An integrative passive sampler consisting of a C18 Empore® disk receiving phase saturated with n-octanol and fitted with low-density polyethylene diffusion membrane was calibrated for the measurement of time-weighted average concentrations of hydrophobic micropollutants, including polyaromatic hydrocarbons and organochlorine pesticides, in water. The effect of temperature and water turbulence on kinetic and thermodynamic parameters characterising the exchange of analytes between the sampler and water was studied in a flow-through system under controlled conditions. It was found that the absorption of test analytes from water to the sampler is related to their desorption to water. This allows for the in situ calibration of the uptake of pollutants using offload kinetics of performance reference compounds. The sampling kinetics are dependent on temperature, and for most of the tested analytes also on the flow velocity. Sampler–water partition coefficients did not significantly change with temperature.

A pesticide runoff event was simulated on two 10 m x 50 m constructed wetlands (one non-vegetated, one vegetated) to evaluate the fate of methyl parathion (MeP) (Penncap-M). Water, sediment, and plant samples were collected at five sites downstream of the inflow for 120 d. Semi-permeable membrane devices (SPMDs) were deployed at each wetland outflow to determine exiting pesticide load. MeP was detected in water at all locations of the non-vegetated wetland (50 m), 30 min post-exposure. MeP was detected 20 m from the vegetated wetland inflow 30 min post-exposure, while after 10d it was detected only at 10 m. MeP was measured only in SPMDs deployed in non-vegetated wetland cells, suggesting detectable levels were not present near the vegetated wetland outflow. Furthermore, mass balance calculations indicated vegetated wetlands were more effective in reducing aqueous loadings of MeP introduced into the wetland systems. This demonstrates the importance of vegetation as sorption sites for pesticides in constructed wetlands.

The objective of this study was to examine the chemistry of trace elements in coalbed methane (CBM) discharge water reacting with semi-arid ephemeral stream channels in Powder River Basin, Wyoming. The study area consisted of two ephemeral streams, Burger Draw and Sue Draw. These streams are tributaries to the perennial Powder River, Wyoming. Samples were collected bimonthly from three CBM discharge points and seven channel locations in Burger Draw and Sue Draw. Samples were also collected bimonthly from the Powder River above and below the confluence of Burger Draw. Before sample collection, pH, temperature, dissolved oxygen (DO), and turbidity were measured in the field. Samples were transported to the laboratory and analyzed for dissolved trace elements including iron (Fe), manganese (Mn), boron (B), arsenic (As), selenium (Se), and fluoride (F). Results suggest pH of discharge water was 7.1 and increased significantly in the downstream channel of Burger Draw to 8.84 before joined with the Powder River. Temperature of CBM produced water at discharge points ranged between 20.3 and 22.7 [composite function (small circle)]C. Before discharge, DO concentrations of CBM produced water were between 1.42 and 1.5 mg/L. No significant differences in temperature, DO, and turbidity were found between Burger Draw flow and Powder River flow. However, significant differences were found within the sampling period in temperature and turbidity in flow of Burger Draw. The temperature, DO, and turbidity were all significantly different in Powder River within the sampling period. The CBM discharge water consisted of higher concentrations of F, Fe and B compared to other components. Significant changes were observed for Fe, Mn, and As; and seasonally for B. Dissolved Fe and Mn decreased, while As and Se increased in downstream channel flow. These findings will be useful in proper management of CBM produced water in semi-arid environments.

The results of a field experiment that investigated the in situ association of total coliforms (TC) and E. coli (EC) with suspended inorganic particles in a drinking water reservoir are presented. The experimental program measured TC and EC at various locations and at multiple depths in a medium sized Australian reservoir subject to continuous inflow forcing. Particle concentrations and size distributions were measured using a LISST (Laser In Situ Scattering Transmissometer) profiler. Correlations between the particle measurements and the bacteria were calculated to provide in situ evidence for the association of TC and EC with suspended inorganic particles. Both TC and EC correlated most strongly with fine particles between 3.2 and 4.5 μm. Development of a simple Lagrangian model of the inflow for particles and microbes additionally provided insight into the relative roles of dilution, sedimentation, and inactivation for the bacteria. The model results and the correlations support the theory that high association with the small particles was due to their high number concentration and the effective surface area available for attachment. It was also evident that the majority of bacteria (> 80%) were physically associated with the suspended particles and allowed a quantitative estimate of the net sedimentation rate. Bacterial attachment and the concomitant increase in settling should be considered when modeling bacterial dynamics, during design of monitoring programs and when implementing pathogen risk management strategies.

Hydrochemistry of an alluvial river was investigated employing the chemometric techniques such as cluster analysis (CA), principal component analysis (PCA), discriminant analysis (DA) and partial least square (PLS) with a view to extract information about the variables responsible for spatial and temporal variations in river hydrochemistry and water quality, the hidden factors explaining the structure of the hydro-chemical database of the river, factors/processes influencing the river hydro-chemistry. Analysis of spearman's correlation coefficient revealed non-significant correlation of the pollution indicator (BOD, COD, SO₄, F, NH₄-N, NO₃-N) variables with season and significant correlation with site, indicating contribution of the site-specific anthropogenic sources in the catchments. Spatial CA clustered the monitoring sites (10nos.) into three groups of relatively non-polluted sites, moderately polluted sites, and highly polluted sites. Temporal CA differentiated among the samples of monsoon and non-monsoon months. PCA rendered considerable data reduction, in terms of eight parameters explaining about 71% of the total variance and evolved six PCs. PCA grouped samples belonging to different seasons and sites distinctly correlating them with natural and anthropogenic variables. Temporal and spatial DA rendered 97 and 92% correct assignations of the samples, respectively, and revealed that temperature, pH, BOD, DO, alkalinity and Ca are the most significant variables to discriminate between the different seasons and account for most of the expected temporal variations in hydrochemistry of the river, whereas, hardness, DO, BOD, COD, Ca and Mg were the most significant discriminating variables in space. Spatial and temporal groupings of the samples were successfully achieved through PLS modeling. PLS showed that the summer season samples are dominated by PO₄, TDS, F, K, COD, BOD, Na, Cl, hardness and alkalinity, whereas, samples of winter season by DO, pH, NH₄-N and coliforms. Furthermore, PLS indicated site-specific dominance of anthropogenic contaminants suggesting for their pollution sources in the corresponding catchments of these sites.

The process of eutrophication in form of intense plant growth has been observed in some lakes and water streams at the Plitvice Lakes National Park in central Croatia. Here we investigate whether this phenomenon is a consequence of anthropogenic pollution or due to naturally produced organic matter in the lakes. We applied chemical analysis of water at two springs and four lakes (nutrients, dissolved organic carbon (DOC), trace elements) and measurements of surface lake sediments (mineral and organic fraction analyses, trace elements) in four different lakes/five sites. The chemical composition of water does not indicate recent anthropogenic pollution of water because the concentrations of most trace elements are below detection limits. The concentrations of DOC and nutrients are slightly higher in the area of increased eutrophication-plant growth. Also the content of organic matter in the sediment is at the highest level in areas with highest C/N ratio indicating that the organic fraction of this sediment is mainly of terrestrial origin. There is no significant difference among the trace element concentration in the upper segment of all cores, deposited approximately during last 50 years when higher anthropogenic influence is expected due to development and touristic activity, and the lower part of the cores, corresponding to the period approximately 100-200 years before present. The content of trace elements and organic matter in sediments decreases from the uppermost lake downstream. According to our results there is no indication of recent anthropogenic pollution in water and sediment. Higher concentrations of DOC in water as well as phosphorus and some other elements in the lake sediment can be a consequence of input of natural organic matter to the lake water.

Lake Vänern is Sweden's largest freshwater reservoir. It has been significantly affected by mercury contamination during the latter half of the 20th century. The aim of this study was to analyse the spatial and vertical mercury distribution, whereas 46 sediment cores were sampled in 2001 and analysed for total mercury. Several of these cores were dated presenting sediment accumulation rates varying from 6-8 mm yr-¹ outside major rivers to ~2 mm yr-¹ in the deeper areas. This was made using ¹³⁷ Cs, which was verified by ²¹⁰ Pb dating. Cluster analysis was used to identify five areas with similar accumulation and mercury concentration regimes. In areas far from shore, surface concentrations ranged from 0.1 to 0.5 ppm Hg, while the deeper layers in contaminated areas held concentrations up to 11 ppm Hg. In total, ~50 tonnes of mercury accumulated in the lake's sediment between ~1940-2001; almost 80% (or 37 tonnes) originate from before the mid 70's when the recovery period began, and at least 30 tonnes can be attributed to the former point source - a chlor-alkali industry.

The feasibility of degrading 16 USEPA priority polycyclic aromatic (PAH) hydrocarbons (PAHs) with heat and Fe(II)-EDTA catalyzed persulfate oxidation was investigated in the laboratory. The experiments were conducted to determine the effects of temperature (i.e. 20 [composite function (small circle)]C, 30 [composite function (small circle)]C and 40 [composite function (small circle)] C) and iron-chelate levels (i.e., 250 mg/L-, 375 mg/L- and 500 mg/L-Fe(II)) on the degradation of dissolved PAHs in aqueous systems, using a series of amber glass jars as the reactors that were placed on a shaker inside an incubator for temperature control. Each experiment was run in duplicate and had two controls (i.e., no persulfate in systems). Samples were collected after a reaction period of 144 hrs and measured for PAHs, pH and sodium persulfate levels. The extent of degradation of PAHs was determined by comparing the data for samples with the controls. The experimental results showed that persulfate oxidation under each of the tested conditions effectively degraded the 16 target PAHs. All of the targeted PAHs were degraded to below the instrument detection limits (~4 μ/L) from a range of initial concentration (i.e., 5 μ/L for benzo(a)pyrene to 57 μ/L for Phenanthrene) within 144 hrs with 5 g/L of sodium persulfate at 20 [composite function (small circle)] C, 30 [composite function (small circle)]C and 40 [composite function (small circle)]C. The data indicated that the persulfate oxidation was effective in degrading the PAHs and that external heat and iron catalysts might not be needed for the degradation of PAHs. The Fe(II)-EDTA catalyzed persulfate also effectively degraded PAHs in the study. In addition, the data on the variation of persulfate concentrations during the experiments indicated that Fe(II)-EDTA accelerated the consumption of persulfate ions. The obtained degradation data cannot be used to evaluate the influence of temperature and Fe(II) levels on the PAH degradation because the PAHs under each of the tested conditions were degraded to below the instrument detection limit within the first sampling point. However, these experiments have demonstrated the feasibility of degrading PAHs in aqueous systems with persulfate oxidation. Additional tests are being conducted to evaluate the effectiveness of treating PAHs in soils and obtaining the rate of degradation of PAHs with persulfate oxidation. Two sets of laboratory experiments were conducted to evaluate the ability of sodium persulfate in oxidizing real world PAH-contaminated soils collected from a Superfund site in Connecticut. The first set of soil sample were treated only with persulfate and to the second batch, mixture of persulfate and Fe(II)-EDTA solutions were added. The results of the second test showed that within 24 hours, 75% to 100% of the initial concentrations of seven PAH compounds detected in the soil samples were degraded by sodium persulfate mixed with FE(II)-EDTA.

During spring of 2005, referent monitoring of the chemical quality of surface waters and sediments in some protected areas in Vojvodina (Serbia) was conducted as a supplement to the Regular monitoring program. The aim of the study was to establish the chemical quality of surface waters and sediments regarding nutrient content. It is shown that the water quality satisfies the criteria of the 1st/2nd class according to our legislation, with the exception of the Ludos location, which showed a contamination with nitrogen matter in water and sediments. With regard to the contamination of water with phosphorus, almost all locations may be considered as potentially problematic.

Determination of total arsenic and As(III) was performed in untreated and treated water samples collected in some small water supply systems in Northern Backa district (Serbia). Concentration of total arsenic in treated water was between 71 and 115% of total arsenic in untreated water (0.001-0.168 mg As/cubic dm). In untreated water concentration of As(III) was between is less than 0.001 and 0.078 mg As/cubic dm. However, during the water treatment (chlorination process) As (III) concentration decreased significantly to the level of 1 to 2% of start concentration in untreated water. Influence of conservation water sample with HCl increased with consumption of KMnO4 on determination of As(III).