The optimization of nickel ion (Ni2+) removal in aqueous solutions with various factors (initial Ni concentration, solution pH, adsorbent dosage, contact time), as affected by raw cow bone (RBO) and its biochar (bone char: BC; produced by pyrolysis processes at 500 °C and a residence time of 4 hours) as adsorbents was investigated by a three-level Box–Behnken model (BBM) under response surface methodology (RSM). A total of 29 experimental runs were set for each adsorbent, and the experimental data were fitted to the empirical model. To understand the Ni2+ adsorption processes better, the properties of RBO and BC were characterized using Fe-SEM, FT-IR, BET, XRD, and CHNS elemental analysis techniques. The BC characteristics showed that pyrolysis increased the specific surface area (by 100 times) and phosphate functional groups, but decreased the carbonate functional groups, and yielded a more irregular and rougher morphological surface compared to RBO. Based on BC's superior ion exchange mechanisms and physical electrostatic adsorption compared to RBO, the removal efficiency of Ni2+ by BC was higher in aqueous solutions. The numerical optimization of BBM revealed that the optimum removal by BC (82.56%) was obtained at an initial Ni2+ concentration of 30.79 mg L−1, pH of 6.99, adsorbent dose of 4.87 g L−1, and contact time of 57.82 min, with the desirability of "1". BC can be effectively used for Ni removal from Ni-contaminated aqueous solutions; still, the application of modification methods (e.g., physical and chemical activation) may be necessary to help remove more Ni2+ by BC.

International audience | Fate, transport and accumulation of nanoplastics have attracted considerable attention in the past few years. While actual researches have been focused on nanoplastics dispersed or aggregated in different environmental system, no study have been focused on the possibility that nanoplastics are co-transported with other natural or anthropogenic materials. Therefore, the large quantity of debris released in the environment, such as cigarette butts (CGB), could be part of the nanoplastics fate and behavior. Here we show the considerable sorption capacities of cigarette filters for nanoplastics. To address this topic, we chose polystyrene-based nanoplastics with similar state of charge (according to the physico-chemical characteristic of the zeta potential −45 to −40 mV) but with different sizes (50–800 nm) and morphologies. A kinetic approach to sorption in fresh water (pH = 8.05; 179.5 μS cm−1) at room temperature was carried out by means of the flow field flow analysis method (AF4) to determine the partition coefficients and water sampling rates between nanoplastics and cigarette butts. Using different models of, more or less environmentally relevant, nanoplastics (NPTs) and adequate analytical strategies, we found partition coefficients between the NPTs and CGBs ranged from 102 to 104 in freshwater conditions. We demonstrated that the physical features of the NPTs (size and morphology) have an influence on the sorption behaviour. Asymmetrical shaped NPTs with broader size distribution seems to be mostly retained in the CGBs after longer equilibration time. This result shows the importance of the NPTs features on the mechanisms governing their transfer and fate in the environment through environmental matrices, especially when other materials are involved. We anticipate our work to be a starting point for investigating the co-transport of NPTs with other materials present in the environment (natural and anthropogenic).

International audience | This review investigates the impact of salinity on the fate of the active compounds of pesticides in a cultivated environment. Due to the over-exploitation of water resources and intensification of agriculture, salinity outbreaks are being observed more often in cultivated fields under pesticide treatments. Nevertheless, there is a poor understanding of the incidence of varying water salt loads on the behavior of pesticides’ active ingredients in soil and water bodies. The present review established that water salinity can affect the diffusion of pesticides’ active ingredients through numerous processes. Firstly, by increasing the vapor pressure and decreasing the solubility of the compounds, which is known as the salting-out effect, salinity can change the colligative properties of water towards molecules and the modification of exchange capacity and sorption onto the chemicals. It has also been established that the osmotic stress induced by salinity could inhibit the biodegradation process by reducing the activity of sensitive microorganisms. Moreover, soil properties like dissolved organic matter, organic carbon,clay content, and soil texture control the fate and availability of chemicals in different processes of persistence in water and soil matrix. In the same line, salinity promotes the formation of different complexes, such as between humic acid and the studied active compounds. Furthermore, salinity can modify the water flux due to soil clogging because of the coagulation and dispersion of clay particle cycles, especially when the change in salinity ranges is severe.

Mitigation of pesticide dispersion in soil and water is required to protect ecosystem health and the anthropic uses of water bodies. Biochar amendments have been suggested to reduce pesticide dispersion due to their high sorption potentials. Nevertheless, appraisals at different scales have been limited by the costs of pesticide analyses. The aim of this study was to evaluate the potential of two fluorescent tracers, uranine (UR) and sulforhodamine B (SRB), for use as pesticide proxies in the context of biochar amendments used for mitigation purposes. Therefore, we compared the sorption processes of both fluorescent tracers and those of three pesticides, glyphosate, 2,4-D, and difenoconazole for soils; three wood biochars (pine, oak, and beech/charm blend); and soil/biochar mixtures representing agricultural usages. The results showed that the sorption of glyphosate by soil was unaffected by amendment with the tested pine, oak, and wood blend biochars. In contrast, the sorption coefficients of UR, SRB, 2,4-D, and difenoconazole were significantly increased with these biochar amendments. SRB, in particular, exhibited sorption behavior similar to that of the hydrophobic fungicide difenoconazole. This indicates promise for the use of SRB as a proxy for hydrophobic pesticides, in testing biochar amendments.

International audience | Due to the dramatic quantity of plastic debris released into our environment, one of the biggest challenges of the next decades is to trace and quantify microplastics (MPs) in our environments, especially to better evaluate their capacity to transport other contaminants such as trace metals. In this study, trace elements (Fe, Cu, Zn, As, Cd, Sn, Sb, Pb, and U) were analyzed in the microplastic subsurface (200 μm) using laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS). Microplastics subjected to the marine environment were collected on beaches (Guadeloupe) exposed to the north Atlantic gyre. We established a strategy to discriminate sorbed contaminants from additives based on the metal concentration profiles in MP subsurface using qualitative and quantitative approaches. A spatiotemporal correlation of the sorption pattern was proposed to compare MPs in terms of relative exposure time and time-weighted average concentrations in the exposure media.

Trivalent chromium [Cr(III)] and tannins serve as necessary substances in leather processing and coexist in tannery site, which lead to the chromium contamination in site soil when disposed improperly. However, coexisting tannins are very likely to complex with Cr(III) and affect its properties, ultimately changing the mobility of chromium in soil. In this study, tannic acid (TA) was selected to investigate the complexation with Cr(III) and the influence on the solubility and sorption of Cr(III) in soils. Then, the transport behavior and mechanism of Cr(III)-TA complexes in soil was clarified. Dialysis results showed that the increase of TA concentration and solution pH promoted the formation of complexed Cr(III). The results of UV–Vis absorption spectroscopy, X-ray photoelectron spectroscopy, and density functional theory calculations indicated that the adjacent ionized phenolic hydroxyls in TA functioned as the binding sites with Cr(III) to form the Cr–O bonds and the degree of complexation increased with pH. The Cr(III)-TA complexes had higher solubility than free Cr(III) at pH ≥ 6.0. Batch sorption experiments demonstrated that the sorption capacity of Cr(III)-TA to soils with different pH was always lower than that of free Cr(III). These reasons led to the stronger mobility of Cr(III)-TA in soil columns than Cr(III). Our research reveals that the enhanced mobility of Cr(III) in soils coexisting with TA.

Distribution in ice is regarded as one of important transport modes for pollutants in seasonal freeze-up waters in cold regions. However, the distribution characteristics and mechanisms of fluorinated antibiotics as emerging contaminants during the water freezing process remain unclear. Here, florfenicol and norfloxacin were selected as model fluorinated antibiotics to investigate their ice-water distribution. Effects of antibiotic molecular structure on the distribution were explored through comparative studies with their non-fluorinated structural analogs. Results showed that phase changes during the ice growth process redistributed the antibiotics, with antibiotic concentrations in water 3.0–6.4 times higher than those in ice. The solute-rich boundary layer with a concentration gradient was presented at the ice-water interface and controlled by constitutional supercooling during the freezing process. The ice-water distribution coefficient (KIW) values of antibiotics increased by 34.8%–38.0% with a doubling of the cooling area. The solute distribution coefficient (Kbₛ) values of antibiotics at −20 °C were 65.6%–70.3% higher than at −10 °C. The KIW and Kbₛ values of all antibiotics were negatively correlated with their water solubilities. The fluorine substituents influenced the binding energies between antibiotics and ice, resulting in a 1.1-fold increase in the binding energy of norfloxacin on the ice surface relative to its structural analog pipemidic acid. The results provide a new insight into the transport behaviors of fluorinated pharmaceuticals in ice-water systems.

Per-and polyfluoroalkyl substances (PFASs) have attracted extensive attention since this century due to their wide distribution, persistence, bioaccumulation/biomagnification potential, and (eco)toxicity. In the present study, we investigated the sorption kinetics, sorption isotherms and desorption behaviors of legacy and emerging PFASs with different chain lengths and functional end groups onto marine sediments at four different salinities (0, 10, 20, and 30 practical salinity units (psu)). Results revealed that the sorption of PFASs onto sediment can be well described by the pseudo-second-order kinetic model. PFASs sorption was influenced by both compound-specific and solution-specific parameters. The distribution coefficient (Kd) for PFASs were increased with the increase of perfluorocarbon chain length and salinity, suggesting that hydrophobic and electrostatic interactions were involved in the adsorption process. 6:2 FTSA showed the lowest adsorption among PFASs with eight carbon atoms (6:2 FTSA, PFOA and PFOS). The increase of perfluorocarbon chain length of PFASs and salinity would result in the decrease of desorption rate of PFASs from sediment. In addition, PFCAs were desorbed more easily from the sediment than the PFSAs with the same perfluorocarbon chain length at all salinity groups. The present study demonstrated that salinity can apparently influence the fate of PFASs in aquatic environment and provided valuable data for modeling the fate of PFASs in real environment.

Application of nanopesticides may substantially increase surface attachment and internalization of engineered nanoparticles (ENPs) in food crops. This study investigated the role of stomata in the internalization of silver nanoparticles (Ag NPs) using abscisic acid (ABA)-responsive ecotypes (Ler and Col-7) and ABA-insensitive mutants (ost1-2 and scord7) of Arabidopsis thaliana in batch sorption experiments, in combination with microscopic visualization. Compared with those of the ABA-free control, stomatal apertures were significantly smaller for the Ler and Col-7 ecotypes (p ˂ 0.05) but remained unchanged for the ost1-2 and scord7 mutants, after exposure to 10 μM ABA for 1 h. Generally Ag NP sorption to the leaves of the Ler and Col-7 ecotypes treated with 10 μM ABA was lower than that in the ABA-free control, mainly due to ABA-induced stomatal closure. The difference in Ag NP sorption with and without ABA was less pronounced for Col-7 than for Ler, suggesting different sorption behaviors between these two ecotypes. In contrast, there was no significant difference in foliar sorption of Ag NPs by the ost1-2 and scord7 mutants with and without ABA treatment. Ag NPs were widely attached to the Arabidopsis leaf surface, and found at cell membrane, cytoplasm, and plasmodesmata, as revealed by scanning electron microscopy and transmission electron microscopy, respectively. These results highlight the important role of stomata in the internationalization of ENPs in plants and may have broad implications in foliar application of nanopesticides and minimizing contamination of food crops by ENPs.