The present study attempts to investigate some blood parameters of Otolithes ruber during different seasons in terms of both temperature and pollution. For so doing it uses 10 specimens, for each station and season, collected from 5 polluted stations, including Petrochemical, Ghanam, Zangi, Douragh, Patil, and Sajafi as the control group, away from pollution in Musa Creek. The fish are anesthetized with 1ml of clove extract per liter. Their blood samples are taken immediately from the caudal vein, using a heparinized syringe. Afterwards, the serum is separated in a centrifuge with a speed of 6000 rpm for 2 minutes. The desired factors are measured by the Mindray BS200 auto-analyzer and the total protein level, by Bradford's usual laboratory methods. Results show that AST, ALT, ALP, Glucose, and Triglycerides have increased in more polluted stations (P≤0.05). In sheer contrast, total protein and Albumin have decreased as pollution grows (P≥0.05). According to this study, environmental water pollution of the fish has a large impact on the concentration of measured blood parameters, whereas the influence of seasonal changes on most of them is low.

In this study, a novel biosorbent is prepared from the pods of Bauhinia variegata is used for defluoridation of the fluoride contaminated water. It is an eco-friendly and economically feasible material. Comparison of adsorption capacity of Physically Treated Bauhinia (PTB) and Chemically Treated Bauhinia (CTB) are carried in this work. Characterization studies like SEM, EDS, FTIR, and XRD are executed to analyze surface morphology and functional groups in PTB and CTB. The experimental procedure was implemented in a batch process where the operating constraints such as dosage, pH, initial fluoride concentration, time, and temperature are varied to attain optimized efficiency. PTB and CTB yield an adsorption capacities of 10.90 mg/g and 15.45 mg/g respectively in the batch process. PTB adheres fluoride in monolayer formation whereas CTB forms multilayer adsorption. The adsorption process was described by the Pseudo first-order model to state the mechanism of physisorption. The negative values of thermodynamic parameters indicate spontaneity and favorable conditions for adsorption process. As CTB has a higher adsorption capacity than PTB, the batch study has been extended to column adsorption. Bed depth, initial fluoride concentration, and flow rate are the experimental variables used to acquire breakthrough curves. Simplified column models like Adam-Bohart, Thomas, and Yoon-Nelson models were analyzed. In column studies, Yoon-Nelson model fitted well in describing the process of adsorption. The maximum adsorption capacity acquired during the column process was found to be 1.176 mg/g with a bed depth of 5 cm and a flow rate of 5 ml/min. Thus, the innocuous and sustainable adsorbent is developed and serves as an excellent defluoridation agent.

Tropospheric ozone is a highly oxidative pollutant with the potential to alter plant metabolism. The direct effects of ozone on plant phenotype may alter interactions with other organisms, such as pollinators, and, consequently, affect plant reproductive success. In a set of greenhouse experiments, we tested whether exposure of plants to a high level of ozone affected their phenological development, their attractiveness to four different pollinators (mason bees, honeybees, hoverflies and bumblebees) and, ultimately, their reproductive success. Exposure of plants to ozone accelerated flowering, particularly on plants that were growing in autumn, when light and temperature cues, that commonly promote flowering, were weaker. Simultaneously, there was a tendency for ozone-exposed plants to disinvest in vegetative growth. Plant exposure to ozone did not substantially affect pollinator preference, but bumblebees had a tendency to visit more flowers on ozone-exposed plants, an effect that was driven by the fact that these plants tended to have more open flowers, meaning a stronger attraction signal. Honeybees spent more time per flower on ozone-exposed plants than on control plants. Acceleration of flower production and the behavioural responses of pollinators to ozone-exposed plants resulted in retained reproductive fitness of plants pollinated by bumblebees, honeybees and mason bees, despite the negative effects of ozone on plant growth. Plants that were pollinated by hoverflies had a reduction in reproductive fitness in response to ozone. In a natural setting, acceleration of flowering by ozone might foster desynchronization between plant and pollinator activities. This can have a strong impact on plants with short flowering periods and on plants that, unlike wild mustard, lack compensatory mechanisms to cope with the absence of pollinator activity in the beginning of flowering.

The limited evidence available suggests that the interaction between chemical pollutants and biological particles may intensify respiratory diseases caused by air pollution in urban areas. Unlike air pollutants, which are routinely measured, records of biotic component are scarce. While pollen concentrations are daily surveyed in most cities, data related to airborne bacteria or fungi are not usually available. This work presents the first effort to understand atmospheric pollution integrating both biotic and abiotic agents, trying to identify relationships among the Proteobacteria, Actinobacteria and Ascomycota phyla with palynological, meteorological and air quality variables using all biological historical records available in the Madrid Greater Region. The tools employed involve statistical hypothesis contrast tests such as Kruskal-Wallis and machine learning algorithms. A cluster analysis was performed to analyse which abiotic variables were able to separate the biotic variables into groups. Significant relationships were found for temperature and relative humidity. In addition, the relative abundance of the biological phyla studied was affected by PM₁₀ and O₃ ambient concentration. Preliminary Generalized Additive Models (GAMs) to predict the biotic relative abundances based on these atmospheric variables were developed. The results (r = 0.70) were acceptable taking into account the scarcity of the available data. These models can be used as an indication of the biotic composition when no measurements are available. They are also a good starting point to continue working in the development of more accurate models and to investigate causal relationships.

Polycyclic aromatic hydrocarbons (PAHs) in soil can be recalcitrant to solvent extraction after aging. We showed in this study that mixing a small amount of water in the extracting solvent during microwave-assisted extraction (MAE) can release recalcitrant PAHs, resulting in significant improvement in the analyzed concentrations. The improvement factor (F) for the total of 16 priority PAHs (∑PAH16) listed by the United States Environmental Protection Agency was 1.44–1.55 for field soils. By comparing the F values for different soil organic components, we demonstrated that the recalcitrant PAHs were primarily associated with biochar, humic acid (HA), and humin (HM), with the F values for ∑PAH16 of 1.94, 6.62, and 4.59, respectively. The results showed that the recalcitrant PAHs comprised a sequestered fraction and a desorption-limited fraction. NMR spectra showed that water worked alone at elevated temperature to promote hydrolysis of biochar and destroy the macromolecular structure, thus causing the release of the otherwise sequestered PAHs during MAE. The substantial reduction in F values for HA and HM after demineralization indicated sequestration of PAHs in organic-mineral complexes, which can be destroyed by hot water treatment. The release of the sequestered fraction was nonselective and independent of compound hydrophobicity. In comparison, the release of the desorption-limited fraction was positively affected by the hydrophobicity of PAHs and was facilitated by the presence of water in the extracting solvent. The results of this study provide important insights into the sequestration and release of recalcitrant PAHs in soil.

Wastewater containg proteinaceous ossein effluents are problematic to be treated. We studied the possibility to treat ossein effluents with the marine cyanobacterium strain Cylindrospermum stagnale. After optimizing the culture conditions of the bacterium, three different types of ossein effluents were tested: dicalcium phosphate (DCP), high total dissolved solids (HTDS) and low total dissolved (LTDS). The effluents were diluted with sea water at the following ratios 1:1, 2:1 and 3:2. The optimum operating conditions were at 3000 lux light intensity and 37 °C temperature. The highest degradation of ossein effluens by C. stagnale was attained for a dilution ratio of 1:1. However, less diluted ossein effluents reduced the growth of C. stagnale drastically. The degradation was shown by measuring the chlorophyll a content and the dry weight of bacterial cells during a seven-day incubation period degradation. Fourier Transform Infrared Spectroscopy (FT-IR) analysis verified the degradation showing the presence of the degradation products of ossein (i.e. calcium carbonate and calcite) in the culture medium. Lipid composition in fatty acids appeared to be suitable for biofuel production. The results showed that the marine cyanobacterium C. stagnale can be used to treat ossein effluents, and at the same time, to produce biofuel in a sustainable way.

Based on the wind erosion equation and the use of moderate resolution imaging spectroradiometer (MODIS) satellite remote sensing data combined with parameter normalization processing, an optimized high spatial-temporal resolution soil fugitive dust (SFD) emission inventory compiling method was proposed in this study. The "2 + 26" cities in northern China, where heavy pollution frequently occurs, were used as a case study. Using the optimized method, we estimated that the PM₅₀, PM₁₀, and PM₂.₅ emissions from SFD of "2 + 26" cities in 2018 were 2,014,927, 1,007,463, and 151,120 tons, respectively. The dust emissions and emission factors of each city presented significant differences and were generally of a greater level in high-latitude areas (such as cities in Hebei Province) than in low-latitude areas (such as cities in Henan and Shandong Province). Moreover, with an increase in latitude, vegetation cover factors generally exhibit an upward trend, while temperature and rainfall exhibit a downward trend. The dust emissions in the different months showed significant differences. The total dust emission reached the highest level in "late winter–early spring" season (February to April), and the monthly emission accounted for 15–17% of the annual emissions. While in the "summer–autumn" season (July to November), it is the lowest level of the whole year, monthly emissions accounted for 3–5% of the annual emissions. The emission inventory method proposed in this study can provide a reference for dust emission assessment and further pollution prevention and control work.

Climate warming is expected to impact the response of species to insecticides. Recent studies show that this interaction between insecticides and temperature can depend on other factors. Here, we tested for the influence of transgenerational effects on the Insecticide × Temperature interaction in the crop pest moth Spodoptera littoralis. Specifically, we analysed reaction norms among experimental clutches based on a split-plot design crossing the factors temperature, insecticide and clutch. The study was performed on 2280 larvae reared at four temperatures (23, 25, 27 and 29 °C), and their response to the insecticide deltamethrin (three concentrations and a control group) was tested. Temperature had a global influence with effects on larval survival, duration of development, pupal body mass, and significant reaction norms of the clutches for temperature variations of only 2 °C. In addition to the expected effect of deltamethrin on mortality, the insecticide slightly delayed the development of S. littoralis, and the effects on mortality and development differed among the clutches. Projection models integrating all the observed responses illustrated the additive effects of deltamethrin and temperature on the population multiplication rate. Variation in the response of the clutches showed that transgenerational effects influenced the impact of insecticide and temperature. Although no evidence indicated that the Insecticide × Temperature interaction depended on transgenerational effects, the studies on the dependence of the Insecticide × Temperature interaction on other factors continue to be crucial to confidently predict the combined effects of insecticides and climate warming.

Ozone (O₃) is a harmful pollutant when present in the lowermost layer of the atmosphere. Therefore, the European Commission formulated directives to regulate O₃ concentrations in near-surface air. However, almost 50% of the 5068 air quality stations in Europe do not monitor O₃ concentrations. This study aims to provide a hybrid modeling system that fills these gaps in the hourly surface O₃ observations on a site scale with much higher accuracy than existing O₃ models. This hybrid model was developed using estimations from multiple linear regression-based eXtreme Gradient Boosting Machines (MLR-XGBM) and O₃ reanalysis from European regional air quality models (CAMS-EU). The binary classification of extremely high O₃ events and the 1- and 24-h forecasts of hourly O₃ were investigated as secondary aims. In this study thirteen stations in Northern Bavaria, out of which six do not monitor O₃, were chosen as test sites. Considering the computational complexity of machine learning algorithms (MLAs), we also applied two recent MLA interpretation methods, namely SHapley Additive exPlanations (SHAP) and Local interpretable model-agnostic explanations (LIME).With SHAP, we showed an increasing effect of temperature on O₃ concentrations which intensifies for temperatures exceeding 17 °C. According to LIME, O₃ concentration peaks are mainly governed by meteorological factors under dry and warm conditions on a regional scale, whereas local nitrogen oxide concentrations control base O₃ concentrations during cold and wet periods.While recently developed MLAs for the spatial estimation of hourly O₃ concentrations had a station-based root-mean-square error (RMSE) above 27 μg/m³, our proposed model significantly reduced the estimation errors by about 66% with an RMSE of 9.49 μg/m³. We also found that logistic regression (LR) and MLR-XGBM performed best in the site-scale classification and 24-h forecast of O₃ concentrations (with a station-averaged accuracy and RMSE of 0.95 and 19.34 μg/m³, respectively).

Extracellular Polymeric Substances (EPS) influenced Poly Cyclic Aromatic Hydrocarbons (PAHs) degrading Klebsiella pneumoniae was isolated from the marine environment. To increase the EPS production by Klebsiella pneumoniae, several physicochemical parameters were tweaked such as different carbon sources (arabinose, glucose, glycerol, lactose, lactic acid, mannitol, sodium acetate, starch, and sucrose at 20 g/L), nitrogen sources (ammonium chloride, ammonium sulphate, glycine, potassium nitrate, protease peptone and urea at 2 g/L), different pH, carbon/nitrogen ratio, temperature, and salt concentration were examined. Maximum EPS growth and biodegradation of Anthracene (74.31%), Acenaphthene (67.28%), Fluorene (62.48%), Naphthalene (57.84%), and mixed PAHs (55.85%) were obtained using optimized conditions such as glucose (10 g/L) as carbon source, potassium nitrate (2 g/L) as the nitrogen source at pH 8, growth temperature of 37 °C, 3% NaCl concentration and 72 h incubation period. The Klebsiella pneumoniae biofilm architecture was studied by confocal laser scanning microscopy (CLSM) and scanning electron microscope (SEM). The present study demonstrates the EPS influenced PAHs degradation of Klebsiella pneumoniae.