Nanocomposite hydrogels based on poly(methacrylamide-co-acrylic acid) and nano-sized montmorillonite were prepared by aqueous dispersion and in situ radical polymerization. Optimum sorption conditions were determined as a function of montmorillonite content, contact time, pH, and temperature. The equilibrium data of Cu(2+) and Ni(2+) conformed to the Freundlich and Langmuir isotherms in terms of relatively high regression values. The maximum monolayer adsorption capacity of the nanocomposite hydrogel (with 3 wt% montmorillonite content), as obtained from the Langmuir adsorption isotherm, was found to be 49.26 and 46.94 mg g(-1) for Cu(2+) and Ni(2+), respectively, at contact time = 60 min, pH = 6.8, adsorbent dose = 100 mg/ml, and temperature = 318 K. Kinetic studies of single system indicated that the pseudo-second order is the best fit with a high correlation coefficient (R (2) = 0.97-0.99). The result of five times sequential adsorption-desorption cycle shows a good degree of desorption and a high adsorption efficiency.

The assessment of general condition of fish in the moderately contaminated aquatic environment was performed on the European chub (Squalius cephalus) caught in September 2009 in the Sutla River in Croatia. Although increases of the contaminants in this river (trace and macro elements, bacteria), as well as physico-chemical changes (decreased oxygen saturation, increased conductivity), were still within the environmentally acceptable limits, their concurrent presence in the river water possibly could have induced stress in aquatic organisms. Several biometric parameters, metallothionein (MT), and total cytosolic protein concentrations in chub liver and gills were determined as indicators of chub condition. Microbiological and parasitological analyses were performed with the aim to evaluate chub predisposition for bacterial bioconcentration and parasitic infections. At upstream river sections with decreased oxygen saturation (∼50 %), decreased Fulton condition indices were observed (FCI: 0.94 g cm(-3)), whereas gonadosomatic (GSI: 2.4 %), hepatosomatic (HSI: 1.31 %), and gill indices (1.3 %) were increased compared to oxygen rich downstream river sections (dissolved oxygen ∼90 %; FCI: 1.02 g cm(-3); GSI: 0.6 %; HIS: ∼1.08 %; gill index: 1.0 %). Slight increase of MT concentrations in both organs at upstream (gills: 1.67 mg g(-1); liver: 1.63 mg g(-1)) compared to downstream sites (gills: 1.56 mg g(-1); liver: 1.23 mg g(-1)), could not be explained by induction caused by increased metal levels in the river water, but presumably by physiological changes caused by general stress due to low oxygen saturation. In addition, at the sampling site characterized by inorganic and fecal contamination, increased incidence of bacterial bioconcentration in internal organs (liver, spleen, kidney) was observed, as well as decrease of intestinal parasitic infections, which is a common finding for metal-contaminated waters. Based on our results, it could be concluded that even moderate contamination of river water by multiple contaminants could result in unfavourable living conditions and cause detectable stress for aquatic organisms.

Jakara River Basin has been extensively studied to assess the overall water quality and to identify the major variables responsible for water quality variations in the basin. A total of 27 sampling points were selected in the riverine network of the Upper Jakara River Basin. Water samples were collected in triplicate and analyzed for physicochemical variables. Pearson product-moment correlation analysis was conducted to evaluate the relationship of water quality parameters and revealed a significant relationship between salinity, conductivity with dissolved solids (DS) and 5-day biochemical oxygen demand (BOD5), chemical oxygen demand (COD), and nitrogen in form of ammonia (NH4). Partial correlation analysis (r p) results showed that there is a strong relationship between salinity and turbidity (r p = 0.930, p = 0.001) and BOD5 and COD (r p = 0.839, p = 0.001) controlling for the linear effects of conductivity and NH4, respectively. Principal component analysis and or factor analysis was used to investigate the origin of each water quality parameter in the Jakara Basin and identified three major factors explaining 68.11 % of the total variance in water quality. The major variations are related to anthropogenic activities (irrigation agricultural, construction activities, clearing of land, and domestic waste disposal) and natural processes (erosion of river bank and runoff). Discriminant analysis (DA) was applied on the dataset to maximize the similarities between group relative to within-group variance of the parameters. DA provided better results with great discriminatory ability using eight variables (DO, BOD5, COD, SS, NH4, conductivity, salinity, and DS) as the most statistically significantly responsible for surface water quality variation in the area. The present study, however, makes several noteworthy contributions to the existing knowledge on the spatial variations of surface water quality and is believed to serve as a baseline data for further studies. Future research should therefore concentrate on the investigation of temporal variations of water quality in the basin.

Vermicomposting of water hyacinth is a good alternative for the treatment of water hyacinth (Eichhornia crassipes) and subsequentially, beneficial for agriculture purposes. The bioavailability and leachability of heavy metals (Zn, Cu, Mn, Fe, Ni, Pb, Cd, and Cr) were evaluated during vermicomposting of E. crassipes employing Eisenia fetida earthworm. Five different proportions (trials 1, 2, 3, 4, and 5) of cattle manure, water hyacinth, and sawdust were prepared for the vermicomposting process. Results show that very poor biomass growth of earthworms was observed in the highest proportion of water hyacinth (trial 1). The water soluble, diethylenetriaminepentaacetic acid (DTPA) extractable, and leachable heavy metals concentration (percentage of total heavy metals) were reduced significantly in all trials except trial 1. The total concentration of some metals was low but its water soluble and DTPA extractable fractions were similar or more than other metals which were present in higher concentration. This study revealed that the toxicity of metals depends on bioavailable fraction rather than total metal concentration. Bioavailable fraction of metals may be toxic for plants and soil microorganisms. The vermicomposting of water hyacinth by E. fetida was very effective for reduction of bioavailability and leachability of selected heavy metals. Leachability test confirmed that prepared vermicompost is not hazardous for soil, plants, and human health. The feasibility of earthworms to mitigate the metal toxicity and to enhance the nutrient profile in water hyacinth vermicompost might be useful in sustainable land renovation practices at low-input basis.

Degradation of bisphenol A (BPA) in aqueous solution was studied with high-efficiency sulfate radical (SO₄⁻·), which was generated by the activation of persulfate (S₂O₈²⁻) with ferrous ion (Fe²⁺). S₂O₈²⁻was activated by Fe²⁺to produce SO₄⁻·, and iron powder (Fe⁰) was used as a slow-releasing source of dissolved Fe²⁺. The major oxidation products of BPA were determined by liquid chromatography-mass spectrometer. The mineralization efficiency of BPA was monitored by total organic carbon (TOC) analyzer. BPA removal efficiency was improved by the increase of initial S₂O₈²⁻or Fe²⁺concentrations and then decreased with excess Fe²⁺concentration. The adding mode of Fe²⁺had significant impact on BPA degradation and mineralization. BPA removal rates increased from 49 to 97 % with sequential addition of Fe²⁺, while complete degradation was observed with continuous diffusion of Fe²⁺, and the latter achieved higher TOC removal rate. When Fe⁰was employed as a slow-releasing source of dissolved Fe²⁺, 100 % of BPA degradation efficiency was achieved, and the highest removal rate of TOC (85 %) was obtained within 2 h. In the Fe⁰–S₂O₈²⁻system, Fe⁰as the activator of S₂O₈²⁻could offer sustainable oxidation for BPA, and higher TOC removal rate was achieved. It was proved that Fe⁰–S₂O₈²⁻system has perspective for future works.

Ecological sampling can be labor intensive, and logistically impractical in certain environments. We optimize line intercept sampling and compare estimation methods for assessing feral swine damage within fragile wetland ecosystems in Florida. Sensitive wetland sites, and the swine damage within them, were mapped using GPS technology. Evenly spaced parallel transect lines were simulated across a digital map of each site. The length of each transect and total swine damage under each transect were measured and percent swine damage within each site was estimated by two methods. The total length method (TLM) combined all transects as a single long transect, dividing the sum of all damage lengths across all transects by the combined length of all transect lines. The equal weight method (EWM) calculated the damage proportion for each transect line and averaged these proportions across all transects. Estimation was evaluated using transect spacings of 1, 3, 5, 10, 15, and 20 m. Based on relative root mean squared error and relative bias measures, the TLM produced higher quality estimates than EWM at all transect spacings. Estimation quality decreased as transect spacing increased, especially for TLM. Estimation quality also increased as the true proportion of swine damage increased. Diminishing improvements in estimation quality as transect spacings decreased suggested 5 m as an optimal tradeoff between estimation quality and labor. An inter-transect spacing of 5 m with TLM estimation appeared an optimal starting point when designing a plan for estimating swine damage, with practical, logistical, economic considerations determining final design details.

In this study, rice husk was modified with NaOH and used as adsorbent for dynamic adsorption of methylene blue (MB) from aqueous solutions. Continuous removal of MB from aqueous solutions was studied in a laboratory scale fixed-bed column packed with NaOH-modified rice husk (NMRH). Effect of different flow rates and bed heights on the column breakthrough performance was investigated. In order to determine the most suitable model for describing the adsorption kinetics of MB in the fixed-bed column system, the bed depth service time (BDST) model as well as the Thomas model was fitted to the experimental data. An artificial neural network (ANN)-based model was also developed for describing the dynamic dye adsorption process. An extensive error analysis was carried out between experimental data and data predicted by the models by using the following error functions: correlation coefficient (R ²), average relative error, sum of the absolute error and Chi-square statistic test (χ ²). Results show that with increasing bed height and decreasing flow rate, the breakthrough time was delayed. All the error functions yielded minimum values for the ANN model than the traditional models (BDST and Thomas), suggesting that the ANN model is the most suitable model to describe the fixed-bed adsorption of MB by NMRH. It is also more rational and reliable to interpret dynamic dye adsorption data through a process of ANN architecture.

Superficial and cored sediment samples from the Moulay Bousselham lagoon and sub-watershed were analyzed for Al, Fe, Cu, Zn, Pb, Mn, Ni, Cr, As, Hg, and Cd. The temporal and spatial distributions of the main contamination sources of heavy metals were identified and described using chemometric and geographic information system (GIS) methods. Sediments from coastal lagoons near urban and agricultural areas are commonly contaminated with heavy metals, and the concentrations found in surface sediments are significantly higher than those from 50-100 years ago. The concentrations of these elements decrease sharply with depth in the sediment column, and the elements are preferentially enriched in the <2-μm-sized fraction of the sediment. The zones of enhanced risk of heavy metals were detected by means of GIS-based geostatistical modeling. According to sediment pollution indices and statistical analysis, heavy metals (Pb, Cu, Ni, Zn, Cr, and Hg) that pose a risk have become largely enriched in the lagoon sediments during the recent period of agricultural intensification.

This study evaluates PCDD/F pollution in the surface sediments of Izmit Bay (Turkey) and assesses the possible sources of PCDD/F inputs to the bay. The results showed that concentrations of toxic PCDD/F congeners in the sediments varied between 0.45 and 255 ng WHO2005-TEQ/kg dry weight. Pollution mapping shows that PCDD/F levels in the central section of Izmit Bay are much higher than those in the eastern and the western sections. Sediments collected from the northern part of the central section showed very high PCDD/F concentrations. The samples reveal three different congener profiles dominated by OCDF, 1,2,3,4,6,7,8-HpCDF, and OCDD respectively. The dominance of OCDF in the sediment samples taken from the central section was attributed to the former production of vinyl chloride monomer in the area, while that of 1,2,3,4,6,7,8-HpCDF was attributed to the (previously unknown) use of a chlorophenol-based fungicide in the region. The OCDD dominated group was explained by the use of pentachlorophenol. The results indicate that historic industrial discharges are the main contributor to the PCDD/F pollution in the sediments.