Abiological granular sludge (ABGS) formation is a potential and facile strategy for improving sludge settling performance during zinc removal from wastewater using chemical precipitation. In this study, the effect of pH, seed dosage, and flocculant dosage on ABGS formation and treated water quality was investigated. Results show that settling velocity of ABGS can reach up to 4.00 cm/s under optimal conditions, e.g., pH of 9.0, zinc oxide (ZnO) seeds dosage of 1.5 g/l, and polyacrylamide (PAM) dosage of 10 mg/l. More importantly, ABGS formation mechanism was investigated in NaOH precipitation process and compared with that in bio-polymer ferric sulfate (BPFS)–NaOH precipitation process regarding their sludge structure and composition. In the NaOH precipitation process, ABGS formation depends on some attractions between particles, such as van der Waals attraction and bridging attraction. However, during the BPFS–NaOH sludge formation process, steric repulsion becomes dominant due to the adsorption of BPFS on ZnO seeds. This repulsion further causes extremely loose structure and poor settling performance of BPFS–NaOH sludge.

The present work compares the efficiency of homogenous Fenton and photo-Fenton processes in the presence of Fe(III)–EDDS complex under different experimental conditions. 4-tert-Butylphenol (4-t-BP), which is one of the endocrine disrupting chemicals, was used as a model pollutant to investigate the Fenton and photo-Fenton application. The efficiency of homogenous photo-Fenton process was significantly much higher than homogenous Fenton process, which is due to the rapid formation of Fe²⁺ under UV irradiation of the iron complex and the photochemical formation of HO• from the photolysis of the complex Fe(III)–EDDS. Through the degradation of 4-t-BP, the effect of Fe(III)–EDDS concentration, H₂O₂ concentration, pH, and oxygen was investigated in both processes. Such trend was also correlated with pH calculating the polychromatic Fe²⁺ quantum yield formation at pH 4.0, 6.0, and 8.6. The results showed that at high Fe(III)–EDDS and H₂O₂ concentrations, a negative effect was found. By the way, the Fenton process was found to be enhanced at basic pH. These results can be very useful for the use and optimization of such iron complex in water treatment process as function of different physico-chemical conditions.

Environmental characteristics in water and sediments of two contrasted coastal Mediterranean lagoons, Bages-Sigean and Canet-St Nazaire, were measured over a three season survey. The urban pollution (treatment plant discharges) is very important in Canet-St Nazaire lagoon reflecting untreated sewages, while in Bages-Sigean, the northern part appears more impacted due to larger anthropogenic inputs. Dissolved Cd concentrations are on the whole similar in both lagoons, whereas Cu concentrations are by far higher in lagoon Canet-St Nazaire. Cu concentrations appear to be highly dependent on dissolved organic carbon whereas salinity seems to control Cd variations. Concerning the sediments, the confined northern part of lagoon Bages-Sigean shows organic carbon and total nitrogen enrichment whereas lipid concentrations are much higher in the Canet-St Nazaire lagoon. Cu complexation seems to be strongly related to organic matter as evidenced by the two significant positive relationships, on one hand between Cu and organic carbon, and on the other hand, between Cu and lipids. On the contrary, Cd concentrations appear to be mainly controlled by carbonates. PCBs and PBDEs were detected only in sediments and show relatively low concentrations compared to similar lagoon environments. Regarding the sediment quality guidelines, Cd, Cu and PCBs in both lagoons did not exceed any Probable Effect Concentration (PEC).

Adsorption of fluoranthene (FLA) in surfactant solution on activated carbon (AC) was investigated. Isotherm, thermodynamic, and kinetic attributes of FLA adsorption in the presence of the surfactant on AC were studied. Effects of AC dosage, initial concentration of TX100, initial concentration of FLA, and addition of fulvic acid on adsorption were studied. The experimental data of both TX100 and FLA fitted the Langmuir isotherm model and the pseudo-second-order kinetic model well. Positive enthalpy showed that adsorption of FLA on AC was endothermic. The efficiency of selective FLA removal generally increased with increasing initial surfactant concentration and decreasing fulvic acid concentration. The surface chemistry of AC may determine the removal of polycyclic aromatic hydrocarbons. The adsorption process may be controlled by the hydrophobic interaction between AC and the adsorbate. The microwave irradiation of AC may be a feasible method to reduce the cost of AC through its regeneration.

Korean water quality managers are required to promptly develop national assessment standards for freshwater sediment quality due to the Four Major River Restoration Project in Korea in 2009. We conducted this study to develop sediment management standards (SMSs), determining obviously and severely polluted sediment, which could have adverse impacts on water quality and aquatic ecosystem. The SMSs values were derived from the 95th percentile of concentration distribution for organic matter and nutrients in sediment quality database. For the SMSs of metals, foreign sediment quality guidelines (SQGs) were adopted. As a result, 13 % for loss on ignition (LOI), 1,600 mg/kg for total phosphorus (TP), and 5,600 mg/kg for total nitrogen (TN) were set as the SMSs for freshwater sediment in Korea. These values were higher than the range of heavily polluted sediment from USEPA Region 5 guideline derived by the similar approaches for the Great Lakes harbor sediments, and similar or lower than the severe effect level (SEL) from provincial sediment quality guideline (PSQG) of Ontario, Canada by screening level concentration (SLC) approach. However, SMSs in the present study are appropriate considering the concentration ranges and the Korean SMSs’ definition for freshwater sediments in Korea. The Puget Sound marine sediment cleanup screening level (CSL) in Washington State, USA were adopted as the Korean SMSs for As (93 mg/kg), Cd (6.7 mg/kg), Cr (270 mg/kg), Cu (390 mg/kg), Pb (530 mg/kg), and Zn (960 mg/kg) in freshwater sediments. Hg concentration (0.59 mg/kg) of CSL was too low to determine the polluted freshwater sediments in Korea, and the SEL of Ontario, Canada for mercury concentration (2 mg/kg) was selected as the SMS for Hg. These values were found reasonable through the assessment of applicability with the datasets from locations directly affected by obvious point sources. These results indicate that SMSs for organic matter, nutrient, and metals derived within the present study can successfully determine obviously and severely polluted sediment in Korea. However, the SMSs have limits to specifically determine the effects of polluted sediment on water quality and aquatic ecosystem in Korea. Thus, we will revise and specify SMSs considering those effects and further sediment quality assessment framework in the near future.

An empirical approach for simulating the infection and progress of leaf rust (caused by Puccinia triticina) during stem elongation on winter wheat was analysed for the 2000 to 2006 growing seasons. The approach was elaborated based on night weather conditions (i.e., air temperature, relative humidity and rainfall) and leaf rust occurrences. Data from three consecutive cropping seasons (2000–2002) at four representative sites of the Grand-Duchy of Luxembourg were used in the set-up phase. The capability to correctly simulate the occurrence expression of P. triticina infections on the upper leaf layers was then assessed over the 2003–2006 period. Our study revealed that the development of leaf rust required a period of at least 12 consecutive hours with air temperatures ranging between 8 and 16 °C, a relative humidity greater than 60 % (optimal values being 12–16 °C and up to 80 % for air temperatures and relative humidity, respectively) and rainfall less than 1 mm. Moreover, leaf rust occurrences and infections were satisfactorily simulated. The false alarm ratio was ranged from 0.06 to 0.20 in all the study sites. The probability of detection and critical success index for WLR infection were also close to 1 (perfect score).

The phenomenon of coagulation settling in liquid suspensions has a variety of applications, including mineral processing, treatment of industrial effluents, and municipal sewage sludge purification. This study was to investigate the coagulation settling characteristics of fine-grind natural zeolite and evaluate the removal efficiency of contaminants simultaneously in static and turbulent flow. A series of column experiments were conducted to pattern the characteristics of spatial and temporal variation of coagulation settling and removal contaminants in static and turbulent flow. The results indicated that the suspended solid concentration presented an apparent exponential decay with coagulation settling time in static flow (R ² > 0.99), coagulation settling rate of the fine zeolite-suspended solid in static flow was between 0.005 and 0.05 cm/s obtained from the repeat depth suction method. The relation between average C/C ₀ of pollutants and suspended solid concentration was exponential before the settlement for 24 h and that was the line after the settlement for 24 h. Several various models were presented to highlight the coagulation settling characteristics of fine-grind natural zeolite in static and turbulent flow. Compared to hydrostatic settling experiments, zeolite-suspended solid presented better removal efficiency of pollutants and greater removal rate of pollutants in turbulent flow.

In the present study, the investigation of the levels of the local and regional oxidants concentration at Athens, Greece, is attempted by analyzing the observations obtained at an urban and a rural station, during 2001–2011 and 2007–2011, respectively. A progressive increase of the daytime and nighttime average of [NO₂]/[Oₓ] versus [NOₓ] is observed showing a larger proportion of Oₓin the form of NO₂when the level of NOₓincreases. Similar results are observed when studying the variation of mean values of [NO₂]/[NOₓ] versus [NOₓ]. The results obtained when compared with those that have earlier detected elsewhere, revealed similarities and discrepancies that are discussed in detail. The parameterized curves that are presented for the first time in this paper may be used by the air quality planners to track the trends in other cities also, and to understand what is or was driving them.

At many contaminated field sites in Europe, monitored natural attenuation is a feasible site remediation option. Natural attenuation includes several processes but only the microbial degradation leads to real contaminant removal and very few methods are accepted by the authorities providing real evidence of microbial contaminant degradation activity. One of those methods is the recently developed in situ microcosm approach (BACTRAP®). These in situ microcosms consist of perforated stainless steel cages or PTFE tubes filled with an activated carbon matrix that is amended with ¹³C-labelled contaminants; the microcosms are then exposed within groundwater monitoring wells. Based on this approach, natural attenuation was accepted by authorities as a site remediation option for the BTEX-polluted site Zeitz in Germany. Currently, the in situ microcosms are restricted to the use inside groundwater monitoring wells at the level of the aquifer. The (classical) system therefore is only applicable on field sites with a network of monitoring wells, and only microbial activity inside the monitoring wells at the level of the aquifer can be assessed. In order to overcome these limitations, a new Direct-Push BACTRAP probe was developed on the basis of the Geoprobe® equipment. With respect to the mechanical boundary conditions of the DP technique, these new probes were constructed in a rugged and segmented manner and are adaptable to various sampling concepts. With this new probe, the approach can be extended to field sites without existing monitoring wells, and microbial activity was demonstrated to be measureable even under very dry conditions inside the vadose zone above the aquifer. In a field test, classical and Direct-Push BACTRAPs were applied in the BTEX-contaminated aquifer at the ModelPROBE reference site Zeitz (Germany). Both types of BACTRAPs were incubated in the centre and at the fringe of the BTEX plume. Analysis of phospholipid fatty acid (PLFA) patterns showed that the bacterial communities on DP-BACTRAPs were more similar to the soil than those found on classical BACTRAPs. During microbial degradation of the ¹³C-labelled substrate on the carrier material of the microcosms, the label was only slightly incorporated into bacterial biomass, as determined by PLFA analysis. This provides clear indication for decreased in situ natural attenuation potential in comparison to earlier sampling campaigns, which is presumably caused by a large-scale source remediation measure in the meantime. In conclusion, Direct-Push-based BACTRAPs offer a promising way to monitor natural attenuation or remediation success at field sites which are currently inaccessible by the technique due to the lack of monitoring wells or due to a main contamination present within the vadose zone.