Knowledge of the transport and fate of pathogenic Escherichia coli, especially in the areas contaminated with crude oil, is required to assess contamination of shallow groundwater resources. The present study aims to investigate the effect of crude oil-mediated water repellency on the movement of nalidixic acid-resistant Escherichia coli strain (E. coli NAR) and bromide (Br) as an inert tracer in two soil types. The soils were contaminated at three levels of 0, 0.5 and 1% w/w of total petroleum hydrocarbons (TPHs) using crude oil. Steady-state saturated flow in the soil columns was controlled using a tension infiltrometer. Leaching experiments were conducted through the columns of repacked (un-weathered) and physically-weathered clay loam (CL) and sandy loam (SL) soils. The columns leachate was sampled at specific times for 4 pore volumes. The shape of breakthrough curves for the E. coli NAR and Br depended on soil texture and structure and the TPHs level. Preferential flow in the crude oil-mediated water-repellent soils facilitated the transport of contaminants especially E. coli NAR. Filtration coefficient and relative adsorption index of bacteria were greatest in the repacked CL soils and were lowest in the weathered SL soils. Discontinuity of soil pores and lower flow velocity resulted in greater filtration of E. coli NAR in the repacked CL soil than other treatments. Physical weathering induced the formation of aggregates which reduced soil particle surfaces available for retention of water-repellent oil and contaminants. Movement of both bacteria and Br tracer in the weathered SL soil with 1% TPHs was higher than other treatments. This finding was attributed to low specific surface area, continuity of the pores and water repellency-mediated preferential pathways in the weathered SL soil columns. Our findings implied that shallow groundwater resources could be very sensitive to microbial contamination particularly in the oil-mediated water-repellent soils.

In this study, graphene aerogel (GA) was successfully prepared through a simple hydrothermal method. The resulting GA exhibited a porous network structure with a large specific surface area (350.8 m²/g), ultra-light mass and easy separation from water. The pHIEP value of the GA was estimated to be 3.5. The adsorption process and the factors that affect adsorption capacity were studied. The adsorption could be conducted in a wide pH range from 2.0 to 7.0. The maximum adsorption capacity of GA towards U(VI) at pH 4.0 and T = 298 K was 238.67 mg/g calculated from the Langmuir model. The GA had greatly rapid adsorption property for the removal of U(VI) at pH 4.0. Kinetic data showed good correlation with pseudo-second-order equation. Fourier transform infrared spectroscopy and X-ray photoelectron spectrometry characterizations showed that GA adsorbed U(VI) through chemical interaction by oxygen-containing and nitrogen-containing groups functional groups. The results show that GA has excellent application potential as an adsorbent material for removing U(VI) from aqueous solution.

Microplastic polystyrene foam has been found widely in the environment and is readily transported by wind or water. Beached and virgin foams of size 0.45–1 mm were prepared as sorbents to study oxytetracycline sorption. Enhanced adsorption were found in the beached foams compared to the virgin foams, corresponding to the higher specific surface area, micropore area and the degree of oxidation of the former. The Freundlich Kf value was 894 ± 84 ((mg kg⁻¹) (mg L⁻¹)¹/ⁿ) for oxytetracycline adsorption on the beached foams, approximately twice as high as on the virgin foams. Effects of solution pH on adsorption to the beached foams were more pronounced to the virgin foams. Maximum adsorption occurred at pH 5 at which electrostatic repulsion between the microplastic surface and the oxytetracycline zwitterion was minimal, indicating that electrostatic interaction may have regulated adsorption. Moreover, H-bonding and multivalent cationic bridging mechanisms may also have affected the adsorption of oxytetracycline to the beached foams as reflected by the ionic effects. Adsorption was promoted more in the presence of humic acid than of fulvic acid, perhaps owing to π-π conjugation between the humic acid and the microplastic surface which led to enhanced electrostatic attraction for oxytetracycline. This study suggests that weathered polystyrene foams may act as carriers of antibiotics in the environment and their potential risks to ecosystem and human health merit further investigation.

In the present study, the daily dose in terms of particle surface area received by citizens living in five cities in Western countries, characterized by different lifestyle, culture, climate and built-up environment, was evaluated and compared. For this purpose, the exposure to sub-micron particle concentration levels of the population living in Barcelona (Spain), Cassino (Italy), Guilford (United Kingdom), Lund (Sweden), and Brisbane (Australia) was measured through a direct exposure assessment approach. In particular, measurements of the exposure at a personal scale were performed by volunteers (15 per each population) that used a personal particle counter for different days in order to obtain exposure data in microenvironments/activities they resided/performed. Non-smoking volunteers performing non-industrial jobs were considered in the study.Particle concentration data allowed obtaining the exposure of the population living in each city. Such data were combined in a Monte Carlo method with the time activity pattern data characteristics of each population and inhalation rate to obtain the most probable daily dose in term of particle surface area as a function of the population gender, age, and nationality.The highest daily dose was estimated for citizens living in Cassino and Guilford (>1000 mm²), whereas the lowest value was recognized for Lund citizens (around 100 mm²). Indoor air quality, and in particular cooking and eating activities, was recognized as the main influencing factor in terms of exposure (and thus dose) of the population: then confirming that lifestyle (e.g. time spent in cooking activities) strongly affect the daily dose of the population. On the contrary, a minor or negligible contribution of the outdoor microenvironments was documented.

Emission of hazardous trace elements (HTEs) from energy production is receiving much attention due to concerns about the toxicity to the ecosystem and human health. This study presented new field measurement data on the HTEs partitioning behavior and size-segregated elemental compositions of gaseous particular matter (PM) generated from a commercial circulating fluidized bed (CFB) power plant. Mineralogical and morphological characteristics of combustion ash and PM2.5 (particle diameter less than 2.5 μm) were determined by X-ray diffractometer (XRD) and scanning electron microscopy with energy dispersive X-ray spectroscopy (SEM/EDS). Functional groups alteration during CFB combustion was characterized by Fourier transform infrared spectroscopy (FTIR). The presence of aliphatic hydrogen at 2910 cm−1 and 2847 cm−1 in the PM2.5 suggested that the aliphatic carbon-rich volatiles were absorbed on the fine particles with large surface area. Fine fly ash (PM2.5) occurred as irregular glass particles or/and as unburned carbon. The typical irregular particles were mainly composed of Al-Si-Ca or Al-Si-Fe phases. The enrichment behavior of HTEs was determined for the airborne size-segregated particular matter. Elemental occurrences, combustion temperature, unburnt carbon, and limestone additives during CFB combustion were critical in the transformation behavior of HTEs. The total potentially mobile pollutants that exit the CFB power plant every year were estimated as follows: 0.22 tons of Cr, 0.12 tons of Co, 0.73 tons of Ni, 0.04 tons of As, 0.07 tons of Se, 3.95 kg of Cd, and 3.34 kg of Sb.

Homes represent a critical microenvironment in terms of air quality due to the proximity to main particle sources and the lack of proper ventilation systems. Biomass-fed heating systems are still extensively used worldwide, then likely emitting a significant amount of particles in indoor environments. Nonetheless, research on biomass emissions are limited to their effects on outdoor air quality then not properly investigating the emission in indoor environments.To this purpose, the present paper aims to evaluate the exposure to different airborne particle metrics (including both sub- and super-micron particles) and attached carcinogenic compounds in dwellings where three different heating systems were used: open fireplaces, closed fireplaces and pellet stoves. Measurements in terms of particle number, lung-deposited surface area, and PM fraction concentrations were measured during the biomass combustion activities, moreover, PM₁₀ samples were collected and chemically analyzed to obtain mass fractions of carcinogenic compounds attached onto particles. Airborne particle doses received by people exposed in such environments were evaluated as well as their excess lung cancer risk.Most probable surface area extra-doses received by people exposed to open fireplaces on hourly basis (56 mm² h⁻¹) resulted one order of magnitude larger than those experienced for exposure to closed fireplaces and pellet stoves. Lifetime extra risk of Italian people exposed to the heating systems under investigation were larger than the acceptable lifetime risk (10⁻⁵): in particular, the risk due to the open fireplace (8.8 × 10⁻³) was non-negligible when compared to the overall lung cancer risk of typical Italian population.

Passive air samplers (PAS) were evaluated for measuring indoor concentrations of phthalates, novel brominated flame retardants (N-BFRs), polybrominated diphenyl ethers (PBDEs), and organophosphate esters (OPEs). Sampling rates were obtained from a 50-day calibration study for two newly introduced PAS, polydimethylsiloxane (PDMS) or silicone rubber PAS (one with and one without a coating of styrene divinyl benzene co-polymer, XAD) and the commonly used polyurethane foam (PUF) PAS. Average sampling rates normalized to PAS surface area were 1.5 ± 1.1 m³ day⁻¹ dm⁻² for both unsheltered PDMS and XAD-PDMS, and 0.90 m³ ± 0.6 day⁻¹dm⁻² for partially sheltered PUF. These values were derived based on the compound-specific sampling rates measured here and in the literature for the PAS tested, to reasonably account for site-specific variability of sampling rates.PDMS and PUF were co-deployed for three weeks in 51 homes located in Ottawa and Toronto, Canada. Duplicate PUF and PDMS samplers gave concentrations within 10% of each other. PDMS and PUF-derived air concentrations were not statistically different for gas-phase compounds. PUF had a higher detection of particle-phase compounds such as some OPEs. Phthalate and OPE air concentrations were ∼100 times higher than those of N-BFRs and PBDEs. Concentrations were not systematically related to PM₁₀, temperature or relative humidity.We conclude that both PAS provide replicable estimates of indoor concentrations of these targeted semi-volatile organic compounds (SVOCs) over a three-week deployment period. However, PUF is advantageous for collecting a wider range of compounds including those in the particle phase.

Smoking activities were recognized as a main risk factor for population. Indeed, mainstream smoke aerosol is directly inhaled by smokers then delivering harmful compounds in the deepest regions of the lung. In order to reduce the potential risk of smoking, different nicotine delivery products have been recently developed. The latest device released is an electrically heated tobacco system (iQOS®, Philip Morris) which is able to warm the tobacco with no combustion. In the present paper a dimensional and volatility characterization of iQOS-generated particles was performed through particle number concentration and distribution measurements in the mainstream aerosol. The experimental analysis was carried out through a condensation particle counter, a fast mobility particle sizer and a thermo-dilution sampling system allowing aerosol samplings at different temperatures. Estimates of the particle surface area dose received by smokers were also carried out on the basis of measured data and typical smoking patterns.The particle number concentrations in the mainstream aerosols resulted lower than 1 × 108 part. cm−3 with particle number distribution modes of about 100 nm. Nonetheless, the volatility analysis showed the high amount of volatile fraction of iQOS-generated particles, indeed, samplings performed at 300 °C confirmed a significant particle shrinking phenomena (modes of about 20 nm). Anyway, the particle number concentration does not statistically decrease at higher sampling temperatures, then showing that a non-volatile fraction is always presents in the emitted particles. The dose received by smokers in terms of non-volatile amount of particle surface area was equal to 1–2 mm2 per puff, i.e. up to 4-fold larger than that received by electronic cigarette vapers.

Carbon nanotubes can be either toxic or beneficial to plant growth and can also modulate toxicity of organic contaminants through surface sorption. The complex interacting toxic effects of carbon nanotubes and organic contaminants in plants have received little attention in the literature to date. In this study, the toxicity of multiwall carbon nanotubes (MWCNT, 50 mg/L) and paraquat (MV, 0.82 mg/L), separately or in combination, were evaluated at the physiological and the proteomic level in Arabidopsis thaliana for 7–14 days. The results revealed that the exposure to MWCNT had no inhibitory effect on the growth of shoots and leaves. Rather, MWCNT stimulated the relative electron transport rate and the effective photochemical quantum yield of PSII value as compared to the control by around 12% and lateral root production up to nearly 4-fold as compared to the control. The protective effect of MWCNT on MV toxicity on the root surface area could be quantitatively explained by the extent of MV adsorption on MWCNT and was related to stimulation of photosynthesis, antioxidant protection and number and area of lateral roots which in turn helped nutrient assimilation. The influence of MWCNT and MV on photosynthesis and oxidative stress at the physiological level was consistent with the proteomics analysis, with various over-expressed photosynthesis-related proteins (by more than 2 folds) and various under-expressed oxidative stress related proteins (by about 2–3 folds). This study brings new insights into the interactive effects of two xenobiotics (MWCNT and MV) on the physiology of a model plant.

CuO engineered nanoparticles (NPs) are of increasing concern due to their extensive use in daily life and adverse effect on aquatic organisms. The investigations on the toxicity of CuO NPs to aquatic plants through uptake from roots versus fronds are limited. This paper discusses the interactions of CuO NPs with Lemna minor, a floating plant. After CuO NPs (150 μg L⁻¹) exposure for 7 days, the frond number, frond surface area and dry weights of whole plants significantly decreased by 32%, 47% and 33%; the responses were dose-dependent. Microscopy imaging showed that the epidermis was severely damaged in fronds, edges were severely sloughed off and cell integrity was damaged in roots. Shrinkage of both chloroplast and starch grains were observed in the frond cells. Internalization of CuO NPs in root and frond cells during CuO NPs (1 mg L⁻¹) exposure was confirmed with the root Cu levels of Lemna minor being three times higher than the fronds by using transmission electron microscopy and flame atomic absorption spectrophotometry. Reactive oxygen species, mainly H₂O₂ (increased by 56%) and ·OH (increased by 57%), accumulated in Lemna minor tissues in response to CuO NPs exposure. Moreover, chloroplasts were confirmed as a site of ROS production. These findings are helpful for better understanding the biological responses of aquatic plants upon NPs exposure.