In this article, we investigated the effect of low intensity pulsed ultrasound (US), temperature and salinity on cleaning efficacy of fine bubbles with diameter <50μm for diesel contaminated sands. About 47% and 76% diesel removal was achieved from 10% (w/w) diesel contaminated fine and medium sands respectively, after 30min treatment with 40kHz low intensity intermittent pulsed US together with MBs in contrast to 41% and 68% diesel removal while treatment with MBs alone. The effect of high temperature was found to be prominent during the initial stages of cleaning. In addition, MBs generated in 599mM saline water efficiently removed 85% diesel from fine sand within 30min in contrast to only 41% diesel removal with MBs in fresh water. This study provides evidence for developing highly efficient MBs based chemical free technology for diesel contaminated sediments.

The size and settling velocity of oil-mineral aggregates (OMAs) derived from diluted bitumen are primary constituents in predictive models for evaluating the potential fate of oil spilled in the aquatic environment. A series of low sediment concentration (15mg·L−1), colder water (<10°C) wave tank experiments designed to measure variability in these parameters in naturally-formed OMAs in response the presence or absence of chemical dispersant are discussed. Corresponding lab experiments revealed settling velocities of artificially formed OMAs on the order of 0.1–0.4mm·s−1. High-resolution imagery of settling particles were analyzed for particle size, density and settling velocity. In situ formation of OMAs in the wave tank was unsuccessful. Possible effects of chemical dispersant on natural sediment flocculation, the size of suspended oil droplets and clearance rates of suspended particles are discussed.

Due to limited samples and low-resolution analysis, conflicting findings on major polychlorinated biphenyl (PCB) congeners and their origins remain in the East China Sea (ECS). Based on high-resolution sampling and high-resolution mass spectrometry analysis, 72 surface sediment samples from the Changjiang Estuary and adjacent ECS shelf were determined to characterize 39 PCB congeners. PCBs (∑39PCBs) ranged from 0.003 to 16.18ng/g dw, presenting a decreasing seaward trend. Tri-, tetra- and penta-CBs were the main components, accounting for >64% of ∑39PCBs in most samples. Tetra-CBs were the dominant congeners, corresponding to results of sediments from Changjiang middle reach and soils from Changjiang Delta. Comparison between PCBs and sediment properties indicated there may be a deposition boundary of 30°N. In the north, the spatial distribution of PCBs is controlled by Changjiang input and hydrodynamic conditions, while in the south closely related to combination of local source and riverine input.

The temporal and spatial distributions of mercury in different fractions and its potential ecological risk were investigated in sediments from the Yangtze River estuary (YRE) by analyzing data collected from the study area. The results showed that mercury in the organic and residual fractions had dominant proportions, from 15.2% to 48.52% and from 45.96% to 81.59%, respectively. The fractions were more susceptible to seasonal changes than other fractions. Higher proportions of mercury in organic fraction were found in wet seasons; the opposite was true for mercury in residual fraction. With respect to the spatial distribution, the concentration mercury in exchangeable, carbonate and Fe-Mn oxide fractions showed a decreasing trend from the inner estuary to the outer estuary, but no obvious trends were found in the distributions of mercury in the organic and residual fractions. The risk assessment code (RAC) was used to evaluate the potential ecological risk in the study area based on the proportions of exchangeable and carbonate fractions. The average RAC values during the four periods were 6.00%, 2.20%, 2.83%, and 0.61%. Although these values show that the risk in the study area is generally low, the distribution of RAC values indicates that the inner estuary has a medium risk, with a value up to 10%.

The Arabian Gulf is a semi-enclosed water body that has witnessed accelerated anthropogenic activity, in terms of commissioning of nuclear power plants, desalination facilities, oil refineries and extensive coastal development. Furthermore, three wars during the past three decades is a potential worry. This study presents the first plutonium baseline in seawater from the Northern Arabian Gulf. The 239+240Pu concentrations in seawater vary, between 2.9 and 4.9mBqm−3, a range that is comparable to other water masses at this latitude. The 238Pu ranged between 0.04 and 0.05mBqm−3 and the 137Cs concentration between 1.04 and 1.18Bqm−3. The ratio of 238Pu/239+240Pu at all eight sampling stations was 0.01, while the ratio of 239+240Pu/137Cs varied between 0.01 and 0.02. The presence of 137Cs and 239+240Pu in seawater from this region can mainly be attributed to the global atmospheric deposition and fluvial transport. The seawater concentration of 239+240Pu is five order of magnitude lower than bottom sediments in the area.

The concentrations and distribution of monoaromatic hydrocarbons (benzene, toluene, ethyl benzene and the sum of m-, p- and o-, xylenes) were determined in the sediments of coastal lagoons of the Gulf of Saros, using a static headspace GC–MS. The total concentrations of BTEX compounds ranged from 368.5 to below detection limit 0.6μgkg−1 dw, with a mean value of 61.5μgkg−1 dw. The light aromatic fraction of m-, p-xylene was the most abundant compound (57.1% in average), and followed by toluene (38.1%)>ethylbenzene (4.1%)>o-xylene (2.5%)>benzene (1.1%). The factor analysis indicated that the levels and distribution of BTEX compounds depend on the type of contaminant source (mobile/point), absorbance of compounds in sediment, and mobility of benzene compound and degradation processes. Point sources are mainly related to agricultural facilities and port activities while the dispersion of compounds are related with their solubility, volatility and effect of sea/saline waters on lagoons.

Marine debris' transboundary nature and new strategies to identify sources and sinks in coastal areas were investigated along the Paranaguá estuarine gradient (southern Brazil), through integration of hydrodynamic modelling, ground truthing estimates and regressive vector analysis. The simulated release of virtual particles in different parts of the inner estuary suggests a residence time shorter than 5days before being exported through the estuary mouth (intermediate compartment) to the open ocean. Stranded litter supported this pathway, with beaches in the internal compartment presenting proportionally more items from domestic sources, while fragmented items with unknown sources were proportionally more abundant in the oceanic beaches. Regressive vector analysis reinforced the inner estuarine origin of the stranded litter in both estuarine and oceanic beaches. These results support the applicability of simple hydrodynamic models to address marine debris' transboundary issues in the land-sea transition zone, thus supporting an ecosystem transboundary (and not territorial) management approach.

MALDI-TOF Mass Spectrometry Biotyping has proven to be a reliable method for identifying bacteria at the species level based on the analysis of the ribosomal proteins mass fingerprint. We evaluate the usefulness of this method to identify Enterococcus species isolated from marine recreational water at Brazilian beaches. A total of 127 Enterococcus spp. isolates were identified to species level by bioMérieux's API® 20 Strep and MALDI-TOF systems. The biochemical test identified 117/127 isolates (92%), whereas MALDI identified 100% of the isolates, with an agreement of 63% between the methods. The 16S rRNA gene sequencing of isolates with discrepant results showed that MALDI-TOF and API® correctly identified 74% and 11% of these isolates, respectively. This discrepancy probably relies on the bias of the API® has to identify clinical isolates. MALDI-TOF proved to be a feasible approach for identifying Enterococcus from environmental matrices increasing the rapidness and accuracy of results.

Forty eight surface sediment samples were collected from the vicinity of Van Island in order to assess the sediment pollution level and potential ecological risk on coral reef ecosystem. The analytical and correlation results indicate a distribution of elements is chiefly controlled by the CaCO3 and OM. The enrichment factor and geoaccumulation index show the elevated level of Pb in the surface sediments is due to application of lead petrol and coal incinerating power plants. The sediment pollution index reveals that majority of the sediments falling under highly polluted sediment category (35.4%) followed by moderately polluted (25%) and dangerous sediment category (14.58%). The potential ecological risk suggests that nearly 66.6% of the samples falling under the low risk category, moderate risk category (20.8%) followed by considerable risk category (8.33%) and very high risk category (4.1%). The accumulation level of trace elements clearly suggests that the coral reef ecosystem is under low risk.

We investigated the potential of coral skeleton δ15N (CS-δ15N) records for tracking anthropogenic-N sources in coral reef ecosystems. We produced a 56yr-long CS-δ15N record (1958–2014) from a reef flat in Guam that has been exposed to varying 1) levels of sewage treatment 2) population density, and 3) land use. Increasing population density (from <30 to 300ind·km−2) and land use changes in the watershed resulted in a ~1‰ enrichment of the CS-δ15N record until a sewage treatment plant (STP) started operation in 1975. Then, CS-δ15N stabilized, despite continued population density and land use changes. Based on population and other considerations, a continued increase in the sewage footprint might have been expected over this time. The stability of CS-δ15N, either contradicts this expectation, or indicates that the impacts on the outer reef at the coring site were buffered by the mixing of reef water with the open ocean.