Noise is one of the main parameters to be considered to achieve a healthy indoor ambience in ferries. Therefore, the noise standards need to be more specialized and specifically based on real sampled data and case studies. In the present research, the noise levels in a ship, under different working conditions, were sampled and compared with those specified in the new and old standards. An initial study showed two main noise sources- clients and main engine- that influence other indoor environments, reducing the quality of life on board. The real-time data revealed that the maximum noise level limits set by the International Maritime Organization (IMO) in the older Resolution A.468 (XII) was mostly respected, except in areas where maintenance of the noise level was difficult, owing to the continuous influx of people, especially at the time of boarding and disembarking of the passengers and at the food self-service areas. In this sense, under the new Resolution MSC.337 (91), the maximum noise level allowed in the accommodation has been reduced by 5 dB (A), but this environment does not meet the standard. More results show that future standards must not only consider the noise level in a working place and add another variable, such as, the number of working hours, to obtain a representative equivalent energy, and they must also consider that a simple modification of this standard implies a redesign of most of the indoor ambiences onboard.

Coastal forest decline due to seasprays has been reported from all continents, both on broadleaves and conifers. The main cause has been identified in the presence of surfactants. Sea winds transport these substances to the leaves, where they are absorbed via cuticula and stomata producing indirect and also direct damage. The scope of this work is the macroscopic and microscopic assessment of the long term effects of polluted seasprays on Aleppo pines in natural conditions from the Saler coastline (Eastern Spain) inwards. Surfactants may be involved in the damage to Aleppo pine in El Saler as more severe episodes of damage have been observed in the last decade

Sewage sludge used as agricultural fertilizer has been identified as an important source of microplastics (MPs) to the environment. However, the fate of MPs added to agricultural soils is largely unknown. This study investigated the fate of MPs in agricultural soils amended with sewage sludge and the role of surface water runoff as a mechanism driving their transfer to aquatic ecosystems. This was assessed using three experimental plots located in a semi-arid area of Central Spain, which were planted with barley. The experimental plots received the following treatments: (1) control or no sludge application; (2) historical sludge application, five years prior to the experiment; and (3) sludge application at the beginning of the experiment. MPs were analyzed in surface water runoff and in different soil layers to investigate transport and infiltration for one year. The sewage sludge used in our experiment contained 5972–7771 MPs/kg dw. Based on this, we estimated that about 16,000 MPs were added to the agricultural plot amended with sludge. As expected, the sludge application significantly increased the MP concentration in soils. The control plot contained low MP concentrations (31–120 MPs kg⁻¹ dw), potentially originating from atmospheric deposition. The plot treated five years prior to the experiment contained 226–412 and 177–235 MPs kg⁻¹ dw at the start and end of the experiment, respectively; while the recently treated plot contained 182–231 and 138–288 MPs kg⁻¹ dw. Our study shows that MP concentrations remain relatively constant in agricultural soils and that the MP infiltration capacity is very low. Surface water runoff had a negligible influence on the export of MPs from agricultural soils, mobilizing only 0.2–0.4% of the MPs added with sludge. We conclude that, in semi-arid regions, agricultural soils can be considered as long-term accumulators of MPs.

This study reports the results obtained from toxicological analyses of different types of baits referred to the laboratory of the Toxicology Area (Faculty of Veterinary Medicine, Cáceres, Spain) over a 17-year period (2002–2018). These baits were suspicious materials found in the environment of the region of Extremadura (Western Spain), where such malpractices are a problem to be addressed, as wide livestock farming and hunting activities are combined with a significant wealth of wildlife (especially birds of prey). A total of 246 baits, including 32 commercial chemical products to be used in baits, were analysed. Samples from 183 cases were received and classified according to the material used for their preparation and the toxic substance found. Overall, the most common bait consisted of meat preparations (56.3% of cases) intended to eliminate predators considered ‘annoying’ for livestock and hunting practices, such as carnivores and scavengers. It should be noted that contact baits (as fenthion-impregnated perches) were also detected (7.6%). Regarding the substances detected, anticholinesterase compounds (organophosphates and carbamates) were the most commonly used substances for the preparation of baits (detected in 85.3% of positive baits). Moreover, 8% of the positive baits presented more than one toxic substance in their composition. Due to the types of toxic compounds and the methods used to prepare the baits, this study shows that the malicious use of highly toxic substances in the environment to kill wildlife is a common and current issue and poses a serious risk to different species.

This study investigates the behavior of Tl in the Ría de Huelva (SW Spain), one of the most metal polluted estuaries in the world. Dissolved Tl concentration displayed a general decrease across the estuary during the dry season (DS); from 5.0 to 0.34 μg/L in the Tinto and Odiel estuaries, respectively, to 0.02 μg/L in the channel where the rivers join. A slighter decrease was observed during the wet season (WS) (from 0.72 to 0.14 μg/L to 0.02 μg/L) due to the dilution effect of rainfalls in the watersheds. These values are 3 orders of magnitude higher than those reported in other estuaries worldwide. Different increases in Tl concentrations with salinity were observed in the upper reaches of the Tinto and Odiel estuaries, attributed to desorption processes from particulate matter. Chemical and mineralogical evidences of particulate matter, point at Fe minerals (i.e., jarosite) as main drivers of Tl particulate transport in the estuary. Unlike other estuaries worldwide, where a fast sorption process onto particulate matter commonly takes place, Tl is mainly desorbed from particulate matter in the Tinto and Odiel estuaries. Thus, Tl may be released back from jarositic particulate matter across the salinity gradient due to the increasing proportion of unreactive TlCl⁰ and K⁺ ions, which compete for adsorption sites with Tl⁺ at increasing salinities. A mixing model based on conservative elements revealed a 6-fold increase in Tl concentrations related to desorption processes. However, mining spills like that occurred in May 2017 may contribute to enhance dissolved and particulate Tl concentrations in the estuary as well as to magnify these desorption processes (up to around 1100% of Tl release), highlighting the impact of the mine spill on the remobilization of Tl from the suspended matter to the water column.

Transfer parameters are key inputs for modeling radionuclide transfer in the environment and estimating risk to humans and wildlife. However, there are no data for many radionuclide-foodstuff/wildlife species combinations. The use of parameters derived from stable element data when data for radionuclides are lacking is increasingly common. But, do radionuclides and stable elements behave in a sufficiently similar way in the environment? To answer this question, at least for soil to plant transfer, sampling was conducted in four different countries (England, Kazakhstan, Spain and Ukraine) affected by different anthropogenic radionuclide source terms (in chronological order: global fallout, Semipalatinsk Test Site, the 1957 Windscale accident and the 1986 Chernobyl accident) together with a bibliographical review. Soil to grass transfer parameters (ratio between dry matter concentrations in plant and soil), Fᵥ, for ¹³⁷Cs and ⁹⁰Sr were significantly higher than those for stable elements, suggesting that the use of the latter could lead to underestimating radionuclide concentrations in plant samples Transfer parameters for ¹³⁷Cs and stable Cs were linearly correlated, with a slope of 1.54. No such correlation was observed for ⁹⁰Sr and stable Sr, the mean value of the ⁹⁰Sr:Sr ratio was 35 ranging (0.33–126); few data were available for the Sr comparison. The use of radionuclide transfer parameters, whenever possible, is recommended over derivation from stable element concentrations. However, we acknowledge that for many radionuclides there will be few or no radionuclide data from environmental studies. From analyses of the data collated there is evidence of a decreasing trend in the Fᵥ(¹³⁷Cs)/Fᵥ(Cs) ratio with time from the Chernobyl accident.

Organic ultraviolet (UV) filters are used in personal care products, but they are also added to industrial products and are constantly released to the environment. This study analyses the occurrence of 8 widely used organic UV filters in seawater from three beaches on the Gran Canaria Island (Spain) and in three wastewater treatment plants (WWTPs) by taking samples from influents and effluents. It also discusses the target compounds’ post-treatment removal efficiencies. Sampling was carried out for 6 months and analytes were extracted by solid phase extraction with Sep-pak C18 cartridges. They were determined by ultra-high performance liquid chromatography coupled to mass spectrometry in tandem. The potential environmental hazard associated with the found concentrations was also assessed for marine organisms. Different target compounds were detected on the analysed beaches and in the wastewater. Benzophenone-3 (BP3) was the most recurrent compound in the seawater samples (frequency detection of 83%) and also in wastewater influents and effluents (measured in all the samples). However, the highest concentrations for seawater (172 μg L⁻¹) and influent wastewater (208 μg L⁻¹) corresponded to octocrylene, while methylene bis-benzotriazolyltetramethylbutylphenol was the compound most concentrated in secondary treatment effluent (34.0 μg L⁻¹) and BP3 in tertiary treatment effluent (8.07 μg L⁻¹). All the analysed samples showed that at least one target UV filter was present. Regarding the removal efficiencies of these compounds in the studied WWTPs, consistent differences between the target compounds were observed in influent concentration terms, where the average removal rates were higher than 50% for most of the compounds. Conventional treatment is unable to completely remove many studied compounds, while tertiary treatment acts as an additional elimination for some of them. An environmental hazard quotient above 1 was found for octocrylene, benzophenone-3 and 4-methylbenzylidene camphor, which indicates a potential high hazard for living species if these compounds are present.