Lignin is the major polluting and colouring constituent present in pulp and paper mill effluent. To degrade lignin and its derivatives, bacterial enzymes can play an important role due to stability at extreme environmental conditions. This study explored the degradation of pulp and paper mill effluent by a rod-shaped Gram-positive bacterial strain RJH-1, isolated from sludge, based on its efficiency to reduce COD, colour, AOX and lignin content. This bacterial isolate was able to grow in nitrogen-free Jensen medium. Further, RJH-1 was identified as Brevibacillus agri strain after 16 s rRNA gene sequencing. Degradation potential of this isolated bacterial strain was evaluated by batch and semi-continuous reactor study. In batch study, the isolate reduced 69 % COD, 47 % colour, 37 % lignin and 39 % AOX after 5 days whereas in control flask, 40 % COD, 26 % colour, 19 % lignin and 22 % AOX reduction was observed by the indigenous bacteria present in wastewater. During semi-continuous reactor study, it reduced 62 % COD, 37 % colour, 30 % lignin and 40 % AOX of effluent at a retention time of only 32 h whereas the reduction in control reactor was 36 % COD, 21 % colour, 18 % lignin and 29 % AOX. This study confirmed that the B. agri has the potential to degrade the lignin and reduce the colour and COD of the pulp and paper mill waste water.

The aim of this study was to describe the mechanisms that native Bacillus cereus M6 isolated from heavy crude oilᵒAPI gravity 11.5 uses to tolerate and/or resist toxic metals. Metal tolerance and removal of Pb(II), Cr(VI), and As(V) was determined. In addition, we evidenced the subcellular distribution of metals, the efflux pump kinetics, and morphological changes in metal-tolerant bacteria. B. cereus M6 exhibited strong tolerance and resistance to the metals evaluated and efficiently removed the metal content by operating efflux pumps and accumulating mainly in membrane fraction. Also, it was found that the model that best fit the efflux corresponds to an equation for resonant oscillations. B. cereus M6 uses mechanisms, including efflux pumps, intracellular and extracellular accumulation in parallel in order to maintain metal levels below a toxic threshold and overcome the effects of high concentrations. These findings are an approach of an energy-dependent efflux system to eliminate excessive amounts of crude oil-associated metals in Bacillus. B. cereus M6 may potentially be useful in designing improved strategies for the bioremediation of soils polluted with metals. Additionally, the prediction model developed would be useful for improving the monitoring of in vitro and in vivo bioremediation processes.

Catalytic ozonation process (COP) is a promising advanced oxidation process for petrochemical wastewater (PCW) treatment. However, the lack of economical and effective catalysts limits its application. Manganese sand ore (MSO) was utilized as a heterogeneous catalyst for ozonation of organic contaminants in PCW in this study. The calcined MSO-assisted COP (cMSO-COP) of aniline exhibited greater degradation than natural MSO-assisted COP or single ozonation process (SOP). The cMSO significantly promoted hydroxyl radical-mediated oxidation, decreased the ozonation activation energy by about 20 %, and doubled the reaction rates in comparison with SOP. The cMSO-COP increased the chemical oxygen demand (COD) removal of PCW twofold relative to SOP. The number of polar organic contaminants decreased by 50 % after cMSO-COP treatment. This study demonstrated the potential use of cMSO for efficient ozonation of petrochemical-derived contaminants at low cost.

Although recent studies show that the iron oxides do not enter or accumulate in plants, they may preclude the transport of water and nutrients in the plants through/as a consequence of their aggregation on the surface of the roots. The feasibility of using iron oxide nanoparticles to modify the availability of trace elements (TEs) to Helianthus annuus in the soil as well as their interference with the plant response during an imposed water deficiency stress were studied in a pot experiment. Plants were grown in a compost pre-amended contaminated soil with and without nano-maghemite (NM) and later exposed to drought. The nano-amendment promoted the growth of H. annuus (higher (25 %) dry weight than in the same soil without NM), mainly due to the insolubilisation of pore water Zn in the soil and the consequent reduction of its availability to the plants. During the water stress, NM did not cause an increase in the accumulation of proline or total amino acids in the plants, which are normally used as drought stress indicators, compared to the control plants without NM. In conclusion, NM could be useful soil amendments during phytoremediation procedures, since it can immobilise TEs in the soil without disrupting the plant water balance.

Paris conurbation is a heavily urbanized but weakly industrialized catchment. Recently, it has been shown at the scale of Paris that alkylphenols (AP) and phthalates (PAE) are not rejected by the industry, but they originate from domestic wastewater at more than 95 %. However, the contribution of the different types of greywater to the pollution by alkylphenols and phthalates was not addressed. This work aims at providing new insights on this particular point. Hence, the concentration of four phthalates (diethyl phthalate (DEP), di-n-butyl phthalate (DnBP), benzyl butyl phthalate (BBP), and di(2-ethylhexyl)phthalate (DEHP)) and two alkylphenols (octylphenols (OP) and isomers of nonylphenol (NP)) were followed in greywater. For each sample, analyses were carried out on both the dissolved and particulate phases. Moreover, water quality parameters were also monitored, in order to find out whether or not any correlation exists between the concentration of the investigated contaminants and the quality of water. Water quality parameters studied are pH, total suspended solids (TSS), dissolved and particular organic carbon (DOC and POC), chemical and biochemical oxygen demands (COD and BOD5), total Kjeldahl nitrogen (TKN), and anionic detergents (methylene blue active substance or MBAS). This paper presents the methodology used to monitor two greywater with the most important volumes: showers and washing machines. These greywater showed high variability with regard to water quality parameters. Moreover, AP and PAE concentrations are given for the first time for these two types of greywater. All compounds except OP were observed in almost all samples in at least one of the two monitored phases. The concentrations varied between limit of quantification for OP and 102 μg/l for DEHP. The levels measured in washing machines were higher than those for showers for all compounds. For instance, median NP concentration in washing machines was 3.59 μg/l against 1.09 μg/l in showers, DEHP was observed at 102 μg/l in washing machines against 16.6 μg/l in showers. Variability of the results was explained by habits of individuals (shower time, number of products used…) but also by differences in product composition. However, each type of water exhibited the same distribution. NP was the most abundant AP (about 85 % of the total amount) while DEHP represented the two thirds of the PAE compounds. The partition coefficients (Kd in l/kg) were evaluated. The results showed that log Kd ranged between 2.1 (DEP) and 4.8 (DEHP). Log Koc presented similar trends lying in the 2.4 (DEP)-5.0 (DEHP) range. Finally, with regard to greywater quality, the application for greywater reuse is discussed.

Natural zeolitic tuff was modified with FeCl₃solution for the removal of fluoride, and the effect of chloride, nitrate, and sulfate ions was examined on fluoride sorption from solutions and drinking water. The unmodified zeolitic tuff (Z) and the iron-modified zeolitic tuff (Fe(III)-Z) were characterized by scanning electron microscopy and X-ray diffraction analysis. The elemental composition, the specific surface area, and the point of zero charge of the zeolitic material were also determined. The fluoride adsorption was carried out in a batch system considering the effect of contact time, the initial concentration of fluoride ions, and the effect of other anions naturally present in the drinking water. The kinetic and isotherm results were adjusted to the pseudo-second-order and Freundlich models, respectively, which indicated that the sorption mechanism was chemisorption on a heterogeneous material. The fluoride sorption capacity was higher in solutions (2.7 mg/g) than in drinking water (0.41 mg/g), and this could be attributed to the presence of other anions. Overall, the presence of chloride ions significantly diminished the fluoride adsorption capacity, while the presence of nitrate and sulfate ions did not show any significant effect; the anion removal efficiency by Fe(III)-Z followed the order F⁻ > > Cl⁻ > NO₃⁻ > SO₄²⁻.

Featured with biodegradability and biocompatibility properties, gelatin (GE) was selected as the backbone to graft poly(acrylic acid) (PAA) to fabricate a granular hydrogel at room temperature in air. Using attapulgite (APT) as an inorganic component, the resulting GE-g-PAA/APT hydrogel was characterized by means of Fourier transform infrared (FTIR) spectroscopy, scanning electron microscopy (SEM), and zeta potential analysis and then used as the adsorbent to be applied in a mixed dye solution containing malachite green and orange G. The addition of APT can significantly reduce the swelling degree during the adsorption process, though its influences on the adsorption capacity are not so expectable. The as-prepared hydrogel shows a wide pH-independent adsorption from 3.0 to 10.0, with the maximum adsorption capacity of 1370 mg/g for GE-g-PAA and 1190 mg/g for GE-g-PAA/APT (5 wt%). More importantly, the as-prepared hydrogel shows high adsorption selectivity for cationic dyes and the dye-loaded hydrogel can be easily regenerated and recovered for successive adsorption cycles. Graphical Abstract Gelatin-based granular hydrogel for selective removal of MG in a mixed dyes containing MG and OG-G.

The first uranium extraction mine of Brazil, nowadays found in decommissioning phase, has caused several negative environmental impacts in its area, as a result of mining, treatment, and beneficiation processes. The generation of acid mine drainage in waste rock pile 4 (WR-4) is one of the negative impacts with the most critical situation. The acidic water, product of this drainage, presents heavy metals and radioactive elements and it may be infiltrated by the basis of the impoundment basin, where this water is collected for treatment. The objective of this study was to investigate a typical tropical soil, located in the area of Ores Treatment Unit of Caldas in the southwestern state of Minas Gerais, Brazil, in order to use it as a mineral liner for a retention basin to minimize leakage of acidic water through the foundation of a containment dam. In this way, geotechnical, chemical, and mineralogical tests were performed in order to characterize a soil sample collected in the area. In addition, adsorption tests were conducted with solutions of aluminum (Al), manganese (Mn), and iron (Fe), and with and without adjustment of the initial pH (pHₜₒ) of the solutions. The results indicated a well-weathered soil composed of kaolinite, gibbsite, and iron oxides. The adsorption tests showed different behaviors for Al, Mn, and Fe considering or not the adjustment of the pHₜₒ. Aluminum showed low adsorption by soil; because of this, only the adsorption isotherms of Mn and Fe for test with adjustment of the pHₜ₀were determinate. The coefficient of distribution (KD) of Mn was 0.0364 L g⁻¹and Fe 0.0281 L g⁻¹. As for the retardation factor (Rd), its values ranged from 81 to 91 for Mn and from 61 to 79 for Fe, considering different behaviors of the adsorption isotherm models.

The potential of agricultural waste materials for the removal bisphenol A (BPA) from aqueous solution was investigated. BPA is an endocrine-disrupting compound (EDC) used mainly in the plastic manufacturing industry. It may be hazardous to humans and animals because of its estrogenic activity. Agricultural wastes are sustainable adsorbents because of their low cost and availability. Hence, this study investigated the removal of BPA from water by adsorption onto treated coir pith, coconut shell and durian peel. The adsorption of BPA from water onto adsorbent was evaluated using field emission scanning electron microscopy (FESEM), Fourier transform infrared spectroscopy (FTIR), and Brunauer–Emmett–Teller (BET). The effects of morphology, functional groups, and surface area on adsorption before and after pretreatment with sulfuric acid and reaction were investigated, and it was found that the treated adsorbent were able to remove BPA. Carbonyl and hydroxyl groups had appear in large number in FTIR analysis. The present study indicates that coir pith had removed 72 % of BPA with adsorption capacity of 4.308 mg/g for 24 h, followed by durian peel (70 %, 4.178 mg/g) and coconut shell (69 %, 4.159 mg/g). The results proved that these modified phyto-waste were promising materials as alternative adsorbent for the removal of BPA from aqueous solution.

In this paper, we compared the costs and benefits of reducing premature mortality caused by exposure to surface ozone and particulate matter with an aerodynamic diameter <2.5 μm (PM₂.₅) in East Asia in 2020. The cost of ozone and PM₂.₅emission reduction is estimated using the Greenhouse Gas and Air Pollution Interactions and Synergies (GAINS)-China model. The benefit of reducing premature mortality caused by exposure to corresponding ozone and PM₂.₅emission is valued by the value of statistical life (VSL). The costs and benefits are evaluated for two emission reduction policies in 2020 with varying stringency in China: Case FS (the strict policy implementation case in China) and Case FR (the less strict policy implementation case in China). For ozone, the emission reduction cost and the benefit of life saving are 33,000 and 8200, 36,600–99,700 and 22,200–60,700 (million int. $, 2005), for Case FS and Case FR, respectively. The corresponding cost and benefit for PM₂.₅are 3580 and 523, 292,000–797,000 and 194,000–530,000 (million int. $, 2005), respectively. In total (ozone and PM₂.₅), the respective values are 36,400 and 8720, 329,000–897,000 and 217,000–591,000 (million int. $, 2005). Owing to these large benefits and also relatively low PM control costs, the benefits of controlling PM₂.₅surpass control costs significantly. The benefit/cost ratio is especially high for PM₂.₅for both policies and highlight the priority of controlling aerosol emissions in East Asia.