hypericumspecies some specimens have been found to display higher levels of the toxic heavy metal Cd than the proposed guide value of 0.5mgkg. Plant and soil samples from various regions in Eastern Austria were collected to study the variability in the Cd content of the herbs and relate it to selected soil properties and soil micronutrient contents. The soils contained between 0.01 and 0.44mgkg-¹Cd in the dry soil. Altogether about 7% of the collected plant samples exceeded 0.5mgkg-¹Cd of dry shoots, the proposed guide value for the drug Herba Hyperici. Plants low in Cd were found on sites in the Alpenvorland, the Hainburger Berge, the Eastern Viennese Basin and the Northern Limestone Alps where the levels did not exceed 0.3mgkg-¹Cd of dry shoots. Higher Cd levels in the plants were present in material from the Waldviertel, the Southern Wienerwald and the Semmering region where often bioaccumulation factors for Cd above 1 could be calculated. In these regions the soil pH and carbonate content was somewhat lower than in other regions whereas the soil organic carbon varied greatly. In the Waldviertel some plants from a field were somewhat higher in Cd than nearby plants from the natural vegetation. In a regression analysis, the soil pH, soil organic carbon and soil Cd content were the main factors influencing Cd accumulation in the plant shoots.

Pedotransfer functions based on general purpose Freundlich isotherms (GPF) were derived for Cd using different combinations of input variables or development conditions. The models match the criterion of flexibility as they were derived from data of 497 soil samples, which had strongly varying soil characteristics. The prediction efficiency of the approaches was investigated by comparison of measured and simulated sorption data for 124 independent soil samples. The parameterisation of the GPF shows that models derived from data of batch sorption experiments by multiple linear regression achieve best goodness-of-fit and statistical consistency. The use of extraction data or nonlinear regression analysis results in greater deviations from the statistical optima. The best overall performance considering parameterisation and validation was observed for the models including (a) the variables 'proton activity', 'clay content', 'soil organic carbon', 'sum of dithionite-extractable Fe- and Mn-oxides' or (b) the variables 'proton activity', 'potential cation exchange capacity', 'sum of dithionite-extractable Fe- and Mn-oxides'.

Zinc toxicity thresholds for reclamation plants are largely unknown. As a result, ecological risk assessments often rely on toxicity thresholds for agronomic species, which may differ from those of restoration species. Our objective was to provide Zn toxicity thresholds for forb species that are commonly used in reclamation activities. We used a greenhouse screening study where seedlings of yarrow (Achillea millefolium L.), Bigelow's tansyaster (Machaeranthera bigelovii (Gray) Greene var. bigelovii), blue flax (Linum perenne L. var. Appar), alfalfa (Medicago sativa L. var. Ladak), Palmer's penstemon (Penstemon palmeri Gray), and Rocky Mountain penstemon (Penstemon strictus Benth. var. Bandera) were grown in sand culture and exposed to increasing concentrations of Zn. Lethal concentrations (LC50 - substrate Zn concentration resulting in 50% mortality), effective concentrations (EC50 - substrate Zn concentration resulting in 50% biomass reduction), and phytotoxicity thresholds (PT50 - tissue Zn concentration resulting in 50% biomass reduction) were then determined. Phytotoxicity thresholds and effective concentrations for these reclamation species were relatively consistent between species. Our estimates of PT50-shoot for these species range from 1258 to 3214 mg Zn kg-¹ . Measures of EC50-plant for these restoration forbs ranged from 82 to 214 mg Zn L-¹ . These thresholds might be more useful for risk assessors working on reclamation sites than those based on non-reclamation species that are widely used.

In multiphase systems capillary pressures play a significant role on fluid movement and retention. The facility to predict the effect of different thermal remediation strategies requires the knowledge of the effect of temperature on capillary pressure-saturation relationships in the soils. The objective of recent study was (a) to develop a technique for routinely measuring the pressure-saturation curves of soil samples saturated with a nonpolar liquid at different regulated temperatures (b) to build a database using the measured pressure-saturation curves and the physical, chemical properties of the model soils (c) to establish the dependence of nonaqueous phase liquid retention on the soil properties and the temperature. The retention curves (extraction isotherms) with nonaqueous phase liquid were determined using a modified pressure plate extractor. The wetting phase was a non-aromatic hydrocarbon distillation product. Pressure plates were designed and constructed in the laboratory of our department. The temperature was held constant at 20, 40 and 60 [composite function (small circle)]C. Statistical analysis was performed involving selected soil parameters and the measured nonaqueous phase liquid retention data. The results show that knowing some easily measurable soil parameters (bulk density, particle size distribution, humus and lime content) we can estimate the nonaqueous phase liquid retention of the soils. The measured “extraction isotherms” provide essential information about the temperature-dependency of pressure-saturation curves.

The objectives of this study were to simplify sample preparation and validate mercury detection in soil and plant samples using inductively coupled plasma atomic emission spectroscopy (ICP-AES). A set of mercury contaminated and mercury free soil and plant samples were digested and analyzed by ICP-AES, inductively coupled plasma mass spectrometry (ICP-MS), and cold vapor atomic absorption spectroscopy (CVAAS). Results show that mercury measurements in soil and plant samples using ICP-AES were in agreement with those analyzed using ICP-MS and CVAAS. The concentrations of mercury in soils and plant tissues determined by ICP-AES were 92.2% and 90.5% of those determined by CVAAS and ICP-MS, respectively. Digestion of soil samples with 4 M HNO₃ and direct measurement by ICP-AES without reduction of Hg²⁺ to Hg⁰ gave a reasonable and acceptable recovery (92%) for determining Hg in soils. We conclude that ICP-AES with optimized conditions (addition of gold chloride, extension of washing time, linear working range, and selection of wavelength - 194 nm) resulted in reliable detection of mercury in environmental samples.

Although lead (Pb) emissions have dropped drastically with the phase-out of tetra-ethyl lead (TEL) as a fuel additive, Pb deposited along highway corridors continues to be of concern because of its toxicity. This paper provides comprehensive data on the extent and distribution of Pb in roadside soils, Pb interaction with soils as a function of soil composition, the retention capacity of soil based on batch adsorption tests, the retention mechanism of Pb using selective sequential extraction, the potential for mobility using batch desorption tests with simulated rain and winter road salt, and column leach tests. Highway soils on high-traffic sections near Burnaby, Canada were found to have Pb accumulations up to 1628mg/kg soil. Contamination was mainly in the top 0.3m, with concentrations rapidly decreasing to the background level at a depth of 0.6m. The top layer contained more organic material and had a high adsorption capacity. Highway soils were found to have 3-10 times higher Pb adsorption capacities than the amount currently deposited. Selective sequential extraction indicated low exchangeable Pb in highway soils. Batch desorption tests with leaching solutions of H₂O (pH 5.5), HNO₃ solution (pH 4.0) and aqueous NaCl solution (0.17M) indicate low likelihood of significant leaching. Selective sequential extraction, leachate extraction and desorption tests show that Pb has limited mobility in highway soil.