A passive air sampler was developed for collecting polycyclic aromatic hydrocarbons (PAHs) in air mass from various directions. The airflow velocity within the sampler was assessed for its responses to ambient wind speed and direction. The sampler was examined for trapped particles, evaluated quantitatively for influence of airflow velocity and temperature on PAH uptake, examined for PAH uptake kinetics, calibrated against active sampling, and finally tested in the field. The airflow volume passing the sampler was linearly proportional to ambient wind speed and sensitive to wind direction. The uptake rate for an individual PAH was a function of airflow velocity, temperature and the octanol–air partitioning coefficient of the PAH. For all PAHs with more than two rings, the passive sampler operated in a linear uptake phase for three weeks. Different PAH concentrations were obtained in air masses from different directions in the field test. A novel directional passive air sampler was developed and tested for monitoring PAHs in air masses from different directions.

Volatile substances and gases resulting e.g. from degradation processes of chemicals in soils emit into the atmosphere and no chemical mass balance is complete without considering this path. Closed soil chambers allow the evaluation of this transfer to the atmosphere. This study deals with the influence of soil chambers with a glass plate cover on physical soil conditions in the chambers and the possibility to simulate the exterior conditions within the chambers. The water content immediately at the soil surface is an important factor for the microbial activity and the transfer of gaseous compounds to the atmosphere as well. It is monitored by specially designed water content sensors in 1 cm depth in the chamber and as control outside. Funnels with a cross section equal to the soil surface area of the chamber collect the rain water and channel it into the soil chamber. This results in soil water content in the chambers very similar to that outside. For the purpose of analysing ¹⁴CO₂ and volatile ¹⁴C-compounds, air is permanently pumped through the chamber. In order to simulate natural conditions, the wind speed is measured 1 cm above the soil surface outside the chambers. A control circuit adjusts the air flow through the chamber to a value corresponding to the wind speed outside. Temperature measurements in 1 cm depth verify that there is no significant difference between the soil chamber and the control outside.

A novel silicate mesoporous material, SBA-15 supported Fe₂O₃, was synthesized by post-synthesis method via ultrasonic-assisted route. The desulfurization test from a gas mixture containing 0.1 vol% H₂S was carried out over SBA-15 supported Fe₂O₃ in a fixed-bed system at atmospheric pressure and room temperature. The effects of the chemical nature of Fe₂O₃ and the textural properties of the material on desulfurization capacity were studied. Materials before and after the desulfurization test were characterized using nitrogen adsorption, XRD, TEM, FTIR, XPS, ICP and other standard methods. The characterization results suggest that modification process does not change the two-dimensional hexagonal mesostructure of SBA-15. Iron species disperses inside channels and the outside surface in the crystalline phase of iron oxide. The material with iron content of 31.3 wt% presented highest H₂S uptake capacity. Structural properties of the material also play important roles in desulfurization performance besides the catalytic effects of iron oxide. The basic feature of material and enough oxygen supply are benefit for the reaction. SBA-15 supported Fe₂O₃ can be an effective alternative to capture H₂S from gas streams.

The pulp left after the extraction of juice from Citrus reticulate (kinnow), is a waste material, which was used as a potential sorbent for Cr(III) and Cr(VI) in the present study. The effect of experimental parameters such as pH, biosorbent dosage, biosorbent particle size, initial metal concentrations, temperature, shaking speed and sorption time on the Cr removal is apparent from the obtained results. The Freundlich isotherm and pseudo second order kinetic models fitted well to the data of Cr(III) and Cr(VI) biosorption by Citrus reticulata waste biomass. Effect of several pretreatments such as gases, natural coagulant and many other chemicals on Cr(III) and Cr(VI) sorption capacity of Citrus reticulata waste biomass was first time analyzed in the present study. The metal sorption capacity of Citrus reticulata waste biomass after a specific pretreatment was not only related to the nature of chemical but also strongly dependent on the oxidation state of the metal.